Abstract: Finite impulse response (FIR) filters have the advantage of linear phase, guaranteed stability, fewer finite precision errors, and efficient implementation. In contrast, they have a major disadvantage of high order need (more coefficients) than IIR counterpart with comparable performance. The high order demand imposes more hardware requirements, arithmetic operations, area usage, and power consumption when designing and fabricating the filter. Therefore, minimizing or reducing these parameters, is a major goal or target in digital filter design task. This paper presents an algorithm proposed for modifying values and the number of non-zero coefficients used to represent the FIR digital pulse shaping filter response. With this algorithm, the FIR filter frequency and phase response can be represented with a minimum number of non-zero coefficients. Therefore, reducing the arithmetic complexity needed to get the filter output. Consequently, the system characteristic i.e. power consumption, area usage, and processing time are also reduced. The proposed algorithm is more powerful when integrated with multiplierless algorithms such as distributed arithmetic (DA) in designing high order digital FIR filters. Here the DA usage eliminates the need for multipliers when implementing the multiply and accumulate unit (MAC) and the proposed algorithm will reduce the number of adders and addition operations needed through the minimization of the non-zero values coefficients to get the filter output.
Abstract: The bit error rate (BER) performance for ultra-wide
band (UWB) indoor communication with impact of metallic furniture
is investigated. The impulse responses of different indoor
environments for any transmitter and receiver location are computed
by shooting and bouncing ray/image and inverse Fourier transform
techniques. By using the impulse responses of these multipath
channels, the BER performance for binary pulse amplitude
modulation (BPAM) impulse radio UWB communication system are
calculated. Numerical results have shown that the multi-path effect
by the metallic cabinets is an important factor for BER performance.
Also the outage probability for the UWB multipath environment with
metallic cabinets is more serious (about 18%) than with wooden
cabinets. Finally, it is worth noting that in these cases the present
work provides not only comparative information but also quantitative
information on the performance reduction.
Abstract: In order to perform on-line measuring and detection
of PD signals, a total solution composing of an HFCT, A/D
converter and a complete software package is proposed. The
software package includes compensation of HFCT contribution,
filtering and noise reduction using wavelet transform and soft
calibration routines. The results have shown good performance and
high accuracy.
Abstract: Temperature rise in a transformer depends on variety
of parameters such as ambient temperature, output current and type
of the core. Considering these parameters, temperature rise estimation
is still complicated procedure. In this paper, we present a new model
based on simple electrical equivalent circuit. This method avoids the
complication associated to accurate estimation and is in very good
agreement with practice.
Abstract: This paper presents the experimental results of silicone rubber polymer insulators for 22 kV systems under salt water dip wheel test based on IEC 62217. Straight shed silicone rubber polymer insulators having leakage distance 685 mm were tested continuously 30,000 cycles. One test cycle includes 4 positions, energized, de-energized, salt water dip and deenergized, respectively. For one test cycle, each test specimen remains stationary for about 40 second in each position and takes 8 second for rotate to next position. By visual observation, sever surface erosion was observed on the trunk near the energized end of tested specimen. Puncture was observed on the upper shed near the energized end. In addition, decreasing in hydrophobicity and increasing in hardness were measured on tested specimen comparing with new specimen. Furthermore, chemical analysis by ATR-FTIR was conducted in order to elucidate the chemical change of tested specimens comparing with new specimen.
Abstract: This paper aims to discuss the influence of resistance
characteristic on the high conductive concrete considering the changes
of voltage and environment. The high conductive concrete with
appropriate proportion is produced to the press-electrode method. The
curve of resistivity with the changes of voltage and environment is
plotted and the changes of resistivity are explored.
Abstract: Analytical expression for maximum power transfer
through a transmission line limited by voltage stability has been
formulated using exact representation of transmission line with
ABCD parameters. The expression has been used for plotting PV
curve at different power factors of a radial transmission line.
Limiting values of reactive power have been obtained.
Abstract: The notion of Next Generation Network (NGN) is
based on the Network Convergence concept which refers to
integration of services (such as IT and communication services) over
IP layer. As the most popular implementation of Service Oriented
Architecture (SOA), Web Services technology is known to be the
base for service integration. In this paper, we present a platform to
deliver communication services as web services. We also implement
a sample service to show the simplicity of making composite web
and communication services using this platform. A Service Logic
Execution Environment (SLEE) is used to implement the
communication services. The proposed architecture is in agreement
with Service Oriented Architecture (SOA) and also can be integrated
to an Enterprise Service Bus to make a base for NGN Service
Delivery Platform (SDP).
Abstract: With the advance in wireless networking, IEEE 802.16 WiMAX technology has been widely deployed for several applications such as “last mile" broadband service, cellular backhaul, and high-speed enterprise connectivity. As a result, military employed WiMAX as a high-speed wireless connection for data-link because of its point to multi-point and non-line-of-sight (NLOS) capability for many years. However, the risk of using WiMAX is a critical factor in some sensitive area of military applications especially in ammunition manufacturing such as solid propellant rocket production. The US DoD policy states that the following certification requirements are met for WiMAX: electromagnetic effects on the environment (E3) and Hazards of Electromagnetic Radiation to Ordnance (HERO). This paper discuses the Recommended Power Densities and Safe Separation Distance (SSD) for HERO on WiMAX systems deployed on solid propellant rocket production. The result of this research found that WiMAX is safe to operate at close proximity distances to the rocket production based on AF Guidance Memorandum immediately changing AFMAN 91-201.
Abstract: The inphase/quadrature (I/Q) amplitude and phase
imbalance effects are studied in coherent optical orthogonal
frequency division multiplexing (CO-OFDM) systems. An analytical
model for the I/Q imbalance is developed and supported by
simulation results. The results indicate that the I/Q imbalance degrades the BER performance considerably.
Abstract: HSDPA is a new feature which is introduced in
Release-5 specifications of the 3GPP WCDMA/UTRA standard to
realize higher speed data rate together with lower round-trip times.
Moreover, the HSDPA concept offers outstanding improvement of
packet throughput and also significantly reduces the packet call
transfer delay as compared to Release -99 DSCH. Till now the
HSDPA system uses turbo coding which is the best coding technique
to achieve the Shannon limit. However, the main drawbacks of turbo
coding are high decoding complexity and high latency which makes
it unsuitable for some applications like satellite communications,
since the transmission distance itself introduces latency due to
limited speed of light. Hence in this paper it is proposed to use LDPC
coding in place of Turbo coding for HSDPA system which decreases
the latency and decoding complexity. But LDPC coding increases the
Encoding complexity. Though the complexity of transmitter
increases at NodeB, the End user is at an advantage in terms of
receiver complexity and Bit- error rate. In this paper LDPC Encoder
is implemented using “sparse parity check matrix" H to generate a
codeword at Encoder and “Belief Propagation algorithm "for LDPC
decoding .Simulation results shows that in LDPC coding the BER
suddenly drops as the number of iterations increase with a small
increase in Eb/No. Which is not possible in Turbo coding. Also same
BER was achieved using less number of iterations and hence the
latency and receiver complexity has decreased for LDPC coding.
HSDPA increases the downlink data rate within a cell to a theoretical
maximum of 14Mbps, with 2Mbps on the uplink. The changes that
HSDPA enables includes better quality, more reliable and more
robust data services. In other words, while realistic data rates are
only a few Mbps, the actual quality and number of users achieved
will improve significantly.
Abstract: This paper mainly about the study on one of the
widely used error correcting codes that is Low parity check Codes
(LDPC). In this paper, the Regular LDPC code has been discussed
The LDPC codes explained in this paper is about the Regular Binary
LDPC codes or the Gallager.
Abstract: Reduction of Single Input Single Output (SISO) discrete systems into lower order model, using a conventional and an evolutionary technique is presented in this paper. In the conventional technique, the mixed advantages of Modified Cauer Form (MCF) and differentiation are used. In this method the original discrete system is, first, converted into equivalent continuous system by applying bilinear transformation. The denominator of the equivalent continuous system and its reciprocal are differentiated successively, the reduced denominator of the desired order is obtained by combining the differentiated polynomials. The numerator is obtained by matching the quotients of MCF. The reduced continuous system is converted back into discrete system using inverse bilinear transformation. In the evolutionary technique method, Particle Swarm Optimization (PSO) is employed to reduce the higher order model. PSO method is based on the minimization of the Integral Squared Error (ISE) between the transient responses of original higher order model and the reduced order model pertaining to a unit step input. Both the methods are illustrated through numerical example.
Abstract: With Power system movement toward restructuring along with factors such as life environment pollution, problems of transmission expansion and with advancement in construction technology of small generation units, it is expected that small units like wind turbines, fuel cells, photovoltaic, ... that most of the time connect to the distribution networks play a very essential role in electric power industry. With increase in developing usage of small generation units, management of distribution networks should be reviewed. The target of this paper is to present a new method for optimal management of active and reactive power in distribution networks with regard to costs pertaining to various types of dispersed generations, capacitors and cost of electric energy achieved from network. In other words, in this method it-s endeavored to select optimal sources of active and reactive power generation and controlling equipments such as dispersed generations, capacitors, under load tapchanger transformers and substations in a way that firstly costs in relation to them are minimized and secondly technical and physical constraints are regarded. Because the optimal management of distribution networks is an optimization problem with continuous and discrete variables, the new evolutionary method based on Ant Colony Algorithm has been applied. The simulation results of the method tested on two cases containing 23 and 34 buses exist and will be shown at later sections.
Abstract: Whereas cellular wireless communication systems are
subject to short-and long-term fading. The effect of wireless channel
has largely been ignored in most of the teletraffic assessment
researches. In this paper, a mathematical teletraffic model is proposed
to estimate blocking and forced termination probabilities of cellular
wireless networks as a result of teletraffic behavior as well as the
outage of the propagation channel. To evaluate the proposed
teletraffic model, gamma inter-arrival and general service time
distributions have been considered based on wireless channel fading
effect. The performance is evaluated and compared with the classical
model. The proposed model is dedicated and investigated in different
operational conditions. These conditions will consider not only the
arrival rate process, but also, the different faded channels models.
Abstract: In a very simple form a Mobile Agent is an independent piece of code that has mobility and autonomy behavior. One of the main advantages of using Mobile Agent in a network is - it reduces network traffic load. In an, ad hoc network Mobile Agent can be used to protect the network by using agent based IDS or IPS. Besides, to deploy dynamic software in the network or to retrieve information from network nodes Mobile Agent can be useful. But in an ad hoc network the Mobile Agent itself needs some security. Security services should be guaranteed both for Mobile Agent and for Agent Server. In this paper to protect the Mobile Agent and Agent Server in an ad hoc network we have proposed a solution which is based on Threshold Cryptography, a new vibe in the cryptographic world where trust is distributed among multiple nodes in the network.
Abstract: Detection and tracking of the lip contour is an important
issue in speechreading. While there are solutions for lip tracking
once a good contour initialization in the first frame is available,
the problem of finding such a good initialization is not yet solved
automatically, but done manually. We have developed a new tracking
solution for lip contour detection using only few landmarks (15
to 25) and applying the well known Active Shape Models (ASM).
The proposed method is a new LMS-like adaptive scheme based on
an Auto regressive (AR) model that has been fit on the landmark
variations in successive video frames. Moreover, we propose an extra
motion compensation model to address more general cases in lip
tracking. Computer simulations demonstrate a fair match between
the true and the estimated spatial pixels. Significant improvements
related to the well known LMS approach has been obtained via a
defined Frobenius norm index.
Abstract: In the present work we model a Multiquantum Well
structure Separate Absorption and Charge Multiplication Avalanche
Photodiode (MQW-SACM-APD), while the Absorption region
coincide with the MQW. We consider the nonuniformity of electric
field using split-step method in active region. This model is based on
the carrier rate equations in the different regions of the device. Using
the model we obtain the photocurrent, and dark current. As an
example, InGaAs/InP SACM-APD and MQW-SACM-APD are
simulated. There is a good agreement between the simulation and
experimental results.
Abstract: In this paper, we propose a novel limited feedback scheme for task planning with service robots. Instead of sending the full service robot state information for the task planning, the proposed scheme send the best-M indices of service robots with a indicator. With the indicator, the proposed scheme significantly reduces the communication overhead for task planning as well as mitigates the system performance degradation in terms of the utility. In addition, we analyze the system performance of the proposed scheme and compare the proposed scheme with the other schemes.
Abstract: Generally speaking, the mobile robot is capable of
sensing its surrounding environment, interpreting the sensed
information to obtain the knowledge of its location and the
environment, planning a real-time trajectory to reach the object. In
this process, the issue of obstacle avoidance is a fundamental topic to
be challenged. Thus, an adaptive path-planning control scheme is
designed without detailed environmental information, large memory
size and heavy computation burden in this study for the obstacle
avoidance of a mobile robot. In this scheme, the robot can gradually
approach its object according to the motion tracking mode, obstacle
avoidance mode, self-rotation mode, and robot state selection. The
effectiveness of the proposed adaptive path-planning control scheme
is verified by numerical simulations of a differential-driving mobile
robot under the possible occurrence of obstacle shapes.