Abstract: In this study acoustic emission (AE) signals obtained during deformation and fracture of two types of ferrite-martensite dual phase steels (DPS) specimens have been analyzed in frequency domain. For this reason two low carbon steels with various amounts of carbon were chosen, and intercritically heat treated. In the introduced method, identifying the mechanisms of failure in the various phases of DPS is done. For this aim, AE monitoring has been used during tensile test of several DPS with various volume fraction of the martensite (VM) and attempted to relate the AE signals and failure mechanisms in these steels. Different signals, which referred to 2-3 micro-mechanisms of failure due to amount of carbon and also VM have been seen. By Fast Fourier Transformation (FFT) of signals in distinct locations, an excellent relationship between peak frequencies in these areas and micro-mechanisms of failure were seen. The results were verified by microscopic observations (SEM).
Abstract: A novel three-phase active power filter (APF) circuit with photovoltaic (PV) system to improve the quality of service and to reduce the capacity of energy storage capacitor is presented. The energy balance concept and sampling technique were used to simplify the calculation algorithm for the required utility source current and to control the voltage of the energy storage capacitor. The feasibility was verified by using the Pspice simulations and experiments. When the APF mode was used during non-operational period, not only the utilization rate, power factor and power quality could be improved, but also the capacity of energy storage capacitor could sparing. As the results, the advantages of the APF circuit are simplicity of control circuits, low cost, and good transient response.
Abstract: Virtual engineering technology has undergone rapid progress in recent years and is being adopted increasingly by manufacturing companies of many engineering disciplines. There is an increasing demand from industry for qualified virtual engineers. The qualified virtual engineers should have the ability of applying engineering principles and mechanical design methods within the commercial software package environment. It is a challenge to the engineering education in universities which traditionally tends to lack the integration of knowledge and skills required for solving real world problems. In this paper, a case study shows some recent development of a MSc Mechanical Engineering course at Department of Engineering and Technology in MMU, and in particular, two units Simulation of Mechanical Systems(SMS) and Computer Aided Fatigue Analysis(CAFA) that emphasize virtual engineering education and promote integration of knowledge acquisition, skill training and industrial application.
Abstract: In this paper, we propose a selective mutation method
for improving the performances of genetic algorithms. In selective
mutation, individuals are first ranked and then additionally mutated
one bit in a part of their strings which is selected corresponding to
their ranks. This selective mutation helps genetic algorithms to fast
approach the global optimum and to quickly escape local optima.
This results in increasing the performances of genetic algorithms.
We measured the effects of selective mutation with four function
optimization problems. It was found from extensive experiments that
the selective mutation can significantly enhance the performances of
genetic algorithms.
Abstract: In this paper we study different similarity based approaches for the development of QSAR model devoted to the prediction of activity of antiobesity drugs. Classical similarity approaches are compared regarding to dissimilarity models based on the consideration of the calculation of Euclidean distances between the nonisomorphic fragments extracted in the matching process. Combining the classical similarity and dissimilarity approaches into a new similarity measure, the Approximate Similarity was also studied, and better results were obtained. The application of the proposed method to the development of quantitative structure-activity relationships (QSAR) has provided reliable tools for predicting of inhibitory activity of drugs. Acceptable results were obtained for the models presented here.
Abstract: Thanks to VR technology advanced, there are many
researches had used VR technology to develop a training system.
Using VR characteristics can simulate many kinds of situations to
reach our training-s goal. However, a good training system not only
considers real simulation but also considers learner-s learning
motivation. So, there are many researches started to conduct game-s
features into VR training system. We typically called this is a serious
game. It is using game-s features to engage learner-s learning
motivation. However, VR or Serious game has another important
advantage. That is simulating feature. Using this feature can create
any kinds of pressured environments. Because in the real
environment may happen any emergent situations. So, increasing the
trainees- pressure is more important when they are training. Most
pervious researches are investigated serious game-s applications and
learning performance. Seldom researches investigated how to
increase the learner-s mental workload when they are training. So, in
our study, we will introduce a real case study and create two types
training environments. Comparing the learner-s mental workload
between VR training and serious game.
Abstract: In this paper, a Web-based e-Training platform that is dedicated to multimodal breast imaging is presented. The assets of this platform are summarised in (i) the efficient representation of the curriculum flow that will permit efficient training; (ii) efficient tagging of multimodal content appropriate for the completion of realistic cases and (iii) ubiquitous accessibility and platform independence via a web-based approach.
Abstract: The influence of physical (external added weight) and
neurophysiological (fatigue) factors on static and dynamic balance in
sport related activities was typified statically by the Romberg test
(one foot flat, eyes open) and dynamically by jumping and hopping
in both horizontal and vertical directions. Twenty healthy males were
participated in this study. In Static condition, added weight increased
body-s inertia and therefore decreased body sway in AP direction
though not significantly. Dynamically, added weight significantly
increased body sway in both ML and AP directions, indicating
instability, and the use of the counter rotating segments mechanism to
maintain balance was demonstrated. Fatigue on the other hand
significantly increased body sway during static balance as a
neurophysiological adaptation primarily to the inverted pendulum
mechanism. Dynamically, fatigue significantly increased body sway
in both ML and AP directions again indicating instability but with a
greater use of counter rotating segments mechanism. Differential
adaptations for each of the two balance mechanisms (inverted
pendulum and counter rotating segments) were found between one
foot flat and two feet flat dynamic conditions, as participants relied
more heavily on the first in the one foot flat conditions and relied
more on the second in the two feet flat conditions.
Abstract: In this paper application of artificial intelligence for
baby and children caring is studied. Then a new idea for injury
prevention and safety announcement is presented by using digital
image processing. The paper presents the structure of the proposed
system. The system determines the possibility of the dangers for
children and babies in yards, gardens and swimming pools or etc. In
the presented idea, multi camera System is used and receiver videos
are processed to find the hazardous areas then the entrance of
children and babies in the determined hazardous areas are analyzed.
In this condition the system does the programmed action capture,
produce alarm or tone or send message.
Abstract: This study investigated the use of modified
atmosphere packaging (MAP) and different packaging to extend the
shelf life of Barbari flat bread. Three atmospheres including 70%CO2
and 30%N2, 50% CO2 and 50%N2 and a normal air as control were
used. The bread samples were packaged in three type pouches. The
shelf life was determined by appearance of mold and yeast (M +Y) in
Barbari bread samples stored at 25 ± 1°C and 38 ± 2% relative
humidity. The results showed that it is possible to prolong the shelf
life of Barbari bread from four days to about 21 days by using
modified atmosphere packaging with high carbon dioxide
concentration and high-barrier laminated and vacuum bags packages.
However, the hardness of samples kept in MAP increase significantly
by increase of carbon dioxide concentration. The correlation
coefficient (r) between headspace CO2 concentration and hardness
was 0.997, 0.997 and 0.599 for A, B and C packaging respectively.
High negative correlation coefficients were found between the crumb
moisture and the hardness values in various packaging. There were
significant negative correlation coefficients between sensory
parameters and hardness of texture.
Abstract: The fabrication of porous NiTi shape memory alloys (SMAs) from elemental powder compacts was conducted by selfpropagating high temperature synthesis (SHS). Effects of the preheating temperature and the chamber pressure on the combustion characteristics as well as the final morphology and the composition of products were studied. The samples with porosity between 56.4 and 59.0% under preheating temperature in the range of 200-300°C and Ar-gas chamber pressure of 138 and 201 kPa were obtained. The pore structures were found to be dissimilar only in the samples processed with different preheating temperature. The major phase in the porous product is NiTi with small amounts of secondary phases, NiTi2 and Ni4Ti3. The preheating temperature and the chamber pressure have very little effect on the phase constituent. While the combustion temperature of the sample was notably increased by increasing the preheating temperature, they were slightly changed by varying the chamber pressure.
Abstract: In this paper an extensive verification of the extraction
method (published earlier) that consistently accounts for self-heating
and Early effect to accurately extract both base and thermal resistance
of bipolar junction transistors is presented. The method verification is
demonstrated on advanced RF SiGe HBTs were the extracted results
for the thermal resistance are compared with those from another
published method that ignores the effect of Early effect on internal
base-emitter voltage and the extracted results of the base resistance
are compared with those determined from noise measurements. A
self-consistency of our method in the extracted base resistance and
thermal resistance using compact model simulation results is also
carried out in order to study the level of accuracy of the method.
Abstract: Regarding previous research studies it was concluded
that thin-walled fiber-cement composites are able to conduct electric
current under specific conditions. This property is ensured by using
of various kinds of carbon materials. Though carbon fibers are less
conductive than metal fibers, composites with carbon fibers were
evaluated as better current conductors than the composites with metal
fibers. The level of electric conductivity is monitored by the means of
impedance measurement of designed samples. These composites
could be used for a range of applications such as heating of
trafficable surfaces or shielding of electro-magnetic fields.
The aim of the present research was to design an element with the
ability to monitor internal processes in building structures and
prevent them from collapsing. As a typical element for laboratory
testing there was chosen a concrete column, which was repeatedly
subjected to load by simple pressure with continual monitoring of
changes in electrical properties.
Abstract: There are many expand of Wi-Fi zones provided
mobile careers and usage of wireless access point at home as increase
of usage of wireless internet caused by the use of smart phone. This
paper shows wireless local area network status, security threats of
WLAN and functionality of major wireless access point in Korea. We
propose security countermeasures concerned with life cycle of access
point from manufacturing to installation, using and finally disposal.
There needed to releasing with configured secure at access point.
Because, it is most cost effective resolution than stage of installation or
other life cycle of access point.
Abstract: In the field of concepts, the measure of Wu and Palmer [1] has the advantage of being simple to implement and have good performances compared to the other similarity measures [2]. Nevertheless, the Wu and Palmer measure present the following disadvantage: in some situations, the similarity of two elements of an IS-A ontology contained in the neighborhood exceeds the similarity value of two elements contained in the same hierarchy. This situation is inadequate within the information retrieval framework. To overcome this problem, we propose a new similarity measure based on the Wu and Palmer measure. Our objective is to obtain realistic results for concepts not located in the same way. The obtained results show that compared to the Wu and Palmer approach, our measure presents a profit in terms of relevance and execution time.
Abstract: In this paper, based on the work in [1], we further give
a general model for acquiring knowledge, which first focuses on the
research of how and when things involved in problems are made
then describes the goals, the energy and the time to give an optimum
model to decide how many related things are supposed to be involved
in. Finally, we acquire knowledge from this model in which there are
the attributes, actions and connections of the things involved at the
time when they are born and the time in their life. This model not
only improves AI theories, but also surely brings the effectiveness
and accuracy for AI system because systems are given more
knowledge when reasoning or computing is used to bring about
results.
Abstract: Greenhouse gases (GHG) emissions impose major
threat to global warming potential (GWP). Unfortunately
manufacturing sector is one of the major sources that contribute
towards the rapid increase in greenhouse gases (GHG) emissions. In
manufacturing sector electric power consumption is the major driver
that influences CO2 emission. Titanium alloys are widely utilized in
aerospace, automotive and petrochemical sectors because of their
high strength to weight ratio and corrosion resistance. Titanium
alloys are termed as difficult to cut materials because of their poor
machinability rating. The present study analyzes energy consumption
during cutting with reference to material removal rate (MRR).
Surface roughness was also measured in order to optimize energy
consumption.
Abstract: New biostimulator from wheat seeds which by its
chemical composition relates to fusicoccin is presented in this article.
New biostimulator could be used as powerful hormonal substance
that has ability to increase productivity and salt tolerance of
agricultural plants. Also on the basis of biostimulator we have
developed vegetative method for fast reproduction of perennial plants
as desert plant - Tamarix gracilis.
Abstract: Healthcare providers sometimes use the power of
humor as a treatment and therapy for buffering mental health or easing
mental disorders because humor can provide relief from distress and
conflict. Humor is also very suitable for advertising because of similar
benefits. This study carefully examines humor's widespread use in
advertising and identifies relationships among humor mechanisms,
female depictions, and product types. The purpose is to conceptualize
how humor theories can be used not only to successfully define a
product as fitting within one of four color categories of the product
color matrix, but also to identify compelling contemporary female
depictions through humor in ads. The results can offer an idealization
for marketing managers and consumers to help them understand how
female role depictions can be effectively used with humor in ads. The
four propositions developed herein are derived from related literature,
through the identification of marketing strategy formulations that
achieve product memory enhancement by adopting humor
mechanisms properly matched with female role depictions.
Abstract: Cities denote instantaneously a challenge and an
opportunity for climate change policy. Cities are the place where
most energy services are needed because urbanization is closely
linked to high population densities and concentration of economic
activities and production (Urban energy demand). Consequently, it is
critical to explain about the role of cities within the world-s energy
systems and its correlation with the climate change issue. With more
than half of the world-s population already living in urban areas, and
that percentage expected to rise to 75 per cent by 2050, it is clear that
the path to sustainable development must pass through cities. Cities
expanding in size and population pose increased challenges to the
environment, of which energy is part as a natural resource, and to the
quality of life. Nowadays, most cities have already understood the
importance of sustainability, both at their local scale as in terms of
their contribution to sustainability at higher geographical scales. It
requires the perception of a city as a complex and dynamic
ecosystem, an open system, or cluster of systems, where the energy
as well as the other natural resources is transformed to satisfy the
needs of the different urban activities. In fact, buildings and
transportation generally represent most of cities direct energy
demand, i.e., between 60 per cent and 80 per cent of the overall
consumption. Buildings, both residential and services are usually
influenced by the local physical and social conditions. In terms of
transport, the energy demand is also strongly linked with the specific
characteristics of a city (urban mobility).The concept of a “smart
city" builds on statistics as seven key axes of a city-s success in
moving towards common platform (brain nerve)of sustainable urban
energy systems.
With the aforesaid knowledge, the authors have suggested a frame
work to role of cities, as energy actors for smart city management.
The authors have discusses the potential elements needed for energy
in smart cities and also identified potential energy actions and
relevant barriers. Furthermore, three levels of city smartness in cities
actions to overcome market /institutional failures with a local
approach are distinguished. The authors have made an attempt to
conceive and implement concepts of city smartness by adopting the
city or local government as nerve center through an integrated
planning approach. Finally, concluding with recommendations for
the organization of the Smart Sustainable Cities for positive changes
of urban India.