Abstract: We present a dextran modified silicon microring
resonator sensor for high density antibody immobilization. An array
of sensors consisting of three sensor rings and a reference ring was
fabricated and its surface sensitivity and the limit of detection were
obtained using polyelectrolyte multilayers. The mass sensitivity and
the limit of detection of the fabricated sensor ring are 0.35 nm/ng
mm-2 and 42.8 pg/mm2 in air, respectively. Dextran modified sensor
surface was successfully prepared by covalent grafting of oxidized
dextran on 3-aminopropyltriethoxysilane (APTES) modified silicon
sensor surface. The antibody immobilization on hydrogel dextran
matrix improves 40% compared to traditional antibody
immobilization method via APTES and glutaraldehyde linkage.
Abstract: This paper presents a vocoder to obtain high quality synthetic speech at 600 bps. To reduce the bit rate, the algorithm is based on a sinusoidally excited linear prediction model which extracts few coding parameters, and three consecutive frames are grouped into a superframe and jointly vector quantization is used to obtain high coding efficiency. The inter-frame redundancy is exploited with distinct quantization schemes for different unvoiced/voiced frame combinations in the superframe. Experimental results show that the quality of the proposed coder is better than that of 2.4kbps LPC10e and achieves approximately the same as that of 2.4kbps MELP and with high robustness.
Abstract: Clustering techniques have been used by many intelligent software agents to group similar access patterns of the Web users into high level themes which express users intentions and interests. However, such techniques have been mostly focusing on one salient feature of the Web document visited by the user, namely the extracted keywords. The major aim of these techniques is to come up with an optimal threshold for the number of keywords needed to produce more focused themes. In this paper we focus on both keyword and similarity thresholds to generate themes with concentrated themes, and hence build a more sound model of the user behavior. The purpose of this paper is two fold: use distance based clustering methods to recognize overall themes from the Proxy log file, and suggest an efficient cut off levels for the keyword and similarity thresholds which tend to produce more optimal clusters with better focus and efficient size.
Abstract: This work proposes an accurate crosstalk noise estimation method in the presence of multiple RLC lines for the use in design automation tools. This method correctly models the loading effects of non switching aggressors and aggressor tree branches using resistive shielding effect and realistic exponential input waveforms. Noise peak and width expressions have been derived. The results obtained are at good agreement with SPICE results. Results show that average error for noise peak is 4.7% and for the width is 6.15% while allowing a very fast analysis.
Abstract: In this paper flow around two cam shaped cylinders had been studied numerically. The equivalent diameter of cylinders is 27.6 mm. The space between center to center of two cam shaped cylinders is define as longitudinal pitch ratio and it varies in range of
2 varies in range of 50
Abstract: With constraints on data availability and for study of power system stability it is adequate to model the synchronous generator with field circuit and one equivalent damper on q-axis known as the model 1.1. This paper presents a systematic procedure for modelling and simulation of a single-machine infinite-bus power system installed with a thyristor controlled series compensator (TCSC) where the synchronous generator is represented by model 1.1, so that impact of TCSC on power system stability can be more reasonably evaluated. The model of the example power system is developed using MATLAB/SIMULINK which can be can be used for teaching the power system stability phenomena, and also for research works especially to develop generator controllers using advanced technologies. Further, the parameters of the TCSC controller are optimized using genetic algorithm. The non-linear simulation results are presented to validate the effectiveness of the proposed approach.
Abstract: This paper presents the identification of the impact
force acting on a simply supported beam. The force identification is
an inverse problem in which the measured response of the structure is
used to determine the applied force. The identification problem is
formulated as an optimization problem and the genetic algorithm is
utilized to solve the optimization problem. The objective function is
calculated on the difference between analytical and measured
responses and the decision variables are the location and magnitude
of the applied force. The results from simulation show the
effectiveness of the approach and its robustness vs. the measurement
noise and sensor location.
Abstract: Despite the extensive use of eLearning systems, there
is no consensus on a standard framework for evaluating this kind of
quality system. Hence, there is only a minimum set of tools that can
supervise this judgment and gives information about the course
content value. This paper presents two kinds of quality set evaluation
indicators for eLearning courses based on the computational process
of three known metrics, the Euclidian, Hamming and Levenshtein
distances. The “distance" calculus is applied to standard evaluation
templates (i.e. the European Commission Programme procedures vs.
the AFNOR Z 76-001 Standard), determining a reference point in the
evaluation of the e-learning course quality vs. the optimal concept(s).
The case study, based on the results of project(s) developed in the
framework of the European Programme “Leonardo da Vinci", with
Romanian contractors, try to put into evidence the benefits of such a
method.
Abstract: A straightforward and intuitive combination of single simulations into an aggregated master-simulation is not trivial. There are lots of problems, which trigger-specific difficulties during the modeling and execution of such a simulation. In this paper we identify these problems and aim to solve them by mapping the task to the field of multi agent systems. The solution is a new meta-model named AGENTMAP, which is able to mitigate most of the problems and to support intuitive modeling at the same time. This meta-model will be introduced and explained on basis of an example from the e-commerce domain.
Abstract: Existing work in temporal logic on representing the
execution of infinitely many transactions, uses linear-time temporal
logic (LTL) and only models two-step transactions. In this paper,
we use the comparatively efficient branching-time computational tree
logic CTL and extend the transaction model to a class of multistep
transactions, by introducing distinguished propositional variables
to represent the read and write steps of n multi-step transactions
accessing m data items infinitely many times. We prove that the
well known correspondence between acyclicity of conflict graphs
and serializability for finite schedules, extends to infinite schedules.
Furthermore, in the case of transactions accessing the same set of
data items in (possibly) different orders, serializability corresponds
to the absence of cycles of length two. This result is used to give an
efficient encoding of the serializability condition into CTL.
Abstract: In this paper, we consider the global exponential stability of the equilibrium point of Hopfield neural networks with delays and impulsive perturbation. Some new exponential stability criteria of the system are derived by using the Lyapunov functional method and the linear matrix inequality approach for estimating the upper bound of the derivative of Lyapunov functional. Finally, we illustrate two numerical examples showing the effectiveness of our theoretical results.
Abstract: The objective of this paper is to present a research
study of the convectors that are used for heating or cooling of the
living room or industrial halls. The key points are experimental
measurement and comprehensive numerical simulation of the flow
coming throughout the part of the convector such as heat exchanger,
input from the fan etc.. From the obtained results, the components of
the convector are optimized in sense to increase thermal power
efficiency due to improvement of heat convection or reduction of air
drag friction. Both optimized aspects are leading to the more
effective service conditions and to energy saving. The significant part
of the convector research is a design of the unique measurement
laboratory and adopting measure techniques. The new laboratory
provides possibility to measure thermal power efficiency and other
relevant parameters under specific service conditions of the
convectors.
Abstract: WLAN Positioning has been presented by many
approaches in literatures using the characteristics of Received Signal
Strength (RSS), Time of Arrival (TOA) or Time Difference of
Arrival (TDOA), Angle of Arrival (AOA) and cell ID. Among these,
RSS approach is the simplest method to implement because there is
no need of modification on both access points and client devices
whereas its accuracy is terrible due to physical environments. For
TOA or TDOA approach, the accuracy is quite acceptable but most
researches have to modify either software or hardware on existing
WLAN infrastructure. The scales of modifications are made on only
access card up to the changes in protocol of WLAN. Hence, it is an
unattractive approach to use TOA or TDOA for positioning system.
In this paper, the new concept of merging both RSS and TOA
positioning techniques is proposed. In addition, the method to
achieve TOA characteristic for positioning WLAN user without any
extra modification necessarily appended in the existing system is
presented. The measurement results confirm that the proposed
technique using both RSS and TOA characteristics provides better
accuracy than using only either RSS or TOA approach.
Abstract: Collateralized Debt Obligations are not as widely used
nowadays as they were before 2007 Subprime crisis. Nonetheless
there remains an enthralling challenge to optimize cash flows
associated with synthetic CDOs. A Gaussian-based model is used
here in which default correlation and unconditional probabilities of
default are highlighted. Then numerous simulations are performed
based on this model for different scenarios in order to evaluate the
associated cash flows given a specific number of defaults at different
periods of time. Cash flows are not solely calculated on a single
bought or sold tranche but rather on a combination of bought and
sold tranches. With some assumptions, the simplex algorithm gives
a way to find the maximum cash flow according to correlation of
defaults and maturities. The used Gaussian model is not realistic in
crisis situations. Besides present system does not handle buying or
selling a portion of a tranche but only the whole tranche. However the
work provides the investor with relevant elements on how to know
what and when to buy and sell.
Abstract: Semiconductor detector arrays are widely used in
high-temperature plasma diagnostics. They have a fast response,
which allows observation of many processes and instabilities in
tokamaks. In this paper, there are reviewed several diagnostics based
on semiconductor arrays as cameras, AXUV photodiodes (referred
often as fast “bolometers") and detectors of both soft X-rays and
visible light installed on the COMPASS tokamak recently. Fresh
results from both spring and summer campaigns in 2012 are
introduced. Examples of the utilization of the detectors are shown on
the plasma shape determination, fast calculation of the radiation
center, two-dimensional plasma radiation tomography in different
spectral ranges, observation of impurity inflow, and also on
investigation of MHD activity in the COMPASS tokamak discharges.
Abstract: Thailand-s health system is challenged by the rising
number of patients and decreasing ratio of medical
practitioners/patients, especially in rural areas. This may tempt
inexperienced GPs to rush through the process of anamnesis with the
risk of incorrect diagnosis. Patients have to travel far to the hospital
and wait for a long time presenting their case. Many patients try to
cure themselves with traditional Thai medicine. Many countries are
making use of the Internet for medical information gathering,
distribution and storage. Telemedicine applications are a relatively
new field of study in Thailand; the infrastructure of ICT had
hampered widespread use of the Internet for using medical
information. With recent improvements made health and technology
professionals can work out novel applications and systems to help
advance telemedicine for the benefit of the people. Here we explore
the use of telemedicine for people with health problems in rural areas
in Thailand and present a Telemedicine Diagnosis System for Rural
Thailand (TEDIST) for diagnosing certain conditions that people
with Internet access can use to establish contact with Community
Health Centers, e.g. by mobile phone. The system uses a Web-based
input method for individual patients- symptoms, which are taken by
an expert system for the analysis of conditions and appropriate
diseases. The analysis harnesses a knowledge base and a backward
chaining component to find out, which health professionals should be
presented with the case. Doctors have the opportunity to exchange
emails or chat with the patients they are responsible for or other
specialists. Patients- data are then stored in a Personal Health Record.
Abstract: CDMA cellular networks support soft handover,
which guarantees the continuity of wireless services and enhanced
communication quality. Cellular networks support multimedia
services under varied propagation environmental conditions. In this
paper, we have shown the effect of characteristic parameters of the
cellular environments on the soft handover performance. We
consider path loss exponent, standard deviation of shadow fading and
correlation coefficient of shadow fading as the characteristic
parameters of the radio propagation environment. A very useful
statistical measure for characterizing the performance of mobile radio
system is the probability of outage. It is shown through numerical
results that above parameters have decisive effect on the probability
of outage and hence the overall performance of the soft handover
algorithm.
Abstract: E-learning refers to the specific kind of learning
experienced within the domain of educational technology, which can
be used in or out of the classroom. In this paper, we give an
overview of an e-learning platform 'An Innovative Interactive and
Online English Platform for Upper Primary Students' is an
interactive web-based application which will serve as an aid to the
primary school students in Mauritius. The objectives of this platform
are to offer quality learning resources for the English subject at our
primary level of education, encourage self-learning and hence
promote e-learning. The platform developed consists of several
interesting features, for example, the English Verb Conjugation tool,
Negative Form tool, Interrogative Form tool and Close Test
Generator. Thus, this learning platform will be useful at a time
where our country is looking for an alternative to private tuition and
also, looking forward to increase the pass rate.
Abstract: In the present paper, an improved initial value
numerical technique is presented to analyze the free vibration of
symmetrically laminated rectangular plate. A combination of the
initial value method (IV) and the finite differences (FD) devices is
utilized to develop the present (IVFD) technique. The achieved
technique is applied to the equation of motion of vibrating laminated
rectangular plate under various types of boundary conditions. Three
common types of laminated symmetrically cross-ply, orthotropic and
isotropic plates are analyzed here. The convergence and accuracy of
the presented Initial Value-Finite Differences (IVFD) technique have
been examined. Also, the merits and validity of improved technique
are satisfied via comparing the obtained results with those available
in literature indicating good agreements.
Abstract: In recent years asymmetric cross section aluminum
alloy stock has been finding increasing use in various industrial manufacturing areas such as general structures and automotive
components. In these areas, components are generally required to have
complex curved configuration and, as such, a bending process is required during manufacture. Undesirable deformation in bending
processes such as flattening or wrinkling can easily occur when thin-walled sections are bent. Hence, a thorough understanding of the
bending behavior of such sections is needed to prevent these undesirable deformations. In this study, the bending behavior of
asymmetric channel section was examined using finite element analysis (FEA). Typical methods of preventing undesirable
deformation, such as asymmetric laminated elastic mandrels were included in FEA model of draw bending. Additionally, axial tension
was applied to prevent wrinkling. By utilizing the FE simulations effect of restriction dies and axial tension on undesirable deformation during the process was clarified.