Abstract: The permanent magnet synchronous motor (PMSM) is
very useful in many applications. Vector control of PMSM is popular
kind of its control. In this paper, at first an optimal vector control for
PMSM is designed and then results are compared with conventional
vector control. Then, it is assumed that the measurements are noisy
and linear quadratic Gaussian (LQG) methodology is used to filter
the noises. The results of noisy optimal vector control and filtered
optimal vector control are compared to each other. Nonlinearity of
PMSM and existence of inverter in its control circuit caused that the
system is nonlinear and time-variant. With deriving average model,
the system is changed to nonlinear time-invariant and then the
nonlinear system is converted to linear system by linearization of
model around average values. This model is used to optimize vector
control then two optimal vector controls are compared to each other.
Simulation results show that the performance and robustness to noise
of the control system has been highly improved.
Abstract: Network management techniques have long been of
interest to the networking research community. The queue size plays
a critical role for the network performance. The adequate size of the
queue maintains Quality of Service (QoS) requirements within
limited network capacity for as many users as possible. The
appropriate estimation of the queuing model parameters is crucial for
both initial size estimation and during the process of resource
allocation. The accurate resource allocation model for the
management system increases the network utilization. The present
paper demonstrates the results of empirical observation of memory
allocation for packet-based services.
Abstract: Developments in scientific and technical area cause to use new methods and techniques in education, as is the case in all fields. Especially, the internet contributes a variety of new methods to design virtual and real time laboratory applications in education. In this study, a real time virtual laboratory is designed and implemented for analog and digital communications laboratory experiments by using Lab VIEW program for Marmara University Electronics-Communication Department. In this application, students can access the virtual laboratory web site and perform their experiments without any limitation of time and location so as the students can observe the signals by changing the parameters of the experiment and evaluate the results.
Abstract: The computer, among the most important inventions of the twentieth century, has become an increasingly important component in our everyday lives. Computer games also have become increasingly popular among people day-by-day, owing to their features based on realistic virtual environments, audio and visual features, and the roles they offer players. In the present study, the metaphors students have for computer games are investigated, as well as an effort to fill the gap in the literature. Students were asked to complete the sentence—‘Computer game is like/similar to….because….’— to determine the middle school students’ metaphorical images of the concept for ‘computer game’. The metaphors created by the students were grouped in six categories, based on the source of the metaphor. These categories were ordered as ‘computer game as a means of entertainment’, ‘computer game as a beneficial means’, ‘computer game as a basic need’, ‘computer game as a source of evil’, ‘computer game as a means of withdrawal’, and ‘computer game as a source of addiction’, according to the number of metaphors they included.
Abstract: In 2002 an amendment to SOLAS opened for
lightweight material constructions in vessels if the same fire safety as
in steel constructions could be obtained. FISPAT (FIreSPread
Analysis Tool) is a computer application that simulates fire spread
and fault injection in cruise vessels and identifies fire sensitive areas.
It was developed to analyze cruise vessel designs and provides a
method to evaluate network layout and safety of cruise vessels. It
allows fast, reliable and deterministic exhaustive simulations and
presents the result in a graphical vessel model. By performing the
analysis iteratively while altering the cruise vessel design it can be
used along with fire chamber experiments to show that the
lightweight design can be as safe as a steel construction and that
SOLAS regulations are fulfilled.
Abstract: The influence of full-fat soy flour (FFSF) and
extrusion conditions on the mechanical characteristics of dry
spaghetti were evaluated. Process was performed with screw speed of
10-40rpm and water circulating temperature of 35-70°C. Data
analysis using mixture design showed that this enrichment resulted in
significant differences in mechanical strength.
Abstract: The study was a case study analysis about Thai Asia
Pacific Brewery Company. The purpose was to analyze the
company’s marketing objective, marketing strategy at company level,
and marketing mix before liquor liberalization in 2000. Methods used
in this study were qualitative and descriptive research approach
which demonstrated the following results of the study demonstrated
as follows: (1) Marketing objective was to increase market share of
Heineken and Amtel, (2) the company’s marketing strategies were
brand building strategy and distribution strategy. Additionally, the
company also conducted marketing mix strategy as follows. Product
strategy: The company added more beer brands namely Amstel and
Tiger to provide additional choice to consumers, product and
marketing research, and product development. Price strategy: the
company had taken the following into consideration: cost,
competitor, market, economic situation and tax. Promotion strategy:
the company conducted sales promotion and advertising. Distribution
strategy: the company extended channels its channels of distribution
into food shops, pubs and various entertainment places. This strategy
benefited interested persons and people who were engaged in the beer
business.
Abstract: This paper deals with the development of a Jacobean model for a 4-axes indigenously developed scara robot arm in the laboratory. This model is used to study the relation between the velocities and the forces in the robot while it is doing the pick and place operation.
Abstract: In this paper the main objective is to analyze the
quality of service of the bus companies operating in the city of
Campos, located in the state of Rio de Janeiro, Brazil. This analysis,
based on the opinion of the bus customers, will help to determine
their degree of satisfaction with the service provided by the bus
companies. The result of this assessment shows that the bus
customers are displeased with the quality of service supplied by the
bus companies. Therefore, it is necessary to identify alternative
solutions to minimize the consequences of the main problems related
to customers- dissatisfaction identified in our evaluation and to help
the bus companies operating in Campos better fulfill their riders-
needs.
Abstract: This research presented in this paper is an on-going
project of an application of neural network and fuzzy models to
evaluate the sociological factors which affect the educational
performance of the students in Sri Lanka. One of its major goals is to
prepare the grounds to device a counseling tool which helps these
students for a better performance at their examinations, especially at
their G.C.E O/L (General Certificate of Education-Ordinary Level)
examination. Closely related sociological factors are collected as raw
data and the noise of these data are filtered through the fuzzy
interface and the supervised neural network is being utilized to
recognize the performance patterns against the chosen social factors.
Abstract: A multicriteria linear programming problem with integer variables and parameterized optimality principle "from lexicographic to Slater" is considered. A situation in which initial coefficients of penalty cost functions are not fixed but may be potentially a subject to variations is studied. For any efficient solution, appropriate measures of the quality are introduced which incorporate information about variations of penalty cost function coefficients. These measures correspond to the so-called stability and accuracy functions defined earlier for efficient solutions of a generic multicriteria combinatorial optimization problem with Pareto and lexicographic optimality principles. Various properties of such functions are studied and maximum norms of perturbations for which an efficient solution preserves the property of being efficient are calculated.
Abstract: While compressing text files is useful, compressing
still image files is almost a necessity. A typical image takes up much
more storage than a typical text message and without compression
images would be extremely clumsy to store and distribute. The
amount of information required to store pictures on modern
computers is quite large in relation to the amount of bandwidth
commonly available to transmit them over the Internet and
applications. Image compression addresses the problem of reducing
the amount of data required to represent a digital image. Performance
of any image compression method can be evaluated by measuring the
root-mean-square-error & peak signal to noise ratio. The method of
image compression that will be analyzed in this paper is based on the
lossy JPEG image compression technique, the most popular
compression technique for color images. JPEG compression is able to
greatly reduce file size with minimal image degradation by throwing
away the least “important" information. In JPEG, both color
components are downsampled simultaneously, but in this paper we
will compare the results when the compression is done by
downsampling the single chroma part. In this paper we will
demonstrate more compression ratio is achieved when the
chrominance blue is downsampled as compared to downsampling the
chrominance red in JPEG compression. But the peak signal to noise
ratio is more when the chrominance red is downsampled as compared
to downsampling the chrominance blue in JPEG compression. In
particular we will use the hats.jpg as a demonstration of JPEG
compression using low pass filter and demonstrate that the image is
compressed with barely any visual differences with both methods.
Abstract: Demand of energy is increasing faster than the
generation. It leads shortage of power in all sectors of society. At
peak hours this shortage is higher. Unless we utilize energy efficient
technology, it is very difficult to minimize the shortage of energy. So
energy efficiency program and energy conservation has an important
role. Energy efficient technologies are cost intensive hence it is
always not possible to implement in country like India. In the recent
study, an educational building with operating hours from 10:00 a.m.
to 05:00 p.m. has been selected to quantify the possibility of lighting
energy conservation. As the operating hour is in daytime, integration
of daylight with artificial lighting system will definitely reduce the
lighting energy consumption. Moreover the initial investment has
been given priority and hence the existing lighting installation was
unaltered. An automatic controller has been designed which will be
operated as a function of daylight through windows and the lighting
system of the room will function accordingly. The result of the study
of integrating daylight gave quite satisfactory for visual comfort as
well as energy conservation.
Abstract: A spectrophotometric method was developed for simultaneous quantification of pseudoephedrine hydrochloride (PSE) triprolidine hydrochloride (TRI) using second derivative method (zero-crossing technique). The second derivative amplitudes of PSE and TRI were measured at 271 and 321 nm, respectively. The calibration curves were linear in the range of 200 to 1,000 g/ml for PSE and 10 to 50 g/ml for TRI. The method was validated for specificity, accuracy, precision, limit of detection and limit of quantitation. The proposed method was applied to the assaying and dissolution of PSE and TRI in commercial tablets without any chemical separation. The results were compared with those obtained by the official USP31 method and statistical tests showed that there is no significant between the methods at 95% confidence level. The proposed method is simple, rapid and suitable for the routine quality control application. KeywordsTriprolidine, Pseudoephedrine, Derivative spectrophotometry, Dissolution testing.
Abstract: The continuity in the electric supply of the electric installations is becoming one of the main requirements of the electric supply network (generation, transmission, and distribution of the electric energy). The achievement of this requirement depends from one side on the structure of the electric network and on the other side on the avaibility of the reserve source provided to maintain the supply in case of failure of the principal one. The avaibility of supply does not only depends on the reliability parameters of the both sources (principal and reserve) but it also depends on the reliability of the circuit breaker which plays the role of interlocking the reserve source in case of failure of the principal one. In addition, the principal source being under operation, its control can be ideal and sure, however, for the reserve source being in stop, a preventive maintenances which proceed on time intervals (periodicity) and for well defined lengths of time are envisaged, so that this source will always available in case of the principal source failure. The choice of the periodicity of preventive maintenance of the source of reserve influences directly the reliability of the electric feeder system In this work and on the basis of the semi- markovian's processes, the influence of the time of interlocking the reserve source upon the reliability of an industrial electric network is studied and is given the optimal time of interlocking the reserve source in case of failure the principal one, also the influence of the periodicity of the preventive maintenance of the source of reserve is studied and is given the optimal periodicity.
Abstract: The utilization of cheese whey as a fermentation
substrate to produce bio-ethanol is an effort to supply bio-ethanol
demand as a renewable energy. Like other process systems, modeling
is also required for fermentation process design, optimization and
plant operation. This research aims to study the fermentation process
of cheese whey by applying mathematics and fundamental concept in
chemical engineering, and to investigate the characteristic of the
cheese whey fermentation process. Steady state simulation results for
inlet substrate concentration of 50, 100 and 150 g/l, and various
values of hydraulic retention time, showed that the ethanol
productivity maximum values were 0.1091, 0.3163 and 0.5639 g/l.h
respectively. Those values were achieved at hydraulic retention time
of 20 hours, which was the minimum value used in this modeling.
This showed that operating reactor at low hydraulic retention time
was favorable. Model of bio-ethanol production from cheese whey
will enhance the understanding of what really happen in the
fermentation process.
Abstract: This paper proposes an effective algorithm approach to hybrid control systems combining fuzzy logic and conventional control techniques of controlling the speed of induction motor assumed to operate in high-performance drives environment. The introducing of fuzzy logic in the control systems helps to achieve good dynamical response, disturbance rejection and low sensibility to parameter variations and external influences. Some fundamentals of the fuzzy logic control are preliminary illustrated. The developed control algorithm is robust, efficient and simple. It also assures precise trajectory tracking with the prescribed dynamics. Experimental results have shown excellent tracking performance of the proposed control system, and have convincingly demonstrated the validity and the usefulness of the hybrid fuzzy controller in high-performance drives with parameter and load uncertainties. Satisfactory performance was observed for most reference tracks.
Abstract: Discrete choice model is the most used methodology for studying traveler-s mode choice and demand. However, to calibrate the discrete choice model needs to have plenty of questionnaire survey. In this study, an aggregative model is proposed. The historical data of passenger volumes for high speed rail and domestic civil aviation are employed to calibrate and validate the model. In this study, different models are compared so as to propose the best one. From the results, systematic equations forecast better than single equation do. Models with the external variable, which is oil price, are better than models based on closed system assumption.
Abstract: Glomerular filtration rate (GFR) is a measure of
kidney function. It is usually estimated from serum concentrations of
cystatin C or creatinine although there has been considerable debate
in the literature about (i) the best equation to use and (ii) the
variability in the correlation between the concentrations of creatinine
and cystatin C. The equations for GFR can be written in a general
form and from these I calculate the error of the GFR estimates
associated with analyte measurement error. These show that the
error of the GFR estimates is such that it is not possible to distinguish
between the equations over much of the concentration range of either
analyte. The general forms of the equations are also used to derive
an expression for the concentration of cystatin C as a function of the
concentration of creatinine. This equation shows that these analyte
concentrations are not linearly related. Clinical reports of cystatin C
and creatinine concentration are consistent with the expression
derived.
Abstract: In this paper delamination phenomenon in
Carbon-Epoxy laminated composite material is investigated
numerically. Arcan apparatus and specimen is modeled in ABAQUS
finite element software for different loading conditions and crack
geometries. The influence of variation of crack geometry on
interlaminar fracture stress intensity factor and energy release rate for
various mixed mode ratios and pure mode I and II was studied. Also,
correction factors for this specimen for different crack length ratios
were calculated. The finite element results indicate that for loading
angles close to pure mode-II loading, a high ratio of mode-II to
mode-I fracture is dominant and there is an opposite trend for loading
angles close to pure mode-I loading. It confirms that by varying the
loading angle of Arcan specimen pure mode-I, pure mode-II and a
wide range of mixed-mode loading conditions can be created and
tested. Also, numerical results confirm that the increase of the mode-
II loading contribution leads to an increase of fracture resistance in
the CF/PEI composite (i.e., a reduction in the total strain energy
release rate) and the increase of the crack length leads to a reduction
of interlaminar fracture resistance in the CF/PEI composite (i.e., an
increase in the total interlaminar strain energy release rate).