Abstract: The source voltage of high-power fuel cell shows strong load dependence at comparatively low voltage levels. In order to provide the voltage of 750V on the DC-link for feeding electrical energy into the mains via a three phase inverter a step-up converter with a large step-up ratio is required. The output voltage of this DC/DC-converter must be stabile during variations of the load current and the voltage of the fuel cell. This paper presents the methods and results of the calculation of the efficiency and the expense for the realization for the circuits of the DC/DC-converter that meet these requirements.
Abstract: The experiment was conducted to study the effect of
rearing systems on fatty acid composition and cholesterol content of
Thai indigenous chicken meat. Three hundred and sixty chicks were
allocated to 2 different rearing systems: conventional, housing in an
indoor pen (5 birds/m2); free-range, housing in an indoor pen (5
birds/m2) with access to a grass paddock (1 bird/m2) from 8 wk of age
until slaughter. All birds were provided with the same diet during the
experimental period. At 16 wk of age, 24 birds per group were
slaughtered to evaluate the fatty acid composition and cholesterol
content of breast and thigh meat. The results showed that the
proportion of SFA, MUFA and PUFA in breast and thigh meat were
not different among groups (P>0.05). However, the proportion of n-3
fatty acids was higher and the ratio of n-6 to n-3 fatty acids was lower
in free-range system than in conventional system (P0.05). The data indicated that the free-range system
could increase the proportion of n-3 fatty acids, but no effect on
cholesterol content in Thai indigenous chicken meat.
Abstract: The effects of seawater and slurry ice bleeding methods on the sensory, microbiological and chemical quality changes of cod fillets during chilled storage were examined in this study. The results from sensory evaluation showed that slurry ice bleeding method prolonged the shelf life of cod fillets up to 13-14 days compared to 10-11 days for fish bled in seawater. Slurry ice bleeding method also led to a slower microbial growth and biochemical developments, resulting lower total plate count (TPC), H2S-producing bacteria count, total volatile basic nitrogen (TVB-N), trimethylamine (TMA), free fatty acid (FFA) content and higher phospholipid content (PL) compared to those of samples bled in seawater. The results of principle component analysis revealed that TPC, H2S-producing bacteria, TVB-N, TMA and FFA were in significant correlation. They were also in negative correlation with sensory evaluation (Torry score), PL and water holding capacity (WHC).
Abstract: Weblogs are resource of social structure to discover and track the various type of information written by blogger. In this paper, we proposed to use mining weblogs technique for identifying the trends of influenza where blogger had disseminated their opinion for the anomaly disease. In order to identify the trends, web crawler is applied to perform a search and generated a list of visited links based on a set of influenza keywords. This information is used to implement the analytics report system for monitoring and analyzing the pattern and trends of influenza (H1N1). Statistical and graphical analysis reports are generated. Both types of the report have shown satisfactory reports that reflect the awareness of Malaysian on the issue of influenza outbreak through blogs.
Abstract: One of the basic concepts in marketing is the concept
of meeting customers- needs. Since customer satisfaction is essential
for lasting survival and development of a business, screening and
observing customer satisfaction and recognizing its underlying
factors must be one of the key activities of every business.
The purpose of this study is to recognize the drivers that effect
customer satisfaction in a business-to-business situation in order to
improve marketing activities. We conducted a survey in which 93
business customers of a manufacturer of Diesel Generator in Iran
participated and they talked about their ideas and satisfaction of
supplier-s services related to its products. We developed the measures
for drivers of satisfaction first by as investigative research (by means
of feedback from executives and customers of sponsoring firm). Then
based on these measures, we created a mail survey, and asked the
respondents to explain their opinion about the sponsoring firm which
was a supplier of diesel generator and similar products. Furthermore,
the survey required the participants to mention their functional areas
and their company features.
In Conclusion we found that there are three drivers for customer
satisfaction, which are reliability, information about product, and
commercial features. Buyers/users from different functional areas
attribute different degree of importance to the last two drivers. For
instance, people from buying and management areas believe that
commercial features are more important than information about
products. But people in engineering, maintenance and production
areas believe that having information about products is more
important than commercial aspects. Marketing experts should
consider the attribute of customers regarding information about the
product and commercial features to improve market share.
Abstract: Recommender Systems act as personalized decision
guides, aiding users in decisions on matters related to personal taste.
Most previous research on Recommender Systems has focused on the
statistical accuracy of the algorithms driving the systems, with no
emphasis on the trustworthiness of the user. RS depends on
information provided by different users to gather its knowledge. We
believe, if a large group of users provide wrong information it will
not be possible for the RS to arrive in an accurate conclusion. The
system described in this paper introduce the concept of Testing the
knowledge of user to filter out these “bad users".
This paper emphasizes on the mechanism used to provide robust
and effective recommendation.
Abstract: Computer modeling has played a unique role in
understanding electrocardiography. Modeling and simulating cardiac
action potential propagation is suitable for studying normal and
pathological cardiac activation. This paper presents a 2-D Cellular
Automata model for simulating action potential propagation in
cardiac tissue. We demonstrate a novel algorithm in order to use
minimum neighbors. This algorithm uses the summation of the
excitability attributes of excited neighboring cells. We try to
eliminate flat edges in the result patterns by inserting probability to
the model. We also preserve the real shape of action potential by
using linear curve fitting of one well known electrophysiological
model.
Abstract: In the last years, the computers have increased their capacity of calculus and networks, for the interconnection of these machines. The networks have been improved until obtaining the actual high rates of data transferring. The programs that nowadays try to take advantage of these new technologies cannot be written using the traditional techniques of programming, since most of the algorithms were designed for being executed in an only processor,in a nonconcurrent form instead of being executed concurrently ina set of processors working and communicating through a network.This paper aims to present the ongoing development of a new system for the reconfiguration of grouping of computers, taking into account these new technologies.
Abstract: We present a non standard Euclidean vehicle
routing problem adding a level of clustering, and we revisit the use
of self-organizing maps as a tool which naturally handles such
problems. We present how they can be used as a main operator
into an evolutionary algorithm to address two conflicting
objectives of route length and distance from customers to bus stops
minimization and to deal with capacity constraints. We apply the
approach to a real-life case of combined clustering and vehicle
routing for the transportation of the 780 employees of an
enterprise. Basing upon a geographic information system we
discuss the influence of road infrastructures on the solutions
generated.
Abstract: The intelligent fuzzy input estimator is used to estimate
the input force of the rigid bar structural system in this study. The
fuzzy Kalman filter without the input term and the fuzzy weighting
recursive least square estimator are two main portions of this method.
The practicability and accuracy of the proposed method were verified
with numerical simulations from which the input forces of a rigid bar
structural system were estimated from the output responses. In order to
examine the accuracy of the proposed method, a rigid bar structural
system is subjected to periodic sinusoidal dynamic loading. The
excellent performance of this estimator is demonstrated by comparing
it with the use of difference weighting function and improper the
initial process noise covariance. The estimated results have a good
agreement with the true values in all cases tested.
Abstract: This paper presents dynamic voltage collapse prediction on an actual power system using support vector machines.
Dynamic voltage collapse prediction is first determined based on the PTSI calculated from information in dynamic simulation output. Simulations were carried out on a practical 87 bus test system by considering load increase as the contingency. The data collected from the time domain simulation is then used as input to the SVM in which support vector regression is used as a predictor to determine the
dynamic voltage collapse indices of the power system. To reduce training time and improve accuracy of the SVM, the Kernel function type and Kernel parameter are considered. To verify the
effectiveness of the proposed SVM method, its performance is compared with the multi layer perceptron neural network (MLPNN). Studies show that the SVM gives faster and more accurate results for dynamic voltage collapse prediction compared with the MLPNN.
Abstract: The communication networks development and
advancement during two last decades has been toward a single goal
and that is gradual change from circuit-switched networks to packed
switched ones. Today a lot of networks operates are trying to
transform the public telephone networks to multipurpose packed
switch. This new achievement is generally called "next generation
networks". In fact, the next generation networks enable the operators
to transfer every kind of services (sound, data and video) on a
network. First, in this report the definition, characteristics and next
generation networks services and then ad-hoc networks role in the
next generation networks are studied.
Abstract: This paper presents a supervised clustering algorithm,
namely Grid-Based Supervised Clustering (GBSC), which is able to
identify clusters of any shapes and sizes without presuming any
canonical form for data distribution. The GBSC needs no prespecified
number of clusters, is insensitive to the order of the input
data objects, and is capable of handling outliers. Built on the
combination of grid-based clustering and density-based clustering,
under the assistance of the downward closure property of density
used in bottom-up subspace clustering, the GBSC can notably reduce
its search space to avoid the memory confinement situation during its
execution. On two-dimension synthetic datasets, the GBSC can
identify clusters with different shapes and sizes correctly. The GBSC
also outperforms other five supervised clustering algorithms when
the experiments are performed on some UCI datasets.
Abstract: Energy generated by the force of water in hydropower
can provide a more sustainable, non-polluting alternative to fossil
fuels, along with other renewable sources of energy, such as wind,
solar and tidal power, bio energy and geothermal energy. Small scale
hydroelectricity in Iran is well suited for “off-grid" rural electricity
applications, while other renewable energy sources, such as wind,
solar and biomass, can be beneficially used as fuel for pumping
groundwater for drinking and small scale irrigation in remote rural
areas or small villages. Small Hydro Power plants in Iran have very
low operating and maintenance costs because they consume no fossil
or nuclear fuel and do not involve high temperature processes. The
equipment is relatively simple to operate and maintain. Hydropower
equipment can adjust rapidly to load changes. The extended
equipment life provides significant economic advantages. Some
hydroelectric plants installed 100 years ago still operate reliably. The
Polkolo river is located on Karun basin at southwest of Iran. Situation
and conditions of Polkolo river are evaluated for construction of
small hydropower in this article. The topographical conditions and
the existence of permanent water from springs provide the suitability
to install hydroelectric power plants on the river Polkolo. The
cascade plant consists of 9 power plants connected with each other
and is having the total head as 1100m and discharge about 2.5cubic
meter per second. The annual production of energy is 105.5 million
kwh.
Abstract: Various methods of geofield parameters restoration (by algebraic polynoms; filters; rational fractions; interpolation splines; geostatistical methods – kriging; search methods of nearest points – inverse distance, minimum curvature, local – polynomial interpolation; neural networks) have been analyzed and some possible mistakes arising during geofield surface modeling have been presented.
Abstract: In this paper, a robust watermarking algorithm using
the wavelet transform and edge detection is presented. The efficiency
of an image watermarking technique depends on the preservation of
visually significant information. This is attained by embedding the
watermark transparently with the maximum possible strength. The
watermark embedding process is carried over the subband
coefficients that lie on edges, where distortions are less noticeable,
with a subband level dependent strength. Also, the watermark is
embedded to selected coefficients around edges, using a different
scale factor for watermark strength, that are captured by a
morphological dilation operation. The experimental evaluation of the
proposed method shows very good results in terms of robustness and
transparency to various attacks such as median filtering, Gaussian
noise, JPEG compression and geometrical transformations.
Abstract: This paper presents the results of a preventive maintenance application-based study and modeling of failure rates in breakers of electrical distribution systems. This is a critical issue in the reliability assessment of a system. In the analysis conducted in this paper, the impacts of failure rate variations caused by a preventive maintenance are examined. This is considered as a part of a Reliability Centered Maintenance (RCM) application program. A number of load point reliability indices is derived using the mathematical model of the failure rate, which is established using the observed data in a distribution system.
Abstract: In this paper, the 1-D conduction-radiation problem is solved by the lattice Boltzmann method. The effects of various parameters such as the scattering albedo, the conduction–radiation parameter and the wall emissivity are studied. In order to check on the accuracy of the numerical technique employed for the solution of the considered problem, the present numerical code was validated with the published study. The found results are in good agreement with those published
Abstract: This paper studies the application of a variety of
sawdust materials in the production of lightweight insulating bricks.
First, the mineralogical and chemical composition of clays was determined. Next, ceramic bricks were fabricated with different
quantities of materials (3–6 and 9 wt. % for sawdust, 65 wt. % for grey clay, 24–27 and 30 wt. % for yellow clay and 2 wt% of tuff).
These bricks were fired at 800 and 950 °C. The effect of adding this sawdust on the technological behaviour of the brick was assessed by
drying and firing shrinkage, water absorption, porosity, bulk density
and compressive strength. The results have shown that the optimum
sintering temperature is 950 °C. Below this temperature, at 950 °C,
increased open porosity was observed, which decreased the compressive strength of the bricks. Based on the results obtained, the
optimum amounts of waste were 9 wt. % sawdust of eucalyptus, 24 wt. % shaping moisture and 1.6 particle size diameter. These percentages produced bricks whose mechanical properties were
suitable for use as secondary raw materials in ceramic brick
production.
Abstract: Safety Health and Environment Code of Practice (SHE
COP) was developed to help road transportation operators to manage
its operation in a systematic and safe manner. A study was conducted
to determine the effectiveness of SHE COP implementation during
non-OPS period. The objective of the study is to evaluate the
implementations of SHE COP among bus operators during wee hour
operations. The data was collected by completing a set of checklist
after observing the activities during pre departure, during the trip, and
upon arrival. The results show that there are seven widely practiced
SHE COP elements. 22% of the buses have average speed exceeding
the maximum permissible speed on the highways (90 km/h), with
13% of the buses were travelling at the speed of more than 100 km/h.
The statistical analysis shows that there is only one significant
association which relates speeding with prior presence of
enforcement officers.