Abstract: The effect of a uniform magnetic field on the
formation of drops of specific size has been investigated numerically
in a T-shaped microchannel. Previous researches indicated that the
drop sizes of secondary stream decreases, with increasing main
stream flow rate and decreasing interfacial tension. In the present
study the effect of a uniform magnetic field on the main stream is
considered, and it is proposed that by increasing the Hartmann
number, the size of the drops of the secondary stream will be
decreased.
Abstract: High building constructions are increasing in south
beaches of the Caspian Sea because of tourist attractions and limitation of residential areas. According to saturated alluvial fields transfer of load from high structures to the soil by piles is inevitable.
In spite of most of these piles are under compression forces, tension piles are used in special conditions. Few studies have been conducted
because of the limited use of these piles. Tension capacity of openended pipe piles in full scale was tested in this study. The length of the bored piles was 420 up to 480 cm and all were in 120 cm
diameter. The results of testing 7 piles were compared with the results of relations given by researches.
Abstract: Due to the growth of the urban area towards lands
contaminated with ancient tails, in this work we evaluated if the
leaching with calcium thiosulfate (CaS2O3) for the recovery of silver,
gold and mercury from this soil, also dissolves arsenic, cadmium and
lead; for this, we determined their quantity per each fraction of size
of particle of the soil before and after the dissolution. Half of the soil
samples were leached in the plant Beneficiadora de Jales del Centro,
S. A. de C.V. and the rest of them remained in the laboratory. The
ICP-OES technique was used to determine the amounts of arsenic,
cadmium and lead, in the samples of both lots. The soil samples were
collected in a neighboring area at El Lampotal, Vetagrande,
Zacatecas, México, with an extension of 600 m2 at 22º52' 37.69'' N,
102º25' 11.73'' W. The amount of arsenic, cadmium and lead found
in nonleached soil and for a particle size of 47 μm was 203.72±3.73,
33.63±1.31 and 3480.99±20.4 mg/kg respectively.
Abstract: Linear two-point boundary value problem of order two is solved using extended cubic B-spline interpolation method. There is one free parameters, λ, that control the tension of the solution curve. For some λ, this method produced better results than cubic B-spline interpolation method.
Abstract: We obtain appropriate sharp estimates for rough oscillatory integrals. Our results represent significant improvements as well as natural extensions of what was known previously.
Abstract: Reinforced concrete crash barriers used in road traffic
must meet a number of criteria. Crash barriers are laid lengthwise,
one behind another, and joined using specially designed steel locks.
While developing BSV reinforced concrete crash barriers (type
ŽPSV), experiments and calculations aimed to optimize the shape of
a newly designed lock and the reinforcement quantity and
distribution in a crash barrier were carried out. The tension carrying
capacity of two parallelly joined locks was solved experimentally.
Based on the performed experiments, adjustments of nonlinear
properties of steel were performed in the calculations. The obtained
results served as a basis to optimize the lock design using a
computational model that takes into account the plastic behaviour of
steel and the influence of the surrounding concrete [6]. The response
to the vehicle impact has been analyzed using a specially elaborated
complex computational model, comprising both the nonlinear model
of the damping wall or crash barrier and the detailed model of the
vehicle [7].
Abstract: This study was designed to investigate the role of serum nitric oxide and sialic acid in the development of diabetic nephropathy as disease marker. Total 210 diabetic patients (age and sex matched) were selected followed by informed consent and divided into four groups (70 each) as I: control; II: diabetic; III: diabetic hypertensive; IV: diabetic nephropathy. The blood samples of all subjects were collected and analyzed for serum nitric oxide, sialic acid, fasting blood glucose, serum urea, creatinine, HbA1c and GFR. The BMI, systolic and diastolic blood pressures, blood glucose, HbA1c and serum sialic acid levels were high (p
Abstract: In this paper, we consider the control of time delay system
by Proportional-Integral (PI) controller. By Using the Hermite-
Biehler theorem, which is applicable to quasi-polynomials, we seek
a stability region of the controller for first order delay systems. The
essence of this work resides in the extension of this approach to
second order delay system, in the determination of its stability region
and the computation of the PI optimum parameters. We have used
the genetic algorithms to lead the complexity of the optimization
problem.
Abstract: Ten percent of the population will develop plantar
fasciitis (PF) during their lifetime. Two million people are treated
yearly accounting for 11-15% of visits to medical professionals.
Treatment ranges from conservative to surgical intervention. The
purpose of this study was to assess the effects of extracorporeal
shockwave therapy (ECSWT) on heel pain, function, range of motion
(ROM), and strength in patients with PF. One hundred subjects were
treated with ECSWT and measures were taken before and three
months after treatment. There was significant differences in visual
analog scale scores for pain at rest (p=0.0001); after activity (p=
0.0001) and; overall improvement (p=0.0001). There was also
significant improvement in Lower Extremity Functional Scale scores
(p=0.0001); ankle plantarflexion (p=0.0001), dorsiflexion (p=0.001),
and eversion (p=0.017),and first metatarsophalangeal joint flexion
(p=0.002) and extension (p=0.003) ROM. ECSWT is an effective
treatment improving heel pain, function and ROM in patients with
PF.
Abstract: In order to supplement the brittle property of concrete,
fibers are added into concrete mixtures. Compared to general concrete,
various characteristics such as tensile strength, bending strength,
bending toughness, and resistance to crack are superior, and even
when cracks occur, improvements on toughness as well as resistance
to shock are excellent due to the growth of fracture energy. Increased
function of steel fiber reinforced concrete can be differentiated
depending on the fiber dispersion, and sand percentage can be an
important influence on the fiber dispersion. Therefore, in this research,
experiments were planned on sand percentage in order to apprehend
the influence of sand percentage on the bending properties and direct
tension of SFRC and basic experiments were conducted on bending
and direct tension in order to recognize the properties of bending
properties and direct tension following the size of the aggregates and
sand percentage.
Abstract: Nowadays there are many methods for representing
knowledge such as semantic network, neural network, and conceptual
graphs. Nonetheless, these methods are not sufficiently efficient
when applied to perform and deduce on knowledge domains about
supporting in general education such as algebra, analysis or plane
geometry. This leads to the introduction of computational network
which is a useful tool for representation knowledge base, especially
for computational knowledge, especially knowledge domain about
general education. However, when dealing with a practical problem,
we often do not immediately find a new solution, but we search
related problems which have been solved before and then proposing
an appropriate solution for the problem. Besides that, when finding
related problems, we have to determine whether the result of them
can be used to solve the practical problem or not. In this paper, the
extension model of computational network has been presented. In this
model, Sample Problems, which are related problems, will be used
like the experience of human about practical problem, simulate the
way of human thinking, and give the good solution for the practical
problem faster and more effectively. This extension model is applied
to construct an automatic system for solving algebraic problems in
middle school.
Abstract: The flow field over a flat roof model building has been numerically investigated in order to determine threedimensional CFD guidelines for the calculation of the turbulent flow over a structure immersed in an atmospheric boundary layer. To this purpose, a complete validation campaign has been performed through a systematic comparison of numerical simulations with wind tunnel experimental data. Wind tunnel measurements and numerical predictions have been compared for five different vertical positions, respectively from the upstream leading edge to the downstream bottom edge of the analyzed model. Flow field characteristics in the neighborhood of the building model have been numerically investigated, allowing a quantification of the capabilities of the CFD code to predict the flow separation and the extension of the recirculation regions. The proposed calculations have allowed the development of a preliminary procedure to be used as guidance in selecting the appropriate grid configuration and corresponding turbulence model for the prediction of the flow field over a three-dimensional roof architecture dominated by flow separation.
Abstract: In this paper, we intend to study the synthesis of the
multibeam arrays. The synthesis implementation-s method for this
type of arrays permits to approach the appropriated radiance-s
diagram. The used approach is based on neural network that are
capable to model the multibeam arrays, consider predetermined
general criteria-s, and finally it permits to predict the appropriated
diagram from the neural model. Our main contribution in this paper is
the extension of a synthesis model of these multibeam arrays.
Abstract: This paper describes a method of signal process applied
on an end effects of Hilbert-Huang transform (HHT) to provide an
improvement in the reality of spectrum. The method is based on
back-propagation network (BPN). To improve the effect, the end
extension of the original signal is obtained by back-propagation
network. A full waveform including origin and its extension is
decomposed by using empirical mode decomposition (EMD) to obtain
intrinsic mode functions (IMFs) of the waveform. Then, the Hilbert
transform (HT) is applied to the IMFs to obtain the Hilbert spectrum of
the waveform. As a result, the method is superiority of the processing
of end effect of HHT to obtain the real frequency spectrum of signals.
Abstract: Relevant agricultural information disseminator
(extension agent) ratio of 1:3500 farm families which become a
menace to agricultural production capacity in developing countries
necessitate this study. Out of 4 zones in the state, 24 extension agents
in each zone, 4 extension agents using cell phones and 120 farmers
using cell phone and 120 other farmers not using cell phone were
purposively selected to give 240 farmers that participated in the
research. Data were collected using interview guide and analysized
using frequency, percentage and t-test.. Frequency of contact with
agricultural information centers revealed that cell phone user farmers
had greater means score of X 41.43 contact as against the low mean
X19.32 contact recorded by farmers receiving agricultural
information from extension agents not using cell phone and their
production was statistically significant at P < 0.05. Usage of cell
phone increase extension agent contact and increase farmers-
production capacity.
Abstract: The frequency dependence of the phase field
model(PFM) is studied. A simple PFM is proposed, and is tested in a
laminar boundary layer. The Blasius-s laminar boundary layer
solution on a flat plate is used for the flow pattern, and several
frequencies are imposed on the PFM, and the decay times of the
interfaces are obtained. The computations were conducted for three
cases: 1) no-flow, and 2) a half ball on the laminar boundary layer, 3) a
line of mass sources in the laminar boundary layer. The computations
show the decay time becomes shorter as the frequency goes larger, and
also show that it is sensitive to both background disturbances and
surface tension parameters. It is concluded that the proposed simple
PFM can describe the properties of decay process, and could give the
fundamentals for the decay of the interface in turbulent flows.
Abstract: In this paper, the direct AnsAz method is used for constructing the multi-wave solutions to the (2+1)-dimensional extension of the Korteweg de-Vries (shortly EKdV) equation. A new breather type of three-wave solutions including periodic breather type soliton solution, breather type of two-solitary solution are obtained. Some cases with specific values of the involved parameters are plotted for each of the three-wave solutions. Mechanical features of resonance interaction among the multi-wave are discussed. These results enrich the variety of the dynamics of higher-dimensional nonlinear wave field.
Abstract: Without uncertainty by applying external loads on
beams, bending is created. The created bending in I-beams, puts one
of the flanges in tension and the other one in compression. With increasing of bending, compression flange buckled and beam in out
of its plane direction twisted, this twisting well-known as Lateral Torsional Buckling. Providing bending moment varieties along the
beam, the critical moment is greater than the case its under pure bending. In other words, the value of bending gradient coefficient is
always greater than unite. In this article by the use of " ANSYS 10.0" software near 80 3-D finite element models developed for the
propose of analyzing beams` lateral torsional buckling and surveying influence of slenderness on beams' bending gradient coefficient.
Results show that, presented Cb coefficient via AISC is not correct for some of beams and value of this coefficient is smaller than what proposed by AISC. Therefore instead of using a constant Cb for each
case of loading , a function with two criterion for calculation of Cb coefficient for some cases is proposed.
Abstract: In this paper, the bio-mechanical analysis of human joints is carried out and the study is extended to the robot manipulator. This study will first focus on the kinematics of human arm which include the movement of each joint in shoulder, wrist, elbow and finger complexes. Those analyses are then extended to the design of a human robot manipulator. A simulator is built for Direct Kinematics and Inverse Kinematics of human arm. In the simulation of Direct Kinematics, the human joint angles can be inserted, while the position and orientation of each finger tips (end-effector) are shown. Inverse Kinematics does the reverse of the Direct Kinematics. Based on previous materials obtained from kinematics analysis, the human manipulator joints can be designed to follow prescribed position trajectories.
Abstract: This study describes a micro device integrated with
multi-chamber for polymerase chain reaction (PCR) with different
annealing temperatures. The device consists of the reaction
polydimethylsiloxane (PDMS) chip, a cover glass chip, and is
equipped with cartridge heaters, fans, and thermocouples for
temperature control. In this prototype, commercial software is utilized
to determine the geometric and operational parameters those are
responsible for creating the denaturation, annealing, and extension
temperatures within the chip. Two cartridge heaters are placed at two
sides of the chip and maintained at two different temperatures to
achieve a thermal gradient on the chip during the annealing step. The
temperatures on the chip surface are measured via an infrared imager.
Some thermocouples inserted into the reaction chambers are used to
obtain the transient temperature profiles of the reaction chambers
during several thermal cycles. The experimental temperatures
compared to the simulated results show a similar trend. This work
should be interesting to persons involved in the high-temperature
based reactions and genomics or cell analysis.