Abstract: A mathematical model for the transmission of SARS is developed. In addition to dividing the population into susceptible (high and low risk), exposed, infected, quarantined, diagnosed and recovered classes, we have included a class called untraced. The model simulates the Gompertz curves which are the best representation of the cumulative numbers of probable SARS cases in Hong Kong and Singapore. The values of the parameters in the model which produces the best fit of the observed data for each city are obtained by using a differential evolution algorithm. It is seen that the values for the parameters needed to simulate the observed daily behaviors of the two epidemics are different.
Abstract: BRI-STARS (BRIdge Stream Tube model for Alluvial
River Simulation) program was used to investigate the scour depth around bridge piers in some of the major river systems in Iran. Model
calibration was performed by collecting different field data. Field data are cataloged on three categories, first group of bridges that
their rivers bed are formed by fine material, second group of bridges
that their rivers bed are formed by sand material, and finally bridges that their rivers bed are formed by gravel or cobble materials.
Verification was performed with some field data in Fars Province. Results show that for wide piers, computed scour depth is more than
measured one. In gravel bed streams, computed scour depth is greater
than measured scour depth, the reason is due to formation of armor layer on bed of channel. Once this layer is eroded, the computed
scour depth is close to the measured one.
Abstract: The LHP is a two-phase device with extremely high
effective thermal conductivity that utilizes the thermodynamic
pressure difference to circulate a cooling fluid. A thermodynamics
analytical model is developed to explore different parameters effects
on a Loop Heat Pipe (LHP).. The effects of pipe length, pipe
diameter, condenser temperature, and heat load are reported. As pipe
length increases and/or pipe diameter decreases, a higher temperature
is expected in the evaporator.
Abstract: The design of Class A and Class AB 2-stage X band
Power Amplifier is described in this report. This power amplifier is
part of a transceiver used in radar for monitoring iron characteristics
in a blast furnace. The circuit was designed using foundry WIN
Semiconductors. The specification requires 15dB gain in the linear
region, VSWR nearly 1 at input as well as at the output, an output
power of 10 dBm and good stable performance in the band 10.9-12.2
GHz. The design was implemented by using inter-stage
configuration, the Class A amplifier was chosen for driver stage i.e.
the first amplifier focusing on the gain and the output amplifier
conducted at Class AB with more emphasis on output power.
Abstract: The three-species food web model proposed and investigated by Gakkhar and Naji is known to have chaotic behaviour for a choice of parameters. An attempt has been made to synchronize the chaos in the model using bidirectional coupling. Numerical simulations are presented to demonstrate the effectiveness and feasibility of the analytical results. Numerical results show that for higher value of coupling strength, chaotic synchronization is achieved. Chaos can be controlled to achieve stable synchronization in natural systems.
Abstract: The article describes problems of city centers with regard to possibilities of their delimitation in a GIS environment. First the definitions and delimitations of a city centre which are in use are mentioned, furthermore a chosen case study (the historical centre of Olomouc city in the Czech Republic) is employed to describe the methods of delimitation in use. In addition to describing the current state, the article also deals with possibilities of delimitation of a city centre in GIS environment by means of several chosen approaches. The authors describe, compare and discuss the chosen methods and assess the achieved results and also applicability of the designed methods for other cities.
Abstract: Laser Doppler flowmetry is a modern method of noninvasive
microcirculation investigation. The aim of our study was to
use this method in the examination of patients with secondary
lymphedema of the lower extremities and obliterating atherosclerosis
of lower extremities. In the analysis of the amplitude-frequency
spectrum of secondary lymphedema patients we have identified
remarkable changes. To describe the changes we used a special
amplitude rate. In both of patients groups this rate was significally
(p
Abstract: Virtualization and high performance computing have been discussed from a performance perspective in recent publications. We present and discuss a flexible and efficient approach to the management of virtual clusters. A virtual machine management tool is extended to function as a fabric for cluster deployment and management. We show how features such as saving the state of a running cluster can be used to avoid disruption. We also compare our approach to the traditional methods of cluster deployment and present benchmarks which illustrate the efficiency of our approach.
Abstract: The hydrothermal behavior of a bed consisting of
magnetic and shale oil particle admixtures under the effect of a
transverse magnetic field is investigated. The phase diagram, bed
void fraction are studied under wide range of the operating
conditions i.e., gas velocity, magnetic field intensity and fraction of
the magnetic particles. It is found that the range of the stabilized
regime is reduced as the magnetic fraction decreases. In addition, the
bed voidage at the onset of fluidization decreases as the magnetic
fraction decreases. On the other hand, Nusselt number and
consequently the heat transfer coefficient is found to increase as the
magnetic fraction decreases. An empirical equation is investigated to
relate the effect of the gas velocity, magnetic field intensity and
fraction of the magnetic particles on the heat transfer behavior in the
bed.
Abstract: Two optimized strategies were successfully established
to develop biomolecule-based magnetic nanoassemblies.
Streptavidin-coated and amine-coated magnetic nanoparticles were
chosen as model scaffolds onto which double-stranded DNA and
human immunoglobulin G were specifically conjugated in succession,
using biotin-streptavidin interaction or covalent cross-linkers. The
success of this study opens the prospect of developing selective and
sensitive nanoparticle-based structures for diagnostics or drug
delivery.
Abstract: The distance between two objects is an important
problem in CAGD, CAD and CG etc. It will be presented in this paper
that a simple and quick method to estimate the distance between a
point and a Bezier curve on a Bezier surface.
Abstract: The paper aims at investigating influence of medium
capacity on linear adsorbed solute dispersion into chemically
heterogeneous fixed beds. A discrete chemical heterogeneity
distribution is considered in the one-dimensional advectivedispersive
equation. The partial differential equation is solved using
finite volumes method based on the Adam-Bashforth algorithm.
Increased dispersion is estimated by comparing breakthrough curves
second order moments and keeping identical hydrodynamic
properties. As a result, dispersion increase due to chemical
heterogeneity depends on the column size and surprisingly on the
solid capacity. The more intense capacity is, the more important
solute dispersion is. Medium length which is known to favour this
effect vanishing according to the linear adsorption in fixed bed seems
to create nonmonotonous variation of dispersion because of the
heterogeneity. This nonmonotonous behaviour is also favoured by
high capacities.
Abstract: This paper presents PSS (Power system stabilizer) design based on optimal fuzzy PID (OFPID). OFPID based PSS design is considered for single-machine power systems. The main motivation for this design is to stabilize or to control low-frequency oscillation on power systems. Firstly, describing the linear PID control then to combine this PID control with fuzzy logic control mechanism. Finally, Fuzzy PID parameters (Kp. Kd, KI, Kupd, Kui) are tuned by Genetic Algorthm (GA) to reach optimal global stability. The effectiveness of the proposed PSS in increasing the damping of system electromechanical oscillation is demonstrated in a one-machine-infinite-bus system
Abstract: The hybridisation of genetic algorithm with heuristics has been shown to be one of an effective way to improve its performance. In this work, genetic algorithm hybridised with four heuristics including a new heuristic called neighbourhood improvement were investigated through the classical travelling salesman problem. The experimental results showed that the proposed heuristic outperformed other heuristics both in terms of quality of the results obtained and the computational time.
Abstract: In this paper we propose a novel method for human
face segmentation using the elliptical structure of the human head. It
makes use of the information present in the edge map of the image.
In this approach we use the fact that the eigenvalues of covariance
matrix represent the elliptical structure. The large and small
eigenvalues of covariance matrix are associated with major and
minor axial lengths of an ellipse. The other elliptical parameters are
used to identify the centre and orientation of the face. Since an
Elliptical Hough Transform requires 5D Hough Space, the Circular
Hough Transform (CHT) is used to evaluate the elliptical parameters.
Sparse matrix technique is used to perform CHT, as it squeeze zero
elements, and have only a small number of non-zero elements,
thereby having an advantage of less storage space and computational
time. Neighborhood suppression scheme is used to identify the valid
Hough peaks. The accurate position of the circumference pixels for
occluded and distorted ellipses is identified using Bresenham-s
Raster Scan Algorithm which uses the geometrical symmetry
properties. This method does not require the evaluation of tangents
for curvature contours, which are very sensitive to noise. The method
has been evaluated on several images with different face orientations.
Abstract: This project aims to investigate the potential of
torrefaction to improve the properties of Malaysian palm kernel shell
(PKS) as a solid fuel. A study towards torrefaction of PKS was
performed under various temperature and residence time of 240, 260,
and 280oC and 30, 60, and 90 minutes respectively. The torrefied
PKS was characterized in terms of the mass yield, energy yield,
elemental composition analysis, calorific value analysis, moisture and
volatile matter contents, and ash and fixed carbon contents. The mass
and energy yield changes in the torrefied PKS were observed to
prove that the temperature has more effect compare to residence time
in the torrefaction process. The C content of PKS increases while H
and O contents decrease after torrefaction, which resulted in higher
heating value between 5 to 16%. Meanwhile, torrefaction caused the
ash and fixed carbon content of PKS to increase, and the moisture
and volatile matter to decrease.
Abstract: Due to the rise of aging population, effective utilization
of healthcare resources has become an important issue. With the
advance of ICT technology, the application of tele-healthcare service
has received more attention than ever. The main purpose of this
research is to investigate how to conduct innovative design for
tele-healthcare service based on user-s perspectives. First, the
healthcare service blueprint was used to describe the processes
of tele-healthcare service delivery, and then construct PZB service
quality gap model based on the literature and practitioners-
interviews. Next, TRIZ theory is applied to implement service
innovation. We found the proposed service innovation procedures can
effectively improve the quality of service design.
Abstract: Decision feedback equalizers are commonly employed to reduce the error caused by intersymbol interference. Here, an adaptive decision feedback equalizer is presented with a new adaptation algorithm. The algorithm follows a block-based approach of normalized least mean square (NLMS) algorithm with set-membership filtering and achieves a significantly less computational complexity over its conventional NLMS counterpart with set-membership filtering. It is shown in the results that the proposed algorithm yields similar type of bit error rate performance over a reasonable signal to noise ratio in comparison with the latter one.
Abstract: This research explores visitor-s expectations of service
quality in intelligent living space showroom – Living 3.0 in Taiwan.
Based on the five dimensions of PZB service quality, a specialist
questionnaire is utilized to establish a complete service quality
evaluation framework for Living 3.0. In this research, analysis
hierarchy process (AHP) is applied to find the relative weights among
the criteria. Finally, the service quality evaluation framework and
evaluation results can be used as a guide for Living 3.0 proprietors to
review, improve, and enhance service planning and service qualities in
the future.
Abstract: The in vitro culture procedure of purple nutsedge
(Cyperus rotundus L.) for multiple shoot induction and tuber
formation was established. Multiple shoots were significantly
induced from a single shoot of about 0.5 – 0.8 cm long, on Murashige
and Skoog (MS) medium supplemented with 4.44 μM 6-
benzyladinine (BA) alone or in combination with 2.85 μM 1-
indoleacetic acid (IAA), providing 17.6 and 15.3 shoots per explant
with 31.2 and 27.5 leaves per explant, respectively, within 6 weeks of
culturing. Moreover, MS medium supplemented with 4.44 μM BA
and 2.85 μM IAA was suitable for tuber induction, obtaining 5.9
tubers with 3.4 rhizomes per explant. In combination with ancymidol
and higher concentration of sucrose, 11.1 μM BA and 60 g/L sucrose
or 11.1 μM BA, 7.8 μM ancymidol and 60 g/L sucrose induced 3.5
tubers with 1.6 rhizomes or 3.5 tubers without rhizome, respectively.
However, MS medium containing 3.9 or 7.8 μM ancymidol in
combination with either 60 or 80 g/L sucrose enchanced significant
root formation at 20.9 – 23.6 roots per explant.