Abstract: In view of geological origin, formation of the shallow
gas reservoir of the Hangzhou Bay, northern Zhejiang Province,
eastern China, and original occurrence characteristics of the gassy
sand are analyzed. Generally, gassy sand in scale gas reservoirs is in
the state of residual moisture content and the approximate scope of
initial matric suction of sand ranges about from 0kPa to100kPa.
Results based on GDS triaxial tests show that the classical shear
strength formulas of unsaturated soil can not effectively describe basic
strength characteristics of gassy sand; the relationship between
apparent cohesion and matric suction of gassy sand agrees well with
the power function, which can reasonably be used to describe the
strength of gassy sand. In the stress path of gas release, shear strength
of gassy sand will increase and experimental results show the formula
proposed in this paper can effectively predict the strength increment.
When saturated strength indexes of the sand are used in engineering
design, moderate reduction should be considered.
Abstract: For several high speed networks, providing resilience against failures is an essential requirement. The main feature for designing next generation optical networks is protecting and restoring high capacity WDM networks from the failures. Quick detection, identification and restoration make networks more strong and consistent even though the failures cannot be avoided. Hence, it is necessary to develop fast, efficient and dependable fault localization or detection mechanisms. In this paper we propose a new fault localization algorithm for WDM networks which can identify the location of a failure on a failed lightpath. Our algorithm detects the failed connection and then attempts to reroute data stream through an alternate path. In addition to this, we develop an algorithm to analyze the information of the alarms generated by the components of an optical network, in the presence of a fault. It uses the alarm correlation in order to reduce the list of suspected components shown to the network operators. By our simulation results, we show that our proposed algorithms achieve less blocking probability and delay while getting higher throughput.
Abstract: Today, advantage of biotechnology especially in environmental issues compared to other technologies is irrefragable. Kimia Gharb Gostar Industries Company, as a largest producer of citric acid in Middle East, applies biotechnology for this goal. Citrogypsum is a by–product of citric acid production and it considered as a valid residuum of this company. At this paper summary of acid citric production and condition of Citrogypsum production in company were introduced in addition to defmition of Citrogypsum production and its applications in world. According to these information and evaluation of present conditions about Iran needing to Citrogypsum, the best priority was introduced and emphasized on strategy selection and proper programming for self-sufficiency. The Delphi technique was used to elicit expert opinions about criteria for evaluating the usages. The criteria identified by the experts were profitability, capacity of production, the degree of investment, marketable, production ease and time production. The Analytical Hierarchy Process (ARP) and Expert Choice software were used to compare the alternatives on the criteria derived from the Delphi process.
Abstract: Solving Ordinary Differential Equations (ODEs) by
using Partitioning Block Intervalwise (PBI) technique is our aim in
this paper. The PBI technique is based on Block Adams Method and
Backward Differentiation Formula (BDF). Block Adams Method
only use the simple iteration for solving while BDF requires Newtonlike
iteration involving Jacobian matrix of ODEs which consumes a
considerable amount of computational effort. Therefore, PBI is
developed in order to reduce the cost of iteration within acceptable
maximum error
Abstract: With the rapid growth and development of information and communication technology, the Internet has played a definite and irreplaceable role in people-s social lives in Taiwan like in other countries. In July 2008, on a general social website, an unexpected phenomenon was noticed – that there were more than one hundred users who started forming clubs voluntarily and having face-to-face gatherings for specific purposes. In this study, it-s argued whether or not teenagers- social contact on the Internet is involved in their life context, and tried to reveal the teenagers- social preferences, values, and needs, which merge with and influence teenagers- social activities. Therefore, the study conducts multiple user experience research methods, which include practical observations and qualitative analysis by contextual inquiries and in-depth interviews. Based on the findings, several design implications for software related to social interactions and cultural inheritance are offered. It is concluded that the inherent values of a social behaviors might be a key issue in developing computer-mediated communication or interaction designs in the future.
Abstract: Various formal and informal brand alliances are being formed in professional service firms. Professional service corporate brand is heavily dependent on brands of professional employees who comprise them, and professional employee brands are in turn dependent on the corporate brand. Prior work provides limited scientific evidence of brand alliance effects in professional service area – i.e., how professional service corporate-employee brand allies are affected by an alliance, what are brand attitude effects after alliance formation and how these effects vary with different strengths of an ally. Scientific literature analysis and theoretical modeling are the main methods of the current study. As a result, a theoretical model is constructed for estimating spillover effects of professional service corporate-employee brand alliances and for comparison among different professional service firm expertise practice models – from “brains" to “procedure" model. The resulting theoretical model lays basis for future experimental studies.
Abstract: To model the human visual system (HVS) in the region of interest, we propose a new objective metric evaluation adapted to wavelet foveation-based image compression quality measurement, which exploits a foveation setup filter implementation technique in the DWT domain, based especially on the point and region of fixation of the human eye. This model is then used to predict the visible divergences between an original and compressed image with respect to this region field and yields an adapted and local measure error by removing all peripheral errors. The technique, which we call foveation wavelet visible difference prediction (FWVDP), is demonstrated on a number of noisy images all of which have the same local peak signal to noise ratio (PSNR), but visibly different errors. We show that the FWVDP reliably predicts the fixation areas of interest where error is masked, due to high image contrast, and the areas where the error is visible, due to low image contrast. The paper also suggests ways in which the FWVDP can be used to determine a visually optimal quantization strategy for foveation-based wavelet coefficients and to produce a quantitative local measure of image quality.
Abstract: Automated storage and retrieval systems (AS/RS)
become frequently used systems in warehouses. There has been a
transition from human based forklift applications to fast and safe
AS/RS applications in firm-s warehouse systems. In this study, basic
components and automation systems of the AS/RS are examined.
Proposed system's automation components and their tasks in the
system control algorithm were stated. According to this control
algorithm the control system structure was obtained.
Abstract: Pipeline infrastructures normally represent high cost of investment and the pipeline must be free from risks that could cause environmental hazard and potential threats to personnel safety. Pipeline integrity such monitoring and management become very crucial to provide unimpeded transportation and avoiding unnecessary production deferment. Thus proper cleaning and inspection is the key to safe and reliable pipeline operation and plays an important role in pipeline integrity management program and has become a standard industry procedure. In view of this, understanding the motion (dynamic behavior), prediction and control of the PIG speed is important in executing pigging operation as it offers significant benefits, such as estimating PIG arrival time at receiving station, planning for suitable pigging operation, and improves efficiency of pigging tasks. The objective of this paper is to review recent developments in speed control system of pipeline PIGs. The review carried out would serve as an industrial application in a form of quick reference of recent developments in pipeline PIG speed control system, and further initiate others to add-in/update the list in the future leading to knowledge based data, and would attract active interest of others to share their view points.
Abstract: In this paper, we introduce the notion θ-Euclidean k-fuzzy ideal in semirings and to study the properties of the image and pre image of a θ -Euclidean k-fuzzy ideal in a semirings under epimorphism.
Abstract: Porcelain specimens were fired at 6C/min to 1250C (dwell time 0.5-3h) and cooled at 6C/min to room temperature. Additionally, three different slower firing/cooling cycles were tried. Sintering profile and effects on MOR, crystalline phase content and morphology were investigated using dilatometry, 4-point bending strength, XRD and FEG-SEM respectively. Industrial-sized specimens prepared using the promising cycle were tested basing on the ANSI standards. Increasing dwell time from 1h to 3h at peak temperature of 1250C resulted in neither a significant effect on the quartz and mullite content nor MOR. Reducing the firing/cooling rate to below 6C/min, for peak temperature of 1250C (dwell time of 1h) does not result in improvement of strength of porcelain. The industrial sized specimen exhibited flashover voltages of 20.3kV (dry) and 9.3kV (wet) respectively, transverse strength of 12.5kN and bulk density of 2.27g/cm3, which are satisfactory. There was however dye penetration during porosity test. KeywordsDwell time, Microstructure, Porcelain, Strength.
Abstract: Measuring the complexity of software has been an
insoluble problem in software engineering. Complexity measures can
be used to predict critical information about testability, reliability,
and maintainability of software systems from automatic analysis of
the source code. During the past few years, many complexity
measures have been invented based on the emerging Cognitive
Informatics discipline. These software complexity measures,
including cognitive functional size, lend themselves to the approach
of the total cognitive weights of basic control structures such as loops
and branches. This paper shows that the current existing calculation
method can generate different results that are algebraically
equivalence. However, analysis of the combinatorial meanings of this
calculation method shows significant flaw of the measure, which also
explains why it does not satisfy Weyuker's properties. Based on the
findings, improvement directions, such as measures fusion, and
cumulative variable counting scheme are suggested to enhance the
effectiveness of cognitive complexity measures.
Abstract: Within the realm of e-government, the development has moved towards testing new means for democratic decisionmaking, like e-panels, electronic discussion forums, and polls. Although such new developments seem promising, they are not problem-free, and the outcomes are seldom used in the subsequent formal political procedures. Nevertheless, process models offer promising potential when it comes to structuring and supporting transparency of decision processes in order to facilitate the integration of the public into decision-making procedures in a reasonable and manageable way. Based on real-life cases of urban planning processes in Sweden, we present an outline for an integrated framework for public decision making to: a) provide tools for citizens to organize discussion and create opinions; b) enable governments, authorities, and institutions to better analyse these opinions; and c) enable governments to account for this information in planning and societal decision making by employing a process model for structured public decision making.
Abstract: Several combinations of the preprocessing algorithms,
feature selection techniques and classifiers can be applied to the data
classification tasks. This study introduces a new accurate classifier,
the proposed classifier consist from four components: Signal-to-
Noise as a feature selection technique, support vector machine,
Bayesian neural network and AdaBoost as an ensemble algorithm.
To verify the effectiveness of the proposed classifier, seven well
known classifiers are applied to four datasets. The experiments show
that using the suggested classifier enhances the classification rates for
all datasets.
Abstract: Glutathione S-transferase was purified from human
erythrocytes and effects of some polyphenols were investigated on
the enzyme activity. The purification procedure was performed on
Glutathione-Agarose affinity chromatography after preparation of
erythrocytes hemolysate with a yield of 81%. The purified enzyme
showed a single band on the SDS-PAGE. The effects of some
poliphenolic compounds such as catechin, dopa, dopamine, progallol
and catechol were examined on the in vitro GST activity. Catechin
was determined to be inhibitor for the enzyme, but others were not
effective on the enzyme as inhibitors or activators. IC50 value -the
concentration of inhibitor which reduces enzyme activity by 50%-
was estimated to be 10 mM. Ki constants were also calculated as 6.38
± 0,70 mM with GSH substrate, and 3.86 ± 0,78 mM with CDNB
substrate using the equations of graphs for the inhibitor, and its
inhibition type was determined as non-competitive.
Abstract: We fabricated the inverted-staggered etch stopper
structure oxide-based TFT and investigated the characteristics of oxide
TFT under the 400 nm wavelength light illumination. When 400 nm
light was illuminated, the threshold voltage (Vth) decreased and
subthreshold slope (SS) increased at forward sweep, while Vth and SS
were not altered when larger wavelength lights, such as 650 nm, 550
nm and 450 nm, were illuminated. At reverse sweep, the transfer curve
barely changed even under 400 nm light. Our experimental results
support that photo-induced hole carriers are captured by donor-like
interface trap and it caused the decrease of Vth and increase of SS. We
investigated the interface trap density increases proportionally to the
photo-induced hole concentration at active layer.
Abstract: Changing in consumers lifestyles and food
consumption patterns provide a great opportunity in developing the
functional food sector in Malaysia. There is only a little knowledge
about whether Malaysian consumers are aware of functional food and
if so what image consumers have of this product. The objective of
this research is to determine the extent to which selected socioeconomic
characteristics and attitudes influence consumers-
awareness of functional food. A survey was conducted in the Klang
Valley, Malaysia where 439 respondents were interviewed using a
structured questionnaire. The result shows that most respondents
have a positive attitude towards functional food. For the binary
logistic estimation, the results indicate that age, income and other
factors such as concern about food safety, subscribing to cooking or
health magazines, being a vegetarian and consumers who have been
involved in a food production company significantly influence
Malaysian consumers- awareness towards functional food.
Abstract: The classification of the protein structure is commonly
not performed for the whole protein but for structural domains, i.e.,
compact functional units preserved during evolution. Hence, a first
step to a protein structure classification is the separation of the
protein into its domains. We approach the problem of protein domain
identification by proposing a novel graph theoretical algorithm. We
represent the protein structure as an undirected, unweighted and
unlabeled graph which nodes correspond the secondary structure
elements of the protein. This graph is call the protein graph. The
domains are then identified as partitions of the graph corresponding
to vertices sets obtained by the maximization of an objective function,
which mutually maximizes the cycle distributions found in the
partitions of the graph. Our algorithm does not utilize any other kind
of information besides the cycle-distribution to find the partitions. If
a partition is found, the algorithm is iteratively applied to each of
the resulting subgraphs. As stop criterion, we calculate numerically
a significance level which indicates the stability of the predicted
partition against a random rewiring of the protein graph. Hence,
our algorithm terminates automatically its iterative application. We
present results for one and two domain proteins and compare our
results with the manually assigned domains by the SCOP database
and differences are discussed.
Abstract: This paper investigates the occurrence of regenerative
chatter vibrations in facing and turning processes. Orthogonal turning
(facing) and normal turning experiments are carried out under stable
as well as in the presence of controlled chatter vibrations. The effects
of chatter vibrations on various sensor signals are captured and
analyzed using frequency domain methods, which successfully
detected the chatter vibrations close to the dominant mode of the
machine tool system.
Abstract: Volume rendering is widely used in medical CT image
visualization. Applying 3D image visualization to diagnosis
application can require accurate volume rendering with high
resolution. Interpolation is important in medical image processing
applications such as image compression or volume resampling.
However, it can distort the original image data because of edge
blurring or blocking effects when image enhancement procedures
were applied. In this paper, we proposed adaptive tension control
method exploiting gradient information to achieve high resolution
medical image enhancement in volume visualization, where restored
images are similar to original images as much as possible. The
experimental results show that the proposed method can improve
image quality associated with the adaptive tension control efficacy.