Abstract: Perth will run out of available sustainable natural
water resources by 2015 if nothing is done to slow usage rates,
according to a Western Australian study [1]. Alternative water
technology options need to be considered for the long-term
guaranteed supply of water for agricultural, commercial, domestic
and industrial purposes. Seawater is an alternative source of water for
human consumption, because seawater can be desalinated and
supplied in large quantities to a very high quality.
While seawater desalination is a promising option, the technology
requires a large amount of energy which is typically generated from
fossil fuels. The combustion of fossil fuels emits greenhouse gases
(GHG) and, is implicated in climate change. In addition to
environmental emissions from electricity generation for desalination,
greenhouse gases are emitted in the production of chemicals and
membranes for water treatment. Since Australia is a signatory to the
Kyoto Protocol, it is important to quantify greenhouse gas emissions
from desalinated water production.
A life cycle assessment (LCA) has been carried out to determine
the greenhouse gas emissions from the production of 1 gigalitre (GL)
of water from the new plant. In this LCA analysis, a new desalination
plant that will be installed in Bunbury, Western Australia, and known
as Southern Seawater Desalinization Plant (SSDP), was taken as a
case study. The system boundary of the LCA mainly consists of three
stages: seawater extraction, treatment and delivery. The analysis
found that the equivalent of 3,890 tonnes of CO2 could be emitted
from the production of 1 GL of desalinated water. This LCA analysis
has also identified that the reverse osmosis process would cause the
most significant greenhouse emissions as a result of the electricity
used if this is generated from fossil fuels
Abstract: As an economic and safe structure, Bi-steel is widely
used in reinforced concrete with less consumption of steel. In this
paper, III Bi-steel concrete beam has been analyzed. Through careful
observation and theoretical analysis, the new calculating formulae for
structural rigidity and crack have been formulated for this Bi-steel
concrete beam. And structural rigidity and the crack features have also
been theoretically analyzed.
Abstract: This paper describes a method of modeling to model
shadow play puppet using sophisticated computer graphics techniques
available in OpenGL in order to allow interactive play in real-time
environment as well as producing realistic animation. This paper
proposes a novel real-time method is proposed for modeling of puppet
and its shadow image that allows interactive play of virtual shadow
play using texture mapping and blending techniques. Special effects
such as lighting and blurring effects for virtual shadow play
environment are also developed. Moreover, the use of geometric
transformations and hierarchical modeling facilitates interaction
among the different parts of the puppet during animation. Based on the
experiments and the survey that were carried out, the respondents
involved are very satisfied with the outcomes of these techniques.
Abstract: Wastages such as grated coconut meat, spent tea and used sugarcane had contributed negative impacts to the environment. Vermicomposting method is fully utilized to manage the wastes towards a more sustainable approach. The worms that are used in the vermicomposting are Eisenia foetida and Eudrillus euginae. This research shows that the vermicompost of wastages has voltage of electrical energy and is able to light up the Light-Emitting Diode (LED) device. Based on the experiment, the use of replicated and double compartments of the component will produce double of voltage. Hence, for conclusion, this harmless and low cost technology of vermicompost can act as a dry cell in order to reduce the usage of hazardous chemicals that can contaminate the environment.
Abstract: The resistive-inductive-capacitive behavior of long
interconnects which are driven by CMOS gates are presented in this
paper. The analysis is based on the ¤Ç-model of a RLC load and is
developed for submicron devices. Accurate and analytical
expressions for the output load voltage, the propagation delay and the
short circuit power dissipation have been proposed after solving a
system of differential equations which accurately describe the
behavior of the circuit. The effect of coupling capacitance between
input and output and the short circuit current on these performance
parameters are also incorporated in the proposed model. The
estimated proposed delay and short circuit power dissipation are in
very good agreement with the SPICE simulation with average
relative error less than 6%.
Abstract: This research paper presents some methods to assess the performance of Wigner Ville Distribution for Time-Frequency representation of non-stationary signals, in comparison with the other representations like STFT, Spectrogram etc. The simultaneous timefrequency resolution of WVD is one of the important properties which makes it preferable for analysis and detection of linear FM and transient signals. There are two algorithms proposed here to assess the resolution and to compare the performance of signal detection. First method is based on the measurement of area under timefrequency plot; in case of a linear FM signal analysis. A second method is based on the instantaneous power calculation and is used in case of transient, non-stationary signals. The implementation is explained briefly for both methods with suitable diagrams. The accuracy of the measurements is validated to show the better performance of WVD representation in comparison with STFT and Spectrograms.
Abstract: Term Extraction, a key data preparation step in Text
Mining, extracts the terms, i.e. relevant collocation of words,
attached to specific concepts (e.g. genetic-algorithms and decisiontrees
are terms associated to the concept “Machine Learning" ). In
this paper, the task of extracting interesting collocations is achieved
through a supervised learning algorithm, exploiting a few
collocations manually labelled as interesting/not interesting. From
these examples, the ROGER algorithm learns a numerical function,
inducing some ranking on the collocations. This ranking is optimized
using genetic algorithms, maximizing the trade-off between the false
positive and true positive rates (Area Under the ROC curve). This
approach uses a particular representation for the word collocations,
namely the vector of values corresponding to the standard statistical
interestingness measures attached to this collocation. As this
representation is general (over corpora and natural languages),
generality tests were performed by experimenting the ranking
function learned from an English corpus in Biology, onto a French
corpus of Curriculum Vitae, and vice versa, showing a good
robustness of the approaches compared to the state-of-the-art Support
Vector Machine (SVM).
Abstract: A numerical method for Riccati equation is presented in this work. The method is based on the replacement of unknown functions through a truncated series of hybrid of block-pulse functions and Chebyshev polynomials. The operational matrices of derivative and product of hybrid functions are presented. These matrices together with the tau method are then utilized to transform the differential equation into a system of algebraic equations. Corresponding numerical examples are presented to demonstrate the accuracy of the proposed method.
Abstract: The permanent magnet synchronous motor (PMSM) is
very useful in many applications. Vector control of PMSM is popular
kind of its control. In this paper, at first an optimal vector control for
PMSM is designed and then results are compared with conventional
vector control. Then, it is assumed that the measurements are noisy
and linear quadratic Gaussian (LQG) methodology is used to filter
the noises. The results of noisy optimal vector control and filtered
optimal vector control are compared to each other. Nonlinearity of
PMSM and existence of inverter in its control circuit caused that the
system is nonlinear and time-variant. With deriving average model,
the system is changed to nonlinear time-invariant and then the
nonlinear system is converted to linear system by linearization of
model around average values. This model is used to optimize vector
control then two optimal vector controls are compared to each other.
Simulation results show that the performance and robustness to noise
of the control system has been highly improved.
Abstract: Network management techniques have long been of
interest to the networking research community. The queue size plays
a critical role for the network performance. The adequate size of the
queue maintains Quality of Service (QoS) requirements within
limited network capacity for as many users as possible. The
appropriate estimation of the queuing model parameters is crucial for
both initial size estimation and during the process of resource
allocation. The accurate resource allocation model for the
management system increases the network utilization. The present
paper demonstrates the results of empirical observation of memory
allocation for packet-based services.
Abstract: Light is one of the most important qualitative and
symbolic factors and has a special position in architecture and urban
development in regard to practical function. The main function of
light, either natural or artificial, is lighting up the environment and
the constructional forms which is called lighting. However, light is
used to redefine the urban spaces by architectural genius with regard
to three aesthetic, conceptual and symbolic factors. In architecture
and urban development, light has a function beyond lighting up the
environment, and the designers consider it as one of the basic
components. The present research aims at studying the function of
light and color in architectural view and their effects in buildings.
Abstract: Cross sections of As radionuclides in the interaction of natGe with 14-30 MeV protons have been deduced by off-line y-ray spectroscopy to find optimal reaction channels leading to radiotracers for positron emission tomography. The experimental results were compared with the previous results and those estimated by the compound nucleus reaction model.
Abstract: The computer, among the most important inventions of the twentieth century, has become an increasingly important component in our everyday lives. Computer games also have become increasingly popular among people day-by-day, owing to their features based on realistic virtual environments, audio and visual features, and the roles they offer players. In the present study, the metaphors students have for computer games are investigated, as well as an effort to fill the gap in the literature. Students were asked to complete the sentence—‘Computer game is like/similar to….because….’— to determine the middle school students’ metaphorical images of the concept for ‘computer game’. The metaphors created by the students were grouped in six categories, based on the source of the metaphor. These categories were ordered as ‘computer game as a means of entertainment’, ‘computer game as a beneficial means’, ‘computer game as a basic need’, ‘computer game as a source of evil’, ‘computer game as a means of withdrawal’, and ‘computer game as a source of addiction’, according to the number of metaphors they included.
Abstract: The traditional software product and process metrics
are neither suitable nor sufficient in measuring the complexity of
software components, which ultimately is necessary for quality and
productivity improvement within organizations adopting CBSE.
Researchers have proposed a wide range of complexity metrics for
software systems. However, these metrics are not sufficient for
components and component-based system and are restricted to the
module-oriented systems and object-oriented systems. In this
proposed study it is proposed to find the complexity of the JavaBean
Software Components as a reflection of its quality and the component
can be adopted accordingly to make it more reusable. The proposed
metric involves only the design issues of the component and does not
consider the packaging and the deployment complexity. In this way,
the software components could be kept in certain limit which in turn
help in enhancing the quality and productivity.
Abstract: In 2002 an amendment to SOLAS opened for
lightweight material constructions in vessels if the same fire safety as
in steel constructions could be obtained. FISPAT (FIreSPread
Analysis Tool) is a computer application that simulates fire spread
and fault injection in cruise vessels and identifies fire sensitive areas.
It was developed to analyze cruise vessel designs and provides a
method to evaluate network layout and safety of cruise vessels. It
allows fast, reliable and deterministic exhaustive simulations and
presents the result in a graphical vessel model. By performing the
analysis iteratively while altering the cruise vessel design it can be
used along with fire chamber experiments to show that the
lightweight design can be as safe as a steel construction and that
SOLAS regulations are fulfilled.
Abstract: The influence of full-fat soy flour (FFSF) and
extrusion conditions on the mechanical characteristics of dry
spaghetti were evaluated. Process was performed with screw speed of
10-40rpm and water circulating temperature of 35-70°C. Data
analysis using mixture design showed that this enrichment resulted in
significant differences in mechanical strength.
Abstract: This paper deals with the development of a Jacobean model for a 4-axes indigenously developed scara robot arm in the laboratory. This model is used to study the relation between the velocities and the forces in the robot while it is doing the pick and place operation.
Abstract: This paper presents a method to support dynamic
packing in cases when no collision-free path can be found. The
method, which is primarily based on path planning and shrinking of
geometries, suggests a minimal geometry design change that results
in a collision-free assembly path. A supplementing approach to
optimize geometry design change with respect to redesign cost is
described. Supporting this dynamic packing method, a new method
to shrink geometry based on vertex translation, interweaved with
retriangulation, is suggested. The shrinking method requires neither
tetrahedralization nor calculation of medial axis and it preserves the
topology of the geometry, i.e. holes are neither lost nor introduced.
The proposed methods are successfully applied on industrial
geometries.
Abstract: This research presented in this paper is an on-going
project of an application of neural network and fuzzy models to
evaluate the sociological factors which affect the educational
performance of the students in Sri Lanka. One of its major goals is to
prepare the grounds to device a counseling tool which helps these
students for a better performance at their examinations, especially at
their G.C.E O/L (General Certificate of Education-Ordinary Level)
examination. Closely related sociological factors are collected as raw
data and the noise of these data are filtered through the fuzzy
interface and the supervised neural network is being utilized to
recognize the performance patterns against the chosen social factors.
Abstract: In this paper discrete choice models, Logit and Probit
are examined in order to predict the economic recession or expansion
periods in USA. Additionally we propose an adaptive neuro-fuzzy
inference system with triangular membership function. We examine
the in-sample period 1947-2005 and we test the models in the out-of
sample period 2006-2009. The forecasting results indicate that the
Adaptive Neuro-fuzzy Inference System (ANFIS) model outperforms
significant the Logit and Probit models in the out-of sample period.
This indicates that neuro-fuzzy model provides a better and more
reliable signal on whether or not a financial crisis will take place.