Abstract: A comprehensive discussion of feasible strategies for sustainable energy supply is urgently needed to achieve a turnaround of the current energy situation. The necessary fundamentals required for the development of a long term energy vision are lacking to a great extent due to the absence of reasonable long term scenarios that fulfill the requirements of climate protection and sustainable energy use. The contribution of the study is based on a search for sustainable energy paths in the long run for Austria. The analysis makes use of secondary data predominantly. The measures developed to avoid CO2 emissions and other ecological risk factors vary to a great extent among all economic sectors. This is shown by the calculation of CO2 cost of abatement curves. In this study it is demonstrated that the most effective technical measures with the lowest CO2 abatement costs yield solutions to the current energy problems. Various scenarios are presented concerning the question how the technological and environmental options for a sustainable energy system for Austria could look like in the long run. It is shown how sustainable energy can be supplied even with today-s technological knowledge and options available. The scenarios developed include an evaluation of the economic costs and ecological impacts. The results are not only applicable to Austria but demonstrate feasible and cost efficient ways towards a sustainable future.
Abstract: Transpedicular screw fixation in spinal fractures,
degenerative changes, or deformities is a well-established procedure.
However, important rate of fixation failure due to screw bending,
loosening, or pullout are still reported particularly in weak bone stock
in osteoporosis. To overcome the problem, mechanism of failure has
to be fully investigated in vitro. Post-mortem human subjects are less
accessible and animal cadavers comprise limitations due to different
geometry and mechanical properties. Therefore, the development of a
synthetic model mimicking the realistic human vertebra is highly
demanded. A bone surrogate, composed of Polyurethane (PU) foam
analogous to cancellous bone porous structure, was tested for 3
different densities in this study. The mechanical properties were
investigated under uniaxial compression test by minimizing the end
artifacts on specimens. The results indicated that PU foam of 0.32
g.cm-3 density has comparable mechanical properties to human
cancellous bone in terms of young-s modulus and yield strength.
Therefore, the obtained information can be considered as primary
step for developing a realistic cancellous bone of human vertebral
body. Further evaluations are also recommended for other density
groups.
Abstract: Sediment loads transfer in hydraulic installations and their consequences for the O&M of modern canal systems is emerging as one of the most important considerations in hydraulic engineering projects apriticularly those which are inteded to feed the irrigation and draiange schemes of large command areas such as the Dez and Mogahn in Iran.. The aim of this paper is to investigate the applicability of the vortex tube as a viable means of extracting sediment loads entering the canal systems in general and the water inatke structures in particulars. The Western conveyance canal of the Dez Diversion weir which feeds the Karkheh Flood Plain in Sothwestern Dezful has been used as the case study using the data from the Dastmashan Hydrometric Station. The SHARC software has been used as an analytical framework to interprete the data. Results show that given the grain size D50 and the canal turbulence the adaption length from the beginning of the canal and after the diversion dam is estimated at 477 m, a point which is suitable for laying the vortex tube.
Abstract: To comply with the international human right
legislation concerning the freedom of movement, transport systems
are required to be made accessible in order that all citizens, regardless
of their physical condition, have equal possibilities to use them. In
Hungary, apparently there is a considerable default in the
improvement of accessible public transport. This study is aiming to
overview the current Hungarian situation and to reveal the reasons of
the deficiency. The result shows that in spite of the relatively
favourable juridical background linked to the accessibility needs and
to the rights of persons with disabilities there is a strong delay in
putting all in practice in the field of public transport. Its main reason
is the lack of financial resource and referring to this the lack of
creating mandatory regulations. In addition to this the proprietary
rights related to public transport are also variable, which also limits
the improvement possibilities. Consequently, first of all an accurate
and detailed regulatory procedure is expected to change the present
unfavourable situation and to create the conditions of the fast
realization, which is already behind time.
Abstract: Optical flow is a research topic of interest for many
years. It has, until recently, been largely inapplicable to real-time
applications due to its computationally expensive nature. This paper
presents a new reliable flow technique which is combined with a
motion detection algorithm, from stationary camera image streams,
to allow flow-based analyses of moving entities, such as rigidity, in
real-time. The combination of the optical flow analysis with motion
detection technique greatly reduces the expensive computation of
flow vectors as compared with standard approaches, rendering the
method to be applicable in real-time implementation. This paper
describes also the hardware implementation of a proposed pipelined
system to estimate the flow vectors from image sequences in real
time. This design can process 768 x 576 images at a very high frame
rate that reaches to 156 fps in a single low cost FPGA chip, which is
adequate for most real-time vision applications.
Abstract: In this paper, we propose an adaptation of the Patricia-Tree for sparse datasets to generate non redundant rule associations. Using this adaptation, we can generate frequent closed itemsets that are more compact than frequent itemsets used in Apriori approach. This adaptation has been experimented on a set of datasets benchmarks.
Abstract: In this paper a new approach to face recognition is presented that achieves double dimension reduction making the system computationally efficient with better recognition results. In pattern recognition techniques, discriminative information of image increases with increase in resolution to a certain extent, consequently face recognition results improve with increase in face image resolution and levels off when arriving at a certain resolution level. In the proposed model of face recognition, first image decimation algorithm is applied on face image for dimension reduction to a certain resolution level which provides best recognition results. Due to better computational speed and feature extraction potential of Discrete Cosine Transform (DCT) it is applied on face image. A subset of coefficients of DCT from low to mid frequencies that represent the face adequately and provides best recognition results is retained. A trade of between decimation factor, number of DCT coefficients retained and recognition rate with minimum computation is obtained. Preprocessing of the image is carried out to increase its robustness against variations in poses and illumination level. This new model has been tested on different databases which include ORL database, Yale database and a color database. The proposed technique has performed much better compared to other techniques. The significance of the model is two fold: (1) dimension reduction up to an effective and suitable face image resolution (2) appropriate DCT coefficients are retained to achieve best recognition results with varying image poses, intensity and illumination level.
Abstract: Previous research has demonstrated that negative
attitudes towards people with physical disabilities and obesity are
predicted by a component of perceived vulnerability to disease; germ
aversion. These findings have been suggested as illustrations of an
evolved but over-active mechanism which promotes the avoidance of
pathogen-carrying individuals. To date, this interpretation of attitude
formation has not been explored with regard to people with
intellectual disability, and no attempts have been made to examine
possible mediating factors. This study examined attitudes in 333
adults and demonstrated that the moderate positive relationship
between germ aversion and negative attitudes toward people with
intellectual disability is fully mediated by social dominance
orientation, a general preference for hierarchies and inequalities
among social groups. These findings have implications for the
design of programs which attempt to promote community acceptance
and inclusion of people with disabilities.
Abstract: Bond graph models of an electrical transformer including
the nonlinear saturation are presented. The transformer
using electrical and magnetic circuits are modelled. These models
determine the relation between self and mutual inductances, and
the leakage and magnetizing inductances of power transformers
with two windings using the properties of a bond graph. The
equivalence between electrical and magnetic variables is given.
The modelling and analysis using this methodology to three phase
power transformers can be extended.
Abstract: To achieve accurate and precise results of finite
element analysis (FEA) of bones, it is important to represent the
load/boundary conditions as identical as possible to the human body
such as the bone properties, the type and force of the muscles, the
contact force of the joints, and the location of the muscle attachment.
In this study, the difference in the Von-Mises stress and the total
deformation was compared by classifying them into Case 1, which
shows the actual anatomical form of the muscle attached to the femur
when the same muscle force was applied, and Case 2, which gives a
simplified representation of the attached location. An inverse
dynamical musculoskeletal model was simulated using data from an
actual walking experiment to complement the accuracy of the
muscular force, the input value of FEA. The FEA method using the
results of the muscular force that were calculated through the
simulation showed that the maximum Von-Mises stress and the
maximum total deformation in Case 2 were underestimated by 8.42%
and 6.29%, respectively, compared to Case 1. The torsion energy and
bending moment at each location of the femur occurred via the stress
ingredient. Due to the geometrical/morphological feature of the femur
of having a long bone shape when the stress distribution is wide, as
shown in Case 1, a greater Von-Mises stress and total deformation are
expected from the sum of the stress ingredients. More accurate results
can be achieved only when the muscular strength and the attachment
location in the FEA of the bones and the attachment form are the same
as those in the actual anatomical condition under the various moving
conditions of the human body.
Abstract: The purpose of this study is to explore the impacts of
computer games on the mathematics instruction. First, the research
designed and implemented the web-based games according to the
content of existing textbook. And the researcher collected and
analyzed the information related to the mathematics instruction
integrating the computer games. In this study, the researcher focused
on the learning motivation of mathematics, mathematics achievement,
and pupil-teacher interactions in classroom. The results showed that
students under instruction integrating computer games significantly
improved in motivation and achievement. The teacher tended to use
less direct teaching and provide more time for student-s active
learning.
Abstract: The tracing methods determine the contribution the
power system sources have in their supplying. The methods can be used
to assess the transmission prices, but also to recover the transmission
fixed cost. In this paper is presented the influence of the modification of
commons structure has on the specific price of transfer. The operator
must make use of a few basic principles about allocation. Most
tracing methods are based on the proportional sharing principle. In this
paper Kirschen method is used. In order to illustrate this method, the 25-
bus test system is used, elaborated within the Electrical Power
Engineering Department, from Timisoara, Romania.
Abstract: The human friendly interaction is the key function of a human-centered system. Over the years, it has received much attention to develop the convenient interaction through intention recognition. Intention recognition processes multimodal inputs including speech, face images, and body gestures. In this paper, we suggest a novel approach of intention recognition using a graph representation called Intention Graph. A concept of valid intention is proposed, as a target of intention recognition. Our approach has two phases: goal recognition phase and intention recognition phase. In the goal recognition phase, we generate an action graph based on the observed actions, and then the candidate goals and their plans are recognized. In the intention recognition phase, the intention is recognized with relevant goals and user profile. We show that the algorithm has polynomial time complexity. The intention graph is applied to a simple briefcase domain to test our model.
Abstract: The paper presents an analytical solution for dispersion
of a solute in the peristaltic motion of a couple stress fluid
through a porous medium with slip condition in the presence of both
homogeneous and heterogeneous chemical reactions. The average
effective dispersion coefficient has been found using Taylor-s limiting
condition and long wavelength approximation. The effects of various
relevant parameters on the average coefficient of dispersion have been
studied. The average effective dispersion coefficient tends to increase
with permeability parameter but tends to decrease with homogeneous
chemical reaction rate parameter, couple stress parameter, slip parameter
and heterogeneous reaction rate parameter.
Abstract: This work offers a study of new simple compact model
of dual-drain Magnetic Field Effect Transistor (MAGFET) including
geometrical effects and biasing dependency. An explanation of the
sensitivity is investigated, involving carrier deflection as the dominant
operating principle. Finally, model verification with simulation results
is introduced to ensure that acceptable error of 2% is achieved.
Abstract: Planar systems of electrodes arranged on both sides of dielectric piezoelectric layer are applied in numerous transducers. They are capable of electronic beam-steering of generated wave both in azimuth and elevation. The wave-beam control is achieved by addressable driving of two-dimensional transducer through proper voltage supply of electrodes on opposite surfaces of the layer. In this paper a semi-analytical method of analysis of the considered transducer is proposed, which is a generalization of the well-known BIS-expansion method. It was earlier exploited with great success in the theory of interdigital transducers of surface acoustic waves, theory of elastic wave scattering by cracks and certain advanced electrostatic problems. The corresponding nontrivial electrostatic problem is formulated and solved numerically.
Abstract: This paper describes a segmentation algorithm based
on the cooperation of an optical flow estimation method with edge
detection and region growing procedures.
The proposed method has been developed as a pre-processing
stage to be used in methodologies and tools for video/image indexing
and retrieval by content. The addressed problem consists in
extracting whole objects from background for producing images of
single complete objects from videos or photos. The extracted images
are used for calculating the object visual features necessary for both
indexing and retrieval processes.
The first task of the algorithm exploits the cues from motion
analysis for moving area detection. Objects and background are then
refined using respectively edge detection and region growing
procedures. These tasks are iteratively performed until objects and
background are completely resolved.
The developed method has been applied to a variety of indoor and
outdoor scenes where objects of different type and shape are
represented on variously textured background.
Abstract: In this era of competitiveness, there is a growing need for supply chains also to become competitive enough to handle pressures like varying customer’s expectations, low cost high quality products to be delivered at the minimum time and the most important is throat cutting competition at world wide scale. In the recent years, supply chain competitiveness has been, therefore, accepted as one of the most important philosophies in the supply chain literature. Various researchers and practitioners have tried to identify and implement strategies in supply chains which can bring competitiveness in the supply chains i.e. supply chain competitiveness. The purpose of this paper is to suggest select strategies for supply chain competitiveness in the Indian manufacturing sector using an integrated approach of literature review and exploratory interviews with eminent professionals from the supply chain area in various industries, academia and research. The aim of the paper is to highlight the important area of competitiveness in the supply chain and to suggest recommendations to the industry and managers of manufacturing sector.
Abstract: Wireless sensor networks (WSNs) have gained
tremendous attention in recent years due to their numerous
applications. Due to the limited energy resource, energy efficient
operation of sensor nodes is a key issue in wireless sensor networks.
Cooperative caching which ensures sharing of data among various
nodes reduces the number of communications over the wireless
channels and thus enhances the overall lifetime of a wireless sensor
network. In this paper, we propose a cooperative caching scheme
called ZCS (Zone Cooperation at Sensors) for wireless sensor
networks. In ZCS scheme, one-hop neighbors of a sensor node form a
cooperative cache zone and share the cached data with each other.
Simulation experiments show that the ZCS caching scheme achieves
significant improvements in byte hit ratio and average query latency
in comparison with other caching strategies.
Abstract: A study of the obtainable watermark data rate for information hiding algorithms is presented in this paper. As the perceptual entropy for wideband monophonic audio signals is in the range of four to five bits per sample, a significant amount of additional information can be inserted into signal without causing any perceptual distortion. Experimental results showed that transform domain watermark embedding outperforms considerably watermark embedding in time domain and that signal decompositions with a high gain of transform coding, like the wavelet transform, are the most suitable for high data rate information hiding. Keywords?Digital watermarking, information hiding, audio watermarking, watermark data rate.