Abstract: One of the aims of the paper is to make a comparison
of experimental results with numerical simulation for a side cooler.
Specifically, it was the amount of air to be delivered by the side
cooler with fans running at 100%. This integral value was measured
and evaluated within the plane parallel to the front side of the side
cooler at a distance of 20mm from the front side. The flow field
extending from the side cooler to the space was also evaluated.
Another objective was to address the contribution of evaluated values
to the increase of data center energy consumption.
Abstract: One of the problems in fault diagnosis of transformer
based on dissolved gas, is lack of matching the result of fault
diagnosis of different standards with the real world. In this paper, the
result of the different standards is analyzed using fuzzy and the result
is compared with the empirical test. The comparison between the
suggested method and existing methods indicate the capability of the
suggested method in on-line fault diagnosis of the transformers. In
addition, in some cases the existing standards are not able to
diagnose the fault. In theses cases, the presented method has the
potential of diagnosing the fault. The information of three
transformers is used to the show the capability of the suggested
method in diagnosing the fault. The results validate the capability of
the presented method in fault diagnosis of the transformer.
Abstract: The toxicity of aqueous extracts of two plants,
Nicotiana tobacum and Eucalyptus globulus were investigated against second instar larvae of Lycoriella auripila, one of the most
important pests of button mushroom, using agar dilution technique.
Seven concentrations of aqueous extracts of both plants were applied
on second instar larvae and their mortality were evaluated after 24, 48 and 72 h. The obtained results revealed that aqueous extracts of N.
tabacum and E. globulus caused 77.55 and 72.5% mortality of larvae
of L. auripila at concentration of 4000 ppm after 72h, respectively. Toxicities of tobacco extract after 24, 48 and 72 h were 1.52, 1.85
and 1.70 times greather than eucalyptus, respectively. The estimated LC50 after 24, 48 and 72 h were 7316.5, 2468.5 and 2013.1 ppm for
tobacco and 64870.0, 6839.5 and 3326.4 ppm for eucalyptus, respectively. These plants merit further study as potential insecticides
for the control of L. auripila.
Abstract: CEMTool is a command style design and analyzing
package for scientific and technological algorithm and a matrix based
computation language. In this paper, we present new 2D & 3D
finite element method (FEM) packages for CEMTool. We discuss
the detailed structures and the important features of pre-processor,
solver, and post-processor of CEMTool 2D & 3D FEM packages. In
contrast to the existing MATLAB PDE Toolbox, our proposed FEM
packages can deal with the combination of the reserved words. Also,
we can control the mesh in a very effective way. With the introduction
of new mesh generation algorithm and fast solving technique, our
FEM packages can guarantee the shorter computational time than
MATLAB PDE Toolbox. Consequently, with our new FEM packages,
we can overcome some disadvantages or limitations of the existing
MATLAB PDE Toolbox.
Abstract: Embedded hardware simulator is a valuable computeraided
tool for embedded application development. This paper focuses
on the ARM926EJ-S MMU, builds state transition models and
formally verifies critical properties for the models. The state transition
models include loading instruction model, reading data model, and
writing data model. The properties of the models are described by
CTL specification language, and they are verified in VIS. The results
obtained in VIS demonstrate that the critical properties of MMU are
satisfied in the state transition models. The correct models can be
used to implement the MMU component in our simulator. In the
end of this paper, the experimental results show that the MMU can
successfully accomplish memory access requests from CPU.
Abstract: Linear Discrimination Analysis (LDA) is a linear
solution for classification of two classes. In this paper, we propose a
variant LDA method for multi-class problem which redefines the
between class and within class scatter matrices by incorporating a
weight function into each of them. The aim is to separate classes as
much as possible in a situation that one class is well separated from
other classes, incidentally, that class must have a little influence on
classification. It has been suggested to alleviate influence of classes
that are well separated by adding a weight into between class scatter
matrix and within class scatter matrix. To obtain a simple and
effective weight function, ordinary LDA between every two classes
has been used in order to find Fisher discrimination value and passed
it as an input into two weight functions and redefined between class
and within class scatter matrices. Experimental results showed that
our new LDA method improved classification rate, on glass, iris and
wine datasets, in comparison to different versions of LDA.
Abstract: A analysis on the conventional the blood pressure estimation method using an oscillometric sphygmomanometer was
performed through a computer simulation using an arterial pressure-volume (APV) model. Traditionally, the maximum amplitude algorithm (MAP) was applied on the oscillation waveforms of the APV model to obtain the mean arterial pressure and the characteristic ratio. The estimation of mean arterial pressure and
characteristic ratio was significantly affected with the shape of the blood pressure waveforms and the cutoff frequency of high-pass filter
(HPL) circuitry. Experimental errors are due to these effects when estimating blood pressure. To find out an algorithm independent from
the influence of waveform shapes and parameters of HPL, the volume
oscillation of the APV model and the phase shift of the oscillation with fast fourier transform (FFT) were testified while increasing the cuff
pressure from 1 mmHg to 200 mmHg (1 mmHg per second). The phase shift between the ranges of volume oscillation was then only observed between the systolic and the diastolic blood pressures. The same results were also obtained from the simulations performed on two different the arterial blood pressure waveforms and one
hyperthermia waveform.
Abstract: The explosion of interest in online gaming and
virtual worlds is leading many universities to investigate
possible educational applications of the new environments.
In this paper we explore the possibilities of 3D online worlds
for teacher education, particularly the field experience
component. Drawing upon two pedagogical examples, we
suggest that virtual simulations may, with certain limitations,
create safe spaces that allow preservice teachers to adopt
alternate identities and interact safely with the “other." In so
doing they may become aware of the constructed nature of
social categories and gain the essential pedagogical skill of
perspective-taking. We suggest that, ultimately, the ability to
be the principal creators of themselves in virtual environments
can increase their ability to do the same in the real world.
Abstract: This paper explains the development of Multifunctional Barcode Inventory Management System (MBIMS) to manage inventory and stock ordering. Today, most of the retailing market is still manually record their stocks and its effectiveness is quite low. By providing MBIMS, it will bring effectiveness to retailing market in inventory management. MBIMS will not only save time in recording input, output and refilling the inventory stock, but also in calculating remaining stock and provide auto-ordering function. This system is developed through System Development Life Cycle (SDLC) and the flow and structure of the system is fully built based on requirements of a retailing market. Furthermore, this system has been developed from methodical research and study where each part of the system is vigilantly designed. Thus, MBIMS will offer a good solution to the retailing market in achieving effectiveness and efficiency in inventory management.
Abstract: Fuel cells have become one of the major areas of
research in the academia and the industry. The goal of most fish
farmers is to maximize production and profits while holding labor
and management efforts to the minimum. Risk of fish kills, disease
outbreaks, poor water quality in most pond culture operations,
aeration offers the most immediate and practical solution to water
quality problems encountered at higher stocking and feeding rates.
Many units of aeration system are electrical units so using a
continuous, high reliability, affordable, and environmentally friendly
power sources is necessary. Aeration of water by using PEM fuel cell
power is not only a new application of the renewable energy, but
also, it provides an affordable method to promote biodiversity in
stagnant ponds and lakes. This paper presents a new design and
control of PEM fuel cell powered a diffused air aeration system for a
shrimp farm in Mersa Matruh in Egypt. Also Artificial intelligence
(AI) techniques control is used to control the fuel cell output power
by control input gases flow rate. Moreover the mathematical
modeling and simulation of PEM fuel cell is introduced. A
comparison study is applied between the performance of fuzzy logic
control (FLC) and neural network control (NNC). The results show
the effectiveness of NNC over FLC.
Abstract: Active power filter continues to be a powerful tool to control harmonics in power systems thereby enhancing the power quality. This paper presents a fuzzy tuned PID controller based shunt active filter to diminish the harmonics caused by non linear loads like thyristor bridge rectifiers and imbalanced loads. Here Fuzzy controller provides the tuning of PID, based on firing of thyristor bridge rectifiers and variations in input rms current. The shunt APF system is implemented with three phase current controlled Voltage Source Inverter (VSI) and is connected at the point of common coupling for compensating the current harmonics by injecting equal but opposite filter currents. These controllers are capable of controlling dc-side capacitor voltage and estimating reference currents. Hysteresis Current Controller (HCC) is used to generate switching signals for the voltage source inverter. Simulation studies are carried out with non linear loads like thyristor bridge rectifier along with unbalanced loads and the results proved that the APF along with fuzzy tuned PID controller work flawlessly for different firing angles of non linear load.
Abstract: This study describes the methodology for the development of a validated in-vitro in-vivo correlation (IVIVC) for metoprolol tartrate modified release dosage forms with distinctive release rate characteristics. Modified release dosage forms were formulated by microencapsulation of metoprolol tartrate into different amounts of ethylcellulose by non-solvent addition technique. Then in-vitro and in-vivo studies were conducted to develop and validate level A IVIVC for metoprolol tartrate. The values of regression co-efficient (R2-values) for IVIVC of T2 and T3 formulations were not significantly (p
Abstract: CO2 is the primary anthropogenic greenhouse gas,
accounting for 77% of the human contribution to the greenhouse
effect in 2004. In the recent years, global concentration of CO2 in the
atmosphere is increasing rapidly. CO2 emissions have an impact on
global climate change. Anthropogenic CO2 is emitted primarily from
fossil fuel combustion. Carbon capture and storage (CCS) is one
option for reducing CO2 emissions. There are three major approaches
for CCS: post-combustion capture, pre-combustion capture and
oxyfuel process. Post-combustion capture offers some advantages as
existing combustion technologies can still be used without radical
changes on them.
There are several post combustion gas separation and capture
technologies being investigated, namely; (a) absorption, (b)
cryogenic separation, (c) membrane separation (d) micro algal biofixation
and (e) adsorption. Apart from establishing new techniques,
the exploration of capture materials with high separation performance
and low capital cost are paramount importance. However, the
application of adsorption from either technology, require easily
regenerable and durable adsorbents with a high CO2 adsorption
capacity. It has recently been reported that the cost of the CO2
capture can be reduced by using this technology. In this paper, the
research progress (from experimental results) in adsorbents for CO2
adsorption, storage, and separations were reviewed and future
research directions were suggested as well.
Abstract: There-s a lack in understanding the indoor climate of Malaysian residential. The assumption of traditional house could
provide the best indoor environment is too good to be true. This research is to understand indoor environment in three types of
Malaysian residential and thermo recorder TR72Ui were placed in
indoor spaces for measurement. There are huge differences of indoor
environment between housing types, and building material helps to control indoor climate. Traditional house indoor climate was similar to
the outdoor. Temperature in the bedroom of terrace and town houses were slightly higher than the living room. Indoor temperature was 2oC
lower in the rainy season than the hot season. It was hard to control
indoor humidity level in traditional house compared with terrace and
town house. As for conclusion, town house provides the best thermal
environment to the building occupants and can be improved with good
roof insulation.
Abstract: Software engineering education not only embraces
technical skills of software development but also necessitates
communication and interaction among learners. In this paper, it is
proposed to adapt the PBL methodology that is especially designed to
be integrated into software engineering classroom in order to promote
collaborative learning environment. This approach helps students
better understand the significance of social aspects and provides a
systematic framework to enhance teamwork skills. The adaptation of
PBL facilitates the transition to an innovative software development
environment where cooperative learning can be actualized.
Abstract: This paper presents the combination of different precipitation data sets and the distributed hydrological model, in order to examine the flood runoff reproductivity of scattered observation catchments. The precipitation data sets were obtained from observation using rain-gages, satellite based estimate (TRMM), and numerical weather prediction model (NWP), then were coupled with the super tank model. The case study was conducted in three basins (small, medium, and large size) located in Central Vietnam. Calculated hydrographs based on ground observation rainfall showed best fit to measured stream flow, while those obtained from TRMM and NWP showed high uncertainty of peak discharges. However, calculated hydrographs using the adjusted rainfield depicted a promising alternative for the application of TRMM and NWP in flood modeling for scattered observation catchments, especially for the extension of forecast lead time.
Abstract: In this paper, we show that the stability can not be
achieved with current stabilizing MPC methods for some unstable
processes. Hence we present a new method for stabilizing these
processes. The main idea is to use a new time varying weighted cost
function for traditional GPC. This stabilizes the closed loop system
without adding soft or hard constraint in optimization problem. By
studying different examples it is shown that using the proposed
method, the closed-loop stability of unstable nonminimum phase
process is achieved.
Abstract: In realizing devices using ZnO, a key challenge is the
production of p-type material. Substitution of oxygen by a group-V
impurity is thought to result in deep acceptor levels, but a candidate
made up from a complex of a group-V impurity (P, As, Sb) on a Zn
site coupled with two vacant Zn sites is widely viewed as a candidate.
We show using density-functional simulations that in contrast to such
a view, complexes involving oxygen interstitials are energetically
more favorable, resulting in group-V impurities coordinated with four,
five or six oxygen atoms.
Abstract: The burst of Web 2.0 technology and social
networking tools manifest different styles of learning and managing
knowledge among both knowledge workers and adult learners. In the
Western countries, open-learning concept has been made popular due
to the ease of use and the reach that the technology provides. In
Malaysia, there are still some gaps between the learners- acceptance
of technology and the full implementation of the technology in the
education system. There is a need to understand how adult learners,
who are knowledge workers, manage their personal knowledge via
social networking tools, especially in their learning process. Four
processes of personal knowledge management (PKM) and four
cognitive enablers are proposed supported by analysed data on adult
learners in a university. The model derived from these processes and
enablers is tested and presented, with recommendations on features to be included in adult learners- learning environment.
Abstract: New graph similarity methods have been proposed in this work with the aim to refining the chemical information extracted from molecules matching. For this purpose, data fusion of the isomorphic and nonisomorphic subgraphs into a new similarity measure, the Approximate Similarity, was carried out by several approaches. The application of the proposed method to the development of quantitative structure-activity relationships (QSAR) has provided reliable tools for predicting several pharmacological parameters: binding of steroids to the globulin-corticosteroid receptor, the activity of benzodiazepine receptor compounds, and the blood brain barrier permeability. Acceptable results were obtained for the models presented here.