Abstract: Power-line networks are widely used today for broadband data transmission. However, due to multipaths within the broadband power line communication (BPLC) systems owing to stochastic changes in the network load impedances, branches, etc., network or channel capacity performances are affected. This paper attempts to investigate the performance of typical medium voltage channels that uses Orthogonal Frequency Division Multiplexing (OFDM) techniques with Quadrature Amplitude Modulation (QAM) sub carriers. It has been observed that when the load impedances are different from line characteristic impedance channel performance decreases. Also as the number of branches in the link between the transmitter and receiver increases a loss of 4dB/branch is found in the signal to noise ratio (SNR). The information presented in the paper could be useful for an appropriate design of the BPLC systems.
Abstract: This paper undertakes the problem of optimal
capacitor placement in a distribution system. The problem is how to
optimally determine the locations to install capacitors, the types and
sizes of capacitors to he installed and, during each load level,the
control settings of these capacitors in order that a desired objective
function is minimized while the load constraints,network constraints
and operational constraints (e.g. voltage profile) at different load
levels are satisfied. The problem is formulated as a combinatorial
optimization problem with a nondifferentiable objective function.
Four solution mythologies based on algorithms (GA),tabu search
(TS), and hybrid GA-SA algorithms are presented.The solution
methodologies are preceded by a sensitivity analysis to select the
candidate capacitor installation locations.
Abstract: Connected dominating set (CDS) problem in unit disk
graph has signi£cant impact on an ef£cient design of routing protocols
in wireless sensor networks, where the searching space for a
route is reduced to nodes in the set. A set is dominating if all the
nodes in the system are either in the set or neighbors of nodes in the
set. In this paper, a simple and ef£cient heuristic method is proposed
for £nding a minimum connected dominating set (MCDS) in ad hoc
wireless networks based on the new parameter support of vertices.
With this parameter the proposed heuristic approach effectively
£nds the MCDS of a graph. Extensive computational experiments
show that the proposed approach outperforms the recently proposed
heuristics found in the literature for the MCD
Abstract: This paper presents an idea to improve the efficiency
of security checks in airports through the active tracking and
monitoring of passengers and staff using OFDM modulation
technique and Finger print authentication. The details of the
passenger are multiplexed using OFDM .To authenticate the
passenger, the fingerprint along with important identification
information is collected. The details of the passenger can be
transmitted after necessary modulation, and received using various
transceivers placed within the premises of the airport, and checked at
the appropriate check points, thereby increasing the efficiency of
checking. OFDM has been employed for spectral efficiency.
Abstract: Linear stability of wake-shear layers in two-phase
shallow flows is analyzed in the present paper. Stability analysis is
based on two-dimensional shallow water equations. It is assumed that
the fluid contains uniformly distributed solid particles. No dynamic
interaction between the carrier fluid and particles is expected in the
initial moment. Linear stability curves are obtained for different
values of the particle loading parameter, the velocity ratio and the
velocity deficit. It is shown that the increase in the velocity ratio
destabilizes the flow. The particle loading parameter has a stabilizing
effect on the flow. The role of the velocity deficit is also
destabilizing: the increase of the velocity deficit leads to less stable
flow.
Abstract: In today-s competitive environment, the security concerns have grown tremendously. In the modern world, possession is known to be 9/10-ths of the law. Hence, it is imperative for one to be able to safeguard one-s property from worldly harms such as thefts, destruction of property, people with malicious intent etc. Due to the advent of technology in the modern world, the methodologies used by thieves and robbers for stealing have been improving exponentially. Therefore, it is necessary for the surveillance techniques to also improve with the changing world. With the improvement in mass media and various forms of communication, it is now possible to monitor and control the environment to the advantage of the owners of the property. The latest technologies used in the fight against thefts and destruction are the video surveillance and monitoring. By using the technologies, it is possible to monitor and capture every inch and second of the area in interest. However, so far the technologies used are passive in nature, i.e., the monitoring systems only help in detecting the crime but do not actively participate in stopping or curbing the crime while it takes place. Therefore, we have developed a methodology to detect the motion in a video stream environment and this is an idea to ensure that the monitoring systems not only actively participate in stopping the crime, but do so while the crime is taking place. Hence, a system is used to detect any motion in a live streaming video and once motion has been detected in the live stream, the software will activate a warning system and capture the live streaming video.
Abstract: The paper proposes an approach for design of modular
systems based on original technique for modeling and formulation of
combinatorial optimization problems. The proposed approach is
described on the example of personal computer configuration design.
It takes into account the existing compatibility restrictions between
the modules and can be extended and modified to reflect different
functional and users- requirements. The developed design modeling
technique is used to formulate single objective nonlinear mixedinteger
optimization tasks. The practical applicability of the
developed approach is numerically tested on the basis of real modules
data. Solutions of the formulated optimization tasks define the
optimal configuration of the system that satisfies all compatibility
restrictions and user requirements.
Abstract: The objectives of this study are to determine the role of media that influence the values, attitudes and behaviors of Thai youths. Analytical qualitative research techniques were used for this purpose. Data collection based techniques was used which were individual interviews and focus group discussions with journalists, sample of high school and university students, and parents. The results show that “Social Media" is still the most popular media for Thai youths. It is also still in the hands of the marketing business and it can motivate Thai youths to do so many things. The main reasons of media exposure are to find quality information that they want quickly, get satisfaction and can use social media to get more exciting and to build communities. They believe that the need for media and information literacy skills is defined as making judgments, personal integrity, training of family and the behavior of close friends.
Abstract: In this paper, a mathematical model is proposed to
estimate the dropping probabilities of cellular wireless networks by
queuing handoff instead of reserving guard channels. Usually, prioritized
handling of handoff calls is done with the help of guard channel
reservation. To evaluate the proposed model, gamma inter-arrival and
general service time distributions have been considered. Prevention of
some of the attempted calls from reaching to the switching center due
to electromagnetic propagation failure or whimsical user behaviour
(missed call, prepaid balance etc.), make the inter-arrival time of
the input traffic to follow gamma distribution. The performance is
evaluated and compared with that of guard channel scheme.
Abstract: Voltage flicker is a disturbance in electrical power
systems. The reason for this disturbance is mainly the large nonlinear
loads such as electric arc furnaces. Synchronous static
compensator (STATCOM) is considered as a proper technique to
mitigate the voltage flicker. Application of more suitable and precise
power electronic converter leads to a more precise performance of the
compensator. In this paper a three-level 12-pulse voltage source
inverter (VSI) with a 12-terminal transformer connected to the ac
system is studied and the obtained results are compared with the
performance of a STATCOM using a simple two-level VSI and an
optimal and more precise performance of the proposed scheme is
achieved.
Abstract: Standards for learning objects focus primarily on
content presentation. They were already extended to support automatic evaluation but it is limited to exercises with a predefined
set of answers. The existing standards lack the metadata required by specialized evaluators to handle types of exercises with an indefinite
set of solutions. To address this issue existing learning object standards were extended to the particular requirements of a
specialized domain. A definition of programming problems as learning objects, compatible both with Learning Management Systems and with systems performing automatic evaluation of
programs, is presented in this paper. The proposed definition includes
metadata that cannot be conveniently represented using existing standards, such as: the type of automatic evaluation; the requirements
of the evaluation engine; and the roles of different assets - tests cases, program solutions, etc. The EduJudge project and its main services
are also presented as a case study on the use of the proposed definition of programming problems as learning objects.
Abstract: This paper proposes an efficient lattice-reduction-aided
detection (LRD) scheme to improve the detection performance of
MIMO-OFDM system. In this proposed scheme, V candidate symbols
are considered at the first layer, and V probable streams are
detected with LRD scheme according to the first detected V candidate
symbols. Then, the most probable stream is selected through a ML
test. Since the proposed scheme can more accurately detect initial
symbol and can reduce transmission of error to rest symbols, the
proposed scheme shows more improved performance than conventional
LRD with very low complexity.
Abstract: High voltage generators are being subject to higher
voltage rating and are being designed to operate in harsh conditions.
Stator windings are the main component of generators in which
Electrical, magnetically and thermal stresses remain major failures
for insulation degradation accelerated aging. A large number of
generators failed due to stator winding problems, mainly insulation
deterioration. Insulation degradation assessment plays vital role in the
asset life management. Mostly the stator failure is catastrophic
causing significant damage to the plant. Other than generation loss,
stator failure involves heavy repair or replacement cost. Electro
thermal analysis is the main characteristic for improvement design of
stator slot-s insulation. Dielectric parameters such as insulation
thickness, spacing, material types, geometry of winding and slot are
major design consideration. A very powerful method available to
analyze electro thermal performance is Finite Element Method
(FEM) which is used in this paper. The analysis of various stator coil
and slot configurations are used to design the better dielectric system
to reduce electrical and thermal stresses in order to increase the
power of generator in the same volume of core. This paper describes
the process used to perform classical design and improvement
analysis of stator slot-s insulation.
Abstract: Polymers are one of the most widely used materials in our every day life. The subject of renewable resources has attracted great attention in the last period of time. New polymeric materials derived from renewable resources, like carbohydrates draw attention to public eye especially because of their biocompatibility and biodegradability. The aim of our paper was to obtain environmentally compatible polymers from monosaccharides. Novel glycopolymers based on D-glucose have been obtained from copolymerization of a new monomer carrying carbohydrate moiety with methyl methacrylate (MMA) via free radical bulk polymerization. Differential scanning calorimetry (DSC) was performed in order to study the copolymerization process of the monomer into the chosen co-monomer; the activation energy of this process was evaluated using Ozawa method. The copolymers obtained were characterized using ATR-FTIR spectroscopy. The thermal stability of the obtained products was studied by thermogravimetry (TG).
Abstract: The goal of this paper is to find Wardrop equilibrium
in transport networks at case of uncertainty situations, where the
uncertainty comes from lack of information. We use simulation tool
to find the equilibrium, which gives only approximate solution, but
this is sufficient for large networks as well. In order to take the
uncertainty into account we have developed an interval-based
procedure for finding the paths with minimal cost using the
Dempster-Shafer theory. Furthermore we have investigated the users-
behaviors using game theory approach, because their path choices
influence the costs of the other users- paths.
Abstract: The volume of biosolids produced in Malaysia
nowadays had increased proportionally to its population size. The end
products from the waste treatments were mounting, thus inevitable
that in the end the environment will be surrounded by the waste. This
study was conducted to investigate the suitability of biosolids to be
reused as fertilizer for non-food crop. By varying the concentration of
biosolids applied onto the soil, growth of five ornamental plant
samples were tested for eight consecutive weeks. The results show
that the pH of the soil after the addition of biosolids ranges from 6.45
to 6.56 which is suitable for the plant growth. The soil samples that
contains biosolid also show higher amount of macronutrients (N, P,
K) and the heavy metals content are significantly increased in the
plant however it does not exceed the guidelines drawn by the
Environmental Protection Agency. It is also proven that there was
only small significant different in the performance of plant growth
between biosolids and commercial fertilizer. It can be seen that
biosolids was able to perform just as well as commercial fertilizer.
Abstract: Commercial nanocomposite food packaging type nano-silver containers were characterised using scanning electron microscopy (SEM) and energy-dispersive X-ray spectroscopy (EDX). The presence of nanoparticles consistent with the incorporation of 1% nano-silver (Ag) and 0.1% titanium dioxide (TiO2) nanoparticle into polymeric materials formed into food containers was confirmed. Both nanomaterials used in this type of packaging appear to be embedded in a layered configuration within the bulk polymer. The dimensions of the incorporated nanoparticles were investigated using X-ray diffraction (XRD) and determined by calculation using the Scherrer Formula; these were consistent with Ag and TiO2 nanoparticles in the size range 20-70nm both were spherical shape nanoparticles. Antimicrobial assessment of the nanocomposite container has also been performed and the results confirm the antimicrobial activity of Ag and TiO2 nanoparticles in food packaging containers. Migration assessments were performed in a wide range of food matrices to determine the migration of nanoparticles from the packages. The analysis was based upon the relevant European safety Directives and involved the application of inductively coupled plasma mass spectrometry (ICP-MS) to identify the range of migration risk. The data pertain to insignificance levels of migration of Ag and TiO2 nanoparticles into the selected food matrices.
Abstract: This paper presents the review of past studies
concerning mathematical models for rescheduling passenger railway
services, as part of delay management in the occurrence of railway
disruption. Many past mathematical models highlighted were aimed
at minimizing the service delays experienced by passengers during
service disruptions. Integer programming (IP) and mixed-integer
programming (MIP) models are critically discussed, focusing on the
model approach, decision variables, sets and parameters. Some of
them have been tested on real-life data of railway companies
worldwide, while a few have been validated on fictive data. Based
on selected literatures on train rescheduling, this paper is able to
assist researchers in the model formulation by providing
comprehensive analyses towards the model building. These analyses
would be able to help in the development of new approaches in
rescheduling strategies or perhaps to enhance the existing
rescheduling models and make them more powerful or more
applicable with shorter computing time.
Abstract: Interactive public displays give access as an
innovative media to promote enhanced communication between
people and information. However, digital public displays are subject
to a few constraints, such as content presentation. Content
presentation needs to be developed to be more interesting to attract
people’s attention and motivate people to interact with the display. In
this paper, we proposed idea to implement contents with interaction
elements for vision-based digital public display. Vision-based
techniques are applied as a sensor to detect passers-by and theme
contents are suggested to attract their attention for encouraging them
to interact with the announcement content. Virtual object, gesture
detection and projection installation are applied for attracting
attention from passers-by. Preliminary study showed positive
feedback of interactive content designing towards the public display.
This new trend would be a valuable innovation as delivery of
announcement content and information communication through this
media is proven to be more engaging.
Abstract: With the proliferation of mobile computing technology, mobile learning (m-learning) will play a vital role in the rapidly growing electronic learning market. However, the acceptance of m-learning by individuals is critical to the successful implementation of m-learning systems. Thus, there is a need to research the factors that affect users- intention to use m-learning. Based on an updated information system (IS) success model, data collected from 350 respondents in Taiwan were tested against the research model using the structural equation modeling approach. The data collected by questionnaire were analyzed to check the validity of constructs. Then hypotheses describing the relationships between the identified constructs and users- satisfaction were formulated and tested.