Abstract: The quality and shelf life of foods of containing lipids (fats and oils) significantly reduces due to rancidity.Applications of natural antioxidants are one of the most effective manners to prevent the oxidation of oils and lipids. The antioxidant properties of juice extracted from barberry fruit (Berberris vulgaris.L) using maceration and SWE (10 bars and 120 - 180°C) methods were investigated and compared with conventional method. The amount of phenolic compound and reduction power of all samples were determined and the data were statistically analyzed using multifactor design. The results showed that the total amount of phenolic compound increased with increasing of pressure and temprature from 1861.9 to 2439.1 (mg Gallic acid /100gr Dry matter). The ability of reduction power of SWE obtained antioxidant extract compared with BHA (synthetic antioxidant) and ascorbic acid (natural antioxidant). There were significant differences among reduction power of extracts and there were remarkable difference with BHA and Ascorbic acid (P
Abstract: The compression-absorption heat pump (C-A HP), one
of the promising heat recovery equipments that make process hot
water using low temperature heat of wastewater, was evaluated by
computer simulation. A simulation program was developed based on
the continuity and the first and second laws of thermodynamics. Both
the absorber and desorber were modeled using UA-LMTD method. In
order to prevent an unfeasible temperature profile and to reduce
calculation errors from the curved temperature profile of a mixture,
heat loads were divided into lots of segments. A single-stage
compressor was considered. A compressor cooling load was also
taken into account. An isentropic efficiency was computed from the
map data. Simulation conditions were given based on the system
consisting of ordinarily designed components. The simulation results
show that most of the total entropy generation occurs during the
compression and cooling process, thus suggesting the possibility that
system performance can be enhanced if a rectifier is introduced.
Abstract: This article presents the developments of efficient
algorithms for tablet copies comparison. Image recognition has
specialized use in digital systems such as medical imaging,
computer vision, defense, communication etc. Comparison between
two images that look indistinguishable is a formidable task. Two
images taken from different sources might look identical but due to
different digitizing properties they are not. Whereas small variation
in image information such as cropping, rotation, and slight
photometric alteration are unsuitable for based matching
techniques. In this paper we introduce different matching
algorithms designed to facilitate, for art centers, identifying real
painting images from fake ones. Different vision algorithms for
local image features are implemented using MATLAB. In this
framework a Table Comparison Computer Tool “TCCT" is
designed to facilitate our research. The TCCT is a Graphical Unit
Interface (GUI) tool used to identify images by its shapes and
objects. Parameter of vision system is fully accessible to user
through this graphical unit interface. And then for matching, it
applies different description technique that can identify exact
figures of objects.
Abstract: In this paper we propose a Multiple Description Image Coding(MDIC) scheme to generate two compressed and balanced rates descriptions in the wavelet domain (Daubechies biorthogonal (9, 7) wavelet) using pairwise correlating transform optimal and application method for Generalized Multiple Description Coding (GMDC) to image coding in the wavelet domain. The GMDC produces statistically correlated streams such that lost streams can be estimated from the received data. Our performance test shown that the proposed method gives more improvement and good quality of the reconstructed image when the wavelet coefficients are normalized by Gaussian Scale Mixture (GSM) model then the Gaussian one ,.
Abstract: This paper presents modeling and analysis of 12-phase distribution static compensator (DSTATCOM), which is capable of balancing the source currents in spite of unbalanced loading and phase outages. In addition to balance the supply current, the power factor can be set to a desired value. The theory of instantaneous symmetrical components is used to generate the twelve-phase reference currents. These reference currents are then tracked using current controlled voltage source inverter, operated in a hysteresis band control scheme. An ideal compensator in place of physical realization of the compensator is used. The performance of the proposed DTATCOM is validated through MATLAB simulation and detailed simulation results are given.
Abstract: Medical Tourism is a new development in Taiwan
recently. The willingness and barriers of potential tourists from
China to participate medical tourism are studied. A questionnaire
survey is conducted and the SPSS software is used to analyze data.
The results show that under one fifth of respondents express full
medical tourism participation willingness. Among travel barriers
toward medical tourism, “insufficient information of medical tourism
trip", “not enough time", “no companion", “worrying about
unsatisfied itinerary." are perceived the most important barriers.
Abstract: The increasing demand for sufficient and clean
energy forces industrial and service companies to align their strategies towards efficient consumption. This trend refers also to the
residential building sector. There, large amounts of energy consumption are caused by house and facility heating. Many of the
operated hot water heating systems lack hydraulic balanced working
conditions for heat distribution and –transmission and lead to
inefficient heating. Through hydraulic balancing of heating systems,
significant energy savings for primary and secondary energy can be
achieved. This paper addresses the use of KNX-technology (Smart
Buildings) in residential buildings to ensure a dynamic adaption of
hydraulic system's performance, in order to increase the heating
system's efficiency. In this paper, the procedure of heating system
segmentation into hydraulically independent units (meshes) is
presented. Within these meshes, the heating valve are addressed and
controlled by a central facility server. Feasibility criteria towards
such drivers will be named. The dynamic hydraulic balance is
achieved by positioning these valves according to heating loads, that
are generated from the temperature settings in the corresponding
rooms. The energetic advantages of single room heating control
procedures, based on the application FacilityManager, is presented.
Abstract: With the advance of information technology in the
new era the applications of Internet to access data resources has
steadily increased and huge amount of data have become accessible
in various forms. Obviously, the network providers and agencies,
look after to prevent electronic attacks that may be harmful or may
be related to terrorist applications. Thus, these have facilitated the
authorities to under take a variety of methods to protect the special
regions from harmful data. One of the most important approaches is
to use firewall in the network facilities. The main objectives of
firewalls are to stop the transfer of suspicious packets in several
ways. However because of its blind packet stopping, high process
power requirements and expensive prices some of the providers are
reluctant to use the firewall. In this paper we proposed a method to
find a discriminate function to distinguish between usual packets and
harmful ones by the statistical processing on the network router logs.
By discriminating these data, an administrator may take an approach
action against the user. This method is very fast and can be used
simply in adjacent with the Internet routers.
Abstract: Stream Control Transmission Protocol (SCTP) has been
proposed to provide reliable transport of real-time communications.
Due to its attractive features, such as multi-streaming and multihoming,
the SCTP is often expected to be an alternative protocol
for TCP and UDP. In the original SCTP standard, the secondary path
is mainly regarded as a redundancy. Recently, most of researches
have focused on extending the SCTP to enable a host to send its
packets to a destination over multiple paths simultaneously. In order
to transfer packets concurrently over the multiple paths, the SCTP
should be well designed to avoid unnecessary fast retransmission
and the mis-estimation of congestion window size through the paths.
Therefore, we propose an Enhanced Cooperative ACK SCTP (ECASCTP)
to improve the path recovery efficiency of multi-homed host
which is under concurrent multiple transfer mode. We evaluated the
performance of our proposed scheme using ns-2 simulation in terms
of cwnd variation, path recovery time, and goodput. Our scheme
provides better performance in lossy and path asymmetric networks.
Abstract: The present microfluidic study is emphasizing the flow behavior within a Y shape micro-bifurcation in two similar flow configurations. We report here a numerical and experimental investigation on the velocity profiles evolution and secondary flows, manifested at different Reynolds numbers (Re) and for two different boundary conditions. The experiments are performed using special designed setup based on optical microscopic devices. With this setup, direct visualizations and quantitative measurements of the path-lines are obtained. A Micro-PIV measurement system is used to obtain velocity profiles distributions in a spatial evolution in the main flows domains. The experimental data is compared with numerical simulations performed with commercial computational code FLUENT in a 3D geometry with the same dimensions as the experimental one. The numerical flow patterns are found to be in good agreement with the experimental manifestations.
Abstract: The photochemical and photo-Fenton oxidation of 1,3-dichloro-2-propanol was performed in a batch reactor, at room temperature, using UV radiation, H2O2 as oxidant, and Fenton-s reagent. The effect of the oxidative agent-s initial concentration was investigated as well as the effect of the initial concentration of Fe(II) by following the target compound degradation, the total organic carbon removal and the chloride ion production. Also, from the kinetic analysis conducted and proposed reaction scheme it was deduced that the addition of Fe(II) significantly increases the production and the further oxidation of the chlorinated intermediates.
Abstract: The aim of this study is to investigate the effect of
perceived social support and stress on the coping capability and level
of depression of foreign and local students in Malaysia. Using
convenience sampling, 200 students from three universities in
Selangor, Malaysia participated in the study. The results of this study
revealed that there was a significant relationship between perceived
social support and coping capability. It is also found that there is a
negative relationship between coping capability and depression.
Further, stress and depression are positively related whereas stress
and coping capability are negatively related. Lastly, there is no
significant difference for the stress level and coping capability
amongst local and foreign students.
Abstract: A new dual-fluid concept was studied that could eventually find application for cold-gas propulsion for small space satellites or other constant flow applications. In basic form, the concept uses two different refrigerant working fluids, each having a different saturation vapor pressure. The higher vapor pressure refrigerant remains in the saturation phase and is used to pressurize the lower saturation vapor pressure fluid (the propellant) which remains in the compressed liquid phase. A demonstration thruster concept based on this principle was designed and built to study its operating characteristics. An automotive-type electronic fuel injector was used to meter and deliver the propellant. Ejected propellant mass and momentum were measured for several combinations of refrigerants and hydrocarbon fluids. The thruster has the advantage of delivering relatively large total impulse at low tank pressure within a small volume.
Abstract: Today, the working areas put forward the administration of change. In order to provide this; it is required from the organizations to be creative. Professional creativity in offices depends on an environment that enables the development of the organization only after the individual or collective exertions within the organization. By providing this environment, the organization will gain efficiency, productivity, and work pleasure. In order to bring up the workforce appropriate to the related expectations, the professional creativity of the office management and secretarial profession candidates should be evaluated, education programs appropriate to this and related directly with the service quality should be prepared and the future of this profession should be directed. The aim of this study is to ensure the attention to improve the prepared education program as well as the creative thoughts and their applications, when carrying out an office management and secretarial training. 144 students took place in this research and a questionnaire of 48 questions was carried out.
Abstract: In the present investigation, H13 tool steel has been
deposited on copper alloy substrate using both CO2 and diode laser.
A detailed parametric analysis has been carried out in order to find
out optimum processing zone for coating defect free H13 tool steel
on copper alloy substrate. Followed by parametric optimization, the
microstructure and microhardness of the deposited clads have been
evaluated. SEM micrographs revealed dendritic microstructure in
both clads. However, the microhardness of CO2 laser deposited clad
was much higher compared to diode laser deposited clad.
Abstract: This paper addresses the development of an intelligent vision system for human-robot interaction. The two novel contributions of this paper are 1) Detection of human faces and 2) Localizing the eye. The method is based on visual attributes of human skin colors and geometrical analysis of face skeleton. This paper introduces a spatial domain filtering method named ?Fuzzily skewed filter' which incorporates Fuzzy rules for deciding the gray level of pixels in the image in their neighborhoods and takes advantages of both the median and averaging filters. The effectiveness of the method has been justified over implementing the eye tracking commands to an entertainment robot, named ''AIBO''.
Abstract: Perceptions of quality from both designers and users
perspective have now stretched beyond the traditional usability,
incorporating abstract and subjective concepts. This has led to a shift
in human computer interaction research communities- focus; a shift
that focuses on achieving user experience (UX) by not only fulfilling
conventional usability needs but also those that go beyond them. The
term UX, although widely spread and given significant importance,
lacks consensus in its unified definition. In this paper, we survey
various UX definitions and modeling frameworks and examine them
as the foundation for proposing a UX evolution lifecycle framework
for understanding UX in detail. In the proposed framework we identify
the building blocks of UX and discuss how UX evolves in various
phases. The framework can be used as a tool to understand experience
requirements and evaluate them, resulting in better UX design and
hence improved user satisfaction.
Abstract: Covering-based rough sets is an extension of rough
sets and it is based on a covering instead of a partition of the
universe. Therefore it is more powerful in describing some practical
problems than rough sets. However, by extending the rough sets,
covering-based rough sets can increase the roughness of each model
in recognizing objects. How to obtain better approximations from
the models of a covering-based rough sets is an important issue.
In this paper, two concepts, determinate elements and indeterminate
elements in a universe, are proposed and given precise definitions
respectively. This research makes a reasonable refinement of the
covering-element from a new viewpoint. And the refinement may
generate better approximations of covering-based rough sets models.
To prove the theory above, it is applied to eight major coveringbased
rough sets models which are adapted from other literature.
The result is, in all these models, the lower approximation increases
effectively. Correspondingly, in all models, the upper approximation
decreases with exceptions of two models in some special situations.
Therefore, the roughness of recognizing objects is reduced. This
research provides a new approach to the study and application of
covering-based rough sets.
Abstract: Blind signatures enable users to obtain valid signatures for a message without revealing its content to the signer. This paper presents a new blind signature scheme, i.e. identity-based blind signature scheme with message recovery. Due to the message recovery property, the new scheme requires less bandwidth than the identitybased blind signatures with similar constructions. The scheme is based on modified Weil/Tate pairings over elliptic curves, and thus requires smaller key sizes for the same level of security compared to previous approaches not utilizing bilinear pairings. Security and efficiency analysis for the scheme is provided in this paper.
Abstract: With the intention of screening for heavy metal
tolerance, a number of bacteria were isolated and characterized from
a pristine soil. Two Gram positive isolates were identified as
Paenibacillus sp. and Bacillus thuringeinsis. Tolerance of Cd2+, Cu2+
and Zn2+ by these bacteria was studied and found that both bacteria
were highly sensitive to Cu2+ compared to other two metals. Both
bacteria showed the same pattern of metal tolerance in the order Zn+
> Cd2+ > Cu2+. When the metal tolerance in both bacteria was
compared, Paenibacillus sp. showed the highest sensitivity to Cu2+
where as B. thuringiensis showed highest sensitivity to Cd2+ and Zn2+
.These findings revealed the potential of Paenibacillus sp. in
developing a biosensor to detect Cu2+ in environmental samples.