Abstract: Many non-conventional adsorbent have been studied
as economic alternative to commercial activated carbon and mostly
agricultural waste have been introduced such as rubber leaf powder
and hazelnut shell. Microwave Incinerated Rice Husk Ash
(MIRHA), produced from the rice husk is one of the low-cost
materials that were used as adsorbent of heavy metal. The aim of
this research was to study the feasibility of using MIRHA500 and
MIRHA800 as adsorbent for the removal of Cu(II) metal ions from
aqueous solutions by the batch studies. The adsorption of Cu(II) into
MIRHA500 and MIRH800 favors Fruendlich isotherm and imply
pseudo – kinetic second order which applied chemisorptions
Abstract: This paper presents an application of particle swarm
optimization (PSO) to the grounding grid planning which compares to
the application of genetic algorithm (GA). Firstly, based on IEEE
Std.80, the cost function of the grounding grid and the constraints of
ground potential rise, step voltage and touch voltage are constructed
for formulating the optimization problem of grounding grid planning.
Secondly, GA and PSO algorithms for obtaining optimal solution of
grounding grid are developed. Finally, a case of grounding grid
planning is shown the superiority and availability of the PSO
algorithm and proposal planning results of grounding grid in cost and
computational time.
Abstract: In this paper, using a model transformation approach a system of linear delay differential equations (DDEs) with multiple delays is converted to a non-delayed initial value problem. The variational iteration method (VIM) is then applied to obtain the approximate analytical solutions. Numerical results are given for several examples involving scalar and second order systems. Comparisons with the classical fourth-order Runge-Kutta method (RK4) verify that this method is very effective and convenient.
Abstract: Air bubbles have been detected in human circulation
of end-stage renal disease patients who are treated by hemodialysis.
The consequence of air embolism, air bubbles, is under recognized
and usually overlooked in daily practice. This paper shows results of
a capacitor based detection method that capable of detecting the
presence of air bubbles in the blood stream in different frequencies.
The method is based on a parallel plates capacitor made of platinum
with an area of 1.5 cm2 and a distance between the two plates is 1cm.
The dielectric material used in this capacitor is Dextran70 solution
which mimics blood rheology. Simulations were carried out using
RC circuit at two frequencies 30Hz and 3 kHz and results compared
with experiments and theory. It is observed that by injecting air
bubbles of different diameters into the device, there were significant
changes in the capacitance of the capacitor. Furthermore, it is
observed that the output voltage from the circuit increased with
increasing air bubble diameter. These results demonstrate the
feasibility of this approach in improving air bubble detection in
Hemodialysis.
Abstract: The effect of a chiral bianisotropic substrate on the
complex resonant frequency of a rectangular microstrip resonator has
been studied on the basis of the integral equation formulation. The
analysis is based on numerical resolution of the integral equation
using Galerkin procedure for moment method in the spectral domain.
This work aim first to study the effect of the chirality of a
bianisotopic substrate upon the resonant frequency and the half
power bandwidth, second the effect of a magnetic anisotropy via an
asymptotic approach for very weak substrate upon the resonant
frequency and the half power bandwidth has been investigated. The
obtained results are compared with previously published work [11-9],
they were in good agreement.
Abstract: The aim of this study is to emphasize the opportunities in space design under the aspect of HCI as performance areas. HCI is a multidisciplinary approach that could be identified in many different areas. The aesthetical reflections of HCI by virtual reality in space design are the high-tech solutions of the new innovations as computational facilities by artistic features. The method of this paper is to identify the subject in 3 main parts. In the first part a general approach and definition of interactivity on the basis of space design; in the second part the concept of multimedia interactive theater by some chosen samples from the world and interactive design aspects; in the third part the samples from Turkey will be identified by stage designing principles. In the results it could be declared that the multimedia database is the virtual approach of theatre stage designing regarding interactive means by computational facilities according to aesthetical aspects. HCI is mostly identified in theatre stages as computational intelligence under the affect of interactivity.
Abstract: Search for a tertiary substructure that geometrically
matches the 3D pattern of the binding site of a well-studied protein provides a solution to predict protein functions. In our previous work,
a web server has been built to predict protein-ligand binding sites
based on automatically extracted templates. However, a drawback of such templates is that the web server was prone to resulting in many
false positive matches. In this study, we present a sequence-order constraint to reduce the false positive matches of using automatically
extracted templates to predict protein-ligand binding sites. The binding site predictor comprises i) an automatically constructed template library and ii) a local structure alignment algorithm for
querying the library. The sequence-order constraint is employed to
identify the inconsistency between the local regions of the query protein and the templates. Experimental results reveal that the sequence-order constraint can largely reduce the false positive matches and is effective for template-based binding site prediction.
Abstract: Abstraction of water from the dry river sand-beds is
well-known as an alternative source of water during dry seasons.
Internally, because of the form of sand particles, voids are created
which can store water in the riverbeds. Large rivers are rare in South
Africa. Many rivers are sand river types and without water during the
prolonged dry periods. South Africa has not taken full advantage of
water storage in sand as a solution to the growing water scarcity both
in urban and rural areas. The paper reviews the benefits of run-off
storage in sand reservoirs gained from other arid areas and need for
adoption in rural areas of South Africa as an alternative water supply
where it is probable.
Abstract: The paper discusses the mathematics of pattern
indexing and its applications to recognition of visual patterns that are
found in video clips. It is shown that (a) pattern indexes can be
represented by collections of inverted patterns, (b) solutions to
pattern classification problems can be found as intersections and
histograms of inverted patterns and, thus, matching of original
patterns avoided.
Abstract: Electric vehicles are considered as technology which
can significantly reduce the problems related to road transport such
as increasing GHG emissions, air pollutions and energy import
dependency.
The core objective of this paper is to analyze the current energetic,
ecological and economic characteristics of different types of electric
vehicles.
The major conclusions of this analysis are: The high investments
cost are the major barrier for broad market breakthrough of battery
electric vehicles and fuel cell vehicles. For battery electric vehicles
also the limited driving range states a key obstacle. The analyzed
hybrids could in principle serve as a bridging technology. However,
due to their tank-to-wheel emissions they cannot state a proper
solution for urban areas.
Finally, the most important perception is that also battery electric
vehicles and fuel cell vehicles are environmentally benign solution if
the primary fuel source is renewable.
Abstract: In contrast to existing methods which do not take into account multiconnectivity in a broad sense of this term, we develop mathematical models and highly effective combination (BIEM and FDM) numerical methods of calculation of stationary and quasistationary temperature field of a profile part of a blade with convective cooling (from the point of view of realization on PC). The theoretical substantiation of these methods is proved by appropriate theorems. For it, converging quadrature processes have been developed and the estimations of errors in the terms of A.Ziqmound continuity modules have been received. For visualization of profiles are used: the method of the least squares with automatic conjecture, device spline, smooth replenishment and neural nets. Boundary conditions of heat exchange are determined from the solution of the corresponding integral equations and empirical relationships. The reliability of designed methods is proved by calculation and experimental investigations heat and hydraulic characteristics of the gas turbine first stage nozzle blade.
Abstract: An improved topology of a voltage-fed quasi-resonant
soft switching LCrCdc series-parallel half bridge inverter with a constant-frequency for electronic ballast applications is proposed in this paper. This new topology introduces a low-cost solution to
reduce switching losses and circuit rating to achieve high-efficiency
ballast. Switching losses effect on ballast efficiency is discussed
through experimental point of view. In this discussion, an improved
topology in which accomplishes soft switching operation over a wide
power regulation range is proposed. The proposed structure uses reverse recovery diode to provide better operation for the ballast system. A symmetrical pulse wide modulation (PWM) control scheme is implemented to regulate a wide range of out-put power.
Simulation results are kindly verified with the experimental
measurements obtained by ballast-lamp laboratory prototype. Different load conditions are provided in order to clarify the
performance of the proposed converter.
Abstract: This paper presents the concept and realisation of an
e-learning tool that provides predefined or automatically generated
exercises concerning logistics cost accounting. Students may practise
where and whenever they like to via the Internet. Their solutions are
marked automatically by the tool while considering consecutive
faults and without any intervention of lecturers.
Abstract: In present work the problem of the ITER fusion
plasma neutron source parameter reconstruction using only the
Vertical Neutron Camera data was solved. The possibility of neutron
source parameter reconstruction was estimated by the numerical
simulations and the analysis of adequateness of mathematic model
was performed. The neutron source was specified in a parametric
form. The numerical analysis of solution stability with respect to data
distortion was done. The influence of the data errors on the
reconstructed parameters is shown:
• is reconstructed with errors less than 4% at all examined values
of δ (until 60%);
• is determined with errors less than 10% when δ do not overcome
5%;
• is reconstructed with relative error more than 10 %;
• integral intensity of the neutron source is determined with error
10% while δ error is less than 15%;
where -error of signal measurements, (R0,Z0), the plasma center
position,- /parameter of neutron source profile.
Abstract: A two dimensional three segments coupled pendulum system that mathematically models human arm configuration was developed along with constructing and solving the equations of motions for this model using the energy (work) based approach of Lagrange. The equations of motion of the model were solved iteratively both as an initial value problem and as a two point boundary value problem. In the initial value problem solutions, both the initial system configuration (segment angles) and initial system velocity (segment angular velocities) were used as inputs, whereas, in the two point boundary value problem solutions initial and final configurations and time were used as inputs to solve for the trajectory of motion. The results suggest that the model solutions are sensitive to small changes in the dynamic forces applied to the system as well as to the initial and boundary conditions used. To overcome the system sensitivity a new approach is suggested.
Abstract: As is known, one of the priority directions of research
works of natural sciences is introduction of applied section of
contemporary mathematics as approximate and numerical methods to
solving integral equation into practice. We fare with the solving of
integral equation while studying many phenomena of nature to whose
numerically solving by the methods of quadrature are mainly applied.
Taking into account some deficiency of methods of quadrature for
finding the solution of integral equation some sciences suggested of
the multistep methods with constant coefficients. Unlike these papers,
here we consider application of hybrid methods to the numerical
solution of Volterra integral equation. The efficiency of the suggested
method is proved and a concrete method with accuracy order p = 4
is constructed. This method in more precise than the corresponding
known methods.
Abstract: The selective wet-etching of amorphous and
crystalline region of Sb20Se80 thin films was carried out using organic
based solution e.g. amines. We report the development of an in situ
real-time method to study the wet chemical etching process of thin
films. Characterization of the structure and surface of films studied
by X-ray diffraction, SEM and EBSD methods has been done and
potential application suggested.
Abstract: A theory for optimal filtering of infinite sets of random
signals is presented. There are several new distinctive features of the
proposed approach. First, a single optimal filter for processing any
signal from a given infinite signal set is provided. Second, the filter is
presented in the special form of a sum with p terms where each term
is represented as a combination of three operations. Each operation
is a special stage of the filtering aimed at facilitating the associated
numerical work. Third, an iterative scheme is implemented into the
filter structure to provide an improvement in the filter performance at
each step of the scheme. The final step of the scheme concerns signal
compression and decompression. This step is based on the solution of
a new rank-constrained matrix approximation problem. The solution
to the matrix problem is described in this paper. A rigorous error
analysis is given for the new filter.
Abstract: In a previously developed fast vortex method, the
diffusion of the vortex sheet induced at the solid wall by the no-slip
boundary conditions was modeled according to the approximation
solution of Koumoutsakos and converted into discrete blobs in the
vicinity of the wall. This scheme had been successfully applied to a
simulation of the flow induced with an impulsively initiated circular
cylinder. In this work, further modifications on this vortex method are
attempted, including replacing the approximation solution by the
boundary-element-method solution, incorporating a new algorithm for
handling the over-weak vortex blobs, and diffusing the vortex sheet
circulation in a new way suitable for high-curvature solid bodies. The
accuracy is thus largely improved. The predictions of lift and drag
coefficients for a uniform flow past a NASA airfoil agree well with the
existing literature.
Abstract: Animation is simply defined as the sequencing of a
series of static images to generate the illusion of movement. Most
people believe that actual drawings or creation of the individual
images is the animation, when in actuality it is the arrangement of
those static images that conveys the motion. To become an animator,
it is often assumed that needed the ability to quickly design
masterpiece after masterpiece. Although some semblance of artistic
skill is a necessity for the job, the real key to becoming a great
animator is in the comprehension of timing. This paper will use a
combination of sprite animation, frame animation, and some other
techniques to cause a group of multi-colored static images to slither
around in the bounded area. In addition to slithering, the images
will also change the color of different parts of their body, much like
the real world creatures that have this amazing ability to change the
colors on their bodies do. This paper was implemented by using
Java 2 Standard Edition (J2SE).
It is both time-consuming and expensive to create animations,
regardless if they are created by hand or by using motion-capture
equipment. If the animators could reuse old animations and even
blend different animations together, a lot of work would be saved in
the process. The main objective of this paper is to examine a method
for blending several animations together in real time. This paper
presents and analyses a solution using Weighted Skeleton
Animation (WSA) resulting in limited CPU time and memory waste
as well as saving time for the animators. The idea presented is
described in detail and implemented. In this paper, text animation,
vertex animation, sprite part animation and whole sprite animation
were tested.
In this research paper, the resolution, smoothness and movement
of animated images will be carried out from the parameters, which
will be obtained from the experimental research of implementing
this paper.