Abstract: In this paper, a novel multipurpose audio watermarking
algorithm is proposed based on Vector Quantization (VQ) in Discrete
Cosine Transform (DCT) domain using the codeword labeling and
index-bit constrained method. By using this algorithm, it can fulfill the
requirements of both the copyright protection and content integrity
authentication at the same time for the multimedia artworks. The
robust watermark is embedded in the middle frequency coefficients of
the DCT transform during the labeled codeword vector quantization
procedure. The fragile watermark is embedded into the indices of the
high frequency coefficients of the DCT transform by using the
constrained index vector quantization method for the purpose of
integrity authentication of the original audio signals. Both the robust
and the fragile watermarks can be extracted without the original audio
signals, and the simulation results show that our algorithm is effective
with regard to the transparency, robustness and the authentication
requirements
Abstract: This main purpose of the study reported here was to
investigate the extent to which the form of school
governance (particularly decision-making) had an impact upon the
effectiveness of the school with reference to parental involvement,
planning and budgeting, professional development of teachers,
school facilities and resources, and student outcomes. Particular
attention was given to decision-making within the governance
arrangements. The study was based on four case studies of high
schools in New South Wales, Australia including one government
school, one independent Christian community school, one
independent Catholic school, and one Catholic systemic school.
The focus of the research was principals, teachers, parents, and
students of four schools with varying governance structures. To
gain a greater insight into the issues, the researchers collected
information by questionnaire, semi-structured interview, and
review of school key documents. This study found that it was not
so much structure but the centrality of the school Principal and the
way that the Principal perceived his/her roles in relation to others
that impacted most on school governance.
Abstract: to simulate the phenomenon of electronic transport in semiconductors, we try to adapt a numerical method, often and most frequently it’s that of Monte Carlo. In our work, we applied this method in the case of a ternary alloy semiconductor GaInP in its cubic form; The Calculations are made using a non-parabolic effective-mass energy band model. We consider a band of conduction to three valleys (ΓLX), major of the scattering mechanisms are taken into account in this modeling, as the interactions with the acoustic phonons (elastic collisions) and optics (inelastic collisions). The polar optical phonons cause anisotropic collisions, intra-valleys, very probable in the III-V semiconductors. Other optical phonons, no polar, allow transitions inter-valleys. Initially, we present the full results obtained by the simulation of Monte Carlo in GaInP in stationary regime. We consider thereafter the effects related to the application of an electric field varying according to time, we thus study the transient phenomenon which make their appearance in ternary material
Abstract: Higher capacities of power plants together with
increased awareness on environmental considerations have led to
taller height of stacks. It is seen that strong wind can result in falling
of stacks. So, aerodynamic consideration of stacks is very important
in order to save the falling of stacks. One stack is not enough in
industries and power sectors and two or three stacks are required for
proper operation of the unit. It is very important to arrange the stacks
in proper way to resist their downfall. The present experimental
study concentrates on the mutual effect of three nearby stacks on
each other at three different arrangements, viz. linear, side-by-side
and triangular. The experiments find out the directions of resultant
forces acting on the stacks in different configurations so that proper
arrangement of supports can be made with respect to the wind
directionality obtained from local meteorological data. One can also
easily ascertain which stack is more vulnerable to wind in
comparison to the others for a particular configuration. Thus, this
study is important in studying the effect of wind force on three stacks
in different arrangements and is very helpful in placing the supports
in proper places in order to avoid failing of stack-like structures due
to wind.
Abstract: The aim of this paper is to confirm the effect of key
design parameters, the punch radius and punch angle, on rupture of the
expansion tube using a finite element analysis with a ductile damage
model. The results of the finite element analysis indicated that the
expansion ratio of the tube was mainly affected by the radius of the
punch. However, the rupture was more affected by the punch angle
than the radius of the punch. The existence of a specific punch angle,
at which rupture did not occur, even if the radius of the punch was
increased, was found.
Abstract: In our modern society electricity is vital to our health,
safety, comfort and well-being. While our daily use of electricity is
often taken for granted, public concern has arisen about potential
adverse health effects from electric and magnetic – electromagnetic –
fields (EMFs) produced by our use of electricity.
This paper aims to compare between the measured magnetic field
values and the simulated models for the indoor medium to low
voltage (MV/LV) distribution substations.
To calculate the magnetic flux density in the substations,
interactive software SUBCALC is used which is based on closed
form solution of the Biot-Savart law with 3D conductor model.
The comparison between the measured values and the simulated
models was acceptable. However there were some discrepancies, as
expected, may be due to the current variation during measurements.
Abstract: The use of synthetic retardants in polymeric insulated
cables is not uncommon in the high voltage engineering to study
electrical treeing phenomenon. However few studies on organic
materials for the same investigation have been carried. .This paper
describes the study on the effects of Oil Palm Empty Fruit Bunch
(OPEFB) microfiller on the tree initiation and propagation in silicone
rubber with different weight percentages (wt %) of filler to insulation
bulk material. The weight percentages used were 0 wt % and 1 wt %
respectively. It was found that the OPEFB retards the propagation of
the electrical treeing development. For tree inception study, the
addition of 1(wt %) OPEFB has increase the tree inception voltage of
silicone rubber. So, OPEFB is a potential retardant to the initiation
and growth of electrical treeing occurring in polymeric materials for
high voltage application. However more studies on the effects of
physical and electrical properties of OPEFB as a tree retardant
material are required.
Abstract: The ability of pomelo peel, a natural biosorbent, to remove Cd(II) ions from aqueous solution by biosorption was investigated. The experiments were carried out by batch method at 25 °C. The influence of solution pH, initial cadmium ion concentrations and contact times were evaluated. Cadmium ion removal increased significantly as the pH of the solution increased from pH 1 to pH 5. At pH 5, the cadmium ion removal reached a maximum value. The equilibrium process was described well by the Langmuir isotherm model, with a maximum biosorption capacity of 21.83 mg/g. The biosorption was relatively quick, (approx. 20 min). Biosorption kinetics followed a pseudo-second-order model. The result showed that pomelo peel was effective as a biosorbent for removing cadmium ions from aqueous solution. It is a low cost material that shows potential to be applied in wastewater technology for remediation of heavy metal contamination.
Abstract: In contrast to existing methods which do not take into account multiconnectivity in a broad sense of this term, we develop mathematical models and highly effective combination (BIEM and FDM) numerical methods of calculation of stationary and quasistationary temperature field of a profile part of a blade with convective cooling (from the point of view of realization on PC). The theoretical substantiation of these methods is proved by appropriate theorems. For it, converging quadrature processes have been developed and the estimations of errors in the terms of A.Ziqmound continuity modules have been received. For visualization of profiles are used: the method of the least squares with automatic conjecture, device spline, smooth replenishment and neural nets. Boundary conditions of heat exchange are determined from the solution of the corresponding integral equations and empirical relationships. The reliability of designed methods is proved by calculation and experimental investigations heat and hydraulic characteristics of the gas turbine first stage nozzle blade.
Abstract: The tensile properties of Mg-3%Al nanocrystalline
alloys were investigated at different test environment. Bulk
nanocrystalline samples of these alloy was successfully prepared by
mechanical alloying (MA) followed by cold compaction, sintering,
and hot extrusion process. The crystal size of the consolidated milled
sample was calculated by X-Ray line profile analysis. The
deformation mechanism and microstructural characteristic at
different test condition was discussed extensively. At room
temperature, relatively lower value of activation volume (AV) and
higher value of strain rate sensitivity (SRS) suggests that new rate
controlling mechanism accommodating plastic flow in the present
nanocrystalline sample. The deformation behavior and the
microstructural character of the present samples were discussed in
details.
Abstract: In this paper, the optical generation of three bands of
continuously tunable millimeter-wave signals using an optical phase
modulator (OPM) and a polarization state rotation filter (PSRF) as an
optical notch filter is analyzed. The effect of the chromatic dispersion
on millimeter-wave signals is presented.
Abstract: Combined therapy using Interferon and Ribavirin is the standard treatment in patients with chronic hepatitis C. However, the number of responders to this treatment is low, whereas its cost and side effects are high. Therefore, there is a clear need to predict patient’s response to the treatment based on clinical information to protect the patients from the bad drawbacks, Intolerable side effects and waste of money. Different machine learning techniques have been developed to fulfill this purpose. From these techniques are Associative Classification (AC) and Decision Tree (DT). The aim of this research is to compare the performance of these two techniques in the prediction of virological response to the standard treatment of HCV from clinical information. 200 patients treated with Interferon and Ribavirin; were analyzed using AC and DT. 150 cases had been used to train the classifiers and 50 cases had been used to test the classifiers. The experiment results showed that the two techniques had given acceptable results however the best accuracy for the AC reached 92% whereas for DT reached 80%.
Abstract: In view of growing competition in the service sector,
services are as much in need of modeling, analysis and improvement
as business or working processes. Graphical process models are
important means to capture process-related know-how for an
effective management of the service process. In this contribution, a
human performance analysis of process model development paying
special attention to model development time and the working method
was conducted. It was found that modelers with higher application
experience need significantly less time for mental activities than
modelers with lower application experience, spend more time on
labeling graphical elements, and achieved higher process model
quality in terms of activity label quality.
Abstract: This study was conducted to examine the effects of ketum extract on development of Chrysomya rufifacies and to analyze the presence of mitragynine in the larvae samples. 110 newly emerged first instar larvae of C. rufifacies were introduced on ketum extract-mixed cow liver at doses of 0, 20, 40 and 60g. Blowfly development rate was determined with 12 hour intervals and
mitragynine in larvae was extracted and quantitated. C. rufifacies in control group took about 192 hours to complete their development from first instar larvae to adult blowfly; meanwhile blowfly form from the highest dose of ketum was 264 hours. Mitragynine was detected in all groups of treatment, except for control. In conclusion, the presence of mitragynine in C. rufifacies is affected in delaying development rates of the blowfly for up to 62 hours or 3 days. Chemical analysis of mitragynine from larvae samples showed that this alkaloid present in all specimens analyzed.
Abstract: This paper presents a solution for a robotic
manipulation problem. We formulate the problem as combining
target identification, tracking and interception. The task in our
solution is sensing a target on a conveyor belt and then intercepting
robot-s end-effector at a convenient rendezvous point. We used
an object recognition method which identifies the target and finds
its position from visualized scene picture, then the robot system
generates a solution for rendezvous problem using the target-s initial
position and belt velocity . The interception of the target and the
end-effector is executed at a convenient rendezvous point along the
target-s calculated trajectory. Experimental results are obtained using
a real platform with an industrial robot and a vision system over it.
Abstract: This study investigates the investors- behavioral
reaction to the investment rating change announcements from the
views of behavioral finance. The empirical results indicate that
self-interest does affect the intention of securities firms to release
investment ratings for individual stocks. In addition, behavioral
pitfalls are also found in the response of retail investors to investment
rating change announcements.
Abstract: A novel feature selection strategy to improve the recognition accuracy on the faces that are affected due to nonuniform illumination, partial occlusions and varying expressions is proposed in this paper. This technique is applicable especially in scenarios where the possibility of obtaining a reliable intra-class probability distribution is minimal due to fewer numbers of training samples. Phase congruency features in an image are defined as the points where the Fourier components of that image are maximally inphase. These features are invariant to brightness and contrast of the image under consideration. This property allows to achieve the goal of lighting invariant face recognition. Phase congruency maps of the training samples are generated and a novel modular feature selection strategy is implemented. Smaller sub regions from a predefined neighborhood within the phase congruency images of the training samples are merged to obtain a large set of features. These features are arranged in the order of increasing distance between the sub regions involved in merging. The assumption behind the proposed implementation of the region merging and arrangement strategy is that, local dependencies among the pixels are more important than global dependencies. The obtained feature sets are then arranged in the decreasing order of discriminating capability using a criterion function, which is the ratio of the between class variance to the within class variance of the sample set, in the PCA domain. The results indicate high improvement in the classification performance compared to baseline algorithms.
Abstract: In Blind Source Separation (BSS) processing, taking
advantage of scaling factor indetermination and based on the floatingpoint
representation, we propose a scaling technique applied to the
separation matrix, to avoid the saturation or the weakness in the
recovered source signals. This technique performs an Automatic Gain
Control (AGC) in an on-line BSS environment. We demonstrate
the effectiveness of this technique by using the implementation of
a division free BSS algorithm with two input, two output. This
technique is computationally cheaper and efficient for a hardware
implementation.
Abstract: There has been considerable growth in the issue of
food & beverage safety in Thailand. This is important because the
level of satisfaction in food & beverage safety has impacts on travel
decision made by foreign tourists. Therefore, this paper was aimed to
test if there is any significant gender effect in the level of satisfaction
of food & beverage safety made by foreign tourists in Thailand. In
addition, this paper utilized the Chi Square test of independent to test
if there was an association between gender and sickness because of
food and if there was an association between gender and the
perception of food safety standard. During January to June, 2012, a
total of 400 foreign tourist respondents, 200 male as well as 200
female foreign tourists, were interviewed at the departure lounge at
Suvarnabhumi airport, Thailand. The findings revealed the
astonishing result that there was no significant effect of gender. Also,
there was no significant difference in the association between gender
and being sick because of food as well as the association between
gender and the perception on the standard of food safety during their
trip in Thailand.
Abstract: Our goal is to effectively increase the number of boats in the river during a six month period. The main factors of determining the number of boats are duration and “select the priority trip". In the microcosmic simulation model, the best result is 4 to 24 nights with DSCF, and the number of boats is 812 with an increasing ratio of 9.0% related to the second best result. However, the number of boats is related to 31.6% less than the best one in 6 to 18 nights with FCFS. In the discrete duration model, we get from 6 to 18 nights, the numbers of boats have increased to 848 with an increase ratio of 29.7% than the best result in model I for the same time range. Moreover, from 4 to 24 nights, the numbers of boats have increase to 1194 with an increase ratio of 47.0% than the best result in model I for the same time range.