Abstract: This paper presents the characterization and design of a capacitive pressure sensor with LC-based 0.35 µm CMOS readout circuit. SPICE is employed to evaluate the characteristics of the readout circuit and COMSOL multiphysics structural analysis is used to simulate the behavior of the pressure sensor. The readout circuit converts the capacitance variation of the pressure sensor into the frequency output. Simulation results show that the proposed pressure sensor has output frequency from 2.50 to 2.28 GHz in a pressure range from 0.1 to 2 MPa almost linearly. The sensitivity of the frequency shift with respect to the applied pressure load is 0.11 GHz/MPa.
Abstract: The aim of the study is to determine the effects of
perceived organizational support on organizational identification. In
accordance with this purpose was applied on 131 family physicians in
Konya. The data obtained by means of the survey method were
analyzed. According to the results of correlation analysis, while
positive relationship between perceived organizational support,
organizational identification and supervisor support was revealed.
Also, with the scope of the research, relationships between these
variables and certain demographic variables were detected.
According to difference analysis results of the research, significant
differences between organizational identification and gender variable
were determined. However, significant differences were not
determined between demographic variables and perceived
organizational support.
Abstract: Thermal water hammer is a special type of water
hammer which rarely occurs in heat exchangers. In biphasic fluids, if
steam bubbles are surrounded by condensate, regarding lower
condensate temperature than steam, they will suddenly collapse. As a
result, the vacuum caused by an extreme change in volume lead to
movement of the condensates in all directions and their collision the
force produced by this collision leads to a severe stress in the pipe
wall. This phenomenon is a special type of water hammer. According
to fluid mechanics, this phenomenon is a particular type of transient
flows during which abrupt change of fluid leads to sudden pressure
change inside the tube. In this paper, the mechanism of abrupt failure
of 80 tubes of 481 tubes of a methanol heat exchanger is discussed.
Initially, due to excessive temperature differences between heat
transfer fluids and simultaneous failure of 80 tubes, thermal shock
was presupposed as the reason of failure. Deeper investigation on
cross-section of failed tubes showed that failure was, ductile type of
failure, so the first hypothesis was rejected. Further analysis and more
accurate experiments revealed that failure of tubes caused by thermal
water hammer. Finally, the causes of thermal water hammer and
various solutions to avoid such mechanism are discussed.
Abstract: In this paper, we propose a novel adaptive
spatiotemporal filter that utilizes image sequences in order to remove
noise. The consecutive frames include: current, previous and next
noisy frames. The filter proposed in this paper is based upon the
weighted averaging pixels intensity and noise variance in image
sequences. It utilizes the Appropriate Number of Consecutive Frames
(ANCF) based on the noisy pixels intensity among the frames. The
number of consecutive frames is adaptively calculated for each
region in image and its value may change from one region to another
region depending on the pixels intensity within the region. The
weights are determined by a well-defined mathematical criterion,
which is adaptive to the feature of spatiotemporal pixels of the
consecutive frames. It is experimentally shown that the proposed
filter can preserve image structures and edges under motion while
suppressing noise, and thus can be effectively used in image
sequences filtering. In addition, the AWA filter using ANCF is
particularly well suited for filtering sequences that contain segments
with abruptly changing scene content due to, for example, rapid
zooming and changes in the view of the camera.
Abstract: Rural areas of Tanzania are still disadvantaged in terms of diffusion of IP-based services; this is due to lack of Information and Communication Technology (ICT) infrastructures, especially lack of connectivity. One of the limitations for connectivity problems in rural areas of Tanzania is the high cost to establish infrastructures for IP-based services [1-2]. However the cost of connectivity varies from one technology to the other and at the same time, the cost is also different from one operator (service provider) to another within the country. This paper presents development of software system to calculate cost of connectivity to rural areas of Tanzania. The system is developed to make an easy access of connectivity cost from different technologies and different operators. The development of the calculator follows the V-model software development lifecycle. The calculator is used to evaluate the economic viability of different technologies considered as being potential candidates to provide rural connectivity. In this paper, the evaluation is based on the techno-economic analysis approach.
Abstract: In this paper, mesh-free element free Galerkin (EFG) method is extended to solve two-dimensional potential flow problems. Two ideal fluid flow problems (i.e. flow over a rigid cylinder and flow over a sphere) have been formulated using variational approach. Penalty and Lagrange multiplier techniques have been utilized for the enforcement of essential boundary conditions. Four point Gauss quadrature have been used for the integration on two-dimensional domain (Ω) and nodal integration scheme has been used to enforce the essential boundary conditions on the edges (┌). The results obtained by EFG method are compared with those obtained by finite element method. The effects of scaling and penalty parameters on EFG results have also been discussed in detail.
Abstract: The work reported in this paper proposes
Swarm-Array computing, a novel technique inspired by swarm
robotics, and built on the foundations of autonomic and parallel
computing. The approach aims to apply autonomic computing
constructs to parallel computing systems and in effect achieve the
self-ware objectives that describe self-managing systems. The
constitution of swarm-array computing comprising four constituents,
namely the computing system, the problem/task, the swarm and the
landscape is considered. Approaches that bind these constituents
together are proposed. Space applications employing FPGAs are
identified as a potential area for applying swarm-array computing for
building reliable systems. The feasibility of a proposed approach is
validated on the SeSAm multi-agent simulator and landscapes are
generated using the MATLAB toolkit.
Abstract: This paper details few mechanical modeling and
design issues of RF MEMS switches. We concentrate on an
electrostatically actuated broad side series switch; surface
micromachined with a crab leg membrane. The same results are
extended to any complex structure. With available experimental data
and fabrication results, we present the variation in dynamic
performance and compliance of the switch with reference to few
design issues, which we find are critical in deciding the dynamic
behavior of the switch, without compromise on the RF
characteristics. The optimization of pull in voltage, transient time and
resonant frequency with regard to these critical design parameters are
also presented.
Abstract: The paper presents an applied study of a multivariate AR(p) process fitted to daily data from U.S. commodity futures markets with the use of Bayesian statistics. In the first part a detailed description of the methods used is given. In the second part two BVAR models are chosen one with assumption of lognormal, the second with normal distribution of prices conditioned on the parameters. For a comparison two simple benchmark models are chosen that are commonly used in todays Financial Mathematics. The article compares the quality of predictions of all the models, tries to find an adequate rate of forgetting of information and questions the validity of Efficient Market Hypothesis in the semi-strong form.
Abstract: Autoregressive Moving average (ARMA) is a parametric based method of signal representation. It is suitable for problems in which the signal can be modeled by explicit known source functions with a few adjustable parameters. Various methods have been suggested for the coefficients determination among which are Prony, Pade, Autocorrelation, Covariance and most recently, the use of Artificial Neural Network technique. In this paper, the method of using Artificial Neural network (ANN) technique is compared with some known and widely acceptable techniques. The comparisons is entirely based on the value of the coefficients obtained. Result obtained shows that the use of ANN also gives accurate in computing the coefficients of an ARMA system.
Abstract: In this paper, we rely on the story of the late British
weapons inspector David Kelly to illustrate how sensemaking can
inform the study of the ethics of suppression of dissent. Using
archival data, we reconstruct Dr. Kelly-s key responsibilities as a
weapons inspector and government employee. We begin by clarifying
the concept of dissent and how it is a useful organizational process.
We identify the various ways that dissent has been discussed in the
organizational literature and reconsider the process of sensemaking.
We conclude that suppression of opinions that deviate from the
majority is part of the identity maintenance of the sensemaking
process. We illustrate the prevention of dissent in organizations
consists of a set of unsatisfactory trade-offs.
Abstract: The reservoir of Kowsar dam supply water for
different usages such as aquaculture farms , drinking, agricultural and
industrial usages for some provinces in south of Iran. The Kowsar
dam is located next to the city of Dehdashat in Kohgiluye and
Boyerahmad province in southern Iran. There are some towns and
villages on the Kowsar dam watersheds, which Dehdasht and Choram
are the most important and populated twons in this area, which can to
be sources of pollution for water reservoir of the Kowsar dam . This
study was done to determine of water pollution of the Kowsar dam
reservoir which is one of the most important water resources of
Kohkiloye and Boyerahmad and Bushehr provinces in south-west
Iran. In this study , water samples during 12 months were collected to
examine Biochemical Oxygen Demand (BOD) and Dissolved
Oxygen(DO) as a criterion for evaluation of water pollution of the
reservoir. In summary ,the study has shown Maximum, average and
minimum levels of BOD have observed 25.9 ,9.15 and 2.3 mg/L
respectively and statistical parameters of data such as standard
deviation , variance and skewness have calculated 7.88, 62 and 1.54
respectively. Finally the results were compared with Iranian national
standards. Among the analyzed samples, as the maximum value of
BOD (25.9 mg/L) was observed at the May 2010 , was within the
maximum admissible limits by the Iranian standards.
Abstract: This study aims at investigating the empirical
relationships between risk preference, internet preference, and
internet knowledge which are known as user characteristics, in
addition to perceived risk of the customers on the internet purchase
intention. In order to test the relationships between the variables of
model 174, a questionnaire was collected from the students with
previous online experience. For the purpose of data analysis,
confirmatory factor analysis (CFA) and structural equation model
(SEM) was used.
Test results show that the perceived risk affects the internet
purchase intention, and increase or decrease of perceived risk
influences the purchase intention when the customer does the internet
shopping. Other factors such as internet preference, knowledge of the
internet, and risk preference affect the internet purchase intention.
Abstract: The influence of humidity and low temperature on the α- amylase activity and isoenzyme composition of grains of different wheat varieties have been studied. The identified samples of varieties have significant difference in the level of enzyme induction under the impact of high humidity and low temperature. It is proposed to use this methodological approach for testing genotypes and wheat breeding lines for resistance to pre-harvest sprouting (PHS).
Abstract: ORC (Organic Rankine Cycle) has potential of
reducing consumption of fossil fuels and has many favorable
characteristics to exploit low-temperature heat sources. In this work
thermodynamic performance of ORC with regeneration is
comparatively assessed for various working fluids. Special attention is
paid to the effects of system parameters such as the turbine inlet
pressure on the characteristics of the system such as net work
production, heat input, volumetric flow rate per 1 MW of net work and
quality of the working fluid at turbine exit as well as thermal
efficiency. Results show that for a given source the thermal efficiency
generally increases with increasing of the turbine inlet pressure
however has optimal condition for working fluids of low critical
pressure such as iso-pentane or n-pentane.
Abstract: Various mechanisms providing mutual exclusion and
thread synchronization can be used to support parallel processing
within a single computer. Instead of using locks, semaphores, barriers
or other traditional approaches in this paper we focus on alternative
ways for making better use of modern multithreaded architectures
and preparing hash tables for concurrent accesses. Hash structures
will be used to demonstrate and compare two entirely different
approaches (rule based cooperation and hardware synchronization
support) to an efficient parallel implementation using traditional
locks. Comparison includes implementation details, performance
ranking and scalability issues. We aim at understanding the effects
the parallelization schemes have on the execution environment with
special focus on the memory system and memory access
characteristics.
Abstract: This paper attempts to identify the significance of
Information and Communications Technology (ICT) and
competitiveness to the profit efficiency of commercial banks in
Malaysia. The profit efficiency of commercial banks in Malaysia, the
dependent variable, was estimated using the Stochastic Frontier
Approach (SFA) on a sample of unbalanced panel data, covering 23
commercial banks, between 1995 to 2007. Based on the empirical
results, ICT was not found to exert a significant impact on profit
efficiency, whereas competitiveness, non ICT stock expenditure and
ownership were significant contributors. On the other hand, the size
of banks was found to have significantly reduced profit efficiency,
opening up for various interpretations of the interrelated role of ICT
and competition.
Abstract: A study of various turbulent inflow generation methods
was performed to compare their relative effectiveness for LES
computations of turbulent boundary layers. This study confirmed
the quality of the turbulent information produced by the family of
recycling and rescaling methods which take information from within
the computational domain. Furthermore, more general inflow methods
also proved applicable to such simulations, with a precursor-like
inflow and a random inflow augmented with forcing planes showing
promising results.
Abstract: Wireless LAN (WLAN) access in public hotspot areas
becomes popular in the recent years. Since more and more multimedia
information is available in the Internet, there is an increasing demand
for accessing multimedia information through WLAN hotspots.
Currently, the bandwidth offered by an IEEE 802.11 WLAN cannot
afford many simultaneous real-time video accesses. A possible way to
increase the offered bandwidth in a hotspot is the use of multiple access
points (APs). However, a mobile station is usually connected to the
WLAN AP with the strongest received signal strength indicator (RSSI).
The total consumed bandwidth cannot be fairly allocated among those
APs. In this paper, we will propose an effective load-balancing scheme
via the support of the IAPP and SNMP in APs. The proposed scheme is
an open solution and doesn-t need any changes in both wireless stations
and APs. This makes load balancing possible in WLAN hotspots,
where a variety of heterogeneous mobile devices are employed.
Abstract: The flow field in a centrifugal fan is highly complex
with flow reversal taking place on the suction side of impeller and
diffuser vanes. Generally performance of the centrifugal fan could be
enhanced by judiciously introducing splitter vanes so as to improve
the diffusion process. An extensive numerical whole field analysis on
the effect of splitter vanes placed in discrete regions of suspected
separation points is possible using CFD. This paper examines the
effect of splitter vanes corresponding to various geometrical
locations on the impeller and diffuser. The analysis shows that the
splitter vanes located near the diffuser exit improves the static
pressure recovery across the diffusing domain to a larger extent. Also
it is found that splitter vanes located at the impeller trailing edge and
diffuser leading edge at the mid-span of the circumferential distance
between the blades show a marginal improvement in the static
pressure recovery across the fan. However, splitters provided near to
the suction side of the impeller trailing edge (25% of the
circumferential gap between the impeller blades towards the suction
side), adversely affect the static pressure recovery of the fan.