Abstract: In this paper a new Genetic Algorithm based on a heuristic operator and Centre of Mass selection operator (CMGA) is designed for the unbounded knapsack problem(UKP), which is NP-Hard combinatorial optimization problem. The proposed genetic algorithm is based on a heuristic operator, which utilizes problem specific knowledge. This center of mass operator when combined with other Genetic Operators forms a competitive algorithm to the existing ones. Computational results show that the proposed algorithm is capable of obtaining high quality solutions for problems of standard randomly generated knapsack instances. Comparative study of CMGA with simple GA in terms of results for unbounded knapsack instances of size up to 200 show the superiority of CMGA. Thus CMGA is an efficient tool of solving UKP and this algorithm is competitive with other Genetic Algorithms also.
Abstract: Gabor-based face representation has achieved enormous success in face recognition. This paper addresses a novel algorithm for face recognition using neural networks trained by Gabor features. The system is commenced on convolving a face image with a series of Gabor filter coefficients at different scales and orientations. Two novel contributions of this paper are: scaling of rms contrast and introduction of fuzzily skewed filter. The neural network employed for face recognition is based on the multilayer perceptron (MLP) architecture with backpropagation algorithm and incorporates the convolution filter response of Gabor jet. The effectiveness of the algorithm has been justified over a face database with images captured at different illumination conditions.
Abstract: Quality control is the crucial step for ISO 9001
Quality System Management Standard for companies. While
measuring the quality level of both raw material and semi
product/product, the calibration of the measuring device is an
essential requirement. Calibration suppliers are in the service sector
and therefore the calibration supplier selection is becoming a worthy
topic for improving service quality.
This study presents the results of a questionnaire about the
selection criteria of a calibration supplier. The questionnaire was
applied to 103 companies and the results are discussed in this paper.
The analysis was made with MINITAB 14.0 statistical programs.
“Competence of documentations" and “technical capability" are
defined as the prerequisites because of the ISO/IEC17025:2005
standard. Also “warranties and complaint policy", “communication",
“service features", “quality" and “performance history" are defined as
very important criteria for calibration supplier selection.
Abstract: A considerable amount of energy is consumed during
transmission and reception of messages in a wireless mesh network
(WMN). Reducing per-node transmission power would greatly
increase the network lifetime via power conservation in addition to
increasing the network capacity via better spatial bandwidth reuse. In
this work, the problem of topology control in a hybrid WMN of
heterogeneous wireless devices with varying maximum transmission
ranges is considered. A localized distributed topology control
algorithm is presented which calculates the optimal transmission
power so that (1) network connectivity is maintained (2) node
transmission power is reduced to cover only the nearest neighbours
(3) networks lifetime is extended. Simulations and analysis of results
are carried out in the NS-2 environment to demonstrate the
correctness and effectiveness of the proposed algorithm.
Abstract: The distillation process in the general sense is a
relatively simple technique from the standpoints of its principles.
When dedicating distillation to water treatment and specifically
producing fresh water from sea, ocean and/ briny waters it is
interesting to notice that distillation has no limitations or domains of
applicability regarding the nature or the type of the feedstock water.
This is not the case however for other techniques that are
technologically quite complex, necessitate bigger capital investments
and are limited in their usability. In a previous paper we have
explored some of the effects of temperature on yield. In this paper,
we continue building onto that knowledge base and focus on the
effects of several additional engineering and design variables on
productivity.
Abstract: There are a many of needs for the development of
SiC-based hydrogen sensor for harsh environment applications. We
fabricated and investigated Pd/Ta2O5/SiC-based hydrogen sensors
with MOS capacitor structure for high temperature process monitoring
and leak detection applications in such automotive, chemical and
petroleum industries as well as direct monitoring of combustion
processes. In this work, we used silicon carbide (SiC) as a substrate to
replace silicon which operating temperatures are limited to below
200°C. Tantalum oxide was investigated as dielectric layer which has
high permeability for hydrogen gas and high dielectric permittivity,
compared with silicon dioxide or silicon nitride. Then, electrical
response properties, such as I-V curve and dependence of capacitance
on hydrogen concentrations were analyzed in the temperature ranges
of room temperature to 500°C for performance evaluation of the
sensor.
Abstract: This paper investigates several factors affecting the
cost of capital for listed Romanian companies. Although there is a
large amount of literature investigating the drivers of the cost of
capital internationally, there is currently little evidence from
emergent markets. Based on a sample of 19 Romanian listed
companies followed by financial analysts for the years 2008-2010,
according to Thomson Reuters- I/B/E/S data base, the paper confirms
the international trends, showing that size, corporate governance
policies, and growth are negatively correlated with the cost of capital.
Abstract: The aim of the paper work is to investigate and predict
the static performance of journal bearing in turbulent flow condition
considering micropolar lubrication. The Reynolds equation has been
modified considering turbulent micropolar lubrication and is solved
for steady state operations. The Constantinescu-s turbulence model is
adopted using the coefficients. The analysis has been done for a
parallel and inertia less flow. Load capacity and friction factor have
been evaluated for various operating parameters.
Abstract: In this paper, a direct torque control - space vector
modulation (DTC-SVM) scheme is presented for a six-phase speed
and voltage sensorless induction motor (IM) drive. The decoupled
torque and stator flux control is achieved based on IM stator flux field orientation. The rotor speed is detected by on-line estimating of
the rotor angular slip speed and stator vector flux speed. In addition, a simple method is introduced to estimate the stator resistance.
Moreover in this control scheme the voltage sensors are eliminated
and actual motor phase voltages are approximated by using PWM
inverter switching times and the dc link voltage. Finally, some simulation and experimental results are presented to verify the
effectiveness and capability of the proposed control scheme.
Abstract: This article explores the self-identity of the Kazakh
people by way of identifying the roots of self-understanding in
Kazakh culture. Unfortunately, Western methods of ethno
psychology cannot fully capture what is unique about identity in
Kazakh culture. Although Kazakhstan is the ninth largest country in
terms of geographical space, Kazakh cultural identity is not wellknown
in the West. In this article we offer an account of the national
psychological features of the Kazakh people, in order to reveal the
spiritual, mental, ethical dimensions of modern Kazakhs. These
factors play a central role in the revival of forms of identity that are
central to the Kazakh people.
Abstract: Pyrite (FeS2) is a promising candidate for cathode
materials in batteries because of it`s high theoretical capacity, low
cost and non-toxicity. In this study, nano size iron disulfide thin film
was prepared on graphite substrate through a new method as battery
cathode. In this way, acetylene black and poly vinylidene fluoride
were used as electron conductor and binder, respectively. Fabricated
thin films were analyzed by XRD and SEM. These results and
electrochemical data confirm improvement of battery discharge
capacity in comparison with commercial type of pyrite.
Abstract: This paper presents a method of reducing the feedback
delay time of DWA(Data Weighted Averaging) used in sigma-delta
modulators. The delay time reduction results from the elimination of
the latch at the quantizer output and also from the falling edge
operation. The designed sigma-delta modulator improves the timing
margin about 16%. The sub-circuits of sigma-delta modulator such as
SC(Switched Capacitor) integrator, 9-level quantizer, comparator, and
DWA are designed with the non-ideal characteristics taken into
account. The sigma-delta modulator has a maximum SNR (Signal to
Noise Ratio) of 84 dB or 13 bit resolution.
Abstract: IFP Group Technology “Sulfrex process" was used in
Iran-s South Pars Gas Complex Refineries for removing sulfur
compounds such as mercaptans, carbonyl sulfide and hydrogen
sulfide, which uses sulfonated cobalt phthalocyanine dispersed in
alkaline solution as catalyst. In this technology, catalyst and alkaline
solution were used circularly. However the stability of catalyst due to
effect of some parameters would reduce with the running of the unit
and therefore sweetening efficiency would be decreased. Hence, the
aim of this research is study the factors effecting on the stability of
catalyst.
Abstract: Com Poisson distribution is capable of modeling the count responses irrespective of their mean variance relation and the parameters of this distribution when fitted to a simple cross sectional data can be efficiently estimated using maximum likelihood (ML) method. In the regression setup, however, ML estimation of the parameters of the Com Poisson based generalized linear model is computationally intensive. In this paper, we propose to use quasilikelihood (QL) approach to estimate the effect of the covariates on the Com Poisson counts and investigate the performance of this method with respect to the ML method. QL estimates are consistent and almost as efficient as ML estimates. The simulation studies show that the efficiency loss in the estimation of all the parameters using QL approach as compared to ML approach is quite negligible, whereas QL approach is lesser involving than ML approach.
Abstract: In recent years, strategic alliances have taken
increasing importance as a means to control competitive forces and to
enter into new markets. Joint ventures are one of the most frequently
used contractual forms in strategic alliances. There are various
motivations for cooperation between two or more firms e.g.,
accessing to technical know-how, accessing to financial resources
and managing risks. The firms must know about these motivations to
encourage for establishing joint venture. So, it is important for
managers to understand about these motives. On the other hand, the
cooperation section is one of the most effective parts in each country.
In this way, our study identifies goals of joint venture between
cooperative manufacturing firms, and prioritizes those using
TOPSIS1. The results show that the most important of joint venture
goals are: accessing to managerial know-how, sharing total capital
investment.
Abstract: Implemented 5-bit 125-MS/s successive
approximation register (SAR) analog to digital converter (ADC) on
FPGA is presented in this paper.The design and modeling of a high
performance SAR analog to digital converter are based on monotonic
capacitor switching procedure algorithm .Spartan 3 FPGA is chosen
for implementing SAR analog to digital converter algorithm. SAR
VHDL program writes in Xilinx and modelsim uses for showing
results.
Abstract: Aggression is a multi- factorial concept and multilevel
in nature. The Young Adolescent is being influenced by family,
school and community. This paper is aimed to determine the
following: aggression level among young adolescents, difference of
level of aggression on school and year levels and to determine the
correlates of aggression. There were 142 high school students from
two different national highs schools (Region 3 and National Capital
Region).Convenience sampling was use in this study. The following
measures were used namely: Aggression Scale, Parental Support
Fighting Scale, Positive Behavior Scale and Exposure to Violence
and Trauma questionnaire. There was no significant difference in
aggression level among different year level and schools. The
findings of the study suggested that high level of community violence
and having low parental support for non-aggressive behavior
contribute to the prediction of aggression.
Abstract: With the advent of emerging personal computing paradigms such as ubiquitous and mobile computing, Web contents are becoming accessible from a wide range of mobile devices. Since these devices do not have the same rendering capabilities, Web contents need to be adapted for transparent access from a variety of client agents. Such content adaptation results in better rendering and faster delivery to the client device. Nevertheless, Web content adaptation sets new challenges for semantic markup. This paper presents an advanced components platform, called MorfeoSMC, enabling the development of mobility applications and services according to a channel model based on Services Oriented Architecture (SOA) principles. It then goes on to describe the potential for integration with the Semantic Web through a novel framework of external semantic annotation of mobile Web contents. The role of semantic annotation in this framework is to describe the contents of individual documents themselves, assuring the preservation of the semantics during the process of adapting content rendering, as well as to exploit these semantic annotations in a novel user profile-aware content adaptation process. Semantic Web content adaptation is a way of adding value to and facilitates repurposing of Web contents (enhanced browsing, Web Services location and access, etc).
Abstract: A dynamic software risk assessment model is
presented. Analogies between dynamic financial analysis and
software risk assessment models are established and based on these
analogies it suggested that dynamic risk model for software projects
is the way to move forward for the risk assessment of software
project. It is shown how software risk assessment change during
different phases of a software project and hence requires a dynamic
risk assessment model to capture these variations. Further evolution
of dynamic financial analysis models is discussed and mapped to the
evolution of software risk assessment models.
Abstract: A Novel fuzzy neural network combining with support vector learning mechanism called support-vector-based fuzzy neural networks (SVBFNN) is proposed. The SVBFNN combine the capability of minimizing the empirical risk (training error) and expected risk (testing error) of support vector learning in high dimensional data spaces and the efficient human-like reasoning of FNN.