Proportion and Particle Size Distribution of Fine Aggregates Extracted From the Drained Binder in a Binder Drainage Test

Binder drainage test is widely used to set an upper limit to the design binder content of porous asphalt. However, the presence of high amount of fine particles in the drained binder may affect the accuracy of the test result. This paper presents a study to characterize the composition and particle size distribution of fine particles accumulated in the drained binder. Fine aggregates and filler in the drained binder were extracted using a suitable solvent. Then, wet and dry sieve analysis was carried out to identify the actual composition of the extracted fine aggregates and filler. From the results, almost half of the drained binder consisted of fine aggregates and this significantly affects the accuracy of the design binder content of porous asphalt mix. This simple finding highlights the importance of taking into account the presence of fine aggregates in the calculation of drained binder.

Authors:

• M. O. Hamzah
• M. R. M. Hasan

Keywords:

• Porous asphalt
• Binder drainage test
• Drained binder
• Fine particle proportion

References:

[1] G. Huber, "Performance survey on open-graded friction course mixes,"
Synthesis of Highway Practice 284, Transportation Research Board,
National Research Council, Washington, D. C., 2000.
[2] H. Bendtsen, C. B. Nielsen, J. Raaberg, and R. A. Macdonald,
"Clogging of porous bituminous surfacing - an investigation in
Copenhagen," Report 120, Road Directorate Danish Road Institute,
2002.
[3] H. Khalid, and F. Pérez, "Performance assessment of Spanish and
British porous asphalts," Performance and Durability of Bituminous
Materials, Published by E & FN Spon, London, 1996, pp. 137-157.
[4] H. Khalid, and C. Walsh, "A rational mix design method for porous
asphalt, In Procedures, 24th European Transport Form, PTRC, Session
G22i (Road Materials & Methods- Worldwide Update). London, 1996.
[5] D. Newcomb, and L. Scofield, "Quiet pavements raise the roof in
Europe," Hot Mix Asphalt Technology, September-October, 2004, pp.
22-28.
[6] C. Pagotto, M. Legret, and P. Le. Cloirec, "Comparison of the hydraulic
bahaviour and the quality of highway runoff water according to the type
of pavement," Wat. Res., Vol 34, No 18, 2000, pp. 4446-4454.
[7] B. Birgisson, R. Roque, A. Varadhan, T. Thai, and L. Jaiswal, "Final
report: Evaluation of thick open graded and bonded friction courses for
Florida," Department of Civil Engineering, College of Engineering,
University of Florida, 2006.
[8] A. E. Alvarez, A. E. Martin, C. K. Estakhri, J. W. Button, C. J Glover,
and S. H. Jung, "Synthesis of current practice on the design,
construction and maintenance of porous friction courses," Texas
Transportation Institute, The Texas A&M University System College
Station, Texas, 2006.
[9] B. K. Ferguson, "Porous pavements: Integrated studies in water
management and land development," CRC Press, 2000 N. W. Corporate
Blvd, Boca Rotan, Florida, 2005.
[10] J. C. Nicholls, "Review of UK porous asphalt trials," TRL Report 264,
Transport Research Laboratory, Transport Research Foundation Group
of Companies, 1997.
[11] R. B. Mallick, P. S. Kandhal, L. A. Cooley, Jr., and D. E. Watson,
"Design, construction, and performance of new generation open- graded
friction courses," NCAT Report No. 2000-01. National Center for
Asphalt Technology, Auburn University, Alabama, 2000.
[12] M. E. Daines, "Pervious macadam: Trials on Trunk Road A38 Burton
bypass," 1984, TRRL Research Report 57, 1986.