Abstract: This paper presents a multi-objective formulation for
optimal siting and sizing of distributed generation (DG) resources in
distribution systems in order to minimize the cost of power losses
and energy not supplied. The implemented technique is based on
particle swarm optimization (PSO) and weight method that employed
to obtain the best compromise between these costs. Simulation
results on 33-bus distribution test system are presented to
demonstrate the effectiveness of the proposed procedure.
Abstract: Multicarrier transmission system such as Orthogonal
Frequency Division Multiplexing (OFDM) is a promising technique
for high bit rate transmission in wireless communication systems.
OFDM is a spectrally efficient modulation technique that can achieve
high speed data transmission over multipath fading channels without
the need for powerful equalization techniques. A major drawback
of OFDM is the high Peak-to-Average Power Ratio (PAPR) of the
transmit signal which can significantly impact the performance of the
power amplifier. In this paper we have compared the PAPR reduction
performance of Golay and Reed-Muller coded OFDM signal. From
our simulation it has been found that the PAPR reduction performance
of Golay coded OFDM is better than the Reed-Muller coded OFDM
signal. Moreover, for the optimum PAPR reduction performance, code
configuration for Golay and Reed-Muller codes has been identified.
Abstract: Wireless Sensor and Actor Networks (WSANs) constitute an emerging and pervasive technology that is attracting increasing interest in the research community for a wide range of applications. WSANs have two important requirements: coordination interactions and real-time communication to perform correct and timely actions. This paper introduces a methodology to facilitate the task of the application programmer focusing on the coordination and real-time requirements of WSANs. The methodology proposed in this model uses a real-time component model, UM-RTCOM, which will help us to achieve the design and implementation of applications in WSAN by using the component oriented paradigm. This will help us to develop software components which offer some very interesting features, such as reusability and adaptability which are very suitable for WSANs as they are very dynamic environments with rapidly changing conditions. In addition, a high-level coordination model based on tuple channels (TC-WSAN) is integrated into the methodology by providing a component-based specification of this model in UM-RTCOM; this will allow us to satisfy both sensor-actor and actor-actor coordination requirements in WSANs. Finally, we present in this paper the design and implementation of an application which will help us to show how the methodology can be easily used in order to achieve the development of WSANs applications.
Abstract: In today-s world, the efficient utilization of wood
resources comes more and more to the mind of forest owners. It is a
very complex challenge to ensure an efficient harvest of the wood
resources. This is one of the scopes the project “Virtual Forest II"
addresses. Its core is a database with data about forests containing
approximately 260 million trees located in North Rhine-Westphalia
(NRW). Based on this data, tree growth simulations and wood
mobilization simulations can be conducted. This paper focuses on the
latter. It describes a discrete-event-simulation with an attached 3-D
real time visualization which simulates timber harvest using trees
from the database with different crop resources. This simulation can
be displayed in 3-D to show the progress of the wood crop. All the
data gathered during the simulation is presented as a detailed
summary afterwards. This summary includes cost-benefit
calculations and can be compared to those of previous runs to
optimize the financial outcome of the timber harvest by exchanging
crop resources or modifying their parameters.
Abstract: Retrieval of the surface reflectance is important in the
remotely sensed data analysis to obtain the atmospheric reflectance or
atmospheric correction. The relationship between visible and mid
infrared reflectance over land was investigated and developed in this
study. The surface reflectances of the two visible bands were
measured using a handheld spectroradiometer collected around
Penang Island. In this study, we use the assumption that the 2.1 μm
band is not affected by aerosol and it is transparent to most aerosol
types (except dust). Therefore the satellite observed signal is the
same as the surface signal in 2.1 μm band. The correlation between
the surface reflectance measured by the spectroradiometer in the blue
and red region and the 2.1 μm observed by the satellite has been
established. We investigate five dates of Landsat TM scenes in this
study. The finding obtained by this study indicates that the surface
reflectance can be retrieved from the 2.1 μm band.
Abstract: Using ab initio theoretical calculations, we present
analysis of fragmentation process. The analysis is performed in two
steps. The first step is calculation of fragmentation energies by ab
initio calculations. The second step is application of the energies to
kinetic description of process. The energies of fragments are
presented in this paper. The kinetics of fragmentation process can be
described by numerical models. The method for kinetic analysis is
described in this paper. The result - composition of fragmentation
products - will be calculated in future. The results from model can be
compared to the concentrations of fragments from mass spectrum.
Abstract: In today-s competitive market, most companies
develop manufacturing systems that can help in cost reduction and
maximum quality. Human issues are an important part of
manufacturing systems, yet most companies ignore their effects on
production performance. This paper aims to developing an integrated
workforce planning system that incorporates the human being.
Therefore, a multi-objective mixed integer nonlinear programming
model is developed to determine the amount of hiring, firing,
training, overtime for each worker type. This paper considers a
workforce planning model including human aspects such as skills,
training, workers- personalities, capacity, motivation, and learning
rates. This model helps to minimize the hiring, firing, training and
overtime costs, and maximize the workers- performance. The results
indicate that the workers- differences should be considered in
workforce scheduling to generate realistic plans with minimum costs.
This paper also investigates the effects of human learning rates on the
performance of the production systems.
Abstract: An experiment was performed in the south of
Morocco in order to evaluate the effect of deficit irrigation by treated
wastewater on chickpea production. We applied six irrigation
treatments on a local variety of chickpea by supplying alternatively
50 or 100% of ETm in a completely randomized design.
We found a highly significant difference between treatments in
terms of biomass production. Drought stress during the vegetative
period showed highest yield with 6.5 t/ha which was more than the
yield obtained for the control (4.9 t/ha). The optimal crop stage in
which deficit irrigation can be applied is the vegetative growth stage,
as the crop has a chance to develop its root system, to be able to
cover the plant needs for water and nutrient supply during the rest of
cycle, and non stress conditions during the flowering and seed filling
stages allow the plant to optimize its photosynthesis and carbon
translocation, therefore increase its productivity.
Abstract: Despite the fact that Knowledge Sharing (KS) is very important, we found only little discussion about the reasons why people have the willingness to share knowledge at such platform even though there is no immediate benefit to the persons who contribute knowledge in it. The aim of this study is to develop an integrative understanding of the factors that support or inhibit individuals- knowledge sharing intentions in virtual communities and to find whether habit would generate people-s willingness to be involved. We apply Social Capital Theory (SCT), and we also add two dimensions for discussion: member incentive and habitual domain (HD). This research assembles the questionnaire from individuals who have experienced knowledge sharing in virtual communities, and applies survey and Structural Equation Model (SEM) to analyze the results from the questionnaires. Finally, results confirm that individuals are willing to share knowledge in virtual communities: (1) if they consider reciprocity, centrality, and have longer tenure in their field, and enjoy helping. (2) if they have the habit of sharing knowledge. This study is useful for the developers of virtual communities to insight into knowledge sharing in cyberspace.
Abstract: Operating a device at high power and high frequency
is a major problem because wall losses greatly reduce the efficiency
of the device. In the present communication, authors analytically
analyzed the dependence of ohmic/RF efficiency, the fraction of
output power with respect to the total power generated, of gyrotron
cavity structure on the conductivity of copper for the second
harmonic TE0,6 mode. This study shows a rapid fall in the RF
efficiency as the quality (conductivity) of copper degrades. Starting
with an RF efficiency near 40% at the conductivity of ideal copper
(5.8 x 107 S/m), the RF efficiency decreases (upto 8%) as the copper
quality degrades. Assuming conductivity half that of ideal copper the
RF efficiency as a function of diffractive quality factor, Qdiff, has
been studied. Here the RF efficiency decreases rapidly with
increasing diffractive Q. Ohmic wall losses as a function of
frequency for 460 GHz gyrotron cavity excited in TE0,6 mode has
also been analyzed. For 460 GHz cavity, the extracted power is
reduced to 32% of the generated power due to ohmic losses in the
walls of the cavity.
Abstract: Electronic banking must be secure and easy to use and
many banks heavily advertise an apparent of 100% secure system
which is contestable in many points. In this work, an alternative
approach to the design of e-banking system, through a new solution
for user authentication and security with digital certificate called
LumaCert is introduced. The certificate applies new algorithm for
asymmetric encryption by utilizing two mathematical operators
called Pentors and UltraPentors. The public and private key in this
algorithm represent a quadruple of parameters which are directly
dependent from the above mentioned operators. The strength of the
algorithm resides in the inability to find the respective Pentor and
UltraPentor operator from the mentioned parameters.
Abstract: The overall service performance of I/O intensive
system depends mainly on workload on its storage system. In
heterogeneous storage environment where storage elements from
different vendors with different capacity and performance are put
together, workload should be distributed according to storage
capability. This paper addresses data placement issue in short video
sharing website. Workload contributed by a video is estimated by the
number of views and life time span of existing videos in same
category. Experiment was conducted on 42,000 video titles in six
weeks. Result showed that the proposed algorithm distributed
workload and maintained balance better than round robin and random
algorithms.
Abstract: This presentation narrates the comparative analysis of
the dissolution data nimesulide microparticles prepared with
ethylcellulose, hydroxypropyl methylcellulose, chitosan and
Poly(D,L-lactide-co-glycolide) as polymers. The analysis of release
profiles showed that the variations noted in the release behavior of
nimesulide from various microparticulate formulations are due to the
nature of used polymer. In addition, maximum retardation in the
nimesulide release was observed with HPMC (floating particles).
Thus HPMC miacroparticles may be preferably employed for
sustained release dosage form development.
Abstract: This paper considers the design of a motion planner
that will simultaneously accomplish control and motion planning of a
n-link nonholonomic mobile manipulator, wherein, a n-link
holonomic manipulator is coupled with a nonholonomic mobile
platform, within an obstacle-ridden environment. This planner,
derived from the Lyapunov-based control scheme, generates
collision-free trajectories from an initial configuration to a final
configuration in a constrained environment cluttered with stationary
solid objects of different shapes and sizes. We demonstrate the
efficiency of the control scheme and the resulting acceleration
controllers of the mobile manipulator with results through computer
simulations of an interesting scenario.
Abstract: In the present paper the extreme shear stresses with the corresponding planes are established using the freely available computer tools like the Gnuplot, Sage, R, Python and Octave. In order to support these freely available computer tools, their strong symbolical and graphical abilities are illustrated. The nature of the stationary points obtained by the Method of Lagrangian Multipliers can be determined using freely available computer symbolical tools like Sage. The characters of the stationary points can be explained in the easiest way using freely available computer graphical tools like Gnuplot, Sage, R, Python and Octave. The presented figures improve the understanding of the problem and the obtained solutions for the majority of students of civil or mechanical engineering.
Abstract: In this work we report the recent progresses that have been achieved by our group in the last half decade on the field of computational proteomics. Specifically, we discuss the application of Molecular Dynamics Simulations and Electronic Structure Calculations in drug design, in the clarification of the structural and dynamic properties of proteins and enzymes and in the understanding of the catalytic and inhibition mechanism of cancer-related enzymes. A set of examples illustrate the concepts and help to introduce the reader into this important and fast moving field.
Abstract: The primary aim of the e-government applications is
the fast citizen service and the accomplishment of governmental
functions. This paper discusses the knowledge management for egovernment
development in the needs and role. The paper focused
on analyzing the advantages of using knowledge management by
using the existing IT technologies to maximize the government
functions efficiency. The proposed new approach of providing
government services is based on using Knowledge management as a
part of e-government system.
Abstract: In general, reports are a form of representing data in
such way that user gets the information he needs. They can be built in
various ways, from the simplest (“select from") to the most complex
ones (results derived from different sources/tables with complex
formulas applied). Furthermore, rules of calculations could be written
as a program hard code or built in the database to be used by dynamic
code. This paper will introduce two types of reports, defined in the
DB structure. The main goal is to manage calculations in optimal
way, keeping maintenance of reports as simple and smooth as
possible.
Abstract: Many problems in computer vision and image
processing present potential for parallel implementations through one
of the three major paradigms of geometric parallelism, algorithmic
parallelism and processor farming. Static process scheduling
techniques are used successfully to exploit geometric and algorithmic
parallelism, while dynamic process scheduling is better suited to
dealing with the independent processes inherent in the process
farming paradigm. This paper considers the application of parallel or
multi-computers to a class of problems exhibiting spatial data
characteristic of the geometric paradigm. However, by using
processor farming paradigm, a dynamic scheduling technique is
developed to suit the MIMD structure of the multi-computers. A
hybrid scheme of scheduling is also developed and compared with
the other schemes. The specific problem chosen for the investigation
is the Hough transform for line detection.
Abstract: Natural language processing systems pose a unique
challenge for software architectural design as system complexity has
increased continually and systems cannot be easily constructed from
loosely coupled modules. Lexical, syntactic, semantic, and pragmatic
aspects of linguistic information are tightly coupled in a manner that
requires separation of concerns in a special way in design,
implementation and maintenance. An aspect oriented software
architecture is proposed in this paper after critically reviewing
relevant architectural issues. For the purpose of this paper, the
syntactic aspect is characterized by an augmented context-free
grammar. The semantic aspect is composed of multiple perspectives
including denotational, operational, axiomatic and case frame
approaches. Case frame semantics matured in India from deep
thematic analysis. It is argued that lexical, syntactic, semantic and
pragmatic aspects work together in a mutually dependent way and
their synergy is best represented in the aspect oriented approach. The
software architecture is presented with an augmented Unified
Modeling Language.