Abstract: Bio-electrical responses obtained from freshwater
sediments by employing microbial fuel cell (MFC) technology were
investigated in this experimental study. During the electricity
generation, organic matter in the sediment was microbially oxidized
under anaerobic conditions with an electrode serving as a terminal
electron acceptor. It was found that the sediment organic matter
(SOM) associated with electrochemically-active electrodes became
more humified, aromatic, and polydispersed, and had a higher average
molecular weight, together with the decrease in the quantity of SOM.
The alteration of characteristics of the SOM was analogous to that
commonly observed in the early stage of SOM diagenetic process (i.e.,
humification). These findings including an elevation of the sediment
redox potential present a possibility of the MFC technology as a new
soil/sediment remediation technique based on its potential benefits:
non-destructive electricity generation and bioremediation.
Abstract: The protection issues in distribution systems with open and closed-loop are studied, and a generalized protection setting scheme based on the traditional over current protection theories is proposed to meet the new requirements. The setting method is expected to be easier realized using computer program, so that the on-line adaptive setting for coordination in distribution system can be implemented. An automatic setting program is created and several cases are taken into practice. The setting results are verified by the coordination curves of the protective devices which are plotted using MATLAB.
Abstract: In this research, the use of light beam size to design the adjustable mirror bender is presented. The focused beam line characterized by its size towards the synchrotron light beam line is investigated. The COSMOSWorks is used in all simulation components of curvature adjustment system to analyze in finite element method. The results based on simulation covers the use of applied forces during adjustment of the mirror radius are presented.
Abstract: This study fabricates p-type Ni1−xO:Li/n-Si heterojunction solar cells (P+/n HJSCs) by using radio frequency (RF) magnetron sputtering and investigates the effect of substrate temperature on photovoltaic cell properties. Grazing incidence x-ray diffraction, four point probe, and ultraviolet-visible-near infrared discover the optoelectrical properties of p-Ni1-xO thin films. The results show that p-Ni1-xO thin films deposited at 300 oC has the highest grain size (22.4 nm), average visible transmittance (~42%), and electrical resistivity (2.7 Ωcm). However, the conversion efficiency of cell is shown only 2.33% which is lower than the cell (3.39%) fabricated at room temperature. This result can be mainly attributed to interfacial layer thickness (SiOx) reduces from 2.35 nm to 1.70 nm, as verified by high-resolution transmission electron microscopy.
Abstract: In this study, a three-dimensional haptotaxis model to simulate the migration of a population of cancer cells has been proposed. The invasion of cancer cells is related with the hapto-attractant and the effect of the interface energies between the cells and the ECM. The diffuse interface model, which incorporates the haptotaxis mechanism and interface energies, is employed. The semi-implicit Fourier spectral scheme is adopted for efficient evaluation of the simulation. The simulation results thoroughly reveal the dynamics of cancer-cell migration.
Abstract: In this paper, we propose the low-MAC FEC controller for practical implementation of JPEG2000 image transmission using IEEE 802.15.4. The proposed low-MAC FEC controller has very small HW size and spends little computation to estimate channel state. Because of this advantage, it is acceptable to apply IEEE 802.15.4 which has to operate more than 1 year with battery. For the image transmission, we integrate the low-MAC FEC controller and RCPC coder in sensor node of LR-WPAN. The modified sensor node has increase of 3% hardware size than conventional zigbee sensor node.
Abstract: Technology assessment is a vital part of decision process in manufacturing, particularly for decisions on selection of new sustainable manufacturing processes. To assess these processes, a matrix approach is introduced and sustainability assessment models are developed. Case studies show that the matrix-based approach provides a flexible and practical way for sustainability evaluation of new manufacturing technologies such as those used in surface coating. The technology assessment of coating processes reveals that compared with powder coating, the sol-gel coating can deliver better technical, economical and environmental sustainability with respect to the selected sustainability evaluation criteria for a decorative coating application of car wheels.
Abstract: This paper proposes a novel spectrum sensing technique
for the digital video broadcasting-terrestrial (DVB-T) systems, which
utilizes the periodicity of pilot signals in the orthogonal frequency
division multiplexing (OFDM) symbols. The proposed scheme can
overcome the effect of the timing synchronization error by recorrelating
the correlation values in the same sample distances. The
numerical results demonstrate that the detection probability performance
of the proposed scheme outperforms that of the conventional
scheme when there exists a timing synchronization error.
Abstract: In this paper, a simple microfluidic device for monitoring algal cell behavior is proposed. An array of algal microwells is fabricated by PDMS soft-lithography using X-ray LIGA mold, placed on a glass substrate. Two layers of replicated PDMS and substrate are attached by oxygen plasma bonding, creating a microchannel for the microfluidic system. Algal cell are loaded into the microfluidic device, which provides positive charge on the bottom surface of wells. Algal cells, which are negative charged, can be attracted to the bottom of the wells via electrostatic interaction. By varying the concentration of algal cells in the loading suspension, it is possible to obtain wells with a single cell. Liquid medium for cells monitoring are flown continuously over the wells, providing nutrient and waste exchange between the well and the main flow. This device could lead to the uncovering of the quantitative biology of the algae, which is a key to effective and extensive algal utilizations in the field of biotechnology, food industry and bioenergy research and developments.
Abstract: Cooperative visual modeling is more and more
necessary in our complicated world. A collaborative environment
which supports interactive operation and communication is required
to increase work efficiency. We present a collaborative visual
modeling framework which collaborative platform could be built on.
On this platform, cooperation and communication is available for
designers from different regions. This framework, which is different
from other collaborative frameworks, contains a uniform message
format, a message handling mechanism and other functions such as
message pretreatment and Role-Communication-Token Access
Control (RCTAC). We also show our implementation of this
framework called Orchestra Designer, which support BPLE
workflow modeling cooperatively online.
Abstract: The paper researched and presented a virtual simulation system based on a full-digital lunar terrain, integrated with kinematics and dynamics module as well as autonomous navigation simulation module. The system simulation models are established. Enabling technologies such as digital lunar surface module, kinematics and dynamics simulation, Autonomous navigation are investigated. A prototype system for lunar rover locomotion simulation is developed based on these technologies. Autonomous navigation is a key echnology in lunar rover system, but rarely involved in virtual simulation system. An autonomous navigation simulation module have been integrated in this prototype system, which was proved by the simulation results that the synthetic simulation and visualizing analysis system are established in the system, and the system can provide efficient support for research on the autonomous navigation of lunar rover.
Abstract: The spectral action balance equation is an equation that
used to simulate short-crested wind-generated waves in shallow water
areas such as coastal regions and inland waters. This equation consists
of two spatial dimensions, wave direction, and wave frequency which
can be solved by finite difference method. When this equation with
dominating convection term are discretized using central differences,
stability problems occur when the grid spacing is chosen too coarse.
In this paper, we introduce the splitting upwind schemes for avoiding
stability problems and prove that it is consistent to the upwind scheme
with same accuracy. The splitting upwind schemes was adopted
to split the wave spectral action balance equation into four onedimensional
problems, which for each small problem obtains the
independently tridiagonal linear systems. For each smaller system
can be solved by direct or iterative methods at the same time which
is very fast when performed by a multi-processor computer.
Abstract: It-s difficult for China-s current land transfer
institutions limited to county-wide to solve the contradiction between
urban-rural development and construction land shortage. On the basis of analyzing China-s construction land transfer system, and evaluation
toward Transfer of development rights (TDR) practices in Anhui and
Chongqing, the passage proposes: (1) we should establish a multi-level
land indicators trade market under the guidance of regional spatial
objectives, and allow land transfer paid across cities and counties
within a specific area following the regulation of both government and
market; (2) it would be better to combine organically the policy ntentions of land plan, regional plan, urban plan and economic plan, and link them with land indicators transfer to promote a wider range of
urban-rural balance and regional coordination.
Abstract: In this paper, we propose disease diagnosis hardware
architecture by using Hypernetworks technique. It can be used to
diagnose 3 different diseases (SPECT Heart, Leukemia, Prostate
cancer). Generally, the disparate diseases require specified diagnosis
hardware model for each disease. Using similarities of three diseases
diagnosis processor, we design diagnosis processor that can diagnose
three different diseases. Our proposed architecture that is combining
three processors to one processor can reduce hardware size without
decrease of the accuracy.
Abstract: Both the minimum energy consumption and
smoothness, which is quantified as a function of jerk, are generally
needed in many dynamic systems such as the automobile and the
pick-and-place robot manipulator that handles fragile equipments.
Nevertheless, many researchers come up with either solely
concerning on the minimum energy consumption or minimum jerk
trajectory. This research paper proposes a simple yet very interesting
relationship between the minimum direct and indirect jerks
approaches in designing the time-dependent system yielding an
alternative optimal solution. Extremal solutions for the cost functions
of direct and indirect jerks are found using the dynamic optimization
methods together with the numerical approximation. This is to allow
us to simulate and compare visually and statistically the time history
of control inputs employed by minimum direct and indirect jerk
designs. By considering minimum indirect jerk problem, the
numerical solution becomes much easier and yields to the similar
results as minimum direct jerk problem.
Abstract: Recently, the RFID (Radio Frequency
Identification) technology attracts the world market attention as
essential technology for ubiquitous environment. The RFID
market has focused on transponders and reader development.
But that concern has shifted to RFID software like as
high-valued e-business applications, RFID middleware and
related development tools. However, due to the high sensitivity
of data and service transaction within the RFID network,
security consideration must be addressed. In order to guarantee
trusted e-business based on RFID technology, we propose a
security enhanced RFID middleware system. Our proposal is
compliant with EPCglobal ALE (Application Level Events),
which is standard interface for middleware and its clients. We
show how to provide strengthened security and trust by
protecting transported data between middleware and its client,
and stored data in middleware. Moreover, we achieve the
identification and service access control against illegal service
abuse. Our system enables secure RFID middleware service
and trusted e-business service.
Abstract: In this paper, we have proposed a novel FinFET with
extended body under the poly gate, which is called EB-FinFET, and
its characteristic is demonstrated by using three-dimensional (3-D)
numerical simulation. We have analyzed and compared it with
conventional FinFET. The extended body height dependence on the
drain induced barrier lowering (DIBL) and subthreshold swing (S.S)
have been also investigated. According to the 3-D numerical
simulation, the proposed structure has a firm structure, an acceptable
short channel effect (SCE), a reduced series resistance, an increased
on state drain current (I
on) and a large normalized I
DS. Furthermore,
the structure can also improve corner effect and reduce self-heating
effect due to the extended body. Our results show that the EBFinFET
is excellent for nanoscale device.
Abstract: Titanium oxide films with different morphologies have for the first time been fabricated through hydrothermal reactions between a titanium substrate and iodine powder in water or ethanol. SEM revealed that iodine supported titanium (Ti-I2) surface shows different morphologies with variable treatment conditions. The mean surface roughness (Ra) was increased in the different groups. Use of surfactant has a role to increase the roughness of the film. The surface roughness was in the range of 0.15 μm-0.42 μm. Furthermore, the electrochemical examinations showed that the Ti-I2 surface fabricated in alcoholic medium has high corrosion resistance than in aqueous medium.
Abstract: We fabricated the inverted-staggered etch stopper
structure oxide-based TFT and investigated the characteristics of oxide
TFT under the 400 nm wavelength light illumination. When 400 nm
light was illuminated, the threshold voltage (Vth) decreased and
subthreshold slope (SS) increased at forward sweep, while Vth and SS
were not altered when larger wavelength lights, such as 650 nm, 550
nm and 450 nm, were illuminated. At reverse sweep, the transfer curve
barely changed even under 400 nm light. Our experimental results
support that photo-induced hole carriers are captured by donor-like
interface trap and it caused the decrease of Vth and increase of SS. We
investigated the interface trap density increases proportionally to the
photo-induced hole concentration at active layer.
Abstract: The influences of pulsed electric fields on early
physiological development in Arabidopsis thaliana were studied.
Inside a 4-mm electroporation cuvette, pre-germination seeds were
subjected to high-intensity, nanosecond electrical pulses generated
using laboratory-assembled pulsed electric field system. The field
strength was varied from 5 to 20 kV.cm-1 and the pulse width and the
pulse number were maintained at 10 ns and 100, respectively,
corresponding to the specific treatment energy from 300 J.kg-1 to 4.5
kJ.kg-1. Statistical analyses on the average leaf area 5 and 15 days
following pulsed electric field treatment showed that the effects
appear significant the second week after treatments with a maximum
increase of 80% compared to the control (P < 0.01).