Abstract: Thermal load calculations have been performed for
multi-layered walls that are composed of three different parts; a
common (sand and cement) plaster, and two types of locally
produced soft and hard bricks. The masonry construction of these
layered walls was based on concrete-backed stone masonry made of
limestone bricks joined by mortar. These multilayered walls are
forming the outer walls of the building envelope of a typical Libyan
house. Based on the periodic seasonal weather conditions, within the
Libyan cost region during summer and winter, measured thermal
conductivity values were used to implement such seasonal variation
of heat flow and the temperature variations through the walls. The
experimental measured thermal conductivity values were obtained
using the Hot Disk technique. The estimation of the thermal
resistance of the wall layers ( R-values) is based on measurements
and calculations. The numerical calculations were done using a
simplified analytical model that considers two different wall
constructions which are characteristics of such houses. According to
the obtained results, the R-values were quite low and therefore,
several suggestions have been proposed to improve the thermal
loading performance that will lead to a reasonable human comfort
and reduce energy consumption.
Abstract: Analytical seismic response of multi-story building
supported on base isolation system is investigated under real
earthquake motion. The superstructure is idealized as a shear type
flexible building with lateral degree-of-freedom at each floor. The
force-deformation behaviour of the isolation system is modelled by
the bi-linear behaviour which can be effectively used to model all
isolation systems in practice. The governing equations of motion of
the isolated structural system are derived. The response of the system
is obtained numerically by step-by-method under three real recorded
earthquake motions and pulse motions associated in the near-fault
earthquake motion. The variation of the top floor acceleration, interstory
drift, base shear and bearing displacement of the isolated
building is studied under different initial stiffness of the bi-linear
isolation system. It was observed that the high initial stiffness of the
isolation system excites higher modes in base-isolated structure and
generate floor accelerations and story drift. Such behaviour of the
base-isolated building especially supported on sliding type of
isolation systems can be detrimental to sensitive equipment installed
in the building. On the other hand, the bearing displacement and base
shear found to reduce marginally with the increase of the initial
stiffness of the initial stiffness of the isolation system. Further, the
above behaviour of the base-isolated building was observed for
different parameters of the bearing (i.e. post-yield stiffness and
characteristic strength) and earthquake motions (i.e. real time history
as well as pulse type motion).
Abstract: To understand the material characteristics of singleand
poly-crystals of pure copper, the respective relationships between
crystallographic orientations and microstructures, and the bending
and mechanical properties were examined. And texture distribution
is also analyzed. A bending test is performed in a SEM apparatus and
while its behaviors are observed in situ. Furthermore, some
analytical results related to crystal direction maps, inverse pole
figures, and textures were obtained from EBSD analyses.
Abstract: A stage-structured predator-prey system with two time delays is considered. By analyzing the corresponding characteristic equation, the local stability of a positive equilibrium is investigated and the existence of Hopf bifurcations is established. Formulae are derived to determine the direction of bifurcations and the stability of bifurcating periodic solutions by using the normal form theory and center manifold theorem. Numerical simulations are carried out to illustrate the theoretical results. Based on the global Hopf bifurcation theorem for general functional differential equations, the global existence of periodic solutions is established.
Abstract: In the present paper, we use generalized B-Spline curve in trigonometric form on circular domain, to capture the transcendental nature of circle involute curve and uncertainty characteristic of design. The required involute curve get generated within the given tolerance limit and is useful in gear design.
Abstract: Mobile devices, which are progressively surrounded
in our everyday life, have created a new paradigm where they
interconnect, interact and collaborate with each other. This network
can be used for flexible and secure coordinated sharing. On the other
hand Grid computing provides dependable, consistent, pervasive, and
inexpensive access to high-end computational capabilities. In this
paper, efforts are made to map the concepts of Grid on Ad-Hoc
networks because both exhibit similar kind of characteristics like
Scalability, Dynamism and Heterogeneity. In this context we
propose “Mobile Ad-Hoc Services Grid – MASGRID".
Abstract: In order to upgrade the seismic resistibility of structures and enhance the functionality of an isolator, a new base isolator called the multiple trench friction pendulum system (MTFPS) is proposed in this study. The proposed MTFPS isolator is composed of a trench concave surface and several intermediate sliding plates in two orthogonal directions. Mathematical formulations have been derived to examine the characteristics of the proposed MTFPS isolator possessing multiple intermediate sliding plates. By means of mathematical formulations, it can be inferred that the natural period and damping effect of the MTFPS isolator with several intermediate sliding plates can be altered continually and controllably during earthquakes. Furthermore, results obtained from shaking table tests demonstrate that the proposed isolator provides good protection to structures for prevention of damage from strong earthquakes.
Abstract: The goal of this research is discovering the
determinants of the success or failure of external cooperation in small
and medium enterprises (SMEs). For this, a survey was given to 190
SMEs that experienced external cooperation within the last 3 years. A
logistic regression model was used to derive organizational or strategic
characteristics that significantly influence whether external
collaboration of domestic SMEs is successful or not. Results suggest
that research and development (R&D) features in general
characteristics (both idea creation and discovering market
opportunities) that focused on and emphasized indirected-market
stakeholders (such as complementary companies and affiliates) and
strategies in innovative strategic characteristics raise the probability of
successful external cooperation. This can be used meaningfully to
build a policy or strategy for inducing successful external cooperation
or to understand the innovation of SMEs.
Abstract: In this study, a fuzzy-logic based control system was
designed to ensure that time and energy is saved during the operation
of load elevators which are used during the construction of tall
buildings. In the control system that was devised, for the load
elevators to work more efficiently, the energy interval where the
motor worked was taken as the output variable whereas the amount
of load and the building height were taken as input variables. The
most appropriate working intervals depending on the characteristics
of these variables were defined by the help of an expert. Fuzzy expert
system software was formed using Delphi programming language. In
this design, mamdani max-min inference mechanism was used and
the centroid method was employed in the clarification procedure. In
conclusion, it is observed that the system that was designed is
feasible and this is supported by statistical analyses..
Abstract: Advancement in Artificial Intelligence has lead to the
developments of various “smart" devices. Character recognition
device is one of such smart devices that acquire partial human
intelligence with the ability to capture and recognize various
characters in different languages. Firstly multiscale neural training
with modifications in the input training vectors is adopted in this
paper to acquire its advantage in training higher resolution character
images. Secondly selective thresholding using minimum distance
technique is proposed to be used to increase the level of accuracy of
character recognition. A simulator program (a GUI) is designed in
such a way that the characters can be located on any spot on the
blank paper in which the characters are written. The results show that
such methods with moderate level of training epochs can produce
accuracies of at least 85% and more for handwritten upper case
English characters and numerals.
Abstract: In this paper we present a hybrid search algorithm for
solving constraint satisfaction and optimization problems. This
algorithm combines ideas of two basic approaches: complete and
incomplete algorithms which also known as systematic search and
local search algorithms. Different characteristics of systematic search
and local search methods are complementary. Therefore we have
tried to get the advantages of both approaches in the presented
algorithm. The major advantage of presented algorithm is finding
partial sound solution for complicated problems which their complete
solution could not be found in a reasonable time. This algorithm
results are compared with other algorithms using the well known
n-queens problem.
Abstract: Partial discharge (PD) detection is an important
method to evaluate the insulation condition of metal-clad apparatus.
Non-intrusive sensors which are easy to install and have no
interruptions on operation are preferred in onsite PD detection.
However, it often lacks of accuracy due to the interferences in PD
signals. In this paper a novel PD extraction method that uses frequency
analysis and entropy based time-frequency (TF) analysis is introduced.
The repetitive pulses from convertor are first removed via frequency
analysis. Then, the relative entropy and relative peak-frequency of
each pulse (i.e. time-indexed vector TF spectrum) are calculated and
all pulses with similar parameters are grouped. According to the
characteristics of non-intrusive sensor and the frequency distribution
of PDs, the pulses of PD and interferences are separated. Finally the
PD signal and interferences are recovered via inverse TF transform.
The de-noised result of noisy PD data demonstrates that the
combination of frequency and time-frequency techniques can
discriminate PDs from interferences with various frequency
distributions.
Abstract: Circle grid space filling plate is a flow conditioner with a fractal pattern and used to eliminate turbulence originating from pipe fittings in experimental fluid flow applications. In this paper, steady state, incompressible, swirling turbulent flow through circle grid space filling plate has been studied. The solution and the analysis were carried out using finite volume CFD solver FLUENT 6.2. Three turbulence models were used in the numerical investigation and their results were compared with the pressure drop correlation of BS EN ISO 5167-2:2003. The turbulence models investigated here are the standard k-ε, realizable k-ε, and the Reynolds Stress Model (RSM). The results showed that the RSM model gave the best agreement with the ISO pressure drop correlation. The effects of circle grids space filling plate thickness and Reynolds number on the flow characteristics have been investigated as well.
Abstract: In this paper, investigation of subsynchronous
resonance (SSR) characteristics of a hybrid series compensated
system and the design of voltage controller for three level 24-pulse
Voltage Source Converter based Static Synchronous Series
Compensator (SSSC) is presented. Hybrid compensation consists of
series fixed capacitor and SSSC which is a active series FACTS
controller. The design of voltage controller for SSSC is based on
damping torque analysis, and Genetic Algorithm (GA) is adopted for
tuning the controller parameters. The SSR Characteristics of SSSC
with constant reactive voltage control modes has been investigated.
The results show that the constant reactive voltage control of SSSC
has the effect of reducing the electrical resonance frequency, which
detunes the SSR.The analysis of SSR with SSSC is carried out based
on frequency domain method, eigenvalue analysis and transient
simulation. While the eigenvalue and damping torque analysis are
based on D-Q model of SSSC, the transient simulation considers both
D-Q and detailed three phase nonlinear system model using
switching functions.
Abstract: An ethnobotanical study was conducted to document
local knowledge and potentials of wild edible tubers that has been
reported and sighted and to investigate and record their distribution in
Pulau Redang and nearby islands of Terengganu, Malaysia.
Information was gathered from 42 villagers by using semi-structured
questionnaire. These respondents were selected randomly and no
appointment was made prior to the visits. For distribution, the
locations of wild edible tubers were recorded by using the Global
Positioning System (GPS). The wild edible tubers recorded were ubi
gadung, ubi toyo, ubi kasu, ubi jaga, ubi seratus and ubi kertas.
Dioscorea or commonly known as yam is reported to be one of the
major food sources worldwide. The majority of villagers used
Dioscorea hispida Dennst. or ubi gadung in many ways in their life
such as for food, medicinal purposes and fish poison. The villagers
have identified this ubi gadung by looking at the morphological
characteristics; that include leaf shape, stem and the color of the
tuber-s flesh.
Abstract: The objective is to fabricate organic light emitting
diode and to study its degradation process in atmosphere condition in
which PFO as an emitting material and PEDOT:PSS as a hole
injecting material were used on ITO substrate. Thus degradation
process of the OLED was studied upon its current-voltage
characteristic. By fabricating this OLED and obtaining blue light and
analysis of current-voltage characteristic during the time after
fabrication, it was observed that the current of the OLED was
exponentially decreased. Current reduction during the initial hours of
fabrication was outstanding and after few days its reduction rate was
dropped significantly, while the diode was dying.
Abstract: Economic crime (i.e. corporate fraud) has a
significant impact on business. This study analyzes the fraud cases
reported by the Malaysian Securities Commission. Frauds involving
market manipulation and/or illegal share trading are the most
common types of fraud reported over the 6 years analyzed. The
highest number of frauds reported involved investment and fund
holding companies. Alarmingly the results indicate quite a high
number of frauds cases are committed by management. The higher
number of Chinese perpetrators may be due to fact that they are the
dominant group in Malaysian business. The result also shows that
more than half of companies involved with fraud are privately held
companies in the investment/fund/finance sector. The results of this
study highlight general characteristic of perpetrators (person and
company) that commit fraud which could help the regulators in their
monitoring and enforcement activities. To investors, this would help
in analyzing their business investment or portfolio risk.
Abstract: Aspect of visual perception occupies a central position
in shaping the physical structure of a city. This paper discusses the
visual characteristics of utopian cities and their impact on the shaping
of real urban structures. Utopian examples of cities will not be
discussed in terms of social and sociological conditions, but rather
the emphasis is on urban utopias and ideal cities that have achieved
or have had potential impact on the shape of the physical structure of
Nikšić. It is a Renaissance-Baroque period with a touch of classicism.
The paper’s emphasis is on the physical dimension, not excluding the
importance of social equilibrium, studies of which are dating back to
Aristotle, Plato, Thomas More, Robert Owen, Tommaso Campanella
and others. The emphasis is on urban utopias and their impact on the
development of sustainable physical structure of a real city in the
context of visual perception. In the case of Nikšić, this paper
identifies the common features of a real city and a utopian city, as
well as criteria for sustainable urban development in the context of
visual achievement.
Abstract: School physical education, through its objectives and
contents, efficiently valorizes the pupils- abilities, developing them,
especially the coordinative skill component, which is the basis of
movement learning, of the development of the daily motility and also
of the special, refined motility required by the practice of certain
sports. Medium school age offers the nervous and motor substratum
needed for the acquisition of complex motor habits, a substratum that
is essential for the coordinative skill. Individuals differ as to the level
at which this function is performed, the extent to which this function
turns an individual into a person that is adapted and adaptable to
complex and various situations. Spatio-temporal orientation, together
with movement combination and coupling, and with kinesthetic,
balance, motor reaction, movement transformation and rhythm
differentiation form the coordinative skills. From our viewpoint,
these are characteristic features with high levels of manifestation in a
complex psychomotor act - valorizing the quality of one-s talent - as
well as indices pertaining to one-s psychomotor intelligence and
creativity.
Abstract: Thermochemcial characteristics of powder fabricated
using oxidation treatment of spent PWR fuel and SIMFUEL were
evaluated for recycling of spent fuel such as DUPIC process.
Especially, the influence of spent fuel burn-ups on the powder
fabrication characteristics was experimentally evaluated, ranging from
27,300 to 65,000 MWd/tU. Densities of powder manufactured from an
oxidation, OREOX and the milling processes at the same process
conditions were compared as a function of the fuel burn-ups
respectively. Also, based on chemical analysis results, homogeneity of
fissile elements in oxidized powder was confirmed.