Abstract: The ferroelectric behavior of barium strontium
titanate (BST) in thin film form has been investigated in order to
study the possibility of using BST for ferroelectric gate-field effect
transistor (FeFET) for memory devices application. BST thin films
have been fabricated as Al/BST/Pt/SiO2/Si-gate configuration. The
variation of the dielectric constant (ε) and tan δ with frequency have
been studied to ensure the dielectric quality of the material. The
results show that at low frequencies, ε increases as the Ba content
increases, whereas at high frequencies, it shows the opposite
variation, which is attributed to the dipole dynamics. tan δ shows low
values with a peak at the mid-frequency range. The ferroelectric
behavior of the Al/BST/Pt/SiO2/Si has been investigated using C-V
characteristics. The results show that the strength of the ferroelectric
hysteresis loop increases as the Ba content increases; this is attributed
to the grain size and dipole dynamics effect.
Abstract: In this paper, a direct method based on variable step
size Block Backward Differentiation Formula which is referred as
BBDF2 for solving second order Ordinary Differential Equations
(ODEs) is developed. The advantages of the BBDF2 method over the
corresponding sequential variable step variable order Backward
Differentiation Formula (BDFVS) when used to solve the same
problem as a first order system are pointed out. Numerical results are
given to validate the method.
Abstract: Recently, the findings on the MEG iterative scheme has demonstrated to accelerate the convergence rate in solving any system of linear equations generated by using approximation equations of boundary value problems. Based on the same scheme, the aim of this paper is to investigate the capability of a family of four-point block iterative methods with a weighted parameter, ω such as the 4 Point-EGSOR, 4 Point-EDGSOR, and 4 Point-MEGSOR in solving two-dimensional elliptic partial differential equations by using the second-order finite difference approximation. In fact, the formulation and implementation of three four-point block iterative methods are also presented. Finally, the experimental results show that the Four Point MEGSOR iterative scheme is superior as compared with the existing four point block schemes.
Abstract: The article deals with pneumatic and hot wire
anemometry measurement on subsonic axi-symmetric air ejector.
Performances of the ejector with and without pulsations of primary
flow are compared, measuring of characteristic pressures and mass
flow rates are performed and ejector efficiency is evaluated. The
pulsations of primary flow are produced by a synthetic jet generator,
which is placed in the supply line of the primary flow just in front of
the primary nozzle. The aim of the pulsation is to intensify the
mixing process. In the article we present: Pressure measuring of
pulsation on the mixing chamber wall, behind the mixing chamber
and behind the diffuser measured by fast pressure transducers and
results of hot wire anemometry measurement. It was found out that
using of primary flow pulsations yields higher back pressure behind
the ejector and higher efficiency. The processes in this ejector and
influences of primary flow pulsations on the mixing processes are
described.
Abstract: In this article the authors are researching cultural
differences between rural and urban characters in case of
contemporary Kazakh cinema.Two motion pictures are analyzed:
“Strizh" (2007) by AbaiKulbai and “Seker" (2009) by
SabitKurmanbekov.According to the authors- opinion ateenage girl
characters in these two films reflect two cultures (urban and rural) of
Kazakh society, which displays complicated socio-cultural processes
of modern Kazakhstan.
Abstract: Antioxidant activities of ethanolic extracts of Ardisia
japonica Blume., Ageartum conyzoides Linn., and Cocculus hirsutus
Linn Diels. leaves was determined qualitatively and quantitatively in
this research. 1, 1-diphenyl-2-picrylhydrazyl (DPPH) free radical
solution was used to investigate free radical scavenging activity of
these leaves extracts. Ascorbic acid (Vitamin C) was used as the
standard. In the present investigation, it is found that all of these
extracts have remarkable antioxidant activities. The EC50 values of
these ethanolic extracts were 12.72 μg/ml for A. japonica, 15.19
μg/ml for A. conyzoides, 10.68 μg/ml for C. hirsutus respectively.
Among these Myanmar medicinal plants, C. hirsutus showed higher
antioxidant activities as well as free radical scavenging activity than
black tea (Camellia sinensis), the famous antioxidant, and A.
japonica and A. conyzoides showed a rather lower antioxidant
activity than tea extracts. According to results from bioassay with
carrot discs infected with Agrobacterium tumefaciens, all extracts
showed anti-tumor activity after 3 weeks of incubation. No gall was
detected in carrot disks treated with C. hirsutus and A. japonica
extracts in the dose of 100ppm and in carrot discs treated with A.
conyzoides extract in the dose of 1000 ppm. Therefore, the research
clearly indicates that these weedy plants of dry farm land are
exceptionally advantageous for human health.
Abstract: The indistinctness of the manufacturing processes makes that a parts cannot be realized in an absolutely exact way towards the specifications on the dimensions. It is thus necessary to assume that the effectively realized product has to belong in a very strict way to compatible intervals with a correct functioning of the parts. In this paper we present an approach based on mixing tow different characteristics theories, the fuzzy system and Petri net system. This tool has been proposed to model and control the quality in an assembly system. A robust command of a mechanical assembly process is presented as an application. This command will then have to maintain the specifications interval of parts in front of the variations. It also illustrates how the technique reacts when the product quality is high, medium, or low.
Abstract: This paper investigates the optimization problem of
multi-product aggregate production planning (APP) with fuzzy data.
From a comprehensive viewpoint of conserving the fuzziness of input
information, this paper proposes a method that can completely
describe the membership function of the performance measure. The
idea is based on the well-known Zadeh-s extension principle which
plays an important role in fuzzy theory. In the proposed solution
procedure, a pair of mathematical programs parameterized by
possibility level a is formulated to calculate the bounds of the
optimal performance measure at a . Then the membership function of
the optimal performance measure is constructed by enumerating
different values of a . Solutions obtained from the proposed method
contain more information, and can offer more chance to achieve the
feasible disaggregate plan. This is helpful to the decision-maker in
practical applications.
Abstract: Studies on residential satisfaction have been actively
discussed under family house setting. However, limited studies have
been conducted on student residential satisfaction. This study is an
attempt to fill the research gap. It focuses on the influence of socioeconomic
on students- satisfaction with the universities- student
housing facilities. The students who stayed at the on-campus student
housing were the respondents. This study employed two-stage cluster
sampling method in classifying the respondents. Self-administered
questionnaires were distributed face-to-face to the students. In
general, it is confirmed that students- socio-economic backgrounds
have influence on the students- satisfaction with their housing
facilities. The main influential factors were the students- economic
status, sense of sharing, and ethnicity of their roommates.
Furthermore, this study could also provide a useful feedback for the
universities in order to improve their student housing facilities.
Abstract: Taking into account the link between the efficiency of
a detector and the complexity of a stealth mechanism, we propose in
this paper a new formalism for stealth using graph theory.
Abstract: Lignocellulosic materials are new targeted source to
produce second generation biofuels like biobutanol. However, this
process is significantly resisted by the native structure of biomass.
Therefore, pretreatment process is always essential to remove
hemicelluloses and lignin prior to the enzymatic hydrolysis.
The goals of pretreatment are removing hemicelluloses and
lignin, increasing biomass porosity, and increasing the enzyme
accessibility. The main goal of this research is to study the important
variables such as pretreatment temperature and time, which can give
the highest total sugar yield in pretreatment step by using dilute
phosphoric acid. After pretreatment, the highest total sugar yield of
13.61 g/L was obtained under an optimal condition at 140°C for 10
min of pretreatment time by using 1.75% (w/w) H3PO4 and at 15:1
liquid to solid ratio. The total sugar yield of two-stage process
(pretreatment+enzymatic hydrolysis) of 27.38 g/L was obtained.
Abstract: Kuwait-s electric power system is vertically integrated
organization owned and operated by the government. For more than
five decades, the government of Kuwait has provided relatively
reliable electric services to consumers with subsidized electric
service fees. Given the country-s rapid socio-economical
development and consequently the increase of electricity demand, a
question that inflicts itself: Is it necessary to reform the power system
to face the fast growing demand? This paper recommends that the
government should consider the private sector as a partner in
operating the power system. Therefore, power system restructuring is
needed to allow such partnership. There are challenges that prevent
such restructuring. Abstract recommendations toward resolving these
challenges are proposed.
Abstract: In the previous multi-solid models,¤ò approach is
used for the calculation of fugacity in the liquid phase. For the first
time, in the proposed multi-solid thermodynamic model,γ approach
has been used for calculation of fugacity in the liquid mixture.
Therefore, some activity coefficient models have been studied that
the results show that the predictive Wilson model is more appropriate
than others. The results demonstrate γ approach using the predictive
Wilson model is in more agreement with experimental data than the
previous multi-solid models. Also, by this method, generates a new
approach for presenting stability analysis in phase equilibrium
calculations. Meanwhile, the run time in γ approach is less than the
previous methods used ¤ò approach. The results of the new model
present 0.75 AAD % (Average Absolute Deviation) from the
experimental data which is less than the results error of the previous
multi-solid models obviously.
Abstract: Resource-constrained project scheduling is an NPhard
optimisation problem. There are many different heuristic
strategies how to shift activities in time when resource requirements
exceed their available amounts. These strategies are frequently based
on priorities of activities. In this paper, we assume that a suitable
heuristic has been chosen to decide which activities should be
performed immediately and which should be postponed and
investigate the resource-constrained project scheduling problem
(RCPSP) from the implementation point of view. We propose an
efficient routine that, instead of shifting the activities, extends their
duration. It makes it possible to break down their duration into active
and sleeping subintervals. Then we can apply the classical Critical
Path Method that needs only polynomial running time. This
algorithm can simply be adapted for multiproject scheduling with
limited resources.
Abstract: Biological reactions of individuals of a testing animal
to toxic substance are unique and can be used as an indication of the
existing of toxic substance. However, to distinguish such phenomenon
need a very complicate system and even more complicate to analyze
data in 3 dimensional. In this paper, a system to evaluate in vitro
biological activities to acute toxicity of stochastic self-affine
non-stationary signal of 3D goldfish swimming by using fractal
analysis is introduced. Regular digital camcorders are utilized by
proposed algorithm 3DCCPC to effectively capture and construct 3D
movements of the fish. A Critical Exponent Method (CEM) has been
adopted as a fractal estimator. The hypothesis was that the swimming
of goldfish to acute toxic would show the fractal property which
related to the toxic concentration. The experimental results supported
the hypothesis by showing that the swimming of goldfish under the
different toxic concentration has fractal properties. It also shows that
the fractal dimension of the swimming related to the pH value of FD Ôëê
0.26pH + 0.05. With the proposed system, the fish is allowed to swim
freely in all direction to react to the toxic. In addition, the trajectories
are precisely evaluated by fractal analysis with critical exponent
method and hence the results exhibit with much higher degree of
confidence.
Abstract: The need to increase the efficiency of health care
systems is becoming an obligation, and one of area of improvement
is the discharge process. The objective of this work is to minimize
the patients discharge time (for insured patients) to be less than 50
minutes by using six sigma approach, this improvement will also:
lead to an increase in customer satisfaction, increase the number of
admissions and turnover on the rooms, increase hospital
profitability.Three different departments were considered in this
study: Female, Male, and Paediatrics. Six Sigma approach coupled
with simulation has been applied to reduce the patients discharge
time for pediatrics, female, and male departments at hospital. Upon
applying these recommendations at hospital: 60%, 80%, and 22% of
insured female, male, and pediatrics patients respectively will have
discharge time less than the upper specification time i.e. 50 min.
Abstract: As every system conceptions the concept of crisis is
based on the system of interdependent elements. These dialectic
elements occur in a majority of definitions even though called
differently. For further theoretical searching but also for practical
utilization it is necessary to understand these elements. The paper
stresses that the concept of crisis is ambiguous. There are identified
and explained the elements that are generally found in most crises
(disruption, precondition, triggers etc).
Abstract: Biodisel is a type of biofuel having similar properties of diesel fuel but lacks substances (undesirable emissions) such as sulfur, nitrogen and aromatic polycyclic. Upon filtration of waste oil, the biodiesel fuel was produced via carrying out transestrification reaction of triglycerides followed by conducting viscosity, density, flash point, cloud point, pour point and copper strip corrosion tests on the samples and comparing with EN14214 and ASTM 6751 standards and all results were found in the permitted limit. The highest yield of biodiesel production reaction was found 46.6435 g when Sodium Hydroxide catalyst in amount of 0.375g was employed, 44.2347 g when Sodium methoxide catalyst in amount of 0.5g was employed and 56.5124 g when acid sulfuric catalyst in amount of 1g was employed and 47.3290 g when two stage reaction was done.
Abstract: In this paper, we propose a novel metal oxide
semiconductor field effect transistor with L-shaped channel structure
(LMOS), and several type of L-shaped structures are also designed,
studied and compared with the conventional MOSFET device for the
same average gate length (Lavg). The proposed device electrical
characteristics are analyzed and evaluated by three dimension (3-D)
ISE-TCAD simulator. It can be confirmed that the LMOS devices
have higher on-state drain current and both lower drain-induced
barrier lowering (DIBL) and subthreshold swing (S.S.) than its
conventional counterpart has. In addition, the transconductance and
voltage gain properties of the LMOS are also improved.
Abstract: The use of magnetic and magnetic/gold core/shell
nanoparticles in biotechnology or medicine has shown good promise
due to their hybrid nature which possesses superior magnetic and
optical properties. Some of these potential applications include
hyperthermia treatment, bio-separations, diagnostics, drug delivery
and toxin removal. Synthesis refinement to control geometric and
magnetic/optical properties, and finding functional surfactants for
biomolecular attachment, are requirements to meet application
specifics.
Various high-temperature preparative methods were used for the
synthesis of iron oxide and gold-coated iron oxide nanoparticles.
Different surface functionalities, such as 11-aminoundecanoic and
11-mercaptoundecanoic acid, were introduced on the surface of the
particles to facilitate further attachment of biomolecular functionality
and drug-like molecules. Nanoparticle thermal stability, composition,
state of aggregation, size and morphology were investigated and the
results from techniques such as Fourier Transform-Infra Red
spectroscopy (FT-IR), Ultraviolet visible spectroscopy (UV-vis),
Transmission Electron Microscopy (TEM) and thermal analysis are
discussed.