Abstract: This paper reports the feasibility of the ARMA model
to describe a bursty video source transmitting over a AAL5 ATM link
(VBR traffic). The traffic represents the activity of the action movie
"Lethal Weapon 3" transmitted over the ATM network using the Fore
System AVA-200 ATM video codec with a peak rate of 100 Mbps
and a frame rate of 25. The model parameters were estimated for a
single video source and independently multiplexed video sources. It
was found that the model ARMA (2, 4) is well-suited for the real data
in terms of average rate traffic profile, probability density function,
autocorrelation function, burstiness measure, and the pole-zero
distribution of the filter model.
Abstract: This paper presents the combination of different precipitation data sets and the distributed hydrological model, in order to examine the flood runoff reproductivity of scattered observation catchments. The precipitation data sets were obtained from observation using rain-gages, satellite based estimate (TRMM), and numerical weather prediction model (NWP), then were coupled with the super tank model. The case study was conducted in three basins (small, medium, and large size) located in Central Vietnam. Calculated hydrographs based on ground observation rainfall showed best fit to measured stream flow, while those obtained from TRMM and NWP showed high uncertainty of peak discharges. However, calculated hydrographs using the adjusted rainfield depicted a promising alternative for the application of TRMM and NWP in flood modeling for scattered observation catchments, especially for the extension of forecast lead time.
Abstract: A mathematical model for determining the overall efficiency
of a multistage tractor gearbox including all gear, lubricant,
surface finish related parameters and operating conditions is
presented. Sliding friction, rolling friction and windage losses were
considered as the main sources of power loss in the gearing system. A
computer code in FORTRAN was developed to simulate the model.
Sliding friction contributes about 98% of the total power loss for
gear trains operating at relatively low speeds (less than 2000 rpm
input speed). Rolling frictional losses decrease with increased load
while windage losses are only significant for gears running at very
high speeds (greater than 3000 rpm). The results also showed that the
overall efficiency varies over the path of contact of the gear meshes
ranging between 94% to 99.5%.
Abstract: Suspended cable structures are most preferable for large spans covering due to rational use of structural materials, but the problem of suspended cable structures is initial shape change under the action of non-symmetrical load. The problem can be solved by increasing of relation of dead weight and imposed load, but this methods cause increasing of materials consumption.Prestressed cable truss usage is another way how the problem of shape change under the action of non-symmetrical load can be fixed. The better results can be achieved if we replace top chord with cable truss with cross web. Rational structure of the cable truss for prestressed cable truss top chord was developed using optimization realized in FEM program ANSYS 12 environment. Single cable and cable truss model work was discovered.Analytical and model testing results indicate, that usage of cable truss with the cross web as a top chord of prestressed cable truss instead of single cable allows to reduce total displacements by 13-16% in the case of non-symmetrical load. In case of uniformly distributed load single cable is preferable.
Abstract: This paper investigates the indices of a creative city in
Isfahan. Its main aim is to evaluate quantitative status of the creative
city indices in Isfahan city, analyze the dispersion and distribution of
these indices in Isfahan city. Concerning these, this study tries to
analyze the creative city indices in fifteen area of Isfahan through
secondary data, questionnaire, TOPSIS model, Shannon entropy and
SPSS. Based on this, the fifteen areas of Isfahan city have been
ranked with 12 factors of creative city indices. The results of studies
show that fifteen areas of Isfahan city are not equally benefiting from
creative indices and there is much difference between the areas of
Isfahan city.
Abstract: detecting the deadlock is one of the important
problems in distributed systems and different solutions have been
proposed for it. Among the many deadlock detection algorithms,
Edge-chasing has been the most widely used. In Edge-chasing
algorithm, a special message called probe is made and sent along
dependency edges. When the initiator of a probe receives the probe
back the existence of a deadlock is revealed. But these algorithms are
not problem-free. One of the problems associated with them is that
they cannot detect some deadlocks and they even identify false
deadlocks. A key point not mentioned in the literature is that when
the process is waiting to obtain the required resources and its
execution has been blocked, how it can actually respond to probe
messages in the system. Also the question of 'which process should
be victimized in order to achieve a better performance when multiple
cycles exist within one single process in the system' has received
little attention. In this paper, one of the basic concepts of the
operating system - daemon - will be used to solve the problems
mentioned. The proposed Algorithm becomes engaged in sending
probe messages to the mandatory daemons and collects enough
information to effectively identify and resolve multi-cycle deadlocks
in distributed systems.
Abstract: Automatic reusability appraisal could be helpful in
evaluating the quality of developed or developing reusable software
components and in identification of reusable components from
existing legacy systems; that can save cost of developing the software
from scratch. But the issue of how to identify reusable components
from existing systems has remained relatively unexplored. In this
paper, we have mentioned two-tier approach by studying the
structural attributes as well as usability or relevancy of the
component to a particular domain. Latent semantic analysis is used
for the feature vector representation of various software domains. It
exploits the fact that FeatureVector codes can be seen as documents
containing terms -the idenifiers present in the components- and so
text modeling methods that capture co-occurrence information in
low-dimensional spaces can be used. Further, we devised Neuro-
Fuzzy hybrid Inference System, which takes structural metric values
as input and calculates the reusability of the software component.
Decision tree algorithm is used to decide initial set of fuzzy rules for
the Neuro-fuzzy system. The results obtained are convincing enough
to propose the system for economical identification and retrieval of
reusable software components.
Abstract: Fiber optic sensor technology offers the possibility of
sensing different parameters like strain, temperature, pressure in
harsh environment and remote locations. these kinds of sensors
modulates some features of the light wave in an optical fiber such an
intensity and phase or use optical fiber as a medium for transmitting
the measurement information.
The advantages of fiber optic sensors in contrast to conventional
electrical ones make them popular in different applications and now a
day they consider as a key component in improving industrial
processes, quality control systems, medical diagnostics, and
preventing and controlling general process abnormalities.
This paper is an introduction to fiber optic sensor technology and
some of the applications that make this branch of optic technology,
which is still in its early infancy, an interesting field.
Abstract: Gabor-based face representation has achieved enormous success in face recognition. This paper addresses a novel algorithm for face recognition using neural networks trained by Gabor features. The system is commenced on convolving a face image with a series of Gabor filter coefficients at different scales and orientations. Two novel contributions of this paper are: scaling of rms contrast and introduction of fuzzily skewed filter. The neural network employed for face recognition is based on the multilayer perceptron (MLP) architecture with backpropagation algorithm and incorporates the convolution filter response of Gabor jet. The effectiveness of the algorithm has been justified over a face database with images captured at different illumination conditions.
Abstract: In this paper test generation methods and appropriate fault models for testing and analysis of embedded systems described as (extended) finite state machines ((E)FSMs) are presented. Compared to simple FSMs, EFSMs specify not only the control flow but also the data flow. Thus, we define a two-level fault model to cover both aspects. The goal of this paper is to reuse well-known FSM-based test generation methods for automation of embedded system testing. These methods have been widely used in testing and validation of protocols and communicating systems. In particular, (E)FSMs-based specification and testing is more advantageous because (E)FSMs support the formal semantic of already standardised formal description techniques (FDTs) despite of their popularity in the design of hardware and software systems.
Abstract: As open innovation has received increasingly attention
in the management of innovation, the importance of identifying
potential partnership is increasing. This paper suggests a methodology
to identify the interested parties as one of Innovation intermediaries to
enable open innovation with patent network. To implement the
methodology, multi-stage patent citation analysis such as
bibliographic coupling and information visualization method such as
keyword vector mapping are utilized. This paper has contribution in
that it can present meaningful collaboration keywords to identified
potential partners in network since not only citation information but
also patent textual information is used.
Abstract: The database reverse engineering problems and
solving processes are getting mature, even though, the academic
community is facing the complex problem of knowledge transfer,
both in university and industrial contexts. This paper presents a new
CASE tool developed at the University of Jordan which addresses an
efficient support of this transfer, namely UJ-CASE-TOOL. It is a
small and self-contained application exhibiting representative
problems and appropriate solutions that can be understood in a
limited time. It presents an algorithm that describes the developed
academic CASE tool which has been used for several years both as
an illustration of the principles of database reverse engineering and
as an exercise aimed at academic and industrial students.
Abstract: Development of knowledge based society carries multiple challenges to the higher education system. Some of the challenges laid before the higher education sector of countries which aspire to become knowledge based societies are: the entrepreneurial leadership of the higher education institutions, finding new sources of financing in order to minimize dependence on public resources, creating connections with the labor market, commercial utilization of R&D results, promotion of innovations as well as the overall promotion of science excellence relevant to the economic sector. Within a framework of this paper and its main subject of research, the challenge which is being put before the higher education institutions is an effort of establishing regional mission of higher education through the open collaboration with regional key factors, both private and public. Development of the mentioned collaboration and its contribution to the overall regional development in Croatia is the main subject of empirical research in this paper.
Abstract: This paper attempts to investigate the factors that influence hotel managers- attitudes towards sustainable tourism practices (STP) in Kuala Lumpur and the state of Selangor in Malaysia. The study distributes 104 questionnaires to hotels ranging from one star to five-star categories including budget hotels. Out of this figure, 60 copies of the questionnaires were returned and analyzed. The finding revealed that of all the seven factors investigated, only the variables measuring incentives and knowledge have significantly influenced sustainable tourism practices in the country. Therefore, government and other green bodies within the country should continue to provide hotels with incentives for sound technologies. Moreover, the government agencies should continue to educate hoteliers on the relevance of environmental protection for the successful implementation of sustainable tourism practices.
Abstract: Dew harvesting needs only weak investment and
exploits a free, clean and inexhaustible energy. This study aims to
measure the relative contributions of dew and rain water in the
Mediterranean Dalmatian coast and islands of Croatia and determine
whether dew water is potable. Two sites were chosen, an open site on
the coast favourable to dew formation (Zadar) and a less favourable
site in a circus of mountains in Komiža (Vis Island). Between July
1st, 2003 and October 31st, 2006, dew hasbeen daily collected on a 1
m2 tilted (30°) test dew condenser together with ordinary
meteorological data (air temperature and relative humidity, cloud
coverage, windspeed and direction). The mean yearly cumulative
dew yields were found to be 20 mm (Zadar) and 9.3 mm (Komiža ).
During the dry season (May to October), monthly cumulative dew
water yield can represent up to 38% of water collected by rain fall. In
July 2003 and 2006, dew water represented about 120% of the
monthly cumulative rain water. Dew and rain water were analyzed in
Zadar. The corresponding parameters were measured: pH, electrical
conductivity, major anions (HCO3
-, Cl-, SO4
2-
, NO3
-
, ,) and major
cations (NH4
+, Na+, K+, Ca2+, Mg2+. Both dew and rain water are in
conformity with the WHO directives for potability except Mg2+.
Using existing roofs and refurbishing the abandoned impluviums to
permit dew collection could then provide a useful supplementary
amount of water, especially during the dry season.
Abstract: The growth and interconnection of power networks in many regions has invited complicated techniques for energy management services (EMS). State estimation techniques become a powerful tool in power system control centers, and that more information is required to achieve the objective of EMS. For the online state estimator, assuming the continuous time is equidistantly sampled with period Δt, processing events must be finished within this period. Advantage of Kalman Filtering (KF) algorithm in using system information to improve the estimation precision is utilized. Computational power is a major issue responsible for the achievement of the objective, i.e. estimators- solution at a small sampled period. This paper presents the optimum utilization of processors in a state estimator based on KF. The model used is presented using Petri net (PN) theory.
Abstract: A new data fusion method called joint probability density matrix (JPDM) is proposed, which can associate and fuse measurements from spatially distributed heterogeneous sensors to identify the real target in a surveillance region. Using the probabilistic grids representation, we numerically combine the uncertainty regions of all the measurements in a general framework. The NP-hard multisensor data fusion problem has been converted to a peak picking problem in the grids map. Unlike most of the existing data fusion method, the JPDM method dose not need association processing, and will not lead to combinatorial explosion. Its convergence to the CRLB with a diminishing grid size has been proved. Simulation results are presented to illustrate the effectiveness of the proposed technique.
Abstract: We intend to point out the differences which exist
between the classical Gini concentration coefficient and a proposed
bipolarization index defined for an arbitrary random variable which
have a finite support.
In fact Gini's index measures only the "poverty degree" for the
individuals from a given population taking into consideration their
wages. The Gini coefficient is not so sensitive to the significant
income variations in the "rich people class" .
In practice there are multiple interdependent relations between the
pauperization and the socio-economical polarization phenomena. The
presence of a strong pauperization aspect inside the population
induces often a polarization effect in this society. But the
pauperization and the polarization phenomena are not identical. For
this reason it isn't always adequate to use a Gini type coefficient,
based on the Lorenz order, to estimate the bipolarization level of the
individuals from the studied population.
The present paper emphasizes these ideas by considering two
families of random variables which have a linear or a triangular type
distributions. In addition, the continuous variation, depending on the
parameter "time" of the chosen distributions, could simulate a real
dynamical evolution of the population.
Abstract: A considerable amount of energy is consumed during
transmission and reception of messages in a wireless mesh network
(WMN). Reducing per-node transmission power would greatly
increase the network lifetime via power conservation in addition to
increasing the network capacity via better spatial bandwidth reuse. In
this work, the problem of topology control in a hybrid WMN of
heterogeneous wireless devices with varying maximum transmission
ranges is considered. A localized distributed topology control
algorithm is presented which calculates the optimal transmission
power so that (1) network connectivity is maintained (2) node
transmission power is reduced to cover only the nearest neighbours
(3) networks lifetime is extended. Simulations and analysis of results
are carried out in the NS-2 environment to demonstrate the
correctness and effectiveness of the proposed algorithm.
Abstract: Linear induction motors are used in various industries
but they have some specific phenomena which are the causes for
some problems. The most important phenomenon is called end effect.
End effect decreases efficiency, power factor and output force and
unbalances the phase currents. This phenomenon is more important
in medium and high speeds machines. In this paper a factor, EEF , is
obtained by an accurate equivalent circuit model, to determine the
end effect intensity. In this way, all of effective design parameters on
end effect is described. Accuracy of this equivalent circuit model is
evaluated by two dimensional finite-element analysis using ANSYS.
The results show the accuracy of the equivalent circuit model.