Abstract: In this paper, we address the problem of reducing the
switching activity (SA) in on-chip buses through the use of a bus
binding technique in high-level synthesis. While many binding
techniques to reduce the SA exist, we present yet another technique for
further reducing the switching activity. Our proposed method
combines bus binding and data sequence reordering to explore a wider
solution space. The problem is formulated as a multiple traveling
salesman problem and solved using simulated annealing technique.
The experimental results revealed that a binding solution obtained
with the proposed method reduces 5.6-27.2% (18.0% on average) and
2.6-12.7% (6.8% on average) of the switching activity when compared
with conventional binding-only and hybrid binding-encoding
methods, respectively.
Abstract: The paper presents an investigation in to the effect of neural network predictive control of UPFC on the transient stability performance of a multimachine power system. The proposed controller consists of a neural network model of the test system. This model is used to predict the future control inputs using the damped Gauss-Newton method which employs ‘backtracking’ as the line search method for step selection. The benchmark 2 area, 4 machine system that mimics the behavior of large power systems is taken as the test system for the study and is subjected to three phase short circuit faults at different locations over a wide range of operating conditions. The simulation results clearly establish the robustness of the proposed controller to the fault location, an increase in the critical clearing time for the circuit breakers, and an improved damping of the power oscillations as compared to the conventional PI controller.
Abstract: This paper presents a hybrid association control
scheme that can maintain load balancing among access points in the
wireless LANs and can satisfy the quality of service requirements of
the multimedia traffic applications. The proposed model is
mathematically described as a linear programming model. Simulation
study and analysis were conducted in order to demonstrate the
performance of the proposed hybrid load balancing and association
control scheme. Simulation results shows that the proposed scheme
outperforms the other schemes in term of the percentage of blocking
and the quality of the data transfer rate providing to the multimedia
and real-time applications.
Abstract: Decision support based upon risk analysis into
comparison of the electricity generation from different renewable
energy technologies can provide information about their effects on
the environment and society. The aim of this paper is to develop the
assessment framework regarding risks to health and environment,
and the society-s benefits of the electric power plant generation from
different renewable sources. The multicriteria framework to
multiattribute risk analysis technique and the decision analysis
interview technique are applied in order to support the decisionmaking
process for the implementing renewable energy projects to
the Bangkok case study. Having analyses the local conditions and
appropriate technologies, five renewable power plants are postulated
as options. As this work demonstrates, the analysis can provide a tool
to aid decision-makers for achieving targets related to promote
sustainable energy system.
Abstract: Developing an accurate classifier for high dimensional microarray datasets is a challenging task due to availability of small sample size. Therefore, it is important to determine a set of relevant genes that classify the data well. Traditionally, gene selection method often selects the top ranked genes according to their discriminatory power. Often these genes are correlated with each other resulting in redundancy. In this paper, we have proposed a hybrid method using feature ranking and wrapper method (Genetic Algorithm with multiclass SVM) to identify a set of relevant genes that classify the data more accurately. A new fitness function for genetic algorithm is defined that focuses on selecting the smallest set of genes that provides maximum accuracy. Experiments have been carried on four well-known datasets1. The proposed method provides better results in comparison to the results found in the literature in terms of both classification accuracy and number of genes selected.
Abstract: This paper reports our analysis of 163 ks observations
of PSR J0538+2817 with the Rossi X-Ray Timing Explorer
(RXTE).The pulse profiles, detected up to 60 keV, show a single
peak asin the case for radio frequency. The profile is well described
by one Gaussians function with full width at half maximum (FWHM)
0.04794. We compared the difference of arrival time between radio
and X-ray pulse profiles for the first time. It turns out that the phase
of radio emits precede the X-ray by 8.7 ± 4.5 ms. Furthermore we
obtained the pulse profiles in the energy ranges of 2.29-6.18 keV,
6.18-12.63 keV and 12.63-17.36 keV. The intensity of pulses
decreases with the increasing energy range. We discuss the emission
geometry in our work.
Abstract: Web-based cooperative learning focuses on (1) the interaction and the collaboration of community members, and (2) the sharing and the distribution of knowledge and expertise by network technology to enhance learning performance. Numerous research literatures related to web-based cooperative learning have demonstrated that cooperative scripts have a positive impact to specify, sequence, and assign cooperative learning activities. Besides, literatures have indicated that role-play in web-based cooperative learning environments enhances two or more students to work together toward the completion of a common goal. Since students generally do not know each other and they lack the face-to-face contact that is necessary for the negotiation of assigning group roles in web-based cooperative learning environments, this paper intends to further extend the application of genetic algorithm (GA) and propose a GA-based algorithm to tackle the problem of role assignment in web-based cooperative learning environments, which not only saves communication costs but also reduces conflict between group members in negotiating role assignments.
Abstract: An attempt in this paper proposes a re-modification to
the minimum moment approach of resource leveling which is a modified minimum moment approach to the traditional method by
Harris. The method is based on critical path method. The new approach suggests the difference between the methods in the
selection criteria of activity which needs to be shifted for leveling resource histogram. In traditional method, the improvement factor
found first to select the activity for each possible day of shifting. In
modified method maximum value of the product of Resources Rate
and Free Float was found first and improvement factor is then
calculated for that activity which needs to be shifted. In the proposed
method the activity to be selected first for shifting is based on the largest value of resource rate. The process is repeated for all the
remaining activities for possible shifting to get updated histogram.
The proposed method significantly reduces the number of iterations
and is easier for manual computations.
Abstract: By means of the idea of three-wave method, we obtain some analytic solutions for high nonlinear form of Benjamin-Bona- Mahony-Burgers (shortly BBMB) equations in its bilinear form.
Abstract: Financial forecasting is an example of signal processing problems. A number of ways to train/learn the network are available. We have used Levenberg-Marquardt algorithm for error back-propagation for weight adjustment. Pre-processing of data has reduced much of the variation at large scale to small scale, reducing the variation of training data.
Abstract: Water vapour transport properties of gypsum block
are studied in dependence on relative humidity using inverse analysis
based on genetic algorithm. The computational inverse analysis is
performed for the relative humidity profiles measured along the
longitudinal axis of a rod sample. Within the performed transient
experiment, the studied sample is exposed to two environments with
different relative humidity, whereas the temperature is kept constant.
For the basic gypsum characterisation and for the assessment of input
material parameters necessary for computational application of
genetic algorithm, the basic material properties of gypsum are
measured as well as its thermal and water vapour storage parameters.
On the basis of application of genetic algorithm, the relative
humidity dependent water vapour diffusion coefficient and water
vapour diffusion resistance factor are calculated.
Abstract: In the stadium structure, the significant dynamic
responses such as resonance or similar behavior can be occurred by
spectator rhythmical activities. Thus, accurate analysis and precise
investigation of stadium structure that is subjected to dynamic loads
are required for practical design and serviceability check of stadium
structures. Moreover, it is desirable to measure and analyze the
dynamic loads of spectator activities because these dynamic loads can
not be easily expressed in numerical formula. In this study, various
dynamic loads induced by spectator movements are measured and
analyzed. These dynamic loads induced by spectators movement of
stadium structure can be classified into the impact load and the
periodic load. These dynamic loads can be expressed as Fourier
harmonic load. And, these dynamic loads could be applied for the
accurate vibration analysis of a stadium structure.
Abstract: The ARMrayan Multimedia Mobile CMS (Content
Management System) is the first mobile CMS that gives the
opportunity to users for creating multimedia J2ME mobile
applications with their desired content, design and logo; simply,
without any need for writing even a line of code. The low-level
programming and compatibility problems of the J2ME, along with
UI designing difficulties, makes it hard for most people –even
programmers- to broadcast their content to the widespread mobile
phones used by nearly all people. This system provides user-friendly,
PC-based tools for creating a tree index of pages and inserting
multiple multimedia contents (e.g. sound, video and picture) in each
page for creating a J2ME mobile application. The output is a standalone
Java mobile application that has a user interface, shows texts
and pictures and plays music and videos regardless of the type of
devices used as long as the devices support the J2ME platform.
Bitmap fonts have also been used thus Middle Eastern languages can
be easily supported on all mobile phone devices. We omitted
programming concepts for users in order to simplify multimedia
content-oriented mobile applictaion designing for use in educational,
cultural or marketing centers. Ordinary operators can now create a
variety of multimedia mobile applications such as tutorials,
catalogues, books, and guides in minutes rather than months.
Simplicity and power has been the goal of this CMS. In this paper,
we present the software engineered-designed concepts of the
ARMrayan MCMS along with the implementation challenges faces
and solutions adapted.
Abstract: The main goal of the article is to present new model of
application architecture of banking IT solution providing the Internet
Banking services that is particularly outsourced. At first, we propose
business rationale and a SWOT analysis to explain the reasons for the
model in the article. The most important factor for our model is
nowadays- big boom around smart phones and tablet devices. As
next, we focus on IT architecture viewpoint where we design
application, integration and security model. Finally, we propose a
generic governance model that serves as a basis for the specialized
governance model. The specialized instance of governance model is
designed to ensure that the development and the maintenance of
different parts of the IT solution are well governed in time.
Abstract: The objective of the research was to study of foot
anthropometry of children aged 7-12 years in the South of Thailand Thirty-three dimensions were measured on 305 male and 295 female
subjects with 3 age ranges (7-12 years old). The instrumentation consists of four types of anthropometer, digital vernier caliper, digital
height gauge and measuring tape. The mean values and standard
deviations of average age, height, and weight of the male subjects were 9.52(±1.70) years, 137.80(±11.55) cm, and 37.57(±11.65) kg.
Female average age, height, and weight subjects were 9.53(±1.70) years, 137.88(±11.55) cm, and 34.90(±11.57) kg respectively. The
comparison of the 33 comparison measured anthropometric. Between
male and female subjects were sexual differences in size on women in almost all areas of significance (p
Abstract: Three dimensional simulations are carried out to estimate the effect of wind direction, wind speed and geometry on the flow and dispersion of vehicular pollutant in a street canyon. The pollutant sources are motor vehicles passing between the two buildings. Suitable emission factors for petrol and diesel vehicles at varying vehicle speed are used for the estimation of the rate of emission from the streets. The dispersion of automobile pollutant released from the street is simulated by introducing vehicular emission source term as a fixed-flux boundary condition at the ground level over the road. The emission source term is suitably calculated by adopting emission factors from literature for varying conditions of street traffic. It is observed that increase in wind angle disturbs the symmetric pattern of pollution distribution along the street length. The concentration increases in the far end of the street as compared to the near end.
Abstract: Sharing consistent and correct master data among
disparate applications in a reverse-logistics chain has long been
recognized as an intricate problem. Although a master data
management (MDM) system can surely assume that responsibility,
applications that need to co-operate with it must comply with
proprietary query interfaces provided by the specific MDM system. In
this paper, we present a RFID-ready MDM system which makes
master data readily available for any participating applications in a
reverse-logistics chain. We propose a RFID-wrapper as a part of our
MDM. It acts as a gateway between any data retrieval request and
query interfaces that process it. With the RFID-wrapper, any
participating applications in a reverse-logistics chain can easily
retrieve master data in a way that is analogous to retrieval of any other
RFID-based logistics transactional data.
Abstract: Wind energy has been shown to be one of the most
viable sources of renewable energy. With current technology, the low
cost of wind energy is competitive with more conventional sources of
energy such as coal. Most blades available for commercial grade
wind turbines incorporate a straight span-wise profile and airfoil
shaped cross sections. These blades are found to be very efficient at
lower wind speeds in comparison to the potential energy that can be
extracted. However as the oncoming wind speed increases the
efficiency of the blades decreases as they approach a stall point. This
paper explores the possibility of increasing the efficiency of the
blades at higher wind speeds while maintaining efficiency at the
lower wind speeds. The design intends to maintain efficiency at
lower wind speeds by selecting the appropriate orientation and size
of the airfoil cross sections based on a low oncoming wind speed and
given constant rotation rate. The blades will be made more efficient
at higher wind speeds by implementing a swept blade profile.
Performance was investigated using the computational fluid
dynamics (CFD).
Abstract: This study examined the effects of neuromuscular
training (NT) on limits of stability (LOS) in female individuals.
Twenty female basketball amateurs were assigned into NT
experimental group or control group by volunteer. All the players were
underwent regular basketball practice, 90 minutes, 3 times per week
for 6 weeks, but the NT experimental group underwent extra NT with
plyometric and core training, 50 minutes, 3 times per week for 6 weeks
during this period. Limits of stability (LOS) were evaluated by the
Biodex Balance System. One factor ANCOVA was used to examine
the differences between groups after training. The significant level for
statistic was set at p
Abstract: Sound pathways in the enclosures of small earphones
are very narrow. In such narrow pathways, the speed of sound
propagation and the phase of sound waves change because of the air
viscosity. We have developed a new finite element method that
includes the effects of damping due to air viscosity for modeling the
sound pathway. This method is developed as an extension of the
existing finite element method for porous sound-absorbing materials.
The numerical calculation results using the proposed finite element
method are validated against the existing calculation methods.