Abstract: In this paper, we propose an improvement of pattern
growth-based PrefixSpan algorithm, called I-PrefixSpan. The general idea of I-PrefixSpan is to use sufficient data structure for Seq-Tree
framework and separator database to reduce the execution time and
memory usage. Thus, with I-PrefixSpan there is no in-memory database stored after index set is constructed. The experimental result
shows that using Java 2, this method improves the speed of PrefixSpan up to almost two orders of magnitude as well as the memory usage to more than one order of magnitude.
Abstract: It is important to remove manganese from water
because of its effects on human and the environment. Human
activities are one of the biggest contributors for excessive manganese
concentration in the environment. The proposed method to remove
manganese in aqueous solution by using adsorption as in carbon
nanotubes (CNT) at different parameters: The parameters are CNT
dosage, pH, agitation speed and contact time. Different pHs are pH
6.0, pH 6.5, pH 7.0, pH 7.5 and pH 8.0, CNT dosages are 5mg,
6.25mg, 7.5mg, 8.75mg or 10mg, contact time are 10 min, 32.5 min,
55 min, 87.5 min and 120 min while the agitation speeds are 100rpm,
150rpm, 200rpm, 250rpm and 300rpm. The parameters chosen for
experiments are based on experimental design done by using Central
Composite Design, Design Expert 6.0 with 4 parameters, 5 levels and
2 replications. Based on the results, condition set at pH 7.0, agitation
speed of 300 rpm, 7.5mg and contact time 55 minutes gives the
highest removal with 75.5%. From ANOVA analysis in Design
Expert 6.0, the residual concentration will be very much affected by
pH and CNT dosage. Initial manganese concentration is 1.2mg/L
while the lowest residual concentration achieved is 0.294mg/L,
which almost satisfy DOE Malaysia Standard B requirement.
Therefore, further experiments must be done to remove manganese
from model water to the required standard (0.2 mg/L) with the initial
concentration set to 0.294 mg/L.
Abstract: The design of Class A and Class AB 2-stage X band
Power Amplifier is described in this report. This power amplifier is
part of a transceiver used in radar for monitoring iron characteristics
in a blast furnace. The circuit was designed using foundry WIN
Semiconductors. The specification requires 15dB gain in the linear
region, VSWR nearly 1 at input as well as at the output, an output
power of 10 dBm and good stable performance in the band 10.9-12.2
GHz. The design was implemented by using inter-stage
configuration, the Class A amplifier was chosen for driver stage i.e.
the first amplifier focusing on the gain and the output amplifier
conducted at Class AB with more emphasis on output power.
Abstract: Two optimized strategies were successfully established
to develop biomolecule-based magnetic nanoassemblies.
Streptavidin-coated and amine-coated magnetic nanoparticles were
chosen as model scaffolds onto which double-stranded DNA and
human immunoglobulin G were specifically conjugated in succession,
using biotin-streptavidin interaction or covalent cross-linkers. The
success of this study opens the prospect of developing selective and
sensitive nanoparticle-based structures for diagnostics or drug
delivery.
Abstract: Agropyron cristatum L. Gaertn. is a native grass of
semiarid region in Iran which is quit resistant to cool and drought
climate and withstand heavy grazing. This species has close
phylogenetic relationship with Triticum and Hordeum. In this
research, the effect of seven different concentrations of growth
regulator 2,4-D on callus production and somatic embryogenesis of
A. cristatum was investigated on Murashige and Skoog medium. The
results showed that the rate of callus, embryo and neomorph were
highest in 1 mg L-1 2,4-D. Callus production was increased in 1 mg
L-1 2,4-D but dramatically decreased at 5.5 and 9 mg L-1 2,4-D. The
somatic embryos were observed at 1 and 4 mg L-1 2,4-D but matured
embryos and plantlet were only occurred at 1 mg L-1 2,4-D. There
were significant differences between 1 mg L-1 2,4-D and other
treatments for producing globular and torpedo embryos, plantlet,
rooted callus and number of roots (p
Abstract: It is well known that metallic particles reduce the
reliability of Gas-Insulated Substation (GIS) equipments by initiating
partial discharge (PDs) that can lead to breakdown and complete
failure of GIS. This paper investigates the characteristics of PDs
caused by metallic particle adhering to the solid spacer. The PD
detection and measurement were carried out by using IEC 60270
method with particles of different sizes and at different positions on
the spacer surface. The results show that a particle of certain size at
certain position possesses a unique PD characteristic as compared to
those caused by particles of different sizes and/or at different
positions. Therefore PD characteristics may be useful for the particle
size and position identification.
Abstract: This paper presents an automated inspection algorithm
for a thick plate. Thick plates typically have various types of surface
defects, such as scabs, scratches, and roller marks. These defects have
individual characteristics including brightness and shape. Therefore, it
is not simple to detect all the defects. In order to solve these problems
and to detect defects more effectively, we propose a dual light
switching lighting method and a defect detection algorithm based on
Gabor filters.
Abstract: This paper describes a computer model of Quantum Field Theory (QFT), referred to in this paper as QTModel. After specifying the initial configuration for a QFT process (e.g. scattering) the model generates the possible applicable processes in terms of Feynman diagrams, the equations for the scattering matrix, and evaluates probability amplitudes for the scattering matrix and cross sections. The computations of probability amplitudes are performed numerically. The equations generated by QTModel are provided for demonstration purposes only. They are not directly used as the base for the computations of probability amplitudes. The computer model supports two modes for the computation of the probability amplitudes: (1) computation according to standard QFT, and (2) computation according to a proposed functional interpretation of quantum theory.
Abstract: This paper proposes and implements an core transform architecture, which is one of the major processes in HEVC video compression standard. The proposed core transform architecture is implemented with only adders and shifters instead of area-consuming multipliers. Shifters in the proposed core transform architecture are implemented in wires and multiplexers, which significantly reduces chip area. Also, it can process from 4×4 to 16×16 blocks with common hardware by reusing processing elements. Designed core transform architecture in 0.13um technology can process a 16×16 block with 2-D transform in 130 cycles, and its gate count is 101,015 gates.
Abstract: In this paper we propose a novel Run Time Interface
(RTI) technique to provide an efficient environment for MPI jobs on
the heterogeneous architecture of PARAM Padma. It suggests an
innovative, unified framework for the job management interface
system in parallel and distributed computing. This approach employs
proxy scheme. The implementation shows that the proposed RTI is
highly scalable and stable. Moreover RTI provides the storage access
for the MPI jobs in various operating system platforms and improve
the data access performance through high performance C-DAC
Parallel File System (C-PFS). The performance of the RTI is
evaluated by using the standard HPC benchmark suites and the
simulation results show that the proposed RTI gives good
performance on large scale supercomputing system.
Abstract: True stress-strain curve of railhead steel is required to
investigate the behaviour of railhead under wheel loading through elasto-plastic Finite Element (FE) analysis. To reduce the rate of wear, the railhead material is hardened through annealing and
quenching. The Australian standard rail sections are not fully hardened and hence suffer from non-uniform distribution of the
material property; usage of average properties in the FE modelling can potentially induce error in the predicted plastic strains. Coupons
obtained at varying depths of the railhead were, therefore, tested under axial tension and the strains were measured using strain gauges as well as an image analysis technique, known as the Particle Image Velocimetry (PIV). The head hardened steel exhibit existence of three distinct zones of yield strength; the yield strength as the ratio of the average yield strength provided in the standard (σyr=780MPa) and
the corresponding depth as the ratio of the head hardened zone along
the axis of symmetry are as follows: (1.17 σyr, 20%), (1.06 σyr, 20%-80%) and (0.71 σyr, > 80%). The stress-strain curves exhibit limited plastic zone with fracture occurring at strain less than 0.1.
Abstract: Ultrafast doped zinc oxide crystal promised us a good
opportunity to build new instruments for ICF fusion neutron
measurement. Two pulsed neutron detectors based on ZnO crystal
wafer have been conceptually designed, the superfast ZnO timing
detector and the scintillation recoil proton neutron detection system.
The structure of these detectors was presented, and some characters
were studied as well. The new detectors could be much faster than
existing systems, and would be more competent for ICF neutron
diagnostics.
Abstract: The experimental design was 4 x 5 factorial with three
replications in fully controlled research greenhouse in Department of
Soil Sciences and Plant Nutrition, Faculty of Agriculture, University
of Selcuk in the year of 2009. Determination of tolerant chickpea
genotypes to drought was made in the research. Additionally,
sophisticated effects of drought on plant growth and development,
biochemical and physical properties or physical defense mechanisms
were presented. According to the results, the primary genotypes were
Ilgın YP (0.0063 g/gh) for leaf water capacity, 22235 70.44(%) for
relative water content, 22159 (82.47%) for real water content,
22159 (5.03 mg/l) for chlorophyll a+b, Ilgın YP (125.89 nmol
H2O2.dak-1/ mg protein-1) for peroxidase, Yunak YP (769.67
unit/ mg protein-1) for superoxide dismutase, Seydişehir YP
(16.74 μg.TA-1) for proline, Gökçe (80.01 nmol H2O2.dak-1/ mg
protein-1) for catalase. Consequently, all the genotypes
increased their enzyme activity depending on the increasing of
drought stress consider with the effects of drought stress on leaf
enzyme activity. Chickpea genotypes are increasing enzyme
activity against to drought stress.
Abstract: This paper presents a 2-D hydrodynamic model of the ablated plasma when irradiating a 50 μm Al solid target with a single pulsed ion beam. The Lagrange method is used to solve the moving fluid for the ablated plasma production and formation mechanism. In the calculations, a 10-ns-single-pulsed of ion beam with a total energy density of 120 J/cm2, is used. The results show that the ablated plasma was formed after 2 ns of ion beam irradiation and it started to expand right after 4-6 ns. In addition, the 2-D model give a better understanding of pulsed ion beam-solid target ablated plasma production and expansion process clearer.
Abstract: Text similarity measurement is a fundamental issue in
many textual applications such as document clustering, classification,
summarization and question answering. However, prevailing approaches
based on Vector Space Model (VSM) more or less suffer
from the limitation of Bag of Words (BOW), which ignores the semantic
relationship among words. Enriching document representation
with background knowledge from Wikipedia is proven to be an effective
way to solve this problem, but most existing methods still
cannot avoid similar flaws of BOW in a new vector space. In this
paper, we propose a novel text similarity measurement which goes
beyond VSM and can find semantic affinity between documents.
Specifically, it is a unified graph model that exploits Wikipedia as
background knowledge and synthesizes both document representation
and similarity computation. The experimental results on two different
datasets show that our approach significantly improves VSM-based
methods in both text clustering and classification.
Abstract: The effect of autofrettage process in strain hardened
thick-walled pressure vessels has been investigated theoretically by
finite element modeling. Equivalent von Mises stress is used as yield
criterion to evaluate the optimum autofrettage pressure and the
optimum radius of elastic-plastic junction. It has been observed that
the optimum autofrettage pressure increases along with the working
pressure. For two different working pressures, the effect of the ratio
of outer to inner radius (b/a=k) value on the optimum autofrettage
pressure is also noticed. The Optimum autofrettage pressure solely
depends on K value rather than on the inner or outer radius.
Furthermore, percentage reduction of von Mises stresses is compared
for different working pressures and different k values. Maximum von
Mises stress developed at different autofrettage pressure is equated
for elastic perfectly plastic and elastic-plastic material with different
slope of strain hardening segment. Cylinder material having higher
slope of strain hardening segment provides better benedictions in the
autofrettage process.
Abstract: Breast cancer is one of the most frequent occurring cancers in women throughout the world including U.K. The grading of this cancer plays a vital role in the prognosis of the disease. In this paper we present an overview of the use of advanced computational method of fuzzy inference system as a tool for the automation of breast cancer grading. A new spectral data set obtained from Fourier Transform Infrared Spectroscopy (FTIR) of cancer patients has been used for this study. The future work outlines the potential areas of fuzzy systems that can be used for the automation of breast cancer grading.
Abstract: The study investigated the educational implications
that can be derived from the work of a variety of celebrated figures
such as Piaget, Vygotsky, and Bruner that will be helpful in the field
of language learning. However, the writer believed these views were
previously expressed not full–fledged by Comenius who has been
described by Howatt (1984) as a genius–the one that the history of
language teaching can claim. And we owe to him more than anyone.
Abstract: One of the biggest problems of SMEs is their tendencies to financial distress because of insufficient finance background. In this study, an Early Warning System (EWS) model based on data mining for financial risk detection is presented. CHAID algorithm has been used for development of the EWS. Developed EWS can be served like a tailor made financial advisor in decision making process of the firms with its automated nature to the ones who have inadequate financial background. Besides, an application of the model implemented which covered 7,853 SMEs based on Turkish Central Bank (TCB) 2007 data. By using EWS model, 31 risk profiles, 15 risk indicators, 2 early warning signals, and 4 financial road maps has been determined for financial risk mitigation.
Abstract: Cryo-electron microscopy (CEM) in combination with
single particle analysis (SPA) is a widely used technique for
elucidating structural details of macromolecular assemblies at closeto-
atomic resolutions. However, development of automated software
for SPA processing is still vital since thousands to millions of
individual particle images need to be processed. Here, we present our
workflow for automated particle picking. Our approach integrates
peak shape analysis to the classical correlation and an iterative
approach to separate macromolecules and background by
classification. This particle selection workflow furthermore provides
a robust means for SPA with little user interaction. Processing
simulated and experimental data assesses performance of the
presented tools.