Abstract: In this paper, a new BiCMOS CCII and CCCII,
capable of operate at ±0.5V and having wide dynamic range with
achieved bandwidth of 480MHz and 430MHz respectively have been
proposed. The structures have been found to be insensitive to the
threshold voltage variations. The proposed circuits are suitable for
implementation using 0.25μm BiCMOS technology. Pspice
simulations confirm the performance of the proposed structures.
Abstract: This article presents new current-mode oscillator circuits using CDTAs which is designed from block diagram. The proposed circuits consist of two CDTAs and two grounded capacitors. The condition of oscillation and the frequency of oscillation can be adjusted by electronic method. The circuits have high output impedance and use only grounded capacitors without any external resistor which is very appropriate to future development into an integrated circuit. The results of PSPICE simulation program are corresponding to the theoretical analysis.
Abstract: Social interest and demand on Home-Network has
been increasing greatly. Although various services are being
introduced to respond to such demands, they can cause serious
security problems when linked to the open network such as Internet.
This paper reviews the security requirements to protect the service
users with assumption that the Home-Network environment is
connected to Internet and then proposes the security model based on
the requirement. The proposed security model can satisfy most of the
requirements and further can be dynamically applied to the future
ubiquitous Home-Networks.
Abstract: This paper presents the experimental results of
discharge current phenomena on various humidity, temperature,
pressure and pollutant conditions of epoxy resin specimen. The
leakage distance of specimen was 3 cm, that it was supplied by high
voltage. The polluted condition was given with NaCl artificial
pollutant. The conducted measurements were discharge current and
applied voltage. The specimen was put in a hermetically sealed
chamber, and the current waveforms were analyzed with FFT.
The result indicated that on discharge condition, the fifth
harmonics still had dominant, rather than third one. The third
harmonics tent to be appeared on low pressure heavily polluted
condition, and followed by high humidity heavily polluted condition.
On the heavily polluted specimen, the peaks discharge current points
would be high and more frequent. Nevertheless, the specimen still
had capacitive property. Besides that, usually discharge current
points were more frequent. The influence of low pressure was still
dominant to be easier to discharge. The non-linear property would be
appear explicitly on low pressure and heavily polluted condition.
Abstract: With the growth of electricity generation from gas
energy gas pipeline reliability can substantially impact the electric
generation. A physical disruption to pipeline or to a compressor
station can interrupt the flow of gas or reduce the pressure and lead
to loss of multiple gas-fired electric generators, which could
dramatically reduce the supplied power and threaten the power
system security. Gas pressure drops during peak loading time on
pipeline system, is a common problem in network with no enough
transportation capacity which limits gas transportation and causes
many problem for thermal domain power systems in supplying their
demand. For a feasible generation scheduling planning in networks
with no sufficient gas transportation capacity, it is required to
consider gas pipeline constraints in solving the optimization problem
and evaluate the impacts of gas consumption in power plants on gas
pipelines operating condition. This paper studies about operating of
gas fired power plants in critical conditions when the demand of gas
and electricity peak together. An integrated model of gas and electric
model is used to consider the gas pipeline constraints in the economic
dispatch problem of gas-fueled thermal generator units.
Abstract: This paper presents the development of adaptive
distance relay for protection of parallel transmission line with mutual
coupling. The proposed adaptive relay, automatically adjusts its
operation based on the acquisition of the data from distance relay of
adjacent line and status of adjacent line from line circuit breaker IED
(Intelligent Electronic Device). The zero sequence current of the
adjacent parallel transmission line is used to compute zero sequence
current ratio and the mutual coupling effect is fully compensated.
The relay adapts to changing circumstances, like failure in
communication from other relays and non - availability of adjacent
transmission line. The performance of the proposed adaptive relay is
tested using steady state and dynamic test procedures. The fault
transients are obtained by simulating a realistic parallel transmission
line system with mutual coupling effect in PSCAD. The evaluation
test results show the efficacy of adaptive distance relay over the
conventional distance relay.
Abstract: The paper aims to show that implementing different
types of reflectors in solar energy systems, will dramatically improve
energy production by means of concentrating and intensifying more
sunlight onto a solar cell. The Solar Intensifier unit is designed to
increase efficiency and performance of a set of solar panels. The unit
was fabricated and tested. The experimental results show good
improvement in the performance of the solar energy system.
Abstract: Wind power is among the most actively developing distributed generation (DG) technology. Majority of the wind power based DG technologies employ wind turbine induction generators (WTIG) instead of synchronous generators, for the technical advantages like: reduced size, increased robustness, lower cost, and increased electromechanical damping. However, dynamic changes of wind speed make the amount of active/reactive power injected/drawn to a WTIG embedded distribution network highly variable. This paper analyzes the effect of wind speed changes on the active and reactive power penetration to the wind energy embedded distribution network. Four types of wind speed changes namely; constant, linear change, gust change and random change of wind speed are considered in the analysis. The study is carried out by three-phase, non-linear, dynamic simulation of distribution system component models. Results obtained from the investigation are presented and discussed.
Abstract: In this paper, an Interactive Compromise Approach
with Particle Swarm Optimization(ICA-PSO) is presented to solve the
Economic Emission Dispatch(EED) problem. The cost function and
emission function are modeled as the nonsmooth functions,
respectively. The bi-objective including both the minimization of cost
and emission is formulated in this paper. ICA-PSO is proposed to
solve EED problem for finding a better compromise solution. The
solution methodology can offer a global or near-global solution for
decision-making requirements. The effectiveness and efficiency of
ICA-PSO are demonstrated by a sample test system. Test results can
be shown that the proposed method provide a practical and flexible
framework for power dispatch.
Abstract: In this paper, we address the problem of adaptive radio
resource allocation (RRA) and packet scheduling in the downlink of a
cellular OFDMA system, and propose a downlink multi-carrier
proportional fair (MPF) scheduler and its joint with adaptive RRA
algorithm to distribute radio resources among multiple users according
to their individual QoS requirements. The allocation and scheduling
objective is to maximize the total throughput, while at the same time
maintaining the fairness among users. The simulation results
demonstrate that the methods presented provide for user more explicit
fairness relative to RRA algorithm, but the joint scheme achieves the
higher sum-rate capacity with flexible parameters setting compared
with MPF scheduler.
Abstract: Facial expression analysis is rapidly becoming an
area of intense interest in computer science and human-computer
interaction design communities. The most expressive way humans
display emotions is through facial expressions. In this paper we
present a method to analyze facial expression from images by
applying Gabor wavelet transform (GWT) and Discrete Cosine
Transform (DCT) on face images. Radial Basis Function (RBF)
Network is used to classify the facial expressions. As a second stage,
the images are preprocessed to enhance the edge details and non
uniform down sampling is done to reduce the computational
complexity and processing time. Our method reliably works even
with faces, which carry heavy expressions.
Abstract: This paper presents recent work on the improvement
of the robotics vision based control strategy for underwater pipeline
tracking system. The study focuses on developing image processing
algorithms and a fuzzy inference system for the analysis of the
terrain. The main goal is to implement the supervisory fuzzy learning
control technique to reduce the errors on navigation decision due to
the pipeline occlusion problem. The system developed is capable of
interpreting underwater images containing occluded pipeline, seabed
and other unwanted noise. The algorithm proposed in previous work
does not explore the cooperation between fuzzy controllers,
knowledge and learnt data to improve the outputs for underwater
pipeline tracking. Computer simulations and prototype simulations
demonstrate the effectiveness of this approach. The system accuracy
level has also been discussed.
Abstract: In this paper, a Cooperative Multi-robot for Carrying
Targets (CMCT) algorithm is proposed. The multi-robot team
consists of three robots, one is a supervisor and the others are
workers for carrying boxes in a store of 100×100 m2. Each robot has
a self recharging mechanism. The CMCT minimizes robot-s worked
time for carrying many boxes during day by working in parallel. That
is, the supervisor detects the required variables in the same time
another robots work with previous variables. It works with
straightforward mechanical models by using simple cosine laws. It
detects the robot-s shortest path for reaching the target position
avoiding obstacles by using a proposed CMCT path planning
(CMCT-PP) algorithm. It prevents the collision between robots
during moving. The robots interact in an ad hoc wireless network.
Simulation results show that the proposed system that consists of
CMCT algorithm and its accomplished CMCT-PP algorithm
achieves a high improvement in time and distance while performing
the required tasks over the already existed algorithms.
Abstract: A way of generating millimeter wave I/Q signal using inductive resonator matched poly-phase filter is suggested. Normally the poly-phase filter generates quite accurate I/Q phase and magnitude but the loss of the filter is considerable due to series connection of passive RC components. This loss term directly increases system noise figure when the poly-phase filter is used in RF Front-end. The proposed matching method eliminates above mentioned loss and in addition provides gain on the passive filter. The working algorithm is illustrated by mathematical analysis. The generated I/Q signal is used in implementing millimeter wave phase shifter for the 60 GHz communication system to verify its effectiveness. The circuit is fabricated in 90 nm TSMC RF CMOS process under 1.2 V supply voltage. The measurement results showed that the suggested method improved gain by 6.5 dB and noise by 2.3 dB. The summary of the proposed I/Q generation is compared with previous works.
Abstract: Continuous-time delta-sigma analog digital converter (ADC) for radio frequency identification (RFID) complementary metal oxide semiconductor (CMOS) biosensor has been reported. This delta-sigma ADC is suitable for digital conversion of biosensor signal because of small process variation, and variable input range. As the input range of continuous-time switched current delta-sigma ADC (Dynamic range : 50 dB) can be limited by using current reference, amplification of biosensor signal is unnecessary. The input range is switched to wide input range mode or narrow input range mode by command of current reference. When the narrow input range mode, the input range becomes ± 0.8 V. The measured power consumption is 5 mW and chip area is 0.31 mm^2 using 1.2 um standard CMOS process. Additionally, automatic input range detecting system is proposed because of RFID biosensor applications.
Abstract: The artificial intelligent controller in power system
plays as most important rule for many applications such as system
operation and its control specially Load Frequency Controller (LFC).
The main objective of LFC is to keep the frequency and tie-line power
close to their decidable bounds in case of disturbance. In this paper,
parallel fuzzy PI adaptive with conventional PD technique for Load
Frequency Control system was proposed. PSO optimization method
used to optimize both of scale fuzzy PI and tuning of PD. Two equal
interconnected power system areas were used as a test system.
Simulation results show the effectiveness of the proposed controller
compared with different PID and classical fuzzy PI controllers in terms
of speed response and damping frequency.
Abstract: The importance of low power consumption is widely
acknowledged due to the increasing use of portable devices, which
require minimizing the consumption of energy. Energy dissipation is
heavily dependent on the software used in the system. Applying
design patterns in object-oriented designs is a common practice
nowadays. In this paper we analyze six design patterns and explore
the effect of them on energy consumption and performance.
Abstract: In this paper we proposed a method for finding video
frames representing one sign in the finger alphabet. The method is
based on determining hands location, segmentation and the use of
standard video quality evaluation metrics. Metric calculation is
performed only in regions of interest. Sliding mechanism for finding
local extrema and adaptive threshold based on local averaging is used
for key frames selection. The success rate is evaluated by recall,
precision and F1 measure. The method effectiveness is compared
with metrics applied to all frames. Proposed method is fast, effective
and relatively easy to realize by simple input video preprocessing
and subsequent use of tools designed for video quality measuring.
Abstract: We study in this paper the effect of the scene
changing on image sequences coding system using Embedded
Zerotree Wavelet (EZW). The scene changing considered here is the
full motion which may occurs. A special image sequence is generated
where the scene changing occurs randomly. Two scenarios are
considered: In the first scenario, the system must provide the
reconstruction quality as best as possible by the management of the
bit rate (BR) while the scene changing occurs. In the second scenario,
the system must keep the bit rate as constant as possible by the
management of the reconstruction quality. The first scenario may be
motivated by the availability of a large band pass transmission
channel where an increase of the bit rate may be possible to keep the
reconstruction quality up to a given threshold. The second scenario
may be concerned by the narrow band pass transmission channel
where an increase of the bit rate is not possible. In this last case,
applications for which the reconstruction quality is not a constraint
may be considered. The simulations are performed with five scales
wavelet decomposition using the 9/7-tap filter bank biorthogonal
wavelet. The entropy coding is performed using a specific defined
binary code book and EZW algorithm. Experimental results are
presented and compared to LEAD H263 EVAL. It is shown that if
the reconstruction quality is the constraint, the system increases the
bit rate to obtain the required quality. In the case where the bit rate
must be constant, the system is unable to provide the required quality
if the scene change occurs; however, the system is able to improve
the quality while the scene changing disappears.
Abstract: The new concept of two–dimensional (2D) image
processing implementation for auto-guiding system is shown in this
paper. It is dedicated to astrophotography and operates with
astronomy CCD guide cameras or with self-guided dual-detector
CCD cameras and ST4 compatible equatorial mounts. This idea was
verified by MATLAB model, which was used to test all procedures
and data conversions. Next the circuit prototype was implemented at
Altera MAX II CPLD device and tested for real astronomical object
images. The digital processing speed of CPLD prototype board was
sufficient for correct equatorial mount guiding in real-time system.