Abstract: Fuel cells have become one of the major areas of
research in the academia and the industry. The goal of most fish
farmers is to maximize production and profits while holding labor
and management efforts to the minimum. Risk of fish kills, disease
outbreaks, poor water quality in most pond culture operations,
aeration offers the most immediate and practical solution to water
quality problems encountered at higher stocking and feeding rates.
Many units of aeration system are electrical units so using a
continuous, high reliability, affordable, and environmentally friendly
power sources is necessary. Aeration of water by using PEM fuel cell
power is not only a new application of the renewable energy, but
also, it provides an affordable method to promote biodiversity in
stagnant ponds and lakes. This paper presents a new design and
control of PEM fuel cell powered a diffused air aeration system for a
shrimp farm in Mersa Matruh in Egypt. Also Artificial intelligence
(AI) techniques control is used to control the fuel cell output power
by control input gases flow rate. Moreover the mathematical
modeling and simulation of PEM fuel cell is introduced. A
comparison study is applied between the performance of fuzzy logic
control (FLC) and neural network control (NNC). The results show
the effectiveness of NNC over FLC.
Abstract: In this paper, an alternating implicit block method for
solving two dimensional scalar wave equation is presented. The
new method consist of two stages for each time step implemented
in alternating directions which are very simple in computation. To
increase the speed of computation, a group of adjacent points is
computed simultaneously. It is shown that the presented method
increase the maximum time step size and more accurate than the
conventional finite difference time domain (FDTD) method and other
existing method of natural ordering.
Abstract: Active power filter continues to be a powerful tool to control harmonics in power systems thereby enhancing the power quality. This paper presents a fuzzy tuned PID controller based shunt active filter to diminish the harmonics caused by non linear loads like thyristor bridge rectifiers and imbalanced loads. Here Fuzzy controller provides the tuning of PID, based on firing of thyristor bridge rectifiers and variations in input rms current. The shunt APF system is implemented with three phase current controlled Voltage Source Inverter (VSI) and is connected at the point of common coupling for compensating the current harmonics by injecting equal but opposite filter currents. These controllers are capable of controlling dc-side capacitor voltage and estimating reference currents. Hysteresis Current Controller (HCC) is used to generate switching signals for the voltage source inverter. Simulation studies are carried out with non linear loads like thyristor bridge rectifier along with unbalanced loads and the results proved that the APF along with fuzzy tuned PID controller work flawlessly for different firing angles of non linear load.
Abstract: The assessment of the efficacy of devised Mobile-
Assisted Instructional Modes in Mobile Learning was the focus of
this research. The study adopted pre-test, post-test, control group
quasi-experimental design. Research instruments were developed,
validated and used for collecting data. Findings revealed that the
students exposed to Mobile Task Based Learning Mode (MTBLM) in
using Mobile-Assisted Instruction (MAI) performed significantly
better. The implication of these findings is that, the Audio tutorial
and Practice Mode (ATPM) (Stimulus instruments) of MAI had been
found better over the other modes used in the study.
Abstract: This study describes the methodology for the development of a validated in-vitro in-vivo correlation (IVIVC) for metoprolol tartrate modified release dosage forms with distinctive release rate characteristics. Modified release dosage forms were formulated by microencapsulation of metoprolol tartrate into different amounts of ethylcellulose by non-solvent addition technique. Then in-vitro and in-vivo studies were conducted to develop and validate level A IVIVC for metoprolol tartrate. The values of regression co-efficient (R2-values) for IVIVC of T2 and T3 formulations were not significantly (p
Abstract: CO2 is the primary anthropogenic greenhouse gas,
accounting for 77% of the human contribution to the greenhouse
effect in 2004. In the recent years, global concentration of CO2 in the
atmosphere is increasing rapidly. CO2 emissions have an impact on
global climate change. Anthropogenic CO2 is emitted primarily from
fossil fuel combustion. Carbon capture and storage (CCS) is one
option for reducing CO2 emissions. There are three major approaches
for CCS: post-combustion capture, pre-combustion capture and
oxyfuel process. Post-combustion capture offers some advantages as
existing combustion technologies can still be used without radical
changes on them.
There are several post combustion gas separation and capture
technologies being investigated, namely; (a) absorption, (b)
cryogenic separation, (c) membrane separation (d) micro algal biofixation
and (e) adsorption. Apart from establishing new techniques,
the exploration of capture materials with high separation performance
and low capital cost are paramount importance. However, the
application of adsorption from either technology, require easily
regenerable and durable adsorbents with a high CO2 adsorption
capacity. It has recently been reported that the cost of the CO2
capture can be reduced by using this technology. In this paper, the
research progress (from experimental results) in adsorbents for CO2
adsorption, storage, and separations were reviewed and future
research directions were suggested as well.
Abstract: A measurement system was successfully fabricated to
detect ion concentrations (hydrogen and chlorine) in this study.
PIC18F4520, the microcontroller was used as the control unit in the
measurement system. The measurement system was practically used
to sense the H+ and Cl- in different examples, and the pH and pCl
values were exhibited on real-time LCD display promptly. In the study,
the measurement method is used to judge whether the response voltage
is stable. The change quantity is smaller than 0.01%, that the present
response voltage compares with next response voltage for H+
measurement, and the above condition is established only 6 sec.
Besides, the change quantity is smaller than 0.01%, that the present
response voltage compares with next response voltage for Clmeasurement,
and the above condition is established only 5 sec.
Furthermore, the average error quantities would also be considered,
and they are 0.05 and 0.07 for measurements of pH and pCl values,
respectively.
Abstract: There-s a lack in understanding the indoor climate of Malaysian residential. The assumption of traditional house could
provide the best indoor environment is too good to be true. This research is to understand indoor environment in three types of
Malaysian residential and thermo recorder TR72Ui were placed in
indoor spaces for measurement. There are huge differences of indoor
environment between housing types, and building material helps to control indoor climate. Traditional house indoor climate was similar to
the outdoor. Temperature in the bedroom of terrace and town houses were slightly higher than the living room. Indoor temperature was 2oC
lower in the rainy season than the hot season. It was hard to control
indoor humidity level in traditional house compared with terrace and
town house. As for conclusion, town house provides the best thermal
environment to the building occupants and can be improved with good
roof insulation.
Abstract: Duplicated region detection is a technical method to
expose copy-paste forgeries on digital images. Copy-paste is one
of the common types of forgeries to clone portion of an image
in order to conceal or duplicate special object. In this type of
forgery detection, extracting robust block feature and also high
time complexity of matching step are two main open problems.
This paper concentrates on computational time and proposes a local
block matching algorithm based on block clustering to enhance time
complexity. Time complexity of the proposed algorithm is formulated
and effects of two parameter, block size and number of cluster, on
efficiency of this algorithm are considered. The experimental results
and mathematical analysis demonstrate this algorithm is more costeffective
than lexicographically algorithms in time complexity issue
when the image is complex.
Abstract: Software engineering education not only embraces
technical skills of software development but also necessitates
communication and interaction among learners. In this paper, it is
proposed to adapt the PBL methodology that is especially designed to
be integrated into software engineering classroom in order to promote
collaborative learning environment. This approach helps students
better understand the significance of social aspects and provides a
systematic framework to enhance teamwork skills. The adaptation of
PBL facilitates the transition to an innovative software development
environment where cooperative learning can be actualized.
Abstract: This paper reports the feasibility of the ARMA model
to describe a bursty video source transmitting over a AAL5 ATM link
(VBR traffic). The traffic represents the activity of the action movie
"Lethal Weapon 3" transmitted over the ATM network using the Fore
System AVA-200 ATM video codec with a peak rate of 100 Mbps
and a frame rate of 25. The model parameters were estimated for a
single video source and independently multiplexed video sources. It
was found that the model ARMA (2, 4) is well-suited for the real data
in terms of average rate traffic profile, probability density function,
autocorrelation function, burstiness measure, and the pole-zero
distribution of the filter model.
Abstract: This paper presents the combination of different precipitation data sets and the distributed hydrological model, in order to examine the flood runoff reproductivity of scattered observation catchments. The precipitation data sets were obtained from observation using rain-gages, satellite based estimate (TRMM), and numerical weather prediction model (NWP), then were coupled with the super tank model. The case study was conducted in three basins (small, medium, and large size) located in Central Vietnam. Calculated hydrographs based on ground observation rainfall showed best fit to measured stream flow, while those obtained from TRMM and NWP showed high uncertainty of peak discharges. However, calculated hydrographs using the adjusted rainfield depicted a promising alternative for the application of TRMM and NWP in flood modeling for scattered observation catchments, especially for the extension of forecast lead time.
Abstract: This paper aims at improving web server performance
by establishing a middleware layer between web and database
servers, which minimizes the overload on the database server. A
middleware system has been developed as a service mainly to
improve the performance. This system manages connection accesses
in a way that would result in reducing the overload on the database
server. In addition to the connection management, this system acts as
an object-oriented model for best utilization of operating system
resources. A web developer can use this Service Broker to improve
web server performance.
Abstract: In this paper, we show that the stability can not be
achieved with current stabilizing MPC methods for some unstable
processes. Hence we present a new method for stabilizing these
processes. The main idea is to use a new time varying weighted cost
function for traditional GPC. This stabilizes the closed loop system
without adding soft or hard constraint in optimization problem. By
studying different examples it is shown that using the proposed
method, the closed-loop stability of unstable nonminimum phase
process is achieved.
Abstract: Suspended cable structures are most preferable for large spans covering due to rational use of structural materials, but the problem of suspended cable structures is initial shape change under the action of non-symmetrical load. The problem can be solved by increasing of relation of dead weight and imposed load, but this methods cause increasing of materials consumption.Prestressed cable truss usage is another way how the problem of shape change under the action of non-symmetrical load can be fixed. The better results can be achieved if we replace top chord with cable truss with cross web. Rational structure of the cable truss for prestressed cable truss top chord was developed using optimization realized in FEM program ANSYS 12 environment. Single cable and cable truss model work was discovered.Analytical and model testing results indicate, that usage of cable truss with the cross web as a top chord of prestressed cable truss instead of single cable allows to reduce total displacements by 13-16% in the case of non-symmetrical load. In case of uniformly distributed load single cable is preferable.
Abstract: Vehicular communications play a substantial role in providing safety in transportation by means of safety message exchange. Researchers have proposed several solutions for securing safety messages. Protocols based on a fixed key infrastructure are more efficient in implementation and maintain stronger security in comparison with dynamic structures. These protocols utilize zone partitioning to establish distinct key infrastructure under Certificate Authority (CA) supervision in different regions. Secure anonymous broadcasting (SAB) is one of these protocols that preserves most of security aspects but it has some deficiencies in practice. A very important issue is region change of a vehicle for its mobility. Changing regions leads to change of CA and necessity of having new key set to resume communication. In this paper, we propose solutions for informing vehicles about region change to obtain new key set before entering next region. This hinders attackers- intrusion, packet loss and lessons time delay. We also make key request messages secure by confirming old CA-s public key to the message, hence stronger security for safety message broadcasting is attained.
Abstract: This paper investigates the indices of a creative city in
Isfahan. Its main aim is to evaluate quantitative status of the creative
city indices in Isfahan city, analyze the dispersion and distribution of
these indices in Isfahan city. Concerning these, this study tries to
analyze the creative city indices in fifteen area of Isfahan through
secondary data, questionnaire, TOPSIS model, Shannon entropy and
SPSS. Based on this, the fifteen areas of Isfahan city have been
ranked with 12 factors of creative city indices. The results of studies
show that fifteen areas of Isfahan city are not equally benefiting from
creative indices and there is much difference between the areas of
Isfahan city.
Abstract: A square matrix over the complex field with non- negative integral trace is called a quasi-permutation matrix. For a finite group G the minimal degree of a faithful representation of G by quasi-permutation matrices over the rationals and the complex numbers are denoted by q(G) and c(G) respectively. Finally r (G) denotes the minimal degree of a faithful rational valued complex character of C. The purpose of this paper is to calculate q(G), c(G) and r(G) for the group S L(2, q) when extended by a certain group of order two.
Abstract: This study was to search for the desirable direction of
the sidewalk planning in Korea by establishing the concepts of
walking and pedestrian space, and analyzing the advanced precedents
in and out of country. Also, based on the precedent studies and
relevant laws, regulations, and systems, it aimed for the following
sequential process: firstly, to derive design elements from the
functions and characteristics of sidewalk and cluster the similar
elements by each characteristics, sampling representative
characteristics and making them hierarchical; then, to analyze their
significances via the first questionnaire survey, and the relative
weights and priorities of each elements via the Analytic Hierarchy
Process(AHP); finally, based on the analysis result, to establish the
frame of suggesting the direction of policy to improve the pedestrian
environment of sidewalk in urban commercial district for the future
planning and design of pedestrian space.
Abstract: detecting the deadlock is one of the important
problems in distributed systems and different solutions have been
proposed for it. Among the many deadlock detection algorithms,
Edge-chasing has been the most widely used. In Edge-chasing
algorithm, a special message called probe is made and sent along
dependency edges. When the initiator of a probe receives the probe
back the existence of a deadlock is revealed. But these algorithms are
not problem-free. One of the problems associated with them is that
they cannot detect some deadlocks and they even identify false
deadlocks. A key point not mentioned in the literature is that when
the process is waiting to obtain the required resources and its
execution has been blocked, how it can actually respond to probe
messages in the system. Also the question of 'which process should
be victimized in order to achieve a better performance when multiple
cycles exist within one single process in the system' has received
little attention. In this paper, one of the basic concepts of the
operating system - daemon - will be used to solve the problems
mentioned. The proposed Algorithm becomes engaged in sending
probe messages to the mandatory daemons and collects enough
information to effectively identify and resolve multi-cycle deadlocks
in distributed systems.