Abstract: The main purpose of this research was to analyze Socio-Cultural obstacles of disseminating of nanotechnology in Iran's agricultural section. One hundred twenty eight out of a total of 190 researchers with different levels of expertise in and familiarity with nanotechnology were randomly selected and questionnaires completed by them. Face validity have been done by expert's suggestion and correction, reliability by using Cronbakh-Alpha formula. The results of a factor analysis showed variation for different factors. For cultural factors 19/475 percent, for management 13/139 percent, information factor 11/277 percent, production factor 9/703 percent, social factor 9/267 percent, and for attitude factor it became 8/947 percent. Also results indicated that socio-cultural factors were the most important obstacle for nanotechnology dissemination in agricultural section in Iran.
Abstract: This study presents an exact general solution for
steady-state conductive heat transfer in cylindrical composite
laminates. Appropriate Fourier transformation has been obtained
using Sturm-Liouville theorem. Series coefficients are achieved by
solving a set of equations that related to thermal boundary conditions
at inner and outer of the cylinder, also related to temperature
continuity and heat flux continuity between each layer. The solution
of this set of equations are obtained using Thomas algorithm. In this
paper, the effect of fibers- angle on temperature distribution of
composite laminate is investigated under general boundary
conditions. Here, we show that the temperature distribution for any
composite laminates is between temperature distribution for
laminates with θ = 0° and θ = 90° .
Abstract: Artemia is one of the most conspicuous invertebrates
associated with aquaculture. It can be considered as a model
organism, offering numerous advantages for comprehensive and
multidisciplinary studies using morphologic or molecular methods.
Since DNA extraction is an important step of any molecular
experiment, a new and a rapid method of DNA extraction from adult
Artemia was described in this study. Besides, the efficiency of this
technique was compared with two widely used alternative techniques,
namely Chelex® 100 resin and SDS-chloroform methods. Data
analysis revealed that the new method is the easiest and the most cost
effective method among the other methods which allows a quick and
efficient extraction of DNA from the adult animal.
Abstract: The study of interaction among the grain, moisture,
and the surrounding space (air) is key to understanding the graindrying
process. In Iran, rice (mostly Indica type) is dried by flat
bed type dryer until the final MC reaches to 6 to 8%. The
experiments were conducted to examine the effect of application of
discharge fan with different heights of paddy on the drying
efficiency. Experiments were designed based on two different
configurations of the drying methods; with and without discharge
fan with three different heights of paddy including; 5, 10, and 15
cm. The humid heated air will be going out immediately by the
suction of discharge fan. The drying time is established upon the
average final MC to achieve about 8%. To save energy and reduce
the drying time, the distribution of temperature between layers
should be fast and uniform with minimum difference; otherwise
the difference of MC gradient between layers will be high and will
induce grain breakage. The difference of final MC between layers
in the two methods was 48-73%. The steady state of temperature
between the two methods has saved time in the range of 10-20%,
and the efficiency of temperature distribution increased 17-26% by
the use of discharge fan.
Abstract: In this paper a new approach for transmission pricing
is presented. The main idea is voltage angle allocation, i.e.
determining the contribution of each contract on the voltage angle of
each bus. DC power flow is used to compute a primary solution for
angle decomposition. To consider the impacts of system non-linearity
on angle decomposition, the primary solution is corrected in different
iterations of decoupled Newton-Raphson power flow. Then, the
contribution of each contract on power flow of each transmission line
is computed based on angle decomposition. Contract-related flows
are used as a measure for “extent of use" of transmission network
capacity and consequently transmission pricing. The presented
approach is applied to a 4-bus test system and IEEE 30-bus test
system.
Abstract: Diabetes is one of the high prevalence diseases
worldwide with increased number of complications, with retinopathy
as one of the most common one. This paper describes how data
mining and case-based reasoning were integrated to predict
retinopathy prevalence among diabetes patients in Malaysia. The
knowledge base required was built after literature reviews and
interviews with medical experts. A total of 140 diabetes patients- data
were used to train the prediction system. A voting mechanism selects
the best prediction results from the two techniques used. It has been
successfully proven that both data mining and case-based reasoning
can be used for retinopathy prediction with an improved accuracy of
85%.
Abstract: This paper discusses the effectiveness of the EEG signal
for human identification using four or less of channels of two different
types of EEG recordings. Studies have shown that the EEG signal
has biometric potential because signal varies from person to person
and impossible to replicate and steal. Data were collected from 10
male subjects while resting with eyes open and eyes closed in 5
separate sessions conducted over a course of two weeks. Features
were extracted using the wavelet packet decomposition and analyzed
to obtain the feature vectors. Subsequently, the neural networks
algorithm was used to classify the feature vectors. Results show that,
whether or not the subjects- eyes were open are insignificant for a 4–
channel biometrics system with a classification rate of 81%. However,
for a 2–channel system, the P4 channel should not be included if data
is acquired with the subjects- eyes open. It was observed that for 2–
channel system using only the C3 and C4 channels, a classification
rate of 71% was achieved.
Abstract: A biocompatible ferrofluid have been prepared by coprecipitation
of FeCl2.4H2O and FeCl3.6H2O under ultrasonic
irradiation and with NaOH as alkaline agent. Cystein was also used
as capping agent in the solution. Magnetic properties of the produced
ferrofluid were then determined by VSM test and magnetite
nanoparticles were characterized by XRD and TEM techniques. The
effect of surfactant to Fe ion weight ratio was also studied during this
project by using two different amount of Dextran. Results showed the
presence of a biocompatible superparamagnetic ferrofluid including
magnetite nanoparticles with particle size ranging under 20 nm. The
increase in the surfactant content results in the narrowing of the size
distribution and reduction of the particle size and more solution
stability.
Abstract: Nowadays predicting political risk level of country
has become a critical issue for investors who intend to achieve
accurate information concerning stability of the business
environments. Since, most of the times investors are layman and
nonprofessional IT personnel; this paper aims to propose a
framework named GECR in order to help nonexpert persons to
discover political risk stability across time based on the political
news and events.
To achieve this goal, the Bayesian Networks approach was
utilized for 186 political news of Pakistan as sample dataset.
Bayesian Networks as an artificial intelligence approach has been
employed in presented framework, since this is a powerful technique
that can be applied to model uncertain domains. The results showed
that our framework along with Bayesian Networks as decision
support tool, predicted the political risk level with a high degree of
accuracy.
Abstract: By analyzing the sources of energy and power
loss in PWM (Pulse Width Modulation) controlled drivers of
water electrolysis cells, it is possible to reduce the power
dissipation and enhance the efficiency of such hydrogen
production units. A PWM controlled power driver is based on
a semiconductor switching element where its power
dissipation might be a remarkable fraction of the total power
demand of an electrolysis system. Power dissipation in a
semiconductor switching element is related to many different
parameters which could be fitted into two main categories:
switching losses and conduction losses. Conduction losses are
directly related to the built, structure and capabilities of a
switching device itself and indeed the conditions in which the
element is handling the switching application such as voltage,
current, temperature and of course the fabrication technology.
On the other hand, switching losses have some other
influencing variables other than the mentioned such as control
system, switching method and power electronics circuitry of
the PWM power driver. By analyzings the characteristics of
recently developed power switching transistors from different
families of Bipolar Junction Transistors (BJT), Metal Oxide
Semiconductor Field Effect Transistors (MOSFET) and
Insulated Gate Bipolar Transistors (IGBT), some
recommendations are made in this paper which are able to
lead to achieve higher hydrogen production efficiency by
utilizing PWM controlled water electrolysis cells.
Abstract: Semiconductor materials with coatings have a wide range of applications in MEMS and NEMS. This work uses transfermatrix method for calculating the radiative properties. Dopped silicon is used and the coherent formulation is applied. The Drude model for the optical constants of doped silicon is employed. Results showed that for the visible wavelengths, more emittance occurs in greater concentrations and the reflectance decreases as the concentration increases. In these wavelengths, transmittance is negligible. Donars and acceptors act similar in visible wavelengths. The effect of wave interference can be understood by plotting the spectral properties such as reflectance or transmittance of a thin dielectric film versus the film thickness and analyzing the oscillations of properties due to constructive and destructive interferences. But this effect has not been shown at visible wavelengths. At room temperature, the scattering process is dominated by lattice scattering for lightly doped silicon, and the impurity scattering becomes important for heavily doped silicon when the dopant concentration exceeds1018cm-3 .