Abstract: Currently, there are many local area industrial networks
that can give guaranteed bandwidth to synchronous traffic, particularly
providing CBR channels (Constant Bit Rate), which allow
improved bandwidth management. Some of such networks operate
over Ethernet, delivering channels with enough capacity, specially
with compressors, to integrate multimedia traffic in industrial monitoring
and image processing applications with many sources. In
these industrial environments where a low latency is an essential
requirement, JPEG is an adequate compressing technique but it
generates VBR traffic (Variable Bit Rate). Transmitting VBR traffic
in CBR channels is inefficient and current solutions to this problem
significantly increase the latency or further degrade the quality. In
this paper an R(q) model is used which allows on-line calculation of
the JPEG quantification factor. We obtained increased quality, a lower
requirement for the CBR channel with reduced number of discarded
frames along with better use of the channel bandwidth.
Abstract: Road traffic accidents are a major cause of death worldwide. In an attempt to reduce accidents, some research efforts have focused on creating Advanced Driver Assistance Systems (ADAS) able to detect vehicle, driver and environmental conditions and to use this information to identify cues for potential accidents. This paper presents continued work on a novel Non-intrusive Intelligent Driver Assistance and Safety System (Ni-DASS) for assessing driver point of regard within vehicles. It uses an on-board CCD camera to observe the driver-s face. A template matching approach is used to compare the driver-s eye-gaze pattern with a set of eye-gesture templates of the driver looking at different focal points within the vehicle. The windscreen is divided into cells and comparison of the driver-s eye-gaze pattern with templates of a driver-s eyes looking at each cell is used to determine the driver-s point of regard on the windscreen. Results indicate that the proposed technique could be useful in situations where low resolution estimates of driver point of regard are adequate. For instance, To allow ADAS systems to alert the driver if he/she has positively failed to observe a hazard.
Abstract: Multirate multimedia delivery applications in multihop Wireless Mesh Network (WMN) are data redundant and delay-sensitive, which brings a lot of challenges for designing efficient transmission systems. In this paper, we propose a new cross layer resource allocation scheme to minimize the receiver side distortion within the delay bound requirements, by exploring application layer Position and Value (P-V) diversity as well as the multihop Effective Capacity (EC). We specifically consider image transmission optimization here. First of all, the maximum supportable source traffic rate is identified by exploring the multihop Effective Capacity (EC) model. Furthermore, the optimal source coding rate is selected according to the P-V diversity of multirate media streaming, which significantly increases the decoded media quality. Simulation results show the proposed approach improved media quality significantly compared with traditional approaches under the same QoS requirements.
Abstract: As a result of traffic congestion caused by sightseeing
and shuttle buses using park-and-ride parking lot near sightseeing spot,
the waiting time for tourist increases. In this paper, when bus parking
lot near sightseeing spot are overcrowded and full, a model for tourists
getting off a bus on a congested road and transfer to the sightseeing
spot by foot is proposed and verified. A model of getting off a bus on a
congested road when the sightseeing parking lot is overcrowded was
considered by the case analysis. As a result, effectiveness of the model
of getting off a bus on a congested road could be quantitatively
verified for times when parking capacity is exceeded and the bus
parking lot next to the sightseeing spot is overcrowded.
Abstract: This paper presents Qmulus- a Cloud Based GPS
Model. Qmulus is designed to compute the best possible route which
would lead the driver to the specified destination in the shortest time
while taking into account real-time constraints. Intelligence
incorporated to Qmulus-s design makes it capable of generating and
assigning priorities to a list of optimal routes through customizable
dynamic updates. The goal of this design is to minimize travel and
cost overheads, maintain reliability and consistency, and implement
scalability and flexibility. The model proposed focuses on
reducing the bridge between a Client Application and a Cloud
service so as to render seamless operations. Qmulus-s system
model is closely integrated and its concept has the potential to be
extended into several other integrated applications making it capable
of adapting to different media and resources.
Abstract: Nowadays, driving support systems, such as car
navigation systems, are getting common, and they support drivers in
several aspects. It is important for driving support systems to detect
status of driver's consciousness. Particularly, detecting driver's
drowsiness could prevent drivers from collisions caused by drowsy
driving. In this paper, we discuss the various artificial detection
methods for detecting driver's drowsiness processing technique. This
system is based on facial images analysis for warning the driver of
drowsiness or in attention to prevent traffic accidents.
Abstract: Recent communications environment significantly
expands the mobile environment. The popularization of smartphones
with various mobile services has emerged, and smartphone users are
rapidly increasing. Because of these symptoms, existing wired
environment in a variety of mobile traffic entering to mobile network
has threatened the stability of the mobile network. Unlike traditional
wired infrastructure, mobile networks has limited radio resources and
signaling procedures for complex radio resource management. So
these traffic is not a problem in wired networks but mobile networks, it
can be a threat. In this paper, we analyze the security threats in mobile
networks and provide direction to solve it.
Abstract: Surveillance system is widely used in the traffic
monitoring. The deployment of cameras is moving toward a
ubiquitous camera (UbiCam) environment. In our previous study, a
novel service, called GPS-VT, was firstly proposed by incorporating
global positioning system (GPS) and visual tracking techniques for
the UbiCam environment. The first prototype is called GODTA
(GPS-based Moving Object Detection and Tracking Approach). For a
moving person carried GPS-enabled mobile device, he can be
tracking when he enters the field-of-view (FOV) of a camera
according to his real-time GPS coordinate. In this paper, GPS-VT
service is applied to the tracking of vehicles. The moving speed of a
vehicle is much faster than a person. It means that the time passing
through the FOV is much shorter than that of a person. Besides, the
update interval of GPS coordinate is once per second, it is
asynchronous with the frame rate of the real-time image. The above
asynchronous is worsen by the network transmission delay. These
factors are the main challenging to fulfill GPS-VT service on a
vehicle.In order to overcome the influence of the above factors, a
back-propagation neural network (BPNN) is used to predict the
possible lane before the vehicle enters the FOV of a camera. Then, a
template matching technique is used for the visual tracking of a target
vehicle. The experimental result shows that the target vehicle can be
located and tracking successfully. The success location rate of the
implemented prototype is higher than that of the previous GODTA.
Abstract: The vehicle fleet of public transportation companies is often equipped with intelligent on-board passenger information systems. A frequently used but time and labor-intensive way for keeping the on-board controllers up-to-date is the manual update using different memory cards (e.g. flash cards) or portable computers. This paper describes a compression algorithm that enables data transmission using low bandwidth wireless radio networks (e.g. GPRS) by minimizing the amount of data traffic. In typical cases it reaches a compression rate of an order of magnitude better than that of the general purpose compressors. Compressed data can be easily expanded by the low-performance controllers, too.
Abstract: Geometric design is an important part of planning
process design for physical highway to fill up basic function of roads,
to give good traffic service. It is found that most of the road safety
problems occur at the horizontal curves and complex-compound
curves. In this paper, review on Sagarinn-Myinsain Portion of Nay
Pyi Taw - Mandalay highway has been conducted in aspect of
geometric design induced road safety condition. Horizontal
alignment of geometric features and curve details are reviewed based
on (AASHTO) standard and revised by Autodesk Land Desktop
Software. Moreover, 85th Percentile Operation Speeds (V85) with
driver confidence on horizontal curves is evaluated in order to obtain
the range of highway safety factor (FS). The length of the selected
highway portion is 13.65 miles and 8 lanes. The results of this study
can be used to investigate the possible hazardous locations in
advance and to revise how design radius and super elevation should
be for better road safety performance for the selected portion.
Moreover, the relationship between highway safety and highway
geometry characteristics can also be known.
Abstract: Performance of vehicle depends on driving patterns
and vehicle drive train configuration. Driving patterns depends on
traffic condition, road condition and driver behavior. HEV design is
carried out under certain constrain like vehicle operating range,
acceleration, decelerations, maximum speed and road grades which
are directly related to the driving patterns. Therefore the detailed
study on HEV performance over a different drive cycle is required
for selection and sizing of HEV components. A simple hardware is
design to measured velocity v/s time profile of the vehicle by
operating vehicle on Indian roads under real traffic conditions. To
size the HEV components, a detailed dynamic model of the vehicle is
developed considering the effect of inertia of rotating components
like wheels, drive chain, engine and electric motor. Using vehicle
model and different Indian drive cycles data, total tractive power
demanded by vehicle and power supplied by individual components
has been calculated.Using above information selection and estimation
of component sizing for HEV is carried out so that HEV performs
efficiently under hostile driving condition. Complete analysis is
carried out in LABVIEW.
Abstract: Discovery schools in Jordan are connected in one flat
ATM bridge network. All Schools connected to the network will hear
broadcast traffic. High percentage of unwanted traffic such as
broadcast, consumes the bandwidth between schools and QRC.
Routers in QRC have high CPU utilization. The number of
connections on the router is very high, and may exceed recommend
manufacturing specifications. One way to minimize number of
connections to the routers in QRC, and minimize broadcast traffic is
to use PPPoE. In this study, a PPPoE solution has been presented
which shows high performance for the clients when accessing the
school server resources. Despite the large number of the discovery
schools at MoE, the experimental results show that the PPPoE
solution is able to yield a satisfactory performance for each client at
the school and noticeably reduce the traffic broadcast to the QRC.
Abstract: The value of emission factor was calculated in the
older type of Diesel engine operating on an engine testing bench and
then compared with the parameters monitored under similar
conditions when the EnviroxTM additive was applied. It has been
found out that the additive based on CeO2 nanoparticles reduces
emission of NOx. The dependencies of NOx emissions on reduced
torque, engine power and revolutions have been observed as well.
Abstract: Unlike the best effort service provided by the internet
today, next-generation wireless networks will support real-time
applications. This paper proposes an adaptive early packet discard
(AEPD) policy to improve the performance of the real time TCP
traffic over ATM networks and avoid the fragmentation problem.
Three main aspects are incorporated in the proposed policy. First,
providing quality-of-service (QoS) guaranteed for real-time
applications by implementing a priority scheduling. Second,
resolving the partially corrupted packets problem by differentiating
the buffered cells of one packet from another. Third, adapting a
threshold dynamically using Fuzzy logic based on the traffic
behavior to maintain a high throughput under a variety of load
conditions. The simulation is run for two priority classes of the input
traffic: real time and non-real time classes. Simulation results show
that the proposed AEPD policy improves throughput and fairness
over that using static threshold under the same traffic conditions.
Abstract: With the exponentially increasing demand for
wireless communications the capacity of current cellular systems will
soon become incapable of handling the growing traffic. Since radio
frequencies are diminishing natural resources, there seems to be a
fundamental barrier to further capacity increase. The solution can be
found in smart antenna systems.
Smart or adaptive antenna arrays consist of an array of antenna
elements with signal processing capability, that optimize the
radiation and reception of a desired signal, dynamically. Smart
antennas can place nulls in the direction of interferers via adaptive
updating of weights linked to each antenna element. They thus cancel
out most of the co-channel interference resulting in better quality of
reception and lower dropped calls. Smart antennas can also track the
user within a cell via direction of arrival algorithms. This implies that
they are more advantageous than other antenna systems. This paper
focuses on few issues about the smart antennas in mobile radio
networks.
Abstract: Traffic incident has bad effect on all parts of society
so controlling road networks with enough traffic devices could help
to decrease number of accidents, so using the best method for
optimum site selection of these devices could help to implement good
monitoring system. This paper has considered here important criteria
for optimum site selection of traffic camera based on aggregation
methods such as Bagging and Dempster-Shafer concepts. In the first
step, important criteria such as annual traffic flow, distance from
critical places such as parks that need more traffic controlling were
identified for selection of important road links for traffic camera
installation, Then classification methods such as Artificial neural
network and Decision tree algorithms were employed for
classification of road links based on their importance for camera
installation. Then for improving the result of classifiers aggregation
methods such as Bagging and Dempster-Shafer theories were used.
Abstract: In Secondary Surveillance Radar (SSR) systems, it is
more difficult to locate and recognise aircrafts in the neighbourhood of civil airports since aerial traffic becomes greater. Here, we propose to apply a recent Blind Source Separation (BSS) algorithm based
on Time-Frequency Analysis, in order to separate messages sent by different aircrafts and falling in the same radar beam in reception. The above source separation method involves joint-diagonalization
of a set of smoothed version of spatial Wigner-Ville distributions.
The technique makes use of the difference in the t-f signatures of the nonstationary sources to be separated. Consequently, as the SSR sources emit different messages at different frequencies, the above fitted to this new application. We applied the technique in simulation to separate SSR replies. Results are provided at the end
of the paper.
Abstract: In this paper, a strategy for long-span bridge disaster response was developed, divided into risk analysis, business impact analysis, and emergency response plan. At the risk analysis stage, the critical risk was estimated. The critical risk was “car accident."The critical process by critical-risk classification was assessed at the business impact analysis stage. The critical process was the task related to the road conditions and traffic safety. Based on the results of the precedent analysis, an emergency response plan was established. By making the order of the standard operating procedures clear, an effective plan for dealing with disaster was formulated. Finally, a prototype software was developed based on the research findings. This study laid the foundation of an information-technology-based disaster response guideline and is significant in that it computerized the disaster response plan to improve the plan-s accessibility.
Abstract: For today-s and future wireless communications applications,
more and more data traffic has to be transmitted with
growing speed and quality demands. The analog front-end of any
mobile device has to cope with very hard specifications regardless
which transmission standard has to be supported. State-of-the-art
analog front-end implementations are reaching the limit of technical
feasibility. For that reason, alternative front-end architectures could
support a continuing development of mobile communications e.g.,
six-port-based front-ends [1], [2].
In this article we propose an analog front-end with high intermediate
frequency and which utilizes additive mixing instead
of multiplicative mixing. The system architecture is presented and
several spurious effects as well as their influence on the system
dimensioning are discussed. Furthermore, several issues concerning
the technical feasibility are provided and some simulation results
are discussed which show the principle functionality of the proposed
superposition heterodyne receiver.
Abstract: Lighting is not only important for the safety of traffic,
but also it is very important for the protection of pedestrians.
Improvement on visibility in a long distance, lighting, signing,
reduces considerably the risk of accidents in crosswalks. This paper
evaluates different aspects of crosswalks including signing and
lighting to improve road safety.