Abstract: Arenga pinnata is an abundantly natural fiber that can be used for sound proof material. However, the scientific data of acoustics properties of Arenga pinnata was not available yet. In this study the sound absorption of pure arenga pinnata was measured. The thickness of Arenga pinnata was varied in 10 mm, 20 mm, 30mm, and 40mm. This work was carried out to investigate the potential of using Arenga pinnata fiber as raw material for sound absorbing material. Impedance Tube Method was used to measure sound absorption coefficient (α). The Measurements was done in accordance with ASTM E1050-98, that is the standard test method for impedance and absorption of acoustical materials using a tube, two microphones and a digital frequency analysis system . The results showed that sound absorption coefficients of Arenga pinnata were good from 2000 Hz to 5000 Hz within the range of 0.75 – 0.90. The optimum sound absorption coefficient was obtained from the thickness of 40 mm. These results indicated that Arenga pinnata fiber is promising to be used as raw material of sound absorbing material with low cost, light, and biodegradable.
Abstract: Bootstrapping has gained popularity in different tests of hypotheses as an alternative in using asymptotic distribution if one is not sure of the distribution of the test statistic under a null hypothesis. This method, in general, has two variants – the parametric and the nonparametric approaches. However, issues on reliability of this method always arise in many applications. This paper addresses the issue on reliability by establishing a reliability measure in terms of quantiles with respect to asymptotic distribution, when this is approximately correct. The test of hypotheses used is Ftest. The simulated results show that using nonparametric bootstrapping in F-test gives better reliability than parametric bootstrapping with relatively higher degrees of freedom.
Abstract: The aim of this paper is to determine Frenet-Serret invariants of non-null curves in Lorentzian 5-space. First, we define a vector product of four vectors, by this way, we present a method to calculate Frenet-Serret invariants of the non-null curves. Additionally, an algebraic example of presented method is illustrated.
Abstract: In manufacturing industries, development of measurement leads to increase the number of monitoring variables and eventually the importance of multivariate control comes to the fore. Statistical process control (SPC) is one of the most widely used as multivariate control chart. Nevertheless, SPC is restricted to apply in processes because its assumption of data as following specific distribution. Unfortunately, process data are composed by the mixture of several processes and it is hard to estimate as one certain distribution. To alternative conventional SPC, therefore, nonparametric control chart come into the picture because of the strength of nonparametric control chart, the absence of parameter estimation. SVDD based control chart is one of the nonparametric control charts having the advantage of flexible control boundary. However,basic concept of SVDD has been an oversight to the important of data characteristic, density distribution. Therefore, we proposed DW-SVDD (Density Weighted SVDD) to cover up the weakness of conventional SVDD. DW-SVDD makes a new attempt to consider dense of data as introducing the notion of density Weight. We extend as control chart using new proposed SVDD and a simulation study of various distributional data is conducted to demonstrate the improvement of performance.
Abstract: Tasks of the work were study the possible E.coli
contamination in red deer meat, identify pathogenic strains from
isolated E.coli, determine their incidence in red deer meat and
determine the presence of VT1, VT2 and eaeA genes for the
pathogenic E.coli. 8 (10%) samples were randomly selected from 80
analysed isolates of E.coli and PCR reaction was performed on them.
PCR was done both on initial materials – samples of red deer meat -
and for already isolated liqueurs. Two of analysed venison samples
contain verotoxin-producing strains of E. coli. It means that this meat
is not safe to consumer. It was proven by the sequestration reaction of
E. coli and by comparison of the obtained results with the database of
microorganism genome available on the internet that the isolated
culture corresponds to region 16S rDNS of E. coli thus presenting
correctness of the microbiological methods.
Abstract: The demand on High voltage (HV) infrastructures is growing due to the corresponding growth in industries and population. New or upgraded HV infrastructure has safety implications since Transmission mains usually occupy the same easement in the vicinity of neighbouring residents. Transmission mains consist of underground (UG) and overhead (OH) sections and the transition between the UG and OH section is known as the UGOH pole. The existence of two transmission mains in the same easement can dictate to resort to more complicated earthing design in order to mitigate the effect of AC interference, and in some cases it can also necessitates completing a Split Study of the system. This paper provides an overview of the AC interference, Split Study and the earthing of an underground feeder including the UGOH pole .In addition, this paper discusses the use of different link boxes on the UG feeder and presents a case study that represent a clear example of the Ac interference and Split factor. Finally, a few recommendations are provided to achieve a safety zone in the area beyond the boundary of the HV system.
Abstract: As a multicultural country, Indonesia has many subcultures
with unique performing arts. Some of them are well-known
to international tourists, such as music ensemble (known as gamelan)
in Bali and Java, shadow puppet play (wayang) in Java, and martial
arts (known as pencak silat) in Sumatra. Some examples of famous
traditional dances in Indonesia are Srimpi from Yogyakarta and Solo,
Legong from Bali, and Gong dance from Kalimantan. Performing arts
show the identity of a nation. However, they are a complex subject,
especially when they are addressed to children. The performing arts,
e.g. music, dance theatre, and opera are experiential, experimental,
and emotionally charged. Therefore, the right strategy and promotion
need to be developed to engage children to appreciate and preserve
traditional dances. This study aims to explore and identify
possibilities of internet usage as a medium to promote traditional
dances, especially to children in Indonesia.
Abstract: A DC servomotor position control system using a Fuzzy Logic Sliding mode Model Following Control or FLSMFC approach is presented. The FLSMFC structure consists of an integrator and variable structure system. The integral control is introduced into it in order to eliminated steady state error due to step and ramp command inputs and improve control precision, while the fuzzy control would maintain the insensitivity to parameter variation and disturbances. The FLSMFC strategy is implemented and applied to a position control of a DC servomotor drives. Experimental results indicated that FLSMFC system performance with respect to the sensitivity to parameter variations is greatly reduced. Also, excellent control effects and avoids the chattering phenomenon.
Abstract: The performance of modified Fenton (MF) treatment
to promote PAH oxidation in artificially contaminated soil was
investigated in packed soil column with a hydrogen peroxide (H2O2)
delivery system simulating in situ injection. Soil samples were spiked
with phenanthrene (low molecular weight PAH) and fluoranthene
(high molecular weight PAH) to an initial concentration of 500
mg/kg dried soil each. The effectiveness of process parameters
H2O2/soil, iron/soil, chelating agent/soil weight ratios and reaction
time were studied using a 24 three level factorial design experiments.
Statistically significant quadratic models were developed using
Response Surface Methodology (RSM) for degrading PAHs from the
soil samples. Optimum operating condition was achieved at mild
range of H2O2/soil, iron/soil and chelating agent/soil weight ratios,
indicating cost efficient method for treating highly contaminated
lands.
Abstract: Microwave energy can be used for drying purpose. It is unique process. It is distinctly different from conventional drying process. It is advantageous over conventional drying / heating processes. When microwave energy is used for drying purpose, the process can be accelerated with a better control to achieve uniform heating, more conversion efficiency, selective drying and ultimately improved product quality of the output. Also, less floor space and compact system are the added advantages. Existing low power microwave drying system is to be modified with suitable applicator. Appropriate sensors are to be used to measure parameters like moisture, temperature, weight of sample. Suitable high tech controller is to be used to control microwave power continuously from minimum to maximum. Phase - controller, cycle - controller and PWM - controller are some of the advanced power control techniques. It has been proposed to work on turmeric using high-tech phase controller to control the microwave power conveniently. The drying of turmeric with microwave energy employing phase controller gives better results as formulated in this paper and hence new approach of processing turmeric will open future doors of profit making to allied industries and the farmers.
Abstract: Scheduling algorithm is a key technology in satellite
switching system with input-buffer. In this paper, a new scheduling
algorithm and its realization are proposed. Based on Crossbar
switching fabric, the algorithm adopts serial scheduling strategy and
adjusts the output port arbitrating strategy for the better equity of every
port. Consequently, it increases the matching probability. The
algorithm can greatly reduce the scheduling delay and cell loss rate.
The analysis and simulation results by OPNET show that the proposed
algorithm has the better performance than others in average delay and
cell loss rate, and has the equivalent complexity. On the basis of these
results, the hardware realization and simulation based on FPGA are
completed, which validate the feasibility of the new scheduling
algorithm.
Abstract: Library management systems are commonly used in
all educational related institutes. Many commercial products are
available. However, many institutions may not be able to afford the
cost of using commercial products. Therefore, an alternative solution
in such situations would be open source software. This paper is
focusing on reviewing open source library management system
packages currently available. The review will focus on the abilities to
perform four basic components which are traditional services,
interlibrary load management, managing electronic materials and
basic common management system such as security, alert system and
statistical reports. In addition, environment, basic requirement and
supporting aspects of each open source package are also mentioned.
Abstract: Image segmentation is an important step in image
processing. Major developments in medical imaging allow
physicians to use potent and non-invasive methods in order to
evaluate structures, performance and to diagnose human diseases. In
this study, an active contour was used to extract vessel networks
from color retina images. Automatic analysis of retina vessels
facilitates calculation of arterial index which is required to diagnose
some certain retinopathies.
Abstract: The primary objective of this research is to improve the flexural capacity of FRP strengthened RC Beam structures with Aluminum and Titanium laminates. FRP rupture of flexural strengthened RC beams using FRP plates generally occurs at the interface between FRP plate and the beam. Therefore, in order to prevent brittle rupture and improve the ductility of the system, this research was performed by using Aluminum and Titanium materials between the two different structural systems. The research also aims to provide various strengthening/retrofitting methods for RC beam structures and to conduct a preliminary analysis of the demands on the structural systems. This was achieved by estimation using the experimental data from this research to identify a flexural capacity for the systems. Ultimately, the preliminary analysis of current study showed that the flexural capacity and system demand ductility was significantly improved by the systems inserted with Aluminum and Titanium anchor plates. Further verification of the experimental research is currently on its way to develop a new or reliable design guideline to retrofit/strengthen the concrete-FRP structural system can be evaluated.
Abstract: To improve the dynamics response of the vehicle
passive suspension, a two-terminal mass is suggested to connect in
parallel with the suspension strut. Three performance criteria, tire grip,
ride comfort and suspension deflection, are taken into consideration to
optimize the suspension parameters. However, the three criteria are
conflicting and non-commensurable. For this reason, the Chebyshev
goal programming method is applied to find the best tradeoff among
the three objectives. A simulation case is presented to describe the
multi-objective optimization procedure. For comparison, the
Chebyshev method is also employed to optimize the design of a
conventional passive suspension. The effectiveness of the proposed
design method has been clearly demonstrated by the result. It is also
shown that the suspension with a two-terminal mass in parallel has
better performance in terms of the three objectives.
Abstract: This paper presents a review of an 8-year study on radiation effects in commercial memory devices operating within the main on-board computer system OBC386 of the Algerian microsatellite Alsat-1. A statistical analysis of single-event upset (SEU) and multiple-bit upset (MBU) activity in these commercial memories shows that the typical SEU rate at alsat-1's orbit is 4.04 × 10-7 SEU/bit/day, where 98.6% of these SEUs cause single-bit errors, 1.22% cause double-byte errors, and the remaining SEUs result in multiple-bit and severe errors.
Abstract: Region covariance (RC) descriptor is an effective
and efficient feature for visual tracking. Current RC-based tracking
algorithms use the whole RC matrix to track the target in video
directly. However, there exist some issues for these whole RCbased
algorithms. If some features are contaminated, the whole RC
will become unreliable, which results in lost object-tracking. In
addition, if some features are very discriminative to the
background, other features are still processed and thus reduce the
efficiency. In this paper a new robust tracking method is proposed,
in which the whole RC matrix is decomposed into several low rank
matrices. Those matrices are dynamically chosen and processed so
as to achieve a good tradeoff between discriminability and
complexity. Experimental results have shown that our method is
more robust to complex environment changes, especially either
when occlusion happens or when the background is similar to the
target compared to other RC-based methods.
Abstract: The early diagnostic decision making in industrial processes is absolutely necessary to produce high quality final products. It helps to provide early warning for a special event in a process, and finding its assignable cause can be obtained. This work presents a hybrid diagnostic schmes for batch processes. Nonlinear representation of raw process data is combined with classification tree techniques. The nonlinear kernel-based dimension reduction is executed for nonlinear classification decision boundaries for fault classes. In order to enhance diagnosis performance for batch processes, filtering of the data is performed to get rid of the irrelevant information of the process data. For the diagnosis performance of several representation, filtering, and future observation estimation methods, four diagnostic schemes are evaluated. In this work, the performance of the presented diagnosis schemes is demonstrated using batch process data.
Abstract: Biogas, a clean renewable energy, is attracting a growing
concern of researchers and professionals in many fields. Based
on the natural and climatic conditions in semi-arid regions of northwestern
China, the present study introduces a specifically-designed
family-size biogas plant (with a digester of 10m3) with manure
and urine of animals and humanity as raw materials. The biogas
plant is applicable to areas with altitudes of more than 2000 meters
in northwestern China. In addition to the installation cost, a little
operational expenditure, structure, characteristics, benefits of this
small-scale biogas plant, this article introduces a wide range of
specific popularization methods such as training, financial support,
guided tour to the biogas plant, community-based group study and
delivery of operational manuals. The feasibility of the biogas plant is
explored on the basis of the availability of the raw materials. Simple
operations contained in the current work increase the possibility of
the wide use of this small-scale biogas plant in similar regions of the
world.
Abstract: The study area receives a wide variety of wastes
generated by municipalities and the industries like paints and
pigments, metal processing industries, thermal power plants electroprocessing
industries etc. The Physico-chemical and structural
investigation of water from river Pandu indicated high level of
chlorides and calcium which made the water unsuitable for human
use. Algae like Cyclotella fumida, Asterionella Formosa,
Cladophora glomerata, Pediastrum simplex, Scenedesmus bijuga,
Cladophora glomerata were the dominant pollution tolerant species
recorded under these conditions. The sensitive and less abundant
species of algae included Spirogyra sps., Merismopedia sps. The
predominance colonies of Zygnema sps, Phormidium sps,
Mycrocystis aeruginosa, Merismopedia minima, Pandorina morum,
seems to correlate with high organic contents of Pandu river water.
This study assumes significance as some algae can be used as
bioindicators of water pollution and algal floral of a municipal drain
carrying waste effluents from industrial area Kanpur and discharge
them into the river Pandu flowing onto southern outskirts of Kanpur
city.