Abstract: The aim of this paper is to examine the relationship among CO2 per capita emissions, energy consumption, economic growth and bilateral trade between Singapore and Malaysia for the 1970-2011 period. ARDL model and Granger causality tests are employed for the analysis. Results of bound F-statistics suggest that long-run relationship exists between CO2 per capita (PCO2) and its determinants. The EKC hypothesis is not supported in Malaysia. Carbon emissions are mainly determined by energy consumption in the short and long run. While, exports to Singapore is a significant variable in explaining PCO2 emissions in Malaysia in long-run. Furthermore, we find a unidirectional causal relationship running from economic growth to PCO2 emissions.
Abstract: The industrial automation is dependent upon pneumatic control systems. The industrial units are now controlled with digital control systems to tackle the process variables like Temperature, Pressure, Flow rates and Composition.
This research work produces an evaluation of the response time fluctuations for proportional mode, proportional integral and proportional integral derivative modes of automated chemical process control. The controller output is measured for different values of gain with respect to time in three modes (P, PI and PID). In case of P-mode for different values of gain the controller output has negligible change. When the controller output of PI-mode is checked for constant gain, it can be seen that by decreasing the integral time the controller output has showed more fluctuations. The PID mode results have found to be more interesting in a way that when rate minute has changed, the controller output has also showed fluctuations with respect to time. The controller output for integral mode and derivative mode are observed with lesser steady state error, minimum offset and larger response time to control the process variable. The tuning parameters in case of P-mode are only steady state gain with greater errors with respect to controller output. The integral mode showed controller outputs with intermediate responses during integral gain (ki). By increasing the rate minute the derivative gain (kd) also increased which showed the controlled oscillations in case of PID mode and lesser overshoot.
Abstract: This paper presents device simulations on the vertical silicon nanowire tunneling FET (VSiNW TFET). Simulations show that a narrow nanowire and thin gate oxide is required for good performance, which is expected even for conventional MOSFETs. The gate length also needs to be more than the nanowire diameter to prevent short channel effects. An effect more unique to TFET is the need for abrupt source to channel junction, which is shown to improve the performance. The ambipolar effect suppression by reducing drain doping concentration is also explored and shown to have little or no effect on performance.
Abstract: It can be determined in preference between
representative mechanical and mathematical model of elasticcreeping
deformation of transversally isotropic array with doubly
periodic system of tilted slots, and offer of the finite elements
calculation scheme, and inspection of the states of two diagonal
arbitrary profile cavities of deep inception, and in setting up the tense
and dislocation fields distribution nature in computing processes.
Abstract: Purpose: To compare attitudes and perceptions of
Israeli native born mothers versus former Soviet Union (FSU)
immigrant mothers regarding the physical health of their infant.
Methodology: cross-sectional design. A convenience sample of 50
participants was recruited by face to face and snowball technique. A
questionnaire was constructed according to the instructions of the
Ministry of Health for the care and treatment of infants. The main
areas explored were: sources of knowledge that the young mother
acquired regarding the care of her infant, ways of caring for the
infant, hygiene and sanitary habits, and the pattern of referral to
health professionals. The last topic relates to emotions mothers might
experience towards their infant.
Results: Mothers from both cultural groups present some similar
caring behaviors, which may express a universal aspect of mothers'
behavior towards their infants. However, immigrant mothers differ
significantly from native born by relying less on their mothers' and
grandmothers' experience, they wean their infants from diapers
earlier, they are stricter about hygiene and sanitary habits and they
tend to consult a physician when their infant has low fever. Native
born and immigrant mothers differ in their expressions of pride and
wonder. Immigrant mothers report of a lesser degree of these
emotions towards their infants than native born mothers.
Conclusion: The theoretical model of socialization and
acculturation of immigrant mothers is employed as an explanatory
model for the current findings Young immigrant mothers undergo a
complex acculturation process and adapt behavioral patterns in
various areas to comply with Israeli norms and values, demonstrating
assimilation. In other areas they adhere to the norms of their original
culture.
Abstract: Now a days video data embedding approach is a very challenging and interesting task towards keeping real time video data secure. We can implement and use this technique with high-level applications. As the rate-distortion of any image is not confirmed, because the gain provided by accurate image frame segmentation are balanced by the inefficiency of coding objects of arbitrary shape, with a lot factors like losses that depend on both the coding scheme and the object structure. By using rate controller in association with the encoder one can dynamically adjust the target bitrate. This paper discusses about to keep secure videos by mixing signature data with negligible distortion in the original video, and to keep steganographic video as closely as possible to the quality of the original video. In this discussion we propose the method for embedding the signature data into separate video frames by the use of block Discrete Cosine Transform. These frames are then encoded by real time encoding H.264 scheme concepts. After processing, at receiver end recovery of original video and the signature data is proposed.
Abstract: Building a service-centric business model requires
new knowledge and capabilities in companies. This paper enlightens
the challenges small and medium sized firms (SMEs) face when
developing their service-centric business models. This paper
examines the premise for knowledge transfer and capability
development required. The objective of this paper is to increase
knowledge about SME-s transformation to service-centric business
models.This paper reports an action research based case study. The
paper provides empirical evidence from three case companies. The
empirical data was collected through multiple methods. The findings
of the paper are: First, the developed model to analyze the current
state in companies. Second, the process of building the service –
centric business models. Third, the selection of suitable service
development methods. The lack of a holistic understanding on
service logic suggests that SMEs need practical and easy to use
methods to improve their business
Abstract: The adsorption of bovine serum albumin (BSA), immunoglobulin G (IgG) and fibrinogen (Fgn) on fluorinated selfassembled monolayers have been studied using time of flight secondary ion mass spectrometry (ToF-SIMS) and Spectroscopic Ellipsometry (SE). The objective of the work has to establish the utility of ToF-SIMS for the determination of the amount of protein adsorbed on the surface. Quantification of surface adsorbed proteins was carried out using SE and a good correlation between ToF-SIMS results and SE was achieved. The surface distribution of proteins were also analysed using Atomic Force Microscopy (AFM). We show that the surface distribution of proteins strongly affect the ToFSIMS results.
Abstract: In this paper, backstepping method (BM) is proposed for a single-link flexible mechanical manipulator. In each step of this method a positive value is obtained. Selections of the gain factor values are very important because controller will have different behavior for each different set of values. Improper selection of these gains can lead to instability of the system. In order to choose proper values for gains BELBIC method has been used in this work. Finally, to prove the efficiency of this method, the obtained results of proposed model are compared with robust controller one. Results show that the combination of backstepping and BELBIC that is presented here, can stabilized the system with higher speed, shorter settling time and lower overshoot in than robust controller.
Abstract: A reconfigurable manufacturing system (RMS) is an
advanced system designed at the outset for rapid changes in its hardware
and software components in order to quickly adjust its production
capacity and functionally. Among various operational decisions, this
study considers the scheduling problem that determines the input
sequence and schedule at the same time for a given set of parts. In
particular, we consider the practical constraints that the numbers of
pallets/fixtures are limited and hence a part can be released into the
system only when the fixture required for the part is available. To
solve the integrated input sequencing and scheduling problems, we
suggest a priority rule based approach in which the two sub-problems
are solved using a combination of priority rules. To show the effectiveness
of various rule combinations, a simulation experiment was
done on the data for a real RMS, and the test results are reported.
Abstract: This paper focuses on a critical component of the situational awareness (SA), the control of autonomous vertical flight for vectored thrust aerial vehicle (VTAV). With the SA strategy, we proposed a flight control procedure to address the dynamics variation and performance requirement difference of flight trajectory for an unmanned helicopter model with vectored thrust configuration. This control strategy for chosen model of VTAV has been verified by simulation of take-off and forward maneuvers using software package Simulink and demonstrated good performance for fast stabilization of motors, consequently, fast SA with economy in energy can be asserted during search-and-rescue operations.
Abstract: In order to integrate knowledge in heterogeneous
case-based reasoning (CBR) systems, ontology-based CBR system
has become a hot topic. To solve the facing problems of
ontology-based CBR system, for example, its architecture is
nonstandard, reusing knowledge in legacy CBR is deficient, ontology
construction is difficult, etc, we propose a novel approach for
semi-automatically construct ontology-based CBR system whose
architecture is based on two-layer ontology. Domain knowledge
implied in legacy case bases can be mapped from relational database
schema and knowledge items to relevant OWL local ontology
automatically by a mapping algorithm with low time-complexity. By
concept clustering based on formal concept analysis, computing
concept equation measure and concept inclusion measure, some
suggestions about enriching or amending concept hierarchy of OWL
local ontologies are made automatically that can aid designers to
achieve semi-automatic construction of OWL domain ontology.
Validation of the approach is done by an application example.
Abstract: This paper presents a customized deformable model
for the segmentation of abdominal and thoracic aortic aneurysms in
CTA datasets. An important challenge in reliably detecting aortic
aneurysm is the need to overcome problems associated with intensity
inhomogeneities and image noise. Level sets are part of an important
class of methods that utilize partial differential equations (PDEs) and
have been extensively applied in image segmentation. A Gaussian
kernel function in the level set formulation, which extracts the local
intensity information, aids the suppression of noise in the extracted
regions of interest and then guides the motion of the evolving contour
for the detection of weak boundaries. The speed of curve evolution
has been significantly improved with a resulting decrease in
segmentation time compared with previous implementations of level
sets. The results indicate the method is more effective than other
approaches in coping with intensity inhomogeneities.
Abstract: For the improvement of the ability in detecting
small calcifications using Ultrasonography (US) we propose a
novel indicator of calcifications in an ultrasound B-mode image
without decrease in frame rate. Since the waveform of an
ultrasound pulse changes at a calcification position, the
decorrelation of adjacent scan lines occurs behind a
calcification. Therefore, we employ the decorrelation of
adjacent scan lines as an indicator of a calcification. The
proposed indicator depicted wires 0.05 mm in diameter at 2 cm
depth with a sensitivity of 86.7% and a specificity of 100%,
which were hardly detected in ultrasound B-mode images. This
study shows the potential of the proposed indicator to
approximate the detectable calcification size using an US
device to that of an X-ray imager, implying the possibility that
an US device will become a convenient, safe, and principal
clinical tool for the screening of breast cancer.
Abstract: the research was accomplished on fresh in Latvia wild
growing cranberries and cranberry cultivars. The aim of the study
was to evaluate effect of pretreatment method and drying conditions
on the volatile compounds composition in cranberries. Berries
pre-treatment methods were: perforation, halving and
steam-blanching. The berries before drying in a cabinet drier were
pre-treated using all three methods, in microwave vacuum
drier – using a steam-blanching and halving. Volatile compounds in
cranberries were analysed using GC-MS of extracts obtained by
SPME. During present research 21 various volatile compounds were
detected in fresh cranberries: the cultivar 'Steven' - 15, 'Bergman'
and 'Early black' – 13, 'Ben Lear' and 'Pilgrim' – 11 and wild
cranberries – 14 volatile compounds. In dried cranberries 20 volatile
compounds were detected. Mathematical data processing allows
drawing a conclusion that there exists the significant influence of
cranberry cultivar, pre-treatment method and drying condition on
volatile compounds in berries and new volatile compound formation.
Abstract: Pore water pressure is normally because of
consolidation, compaction and water level fluctuation on reservoir.
Measuring, controlling and analyzing of pore water pressure have
significant importance in both of construction and operation period.
Since end of 2002, (dam start up) nature of KARKHEH dam has
been analyzed by using the gathered information from
instrumentation system of dam. In this lecture dam condition after
start up have been analyzed by using the gathered data from located
piezometers in core of dam. According to TERZAGHI equation and
records of piezometers, consolidation lasted around five years during
early years of construction stage, and current pore water pressure in
core of dam is caused by water level fluctuation in reservoir.
Although there is time lag between water level fluctuation and results
of piezometers. These time lags have been checked and the results
clearly show that one of the most important causes of it is distance
between piezometer and reservoir.
Abstract: Provision of optical devices without proper instruction
and training may cause frustration resulting in rejection or incorrect
use of the magnifiers. However training in the use of magnifiers
increases the cost of providing these devices. This study compared
the efficacy of providing instruction alone and instruction plus
training in the use of magnifiers. 24 participants randomly assigned
to two groups. 15 received instruction and training and 9 received
instruction only. Repeated measures of print size and reading speed
were performed at pre, post training and follow up. Print size
decreased in both groups between pre and post training maintained at
follow up. Reading speed increased in both groups over time with the
training group demonstrating more rapid improvement. Whilst
overall outcomes were similar, training decreased the time required
to increase reading speed supporting the use of training for increased
efficiency. A cost effective form of training is suggested.
Abstract: Thousands of masters athletes participate
quadrennially in the World Masters Games (WMG), yet this cohort
of athletes remains proportionately under-investigated. Due to a
growing global obesity pandemic in context of benefits of physical
activity across the lifespan, the prevalence of obesity in this unique
population was of particular interest. Data gathered on a sub-sample
of 535 football code athletes, aged 31-72 yrs ( =47.4, s =±7.1),
competing at the Sydney World Masters Games (2009) demonstrated
a significantly (p
Abstract: A gradient learning method to regulate the trajectories
of some nonlinear chaotic systems is proposed. The method is
motivated by the gradient descent learning algorithms for neural
networks. It is based on two systems: dynamic optimization system
and system for finding sensitivities. Numerical results of several
examples are presented, which convincingly illustrate the efficiency
of the method.
Abstract: When faced with stochastic networks with an uncertain
duration for their activities, the securing of network completion time
becomes problematical, not only because of the non-identical pdf of
duration for each node, but also because of the interdependence of
network paths. As evidenced by Adlakha & Kulkarni [1], many
methods and algorithms have been put forward in attempt to resolve
this issue, but most have encountered this same large-size network
problem. Therefore, in this research, we focus on network reduction
through a Series/Parallel combined mechanism. Our suggested
algorithm, named the Activity Network Reduction Algorithm
(ANRA), can efficiently transfer a large-size network into an S/P
Irreducible Network (SPIN). SPIN can enhance stochastic network
analysis, as well as serve as the judgment of symmetry for the Graph
Theory.