Abstract: Wireless Sensor Networks can be used to monitor the
physical phenomenon in such areas where human approach is nearly
impossible. Hence the limited power supply is the major constraint of
the WSNs due to the use of non-rechargeable batteries in sensor
nodes. A lot of researches are going on to reduce the energy
consumption of sensor nodes. Energy map can be used with
clustering, data dissemination and routing techniques to reduce the
power consumption of WSNs. Energy map can also be used to know
which part of the network is going to fail in near future. In this paper,
Energy map is constructed using the prediction based approach.
Adaptive alpha GM(1,1) model is used as the prediction model.
GM(1,1) is being used worldwide in many applications for predicting
future values of time series using some past values due to its high
computational efficiency and accuracy.
Abstract: Low-density parity-check (LDPC) codes have been shown to deliver capacity approaching performance; however, problematic graphical structures (e.g. trapping sets) in the Tanner graph of some LDPC codes can cause high error floors in bit-error-ratio (BER) performance under conventional sum-product algorithm (SPA). This paper presents a serial concatenation scheme to avoid the trapping sets and to lower the error floors of LDPC code. The outer code in the proposed concatenation is the LDPC, and the inner code is a high rate array code. This approach applies an interactive hybrid process between the BCJR decoding for the array code and the SPA for the LDPC code together with bit-pinning and bit-flipping techniques. Margulis code of size (2640, 1320) has been used for the simulation and it has been shown that the proposed concatenation and decoding scheme can considerably improve the error floor performance with minimal rate loss.
Abstract: In this paper, propagation of cos-Gaussian beam in strongly nonlocal nonlinear media has been stimulated by using paraxial group transformation. At first, cos-Gaussian beam, nonlocal nonlinear media, critical power, transfer matrix, and paraxial group transformation are introduced. Then, the propagation of the cos-Gaussian beam in strongly nonlocal nonlinear media is simulated. Results show that beam propagation has periodic structure during self-focusing effect in this case. However, this simple method can be used for investigation of propagation of kinds of beams in ABCD optical media.
Abstract: The main purpose of this paper is to investigate a discrete time three–species food chain system with ratio dependence. By employing coincidence degree theory and analysis techniques, sufficient conditions for existence of periodic solutions are established.
Abstract: The seismic response of steel shear wall system considering nonlinearity effects using finite element method is investigated in this paper. The non-linear finite element analysis has potential as usable and reliable means for analyzing of civil structures with the availability of computer technology. In this research the large displacements and materially nonlinear behavior of shear wall is presented with developing of finite element code. A numerical model based on the finite element method for the seismic analysis of shear wall is presented with developing of finite element code in this research. To develop the finite element code, the standard Galerkin weighted residual formulation is used. Two-dimensional plane stress model and total Lagrangian formulation was carried out to present the shear wall response and the Newton-Raphson method is applied for the solution of nonlinear transient equations. The presented model in this paper can be developed for analysis of civil engineering structures with different material behavior and complicated geometry.
Abstract: In this paper we propose a novel approach for ascertaining human identity based on fusion of profile face and gait biometric cues The identification approach based on feature learning in PCA-LDA subspace, and classification using multivariate Bayesian classifiers allows significant improvement in recognition accuracy for low resolution surveillance video scenarios. The experimental evaluation of the proposed identification scheme on a publicly available database [2] showed that the fusion of face and gait cues in joint PCA-LDA space turns out to be a powerful method for capturing the inherent multimodality in walking gait patterns, and at the same time discriminating the person identity..
Abstract: Data Envelopment Analysis (DEA) is one of the most
widely used technique for evaluating the relative efficiency of a set
of homogeneous decision making units. Traditionally, it assumes that
input and output variables are known in advance, ignoring the critical
issue of data uncertainty. In this paper, we deal with the problem
of efficiency evaluation under uncertain conditions by adopting the
general framework of the stochastic programming. We assume that
output parameters are represented by discretely distributed random
variables and we propose two different models defined according to a
neutral and risk-averse perspective. The models have been validated
by considering a real case study concerning the evaluation of the
technical efficiency of a sample of individual firms operating in
the Italian leather manufacturing industry. Our findings show the
validity of the proposed approach as ex-ante evaluation technique
by providing the decision maker with useful insights depending on
his risk aversion degree.
Abstract: Studies have shown that the SnAgCu solder family has been widely used as a replacement for conventional Sn-Pb solders. An attractive approach is by introducing alloying additives (rare earth elements (RE), Zn, Co, Fe, Ni, Sb) into the SnAgCu solder, which helps in refining the microstructure also improving the mechanical and wetting properties of the solder. The present work focuses on the effect of additions of 0.5% Ce and Fe into Sn-3.0Ag-0.5Cu solder, in attempt to reduce the intermetallic compound (IMC) growth and reflow properties of the solder on Cu and Ni (P) surface finish, as well as effects thermal aging on the formation of intermetallic compound (IMC) on different surface finish. Excessive intermetallic compound growth may effect the interface and solder joint due to the brittle nature of the intermetallic compounds. Thus, by introducing alloying elements, IMC layer thickness can be decrease, resulting in better joint and solder reliability.
Abstract: Mixed-traffic (e.g., pedestrians, bicycles, and vehicles)
data at an intersection is one of the essential factors for intersection
design and traffic control. However, some data such as pedestrian
volume cannot be directly collected by common detectors (e.g.
inductive loop, sonar and microwave sensors). In this paper, a video
based detection algorithm is proposed for mixed-traffic data collection
at intersections using surveillance cameras. The algorithm is derived
from Gaussian Mixture Model (GMM), and uses a mergence time
adjustment scheme to improve the traditional algorithm. Real-world
video data were selected to test the algorithm. The results show that
the proposed algorithm has the faster processing speed and more
accuracy than the traditional algorithm. This indicates that the
improved algorithm can be applied to detect mixed-traffic at
signalized intersection, even when conflicts occur.
Abstract: Despite extensive study on wireless sensor network
security, defending internal attacks and finding abnormal behaviour
of the sensor are still difficult and unsolved task. The conventional
cryptographic technique does not give the robust security or detection
process to save the network from internal attacker that cause by
abnormal behavior. The insider attacker or abnormally behaved
sensor identificationand location detection framework using false
massage detection and Time difference of Arrival (TDoA) is
presented in this paper. It has been shown that the new framework
can efficiently identify and detect the insider attacker location so that
the attacker can be reprogrammed or subside from the network to
save from internal attack.
Abstract: The paper shows some ability to manage two-phase
flows arising from the use of unsteady effects. In one case, we
consider the condition of fragmentation of the interface between the
two components leads to the intensification of mixing. The problem
is solved when the temporal and linear scale are small for the
appearance of the developed mixing layer. Showing that exist such
conditions for unsteady flow velocity at the surface of the channel,
which will lead to the creation and fragmentation of vortices at Re
numbers of order unity. Also showing that the Re is not a criterion of
similarity for this type of flows, but we can introduce a criterion that
depends on both the Re, and the frequency splitting of the vortices. It
turned out that feature of this situation is that streamlines behave
stable, and if we analyze the behavior of the interface between the
components it satisfies all the properties of unstable flows. The other
problem we consider the behavior of solid impurities in the extensive
system of channels. Simulated unsteady periodic flow modeled
breaths. Consider the behavior of the particles along the trajectories.
It is shown that, depending on the mass and diameter of the particles,
they can be collected in a caustic on the channel walls, stop in a
certain place or fly back. Of interest is the distribution of particle
velocity in frequency. It turned out that by choosing a behavior of the
velocity field of the carrier gas can affect the trajectory of individual
particles including force them to fly back.
Abstract: Binder drainage test is widely used to set an upper
limit to the design binder content of porous asphalt. However, the
presence of high amount of fine particles in the drained binder may
affect the accuracy of the test result. This paper presents a study to
characterize the composition and particle size distribution of fine
particles accumulated in the drained binder. Fine aggregates and filler
in the drained binder were extracted using a suitable solvent. Then,
wet and dry sieve analysis was carried out to identify the actual
composition of the extracted fine aggregates and filler. From the
results, almost half of the drained binder consisted of fine aggregates
and this significantly affects the accuracy of the design binder content
of porous asphalt mix. This simple finding highlights the importance
of taking into account the presence of fine aggregates in the
calculation of drained binder.
Abstract: The objective of this research was to study the factors
related to the satisfaction of consumers who purchased a Toyota
SUV Fortuner. This paper was a survey data which collected 400
samples from 65 car dealerships. The survey was conducted mainly
in Bangkok, Thailand. The statistics utilized in this paper included
percentage, mean, standard deviation and Pearson Product-Moment.
The findings revealed that the majority of respondent were male with
an undergraduate degree, married and live together. The average
income of the respondents was between 20,001 - 30,000 baht. Most
of them worked for private companies. Most of them had a family
with the average of 4 members. The hypotheses testing revealed that
the factors of marketing mix in terms of product (ability, gas
mileage, and safety) were related to overall satisfaction at the
medium level. However, the findings also revealed that the factors of
marketing mix in terms of product (image), price, and promotion, and
service center were related to the overall satisfaction at the low level.
Abstract: Service innovations are central concerns in fast
changing environment. Due to the fitness in customer demands and
advances in information technologies (IT) in service management, an
expanded conceptualization of e-service innovation is required.
Specially, innovation practices have become increasingly more
challenging, driving managers to employ a different open innovation
model to maintain competitive advantages. At the same time, firms
need to interact with external and internal customers in innovative
environments, like the open innovation networks, to co-create values.
Based on these issues, an important conceptual framework of e-service
innovation is developed. This paper aims to examine the contributing
factors on e-service innovation and firm performance, including
financial and non-financial aspects. The study concludes by showing
how e-service innovation will play a significant role in growing the
overall values of the firm. The discussion and conclusion will lead to a
stronger understanding of e-service innovation and co-creating values
with customers within open innovation networks.
Abstract: This article first summarizes reasons why current approaches supporting Open Learning and Distance Education need to be complemented by tools permitting lecturers, researchers and students to cooperatively organize the semantic content of Learning related materials (courses, discussions, etc.) into a fine-grained shared semantic network. This first part of the article also quickly describes the approach adopted to permit such a collaborative work. Then, examples of such semantic networks are presented. Finally, an evaluation of the approach by students is provided and analyzed.
Abstract: The paper focuses on the area of context modeling with respect to the specification of context-aware systems supporting ubiquitous applications. The proposed approach, followed within the SIMPLICITY IST project, uses a high-level system ontology to derive context models for system components which consequently are mapped to the system's physical entities. For the definition of user and device-related context models in particular, the paper suggests a standard-based process consisting of an analysis phase using the Common Information Model (CIM) methodology followed by an implementation phase that defines 3GPP based components. The benefits of this approach are further depicted by preliminary examples of XML grammars defining profiles and components, component instances, coupled with descriptions of respective ubiquitous applications.
Abstract: A study was carried out to determine the effect of water quality on flotation performance. The experimental test work comprised of batch flotation tests using Denver lab cell for a period of 10 minutes. Nine different test runs were carried out in triplicates to ensure reproducibility using different water types from different thickener overflows, return and sewage effluent water (process water) and portable water. The water sources differed in pH, total dissolved solids, total suspended solids and conductivity. Process water was found to reduce the concentrate recovery and mass pull, while portable water increased the concentrate recovery and mass pull. Portable water reduced the concentrate grade while process water increased the concentrate grade. It is proposed that a combination of process water and portable water supply be used in flotation circuits to balance the different effects that the different water types have on the flotation efficiency.
Abstract: This study examines age and sex patterns of
children-s disability in the Parila union of Rajshahi, Bangladesh. For
this we assumed that (1) prevalence of disability patterns and its
severity in the middle childhood are higher than in the infancy or
latter childhood in the Parila union of Rajshahi, (2) prevalence of
disability patterns and its severity among the boys compared to girls
are higher in the study area of Bangladesh. In order to examine the
assumptions 102 samples, including their mothers were selected
based on snowball process and the respondents were individually
interviewed with semi-structured questionnaire method. The results
of the study suggest that disability patterns and its severity among the
male children were two-fold higher than the female children. In
addition, these patterns of children-s disability and its severity in the
middle childhood were also higher than in the infancy or latter
childhood. Further study should conduct how socio-structural factors
influence age and sex patterns of children-s disability patterns and its
severity in Bangladesh.
Abstract: The recognition of human faces, especially those with
different orientations is a challenging and important problem in image
analysis and classification. This paper proposes an effective scheme
for rotation invariant face recognition using Log-Polar Transform and
Discrete Cosine Transform combined features. The rotation invariant
feature extraction for a given face image involves applying the logpolar
transform to eliminate the rotation effect and to produce a row
shifted log-polar image. The discrete cosine transform is then applied
to eliminate the row shift effect and to generate the low-dimensional
feature vector. A PSO-based feature selection algorithm is utilized to
search the feature vector space for the optimal feature subset.
Evolution is driven by a fitness function defined in terms of
maximizing the between-class separation (scatter index).
Experimental results, based on the ORL face database using testing
data sets for images with different orientations; show that the
proposed system outperforms other face recognition methods. The
overall recognition rate for the rotated test images being 97%,
demonstrating that the extracted feature vector is an effective rotation
invariant feature set with minimal set of selected features.
Abstract: The performance of an image filtering system depends
on its ability to detect the presence of noisy pixels in the image. Most
of the impulse detection schemes assume the presence of salt and
pepper noise in the images and do not work satisfactorily in case of
uniformly distributed impulse noise. In this paper, a new algorithm is
presented to improve the performance of switching median filter in
detection of uniformly distributed impulse noise. The performance of
the proposed scheme is demonstrated by the results obtained from
computer simulations on various images.