Abstract: The objective of this study is to evaluate the
occurrence of fungi in aerobic and anoxic activated sludge from
membrane bioreactors (MBRs). Thirty-six samples of both aerobic
and anoxic activated sludge were taken from 2 MBR treating
domestic wastewater. Over a period of eight months 2 samples from
each plant were taken per month. The samples were prepared for
count and definition of fungi. The obtained data show that, sixty
species belonging to 27 genera were collected from activated sludge
samples under aerobic and anoxic conditions. Regarding to the fungi
definition, under aerobic condition the Geotrichum was found at
(8.8%) followed by Penicillium (75.0%), Yeasts (65.7%) and
Trichoderma (55.5%), while Yeasts (77.1%) Geotrichum
candidumand Penicillium (61.1%) species were the most prevalent in
anoxic activated sludge. The results indicate that activated sludge is
habitat for growth and sporulation of different groups of fungi, both
saprophytic and pathogenic.
Abstract: This paper focuses on the 3D reconstruction of
the architectural design of Darul Ridzuan Museum. It has
concentrated on designing exterior part of the building according
to colored digital photo of the real museum. Besides viewing the
architecture, walkthroughs are generated for the user to control
it in an easier way. User can travel through the museum to get
the feel of the environment and to explore the design of the
museum as a whole; both exterior and interior. The result has
shown positive result in terms of realism, navigation, collision
detection, suitability, usability and user-s acceptance. In brief,
the 3D virtual museum has provided an alternative to present a
real museum.
Abstract: In the planning point of view, it is essential to have
mode choice, due to the massive amount of incurred in transportation
systems. The intercity travellers in Libya have distinct features, as
against travellers from other countries, which includes cultural and
socioeconomic factors. Consequently, the goal of this study is to
recognize the behavior of intercity travel using disaggregate models,
for projecting the demand of nation-level intercity travel in Libya.
Multinomial Logit Model for all the intercity trips has been
formulated to examine the national-level intercity transportation in
Libya. The Multinomial logit model was calibrated using nationwide
revealed preferences (RP) and stated preferences (SP) survey. The
model was developed for deference purpose of intercity trips (work,
social and recreational). The variables of the model have been
predicted based on maximum likelihood method. The data needed for
model development were obtained from all major intercity corridors
in Libya. The final sample size consisted of 1300 interviews. About
two-thirds of these data were used for model calibration, and the
remaining parts were used for model validation. This study, which is
the first of its kind in Libya, investigates the intercity traveler’s
mode-choice behavior. The intercity travel mode-choice model was
successfully calibrated and validated. The outcomes indicate that, the
overall model is effective and yields higher precision of estimation.
The proposed model is beneficial, due to the fact that, it is receptive
to a lot of variables, and can be employed to determine the impact of
modifications in the numerous characteristics on the need for various
travel modes. Estimations of the model might also be of valuable to
planners, who can estimate possibilities for various modes and
determine the impact of unique policy modifications on the need for
intercity travel.
Abstract: In this paper, a Cooperative Multi-robot for Carrying
Targets (CMCT) algorithm is proposed. The multi-robot team
consists of three robots, one is a supervisor and the others are
workers for carrying boxes in a store of 100×100 m2. Each robot has
a self recharging mechanism. The CMCT minimizes robot-s worked
time for carrying many boxes during day by working in parallel. That
is, the supervisor detects the required variables in the same time
another robots work with previous variables. It works with
straightforward mechanical models by using simple cosine laws. It
detects the robot-s shortest path for reaching the target position
avoiding obstacles by using a proposed CMCT path planning
(CMCT-PP) algorithm. It prevents the collision between robots
during moving. The robots interact in an ad hoc wireless network.
Simulation results show that the proposed system that consists of
CMCT algorithm and its accomplished CMCT-PP algorithm
achieves a high improvement in time and distance while performing
the required tasks over the already existed algorithms.
Abstract: In Algeria, some fruit trees produce fruits in free nature. Such trees are Celtis australis, Crataegus azarolus, Crataegus monogyna and Zizyphus lotus. In spite of their appreciable consumption, their nutritional value remains unknown. The objective of this study is the determination of sugars in the pulpe and almond of the above fruits. The biochemical analysis shows that these fruits present interesting contents of soluble sugars which confers significant caloric intakes to them. As well as significant fibres which give them therapeutic and industrial benefits? The analysis of the almonds shows that it contains considerable contents of sugars which enable them to be an energetic food.
Abstract: The usage of internet is rapidly increasing and the usage of mobile agent technology in internet environment has a great demand. The security issue one of main obstacles that restrict the mobile agent technology to spread. This paper proposes Secure-Image Mechanism (SIM) as a new mechanism to protect mobile agents against malicious hosts. . SIM aims to protect mobile agent by using the symmetric encryption and hash function in cryptography science. This mechanism can prevent the eavesdropping and alteration attacks. It assists the mobile agents to continue their journey normally incase attacks occurred.
Abstract: The technology usages of high speed Internet leads to
establish and start new era of online education. With the
advancement of the information technology and communication
systems new opportunities have been created. This leads universities
to have various online education channels to meet the demand of
different learners- needs. One of these channels is M-learning, which
can be used to improve the online education environment. With using
such mobile technology in learning both students and instructors can
easily access educational courses anytime from anywhere. The paper
first presents literature about mobile learning and to what extent this
approach can be utilized to enhance the overall learning system. It
provides a comparison between mobile learning and traditional elearning
showing the wide array of benefits of the new generation of
technology. The possible challenges and potential advantages of Mlearning
in the online education system are also discussed.
Abstract: The thermal, epithermal and fast fluxes were
calculated for three irradiation channels at Egypt Second Research
Reactor (ETRR-2) using CITVAP code. The validity of the
calculations was verified by experimental measurements. There are
some deviations between measurements and calculations. This is due
to approximations in the calculation models used, homogenization of
regions, condensation of energy groups and uncertainty in nuclear
data used. Neutron flux data for the three irradiation channels are
now available. This would enable predicting the irradiation
conditions needed for future radioisotope production.
Abstract: By taking advantage of computer-s processing power, an unlimited number of variations and parameters in both spatial and environmental can be provided while following the same set of rules and constraints. This paper focuses on using the tools of parametric urbanism towards a more responsive environmental and sustainable urban morphology. It presents an understanding to Parametric Urban Comfort Envelope (PUCE) as an interactive computational assessment urban model. In addition, it investigates the applicability potentials of this model to generate an optimized urban form to Borg El Arab city (a new Egyptian Community) concerning the human comfort values specially wind and solar envelopes. Finally, this paper utilizes its application outcomes -both visual and numerical- to extend the designer-s limitations by decrease the concern of controlling and manipulation of geometry, and increase the designer-s awareness about the various potentials of using the parametric tools to create relationships that generate multiple geometric alternatives.
Abstract: An experiment was conducted using two aeration
methods (water-into-air and air-into-water) and followed by filtration
processes using manganese greensand material. The properties of
groundwater such as pH, dissolved oxygen, turbidity and heavy metal
concentration (iron and manganese) will be assessed. The objectives
of this study are i) to determine the effective aeration method and ii)
to assess the effectiveness of manganese greensand as filter media in
removing iron and manganese concentration in groundwater. Results
showed that final pH for all samples after treatment are in range from
7.40 and 8.40. Both aeration methods increased the dissolved oxygen
content. Final turbidity for groundwater samples are between 3 NTU
to 29 NTU. Only three out of eight samples achieved iron
concentration of 0.3mg/L and less and all samples reach manganese
concentration of 0.1mg/L and less. Air-into-water aeration method
gives higher percentage of iron and manganese removal compare to
water-into-air method.
Abstract: According to the masonry standard the compressive
strength is basically dependent on factors such as the mortar strength
and the relative values of unit and mortar strength. However
interlocking brick has none or less use of mortar. Therefore there is a need to investigate the behavior of masonry walls using interlocking
bricks. In this study a series of tests have been conducted; physical
properties and compressive strength of brick units and masonry walls
were constructed from interlocking bricks and tested under constant
vertical load at different eccentricities. The purpose of the
experimental investigations is to obtain the force displacement curves, analyze the behavior of masonry walls. The results showed
that the brick is categorized as common brick (BS 3921:1985) and severe weathering grade (ASTM C62). The maximum compressive stress of interlocking brick wall is 3.6 N/mm2 and fulfilled the requirement of standard for residential building.
Abstract: In recent years, rehabilitation has been the subject of extensive research due to increased spending on building work and repair of built works. In all cases, it is absolutely essential to carry out methods of strengthening or repair of structural elements, and that following an inspection analysis and methodology of a correct diagnosis. The reinforced concrete columns are important elements in building structures. They support the vertical loads and provide bracing against the horizontal loads. This research about the behavior of reinforced concrete rectangular columns, rehabilitated by concrete liner, confinement FRP fabric, steel liner or cage formed by metal corners. It allows comparing the contributions of different processes used perspective section resistance elements rehabilitated compared to that is not reinforced or repaired. The different results obtained revealed a considerable gain in bearing capacity failure of reinforced sections cladding concrete, metal bracket, steel plates and a slight improvement to the section reinforced with fabric FRP. The use of FRP does not affect the weight of the structures, but the use of different techniques cladding increases the weight of elements rehabilitated and therefore the weight of the building which requires resizing foundations.
Abstract: Based on the homotopy perturbation method (HPM)
and Padé approximants (PA), approximate and exact solutions are
obtained for cubic Boussinesq and modified Boussinesq equations.
The obtained solutions contain solitary waves, rational solutions.
HPM is used for analytic treatment to those equations and PA for
increasing the convergence region of the HPM analytical solution.
The results reveal that the HPM with the enhancement of PA is a
very effective, convenient and quite accurate to such types of partial
differential equations.
Abstract: We demonstrate single-photon interference over 10 km using a plug and play system for quantum key distribution. The quality of the interferometer is measured by using the interferometer
visibility. The coding of the signal is based on the phase coding and the value of visibility is based on the interference effect, which result a number of count. The setup gives full control of polarization inside
the interferometer. The quality measurement of the interferometer is based on number of count per second and the system produces 94 % visibility in one of the detectors.
Abstract: Classification of video sequences based on their contents is a vital process for adaptation techniques. It helps decide which adaptation technique best fits the resource reduction requested by the client. In this paper we used the principal feature analysis algorithm to select a reduced subset of video features. The main idea is to select only one feature from each class based on the similarities between the features within that class. Our results showed that using this feature reduction technique the source video features can be completely omitted from future classification of video sequences.
Abstract: Economic crime (i.e. corporate fraud) has a
significant impact on business. This study analyzes the fraud cases
reported by the Malaysian Securities Commission. Frauds involving
market manipulation and/or illegal share trading are the most
common types of fraud reported over the 6 years analyzed. The
highest number of frauds reported involved investment and fund
holding companies. Alarmingly the results indicate quite a high
number of frauds cases are committed by management. The higher
number of Chinese perpetrators may be due to fact that they are the
dominant group in Malaysian business. The result also shows that
more than half of companies involved with fraud are privately held
companies in the investment/fund/finance sector. The results of this
study highlight general characteristic of perpetrators (person and
company) that commit fraud which could help the regulators in their
monitoring and enforcement activities. To investors, this would help
in analyzing their business investment or portfolio risk.
Abstract: This paper proposes a Fuzzy Sliding Mode Control (FSMC) as a control strategy for Buck-Boost DC-DC converter. The proposed fuzzy controller specifies changes in the control signal based on the knowledge of the surface and the surface change to satisfy the sliding mode stability and attraction conditions. The performances of the proposed fuzzy sliding controller are compared to those obtained by a classical sliding mode controller. The satisfactory simulation results show the efficiency of the proposed control law which reduces the chattering phenomenon. Moreover, the obtained results prove the robustness of the proposed control law against variation of the load resistance and the input voltage of the studied converter.
Abstract: We construct an exponentially weighted Legendre- Gauss Tau method for solving differential equations with oscillatory solutions. The proposed method is applied to Sturm-Liouville problems. Numerical examples illustrating the efficiency and the high accuracy of our results are presented.
Abstract: The main idea behind in network aggregation is that,
rather than sending individual data items from sensors to sinks,
multiple data items are aggregated as they are forwarded by the
sensor network. Existing sensor network data aggregation techniques
assume that the nodes are preprogrammed and send data to a central
sink for offline querying and analysis. This approach faces two major
drawbacks. First, the system behavior is preprogrammed and cannot
be modified on the fly. Second, the increased energy wastage due to
the communication overhead will result in decreasing the overall
system lifetime. Thus, energy conservation is of prime consideration
in sensor network protocols in order to maximize the network-s
operational lifetime. In this paper, we give an energy efficient
approach to query processing by implementing new optimization
techniques applied to in-network aggregation. We first discuss earlier
approaches in sensors data management and highlight their
disadvantages. We then present our approach “Energy Efficient
Indexed Aggregation" (EEIA) and evaluate it through several
simulations to prove its efficiency, competence and effectiveness.
Abstract: This paper presents modern vibration signalprocessing
techniques for vehicle gearbox fault diagnosis, via the
wavelet analysis and the Squared Envelope (SE) technique. The
wavelet analysis is regarded as a powerful tool for the detection of
sudden changes in non-stationary signals. The Squared Envelope
(SE) technique has been extensively used for rolling bearing
diagnostics. In the present work a scheme of using the Squared
Envelope technique for early detection of gear tooth pit. The pitting
defect is manufactured on the tooth side of a fifth speed gear on the
intermediate shaft of a vehicle gearbox. The objective is to
supplement the current techniques of gearbox fault diagnosis based
on using the raw vibration and ordered signals. The test stand is
equipped with three dynamometers; the input dynamometer serves as
the internal combustion engine, the output dynamometers introduce
the load on the flanges of output joint shafts. The gearbox used for
experimental measurements is the type most commonly used in
modern small to mid-sized passenger cars with transversely mounted
powertrain and front wheel drive; a five-speed gearbox with final
drive gear and front wheel differential. The results show that the
approaches methods are effective for detecting and diagnosing
localized gear faults in early stage under different operation
conditions, and are more sensitive and robust than current gear
diagnostic techniques.