Abstract: The renewable energy has been attracting attention as
a new alternative energy due to the problem of environmental
pollution and resource depletion. In particular, daylighting and PV
system are regarded as the solutions. In this paper, the hybrid
dimming control system supplied by solar cell and daylighting
system was designed. Daylighting system is main source and PV
system is spare source. PV system operates the LED lamp which
supports daylighting system because daylighting system is unstable
due to the variation of irradiance. In addition, PV system has a role
charging batteries. Battery charging has a benefit that PV system
operate LED lamp in the bad weather. However, LED lamp always
can`t turn on that-s why dimming control system was designed. In
particular, the solar charging robot was designed to check the
interior irradiance intensity. These systems and the application of
the solar charging robot are expected to contribute developing
alternative energy in the near future.
Abstract: Active vibration isolation systems are less commonly
used than passive systems due to their associated cost and power
requirements. In principle, semi-active isolation systems can deliver
the versatility, adaptability and higher performance of fully active
systems for a fraction of the power consumption. Various semi-active
control algorithms have been suggested in the past. This paper
studies the 4DOF model of semi-active suspension performance
controlled by on–off and continuous skyhook damping control
strategy. The frequency and transient responses of model are
evaluated in terms of body acceleration, roll angle and tire deflection
and are compared with that of a passive damper. The results show
that the semi-active system controlled by skyhook strategy always
provides better isolation than a conventional passively damped
system except at tire natural frequencies.
Abstract: A synchronous network-on-chip using wormhole packet switching
and supporting guaranteed-completion best-effort with low-priority (LP)
and high-priority (HP) wormhole packet delivery service is presented in
this paper. Both our proposed LP and HP message services deliver a good
quality of service in term of lossless packet completion and in-order message
data delivery. However, the LP message service does not guarantee minimal
completion bound. The HP packets will absolutely use 100% bandwidth of
their reserved links if the HP packets are injected from the source node with
maximum injection. Hence, the service are suitable for small size messages
(less than hundred bytes). Otherwise the other HP and LP messages, which
require also the links, will experience relatively high latency depending on the
size of the HP message. The LP packets are routed using a minimal adaptive
routing, while the HP packets are routed using a non-minimal adaptive routing
algorithm. Therefore, an additional 3-bit field, identifying the packet type,
is introduced in their packet headers to classify and to determine the type
of service committed to the packet. Our NoC prototypes have been also
synthesized using a 180-nm CMOS standard-cell technology to evaluate the
cost of implementing the combination of both services.
Abstract: Data mining, which is the exploration of
knowledge from the large set of data, generated as a result of
the various data processing activities. Frequent Pattern Mining
is a very important task in data mining. The previous
approaches applied to generate frequent set generally adopt
candidate generation and pruning techniques for the
satisfaction of the desired objective. This paper shows how
the different approaches achieve the objective of frequent
mining along with the complexities required to perform the
job. This paper will also look for hardware approach of cache
coherence to improve efficiency of the above process. The
process of data mining is helpful in generation of support
systems that can help in Management, Bioinformatics,
Biotechnology, Medical Science, Statistics, Mathematics,
Banking, Networking and other Computer related
applications. This paper proposes the use of both upward and
downward closure property for the extraction of frequent item
sets which reduces the total number of scans required for the
generation of Candidate Sets.
Abstract: We propose a method for discrimination and
classification of ovarian with benign, malignant and normal tissue
using independent component analysis and neural networks. The
method was tested for a proteomic patters set from A database, and
radial basis functions neural networks. The best performance was
obtained with probabilistic neural networks, resulting I 99% success
rate, with 98% of specificity e 100% of sensitivity.
Abstract: A simple approach is demonstrated for growing large
scale, nearly vertically aligned ZnO nanowire arrays by thermal
oxidation method. To reveal effect of temperature on growth and
physical properties of the ZnO nanowires, gold coated zinc substrates
were annealed at 300 °C and 400 °C for 4 hours duration in air. Xray
diffraction patterns of annealed samples indicated a set of well
defined diffraction peaks, indexed to the wurtzite hexagonal phase of
ZnO. The scanning electron microscopy studies show formation of
ZnO nanowires having length of several microns and average of
diameter less than 500 nm. It is found that the areal density of wires
is relatively higher, when the annealing is carried out at higher
temperature i.e. at 400°C. From the field emission studies, the values
of the turn-on and threshold field, required to draw emission current
density of 10 μA/cm2 and 100 μA/cm2 are observed to be 1.2 V/μm
and 1.7 V/μm for the samples annealed at 300 °C and 2.9 V/μm and
3.7 V/μm for that annealed at 400 °C, respectively. The field
emission current stability, investigated over duration of more than 2
hours at the preset value of 1 μA, is found to be fairly good in both
cases. The simplicity of the synthesis route coupled with the
promising field emission properties offer unprecedented advantage
for the use of ZnO field emitters for high current density
applications.
Abstract: In this study, we examined gender differences in: (1) a
flexible remembering task, that asked for episodic memory decisions
at an item-specific versus category-based level, and (2) the retrieval
specificity of autobiographical memory during free recall.
Differences favouring women were found on both measures.
Furthermore, a significant association was observed, across gender
groups, between level of specificity in the autobiographical memory
interview and sensitivity to gist on the flexible remembering task.
These results suggest that similar cognitive processes may partially
contribute to both the ability for specific autobiographical recall and
the capacity for inhibition of gist-information on the flexible
remembering task.
Abstract: Speeded-Up Robust Feature (SURF) is commonly used for feature matching in stereovision because of their robustness towards scale changes and rotational changes. However, SURF feature cannot cope with large viewpoint changes or skew distortion. This paper introduces a method which can help to improve the wide baseline-s matching performance in term of accuracy by rectifying the image using two vanishing points. Simplified orientation correction was used to remove the false matching..
Abstract: The performances of small and medium enterprises
have stagnated in the last two decades. This has mainly been due to
the emergence of HIV / Aids. The disease has had a detrimental
effect on the general economy of the country leading to morbidity
and mortality of the Kenyan workforce in their primary age. The
present study sought to establish the economic impact of HIV / Aids
on the micro-enterprise development in Obunga slum – Kisumu, in
terms of production loss, increasing labor related cost and to establish
possible strategies to address the impact of HIV / Aids on microenterprises.
The study was necessitated by the observation that most
micro-enterprises in the slum are facing severe economic and social
crisis due to the impact of HIV / Aids, they get depleted and close
down within a short time due to death of skilled and experience
workforce. The study was carried out between June 2008 and June
2009 in Obunga slum. Data was subjected to computer aided
statistical analysis that included descriptive statistic, chi-squared and
ANOVA techniques. Chi-squared analysis on the micro-enterprise
owners opinion on the impact of HIV / Aids on depletion of microenterprise
compared to other diseases indicated high levels of the
negative effects of the disease at significance levels of P
Abstract: The role of corporate governance is to reduce the
divergence of interests between shareholders and managers. The role
of corporate governance is more useful when managers have an
incentive to deviate from shareholders- interests. One example of
management-s deviation from shareholders- interests is the
management of earnings through the use of accounting accruals. This
paper examines the association between corporate governance
internal mechanisms ownership concentration, board independence,
the existence of CEO-Chairman duality and earnings management.
Firm size and leverage are control variables. The population used in
this study comprises firms listed on the Tehran Stock Exchange
(TSE) between 2004 and 2008, the sample comprises 196 firms.
Panel Data method is employed as technique to estimate the model.
We find that there is negative significant association between
ownership concentration and board independence manage earnings
with earnings management, there is negative significant association
between the existence of CEO-Chairman duality and earnings
management. This study also found a positive significant association
between control variable (firm size and leverage) and earnings
management.
Abstract: In this paper, the transformers over-load problem of Shiraz substation in Fars Regional Electric Company (FREC) is investigated for a period of three years plan. So the suggestions for using phase shifting transformer (PST) and unified power flow controller (UPFC) in order to solve this problem are examined in details and finally, some economical and practical designs will be given in order to solve the related problems. Practical consideration and using the basic and fundamental concept of powers in transmission lines in order to find the economical design are the main advantages of this research. The simulation results of the integrated overall system with different designs compare them base on economical and practical aspects to solve the over-load and loss-reduction.
Abstract: The rate of nitrate adsorption by a nitrate selective ion
exchange resin was investigated in a well-stirred batch experiments.
The kinetic experimental data were simulated with diffusion models including external mass transfer, particle diffusion and chemical
adsorption. Particle pore volume diffusion and particle surface diffusion were taken into consideration separately and simultaneously
in the modeling. The model equations were solved numerically using the Crank-Nicholson scheme. An optimization technique was
employed to optimize the model parameters. All nitrate concentration
decay data were well described with the all diffusion models. The
results indicated that the kinetic process is initially controlled by external mass transfer and then by particle diffusion. The external
mass transfer coefficient and the coefficients of pore volume diffusion and surface diffusion in all experiments were close to each
other with the average value of 8.3×10-3 cm/S for external mass
transfer coefficient. In addition, the models are more sensitive to the
mass transfer coefficient in comparison with particle diffusion. Moreover, it seems that surface diffusion is the dominant particle
diffusion in comparison with pore volume diffusion.
Abstract: Recognition of characters greatly depends upon the features used. Several features of the handwritten Arabic characters are selected and discussed. An off-line recognition system based on the selected features was built. The system was trained and tested with realistic samples of handwritten Arabic characters. Evaluation of the importance and accuracy of the selected features is made. The recognition based on the selected features give average accuracies of 88% and 70% for the numbers and letters, respectively. Further improvements are achieved by using feature weights based on insights gained from the accuracies of individual features.
Abstract: This paper presents an overview of the multiobjective shortest path problem (MSPP) and a review of essential and recent issues regarding the methods to its solution. The paper further explores a multiobjective evolutionary algorithm as applied to the MSPP and describes its behavior in terms of diversity of solutions, computational complexity, and optimality of solutions. Results show that the evolutionary algorithm can find diverse solutions to the MSPP in polynomial time (based on several network instances) and can be an alternative when other methods are trapped by the tractability problem.
Abstract: In this study we propose a novel monitor hydraulic
automatic gauge control (HAGC) system based on fuzzy feedforward
controller. This is used in the development of cold rolling
mill automation system to improve the quality of cold strip. According to features/ properties of entry steel strip like its average
yield stress, width of strip, and desired exit thickness, this controller realizes the compensation for the exit thickness error. The traditional methods of adjusting the roller position, can-t tolerate the variance in
the entry steel strip. The proposed method uses a mathematical model
of the system together with the expert knowledge to perform this adjustment while minimizing the effect of the stated problem. In
order to improve the speed of the controller in rejecting disturbances
introduced by entry strip thickness variations, expert knowledge is added as a feed-forward term to the HAGC system. Simulation
results for the application of the proposed controller to a real cold mill show that the exit strip quality is highly improved.
Abstract: The study presents a brief and synthetic discussion of selected conclusions resulting from multidimensional and in-depth empirical studies. Its theoretical part presents the assumptions referring to social responsibility management from the perspective of the specific nature of small enterprise functioning, while the empirical part presents the selected dysfunctions and paradoxes in social responsibility management referring to this group of enterprises. The paper is summarized by a short list of the resulting recommendations.
Abstract: Elastic and inelastic scattering of α-particles by 9Be nuclei at different incident energies have been analyzed. Optical model parameters (OMPs) of α-particles elastic scattering by 9Be at different energies have been obtained. Coupled Reaction Channel (CRC) of elastic scattering, inelastic scattering and transfer reaction has been calculated using Fresco Code. The effect of involving CRC calculations on the analysis of differential cross section has been studied. The transfer reaction of (5He) in the reaction 9Be(α,9Be)α has been studied. The spectroscopic factor of 9Be≡α+5He has been extracted.
Abstract: In order to study the influence of different methods of controlling weeds such as mechanical weeding and mechanical weeder efficiency analysis in mechanical cultivation conditions, in farming year of 2011 an experiment was done in a farm in coupling and development of technology center in Haraz,Iran. The treatments consisted of (I) control treatment: where no weeding was done, (II) use of mechanical weeding without engine and (III) power mechanical weeding. Results showed that experimental treatments had significantly different effects (p=0.05) on yield traits and number of filled grains per panicle, while treatments had the significant effects on grain weight and dry weight of weeds in the first, second and third weeding methods at 1% of confidence level. Treatment (II) had its most significant effect on number of filled grains per panicle and yield performance standpoint, which was 3705.97 kg ha-1 in its highest peak. Treatment (III) was ranked as second influential with 3559.8 kg ha-1. In addition, under (I) treatments, 2364.73 kg ha-1 of yield produced. The minimum dry weights of weeds in all weeding methods were related to the treatment (II), (III) and (I), respectively. The correlation coefficient analysis showed that total yield had a significant positive correlation with the panicle grain yield per plant (r= 0.55*) and the number of grains per panicle-1 (r= 0.57*) and the number of filled grains (r= 0.63*). Total rice yield also had negative correlation of r= -0. 64* with weed dry weight at second weed sampling time (17 DAT). The weed dry weight at third and fourth sampling times (24 and 40 DAT) had negative correlations of -0.65** and r=-0.61* with rice yield, respectively.
Abstract: Losses of surfactant due to sorption need to be
considered when selecting surfactant doses for soil bioremediation.
The degree of surfactant sorption onto soil depends primarily on the
organic carbon fraction of soil and the chemical nature of the
surfactant. The use of biosurfactants in the control of the
bioavailability of toxicants in soils is an attractive option because of
their biodegradability. In this work biosurfactants were produced
from a cheap raw material, trimming vine shoots, employing
Lactobacillus pentosus. When biosurfactants from L. pentosus was
added to sediments the surface tensión of the water containing the
sediments rapidly increase, the same behaviour was observed with
the chemical surfactant Tween 20; whereas sodyum dodecyl sulphate
(SDS) kept the surface tension of the water around 36 mN/m. It
means, that the behaviour of biosurfactants from L. pentosus is more
similar to non-ionic surfactatns than to anionic surfactants.
Abstract: In article the data of chronic toxicity for pre-clinical
researches of Ramon preparation is described. Ramon effects to
hormone system and gastrointestinal tract; local irritative effect,
allergic, pyrogenic properties and reaction to the immune system
were studied.