Abstract: This article analyses conspiracy theories as part of the
wider discourses of missionary politics. It presents a case study of
Venezuela and describes how its leaders use conspiracy theories as
political tools. Through quotes taken form Venezuelan president
Chavez-s public speeches and other sources, and through a short
analysis of the ideological basis of his discourses, it shows how
conspiracy theories are constructed and how they affect the local
political praxis. The article also describes how conspiracy theories
have been consistently used as an important part of the construction of
a political religion for the New Man of the Bolivarian Revolution. It
concludes that the use of conspiracy theories by political leaders
produces a sense of loss of political agency.
Abstract: Aggregation behavior of sodium salicylate and sodium cumene sulfonate was studied in aqueous solution at different temperature. Specific conductivity and relative viscosity were measured at different temperature to find minimum hydrotropic concentration. The thermodynamic parameters (free energy, enthalpy and entropy) were evaluated in the temperature range of 30°C-70°C. The free energy decreased with increase in temperature. The aggregation was found to be exothermic in nature and favored by positive value of entropy.
Abstract: The study of the fouling deposition of pink guava
juice (PGJ) is relatively new research compared to milk fouling
deposit. In this work, a new experimental set-up was developed to
imitate the fouling formation in heat exchanger, namely a continuous
flow experimental set-up heat exchanger. The new experimental setup
was operated under industrial pasteurization temperature of PGJ,
which was at 93°C. While the flow rate and pasteurization period
were based on the experimental capacity, which were 0.5 and 1
liter/min for the flow rate and the pasteurization period was set for 1
hour. Characterization of the fouling deposit was determined by
using various methods. Microstructure of the deposits was carried
out using ESEM. Proximate analyses were performed to determine
the composition of moisture, fat, protein, fiber, ash and carbohydrate
content. A study on the hardness and stickiness of the fouling deposit
was done using a texture analyzer. The presence of seedstone in pink
guava juice was also analyzed using a particle analyzer. The findings
shown that seedstone from pink guava juice ranging from 168 to
200μm and carbohydrate was found to be a major composition
(47.7% of fouling deposit consists of carbohydrate). Comparison
between the hardness and stickiness of the deposits at two different
flow rates showed that fouling deposits were harder and denser at
higher flow rate. Findings from this work provide basis knowledge
for further study on fouling and cleaning of PGJ.
Abstract: 98% of the energy needed in Taiwan has been
imported. The prices of petroleum and electricity have been
increasing. In addition, facility capacity, amount of electricity
generation, amount of electricity consumption and number of Taiwan
Power Company customers have continued to increase. For these
reasons energy conservation has become an important topic. In the
past linear regression was used to establish the power consumption
models for chillers. In this study, grey prediction is used to evaluate
the power consumption of a chiller so as to lower the total power
consumption at peak-load (so that the relevant power providers do not
need to keep on increasing their power generation capacity and facility
capacity).
In grey prediction, only several numerical values (at least four
numerical values) are needed to establish the power consumption
models for chillers. If PLR, the temperatures of supply chilled-water
and return chilled-water, and the temperatures of supply cooling-water
and return cooling-water are taken into consideration, quite accurate
results (with the accuracy close to 99% for short-term predictions)
may be obtained. Through such methods, we can predict whether the
power consumption at peak-load will exceed the contract power
capacity signed by the corresponding entity and Taiwan Power
Company. If the power consumption at peak-load exceeds the power
demand, the temperature of the supply chilled-water may be adjusted
so as to reduce the PLR and hence lower the power consumption.
Abstract: This paper discusses the utilization of marine biomass as an energy resource in Japan. A marine biomass energy system in Japan was proposed consisting of seaweed cultivation (Laminaria japonica) at offshore marine farms, biogas production via methane fermentation of the seaweeds, and fuel cell power generation driven by the generated biogas. We estimated energy output, energy supply potential, and CO2 mitigation in Japan on the basis of the proposed system. As a result, annual energy production was estimated to be 1.02-109 kWh/yr at nine available sites. Total CO2 mitigation was estimated to be 1.04-106 tonnes per annum at the nine sites. However, the CO2 emission for the construction of relevant facilities is not taken into account in this paper. The estimated CO2 mitigation is equivalent to about 0.9% of the required CO2 mitigation for Japan per annum under the Kyoto Protocol framework.
Abstract: In recent methodological articles related to structural equation modeling (SEM), the question of how to measure endogenous formative variables has been raised as an urgent, unresolved issue. This research presents an empirical application from the CRM system development context to test a recently developed technique, which makes it possible to measure endogenous formative constructs in structural models. PLS path modeling is used to demonstrate the feasibility of measuring antecedent relationships at the formative indicator level, not the formative construct level. Empirical results show that this technique is a promising approach to measure antecedent relationships of formative constructs in SEM.
Abstract: In this paper, naturally immobilized lipase, Carica
papaya lipase, catalyzed biodiesel production from fish oil was
studied. The refined fish oil, extracted from the discarded parts of
fish, was used as a starting material for biodiesel production. The
effects of molar ratio of oil: methanol, lipase dosage, initial water
activity of lipase, temperature and solvent were investigated. It was
found that Carica papaya lipase was suitable for methanolysis of fish
oil to produce methyl ester. The maximum yield of methyl ester
could reach up to 83% with the optimal reaction conditions: oil:
methanol molar ratio of 1: 4, 20% (based on oil) of lipase, initial
water activity of lipase at 0.23 and 20% (based on oil) of tert-butanol
at 40oC after 18 h of reaction time. There was negligible loss in
lipase activity even after repeated use for 30 cycles.
Abstract: Motion detection is very important in image
processing. One way of detecting motion is using optical flow.
Optical flow cannot be computed locally, since only one independent
measurement is available from the image sequence at a point, while
the flow velocity has two components. A second constraint is needed.
The method used for finding the optical flow in this project is
assuming that the apparent velocity of the brightness pattern varies
smoothly almost everywhere in the image. This technique is later
used in developing software for motion detection which has the
capability to carry out four types of motion detection. The motion
detection software presented in this project also can highlight motion
region, count motion level as well as counting object numbers. Many
objects such as vehicles and human from video streams can be
recognized by applying optical flow technique.
Abstract: The purpose of this study is to suggest direction for
future study of the energy-IT industry that will be used for framework to increase IT utilization in the energy industry. Recently, Green IT is a becoming global issue because of global environmental pollution.
Also, IT roles in energy industry are becoming more important.
However, the related studies were IT industry oriented that is not sufficient to make plan for Green energy. Therefore, after analyzing
existing studies related to Green energy and Green IT,
re-categorization for Green energy-IT industry was suggested. Direction of framework is based on energy industry that enable to link between energy and IT. The results of this study suggest comprehensive insight to Green energy-IT industry. Thus it is able to
provide useful implications and guidelines to increase IT utilization in the energy industry.
Abstract: In this paper we present a linear autozeroing ultra lowvoltage amplifier. The autozeroing performed by all ULV circuits is important to reduce the impact of noise and especially avoid power supply noise in mixed signal low-voltage CMOS circuits. The simulated data presented is relevant for a 90nm TSMC CMOS process.
Abstract: The use and management of projects has risen to
a new prominence, with projects seen as critical to economic in
both the private and public sectors due challenging and dynamic
business environment. However, failure in managing project is
encountered regularly, which cause the waste of company
resources. The impacts of projects that failed to meet
stakeholders expectations have left behind long lasting negative
consequences in organization. Therefore, this research aims to
investigate on key success factors of project management in an
organization. It is believed that recognizing important factors
that contribute to successful project will help companies to
increase the overall profitability. 150 questionnaires were
distributed to respondents and 110 questionnaires were collected
and used in performing the data analysis. The result has strongly
supported the relationship between independent variables and
project performance.
Abstract: RFID tag is a small and inexpensive microchip which is
capable of transmitting unique identifier through wireless network in a
short distance. If a group of RFID tags can be scanned simultaneously
by one reader, RFID Group proof could be generated. Group proof can
be used in various applications, such as good management which is
usually achieved using barcode system. A lot of RFID group proof
schemes have been proposed by many researchers. In this paper, we
introduce some existing group proof schemes and then analyze their
vulnerabilities to the privacy. Moreover, we propose a new attack
model, which threats the privacy of user by tracking tags in a group.
Abstract: With the rapid usage of portable devices mobility in
IP networks becomes more important issue in the recent years. IETF
standardized Mobile IP that works in Network Layer, which involves
tunneling of IP packets from HA to Foreign Agent. Mobile IP suffers
many problems of Triangular Routing, conflict with private
addressing scheme, increase in load in HA, need of permanent home
IP address, tunneling itself, and so on. In this paper, we proposed
mobility management in Application Layer protocol SIP and show
some comparative analysis between Mobile IP and SIP in context of
mobility.
Abstract: This paper will first describe predictor controllers
when the proportional-integral-derivative (PID) controllers are
inactive for procedures that have large delay time (LDT) in transfer
stage. Therefore in those states, the predictor controllers are better
than the PID controllers, then compares three types of predictor
controllers. The value of these controller-s parameters are obtained
by trial and error method, so here an effort has been made to obtain
these parameters by Ziegler-Nichols method. Eventually in this paper
Ziegler-Nichols method has been described and finally, a PIP
controller has been designed for a thermal system, which circulates
hot air to keep the temperature of a chamber constant.
Abstract: The two-dimensional gel electrophoresis method
(2-DE) is widely used in Proteomics to separate thousands of proteins
in a sample. By comparing the protein expression levels of proteins in
a normal sample with those in a diseased one, it is possible to identify
a meaningful set of marker proteins for the targeted disease. The major
shortcomings of this approach involve inherent noises and irregular
geometric distortions of spots observed in 2-DE images. Various
experimental conditions can be the major causes of these problems. In
the protein analysis of samples, these problems eventually lead to
incorrect conclusions. In order to minimize the influence of these
problems, this paper proposes a partition based pair extension method
that performs spot-matching on a set of gel images multiple times and
segregates more reliable mapping results which can improve the
accuracy of gel image analysis. The improved accuracy of the
proposed method is analyzed through various experiments on real
2-DE images of human liver tissues.
Abstract: Vector quantization is a powerful tool for speech
coding applications. This paper deals with LPC Coding of speech
signals which uses a new technique called Multi Switched Split
Vector Quantization, This is a hybrid of two product code vector
quantization techniques namely the Multi stage vector quantization
technique, and Switched split vector quantization technique,. Multi
Switched Split Vector Quantization technique quantizes the linear
predictive coefficients in terms of line spectral frequencies. From
results it is proved that Multi Switched Split Vector Quantization
provides better trade off between bitrate and spectral distortion
performance, computational complexity and memory requirements
when compared to Switched Split Vector Quantization, Multi stage
vector quantization, and Split Vector Quantization techniques. By
employing the switching technique at each stage of the vector
quantizer the spectral distortion, computational complexity and
memory requirements were greatly reduced. Spectral distortion was
measured in dB, Computational complexity was measured in
floating point operations (flops), and memory requirements was
measured in (floats).
Abstract: The purpose of this work is to identify the positive and negative aspects of parties- participation in the country-s modernization, which in turn, will help a country to determine the necessary steps to improve the social-economic development. The article considers a question of the role of the dominating party of Kazakhstan and ruling party of China in the country-s modernization. Using a comparative analysis reveals differences between the People's Democratic Party “Nur Otan" and the Communist Party of China. It is discussed the policy of carrying out of modernization, the main actions of political parties of both countries with a view of modernization implementation.
Abstract: Dynamics of a vapour bubble generated due to a high local energy input near a circular thin bronze plate in the absence of the buoyancy forces is numerically investigated in this paper. The bubble is generated near a thin bronze plate and during the growth and collapse of the bubble, it deforms the nearby plate. The Boundary Integral Equation Method is employed for numerical simulation of the problem. The fluid is assumed to be incompressible, irrotational and inviscid and the surface tension on the bubble boundary is neglected. Therefore the fluid flow around the vapour bubble can be assumed as a potential flow. Furthermore, the thin bronze plate is assumed to have perfectly plastic behaviour. Results show that the displacement of the circular thin bronze plate has considerable effect on the dynamics of its nearby vapour bubble. It is found that by decreasing the thickness of the thin bronze plate, the growth and collapse rate of the bubble becomes higher and consequently the lifetime of the bubble becomes shorter.
Abstract: This paper is a part of research, in which the way the
biomedical engineers follow in their work is analyzed. The goal of
this paper is to present a method for specification of user
requirements in the medical devices maintenance process. Data
Gathering Methods, Research Model Phases and Descriptive
Analysis is presented. These technology and verification rules can be
implemented in Medical devices maintenance management process to
the maintenance process.
Abstract: Droplet size distributions in the cold spray of a fuel
are important in observed combustion behavior. Specification of
droplet size and velocity distributions in the immediate downstream
of injectors is also essential as boundary conditions for advanced
computational fluid dynamics (CFD) and two-phase spray transport
calculations. This paper describes the development of a new model to
be incorporated into maximum entropy principle (MEP) formalism
for prediction of droplet size distribution in droplet formation region.
The MEP approach can predict the most likely droplet size and
velocity distributions under a set of constraints expressing the
available information related to the distribution.
In this article, by considering the mechanisms of turbulence
generation inside the nozzle and wave growth on jet surface, it is
attempted to provide a logical framework coupling the flow inside the
nozzle to the resulting atomization process. The purpose of this paper
is to describe the formulation of this new model and to incorporate it
into the maximum entropy principle (MEP) by coupling sub-models
together using source terms of momentum and energy. Comparison
between the model prediction and experimental data for a gas turbine
swirling nozzle and an annular spray indicate good agreement
between model and experiment.