Abstract: In this paper, a set of experimental data has been used to assess the influence of abrasive water jet (AWJ) process parameters in cutting 6063-T6 aluminum alloy. The process variables considered here include nozzle diameter, jet traverse rate, jet pressure and abrasive flow rate. The effects of these input parameters are studied on depth of cut (h); one of most important characteristics of AWJ. The Taguchi method and regression modeling are used in order to establish the relationships between input and output parameters. The adequacy of the model is evaluated using analysis of variance (ANOVA) technique. In the next stage, the proposed model is embedded into a Simulated Annealing (SA) algorithm to optimize the AWJ process parameters. The objective is to determine a suitable set of process parameters that can produce a desired depth of cut, considering the ranges of the process parameters. Computational results prove the effectiveness of the proposed model and optimization procedure.
Abstract: The predictability of masonry arch bridges and their
behaviour is widely considered doubtful due to the lack of knowledge
about the conditions of a given masonry arch bridge. The assessment
methods for masonry arch bridges are MEXE, ARCHIE, RING and
Frame Analysis Method. The material properties of the masonry and
fill material are extremely difficult to determine accurately.
Consequently, it is necessary to examine the effect of load dispersal
angle through the fill material, the effect of variations in the stiffness
of the masonry, the tensile strength of the masonry mortar continuum
and the compressive strength of the masonry mortar continuum. It is
also important to understand the effect of fill material on load
dispersal angle to determine their influence on ratings. In this paper a
series of parametric studies, to examine the sensitivity of assessment
ratings to the various sets of input data required by the frame analysis
method, are carried out.
Abstract: This paper studied the synthesis of monoacylglycerol (monolaurin) by glycerolysis of coconut oil and crude glycerol, catalyzed by Carica papaya lipase. Coconut oil obtained from cold pressed extraction method and crude glycerol obtained from the biodiesel plant in Department of Chemistry, Uttaradit Rajabhat University, Thailand which used oils were used as raw materials for biodiesel production through transesterification process catalyzed by sodium hydroxide. The influences of the following variables were studied: (i) type of organic solvent, (ii) molar ratio of substrate, (iii) reaction temperature, (iv) reaction time, (v) lipase dosage, and (vi) initial water activity of enzyme. High yields in monoacylglycerol (58.35%) were obtained with molar ratio of glycerol to oil at 8:1 in ethanol, temperature was controlled at 45oC for 36 hours, the amount of enzyme used was 20 wt% of oil and initial water activity of enzyme at 0.53.
Abstract: Aircraft propulsion systems often use Y-shaped
subsonic diffusing ducts as twin air-intakes to supply the ambient air
into the engine compressor for thrust generation. Due to space
constraint, the diffusers need to be curved, which causes severe flow
non-uniformity at the engine face. The present study attempt to
control flow in a mild-curved Y-duct diffuser using trapezoidalshaped
vortex generators (VG) attached on either both the sidewalls
or top and bottom walls of the diffuser at the inflexion plane. A
commercial computational fluid dynamics (CFD) code is modified
and is used to simulate the effects of SVG in flow of a Y-duct
diffuser. A few experiments are conducted for CFD code validation,
while the rest are done computationally. The best combination of Yduct
diffuser is found with VG-2 arranged in co-rotating sequence
and attached to both the sidewalls, which ensures highest static
pressure recovery, lowest total pressure loss, minimum flow
distortion and less flow separation in Y-duct diffuser. The decrease in
VG height while attached to top and bottom walls further improves
axial flow uniformity at the diffuser outlet by a great margin as
compared to the bare duct.
Abstract: The paper investigates the relationship between the foreign direct investment (FDI) and the corporate governance or transparency by investigating the country-level FDI flows, FDI inward performance, corporate governance and transparency variables. From the regression analysis with Newey-West estimator of 28 country panel data from 1990- 2002, we find strong positive relationships between corporate governance or transparency level of hosting countries and FDI inward performance within hosting countries. A strong positive relationship is found between anti-director rights level or number of analysts of hosting countries and FDI inward performance within hosting countries. Also, we find a positive relationship between the number of analysts of hosting countries and FDI inflows. The empirical results are consistent with stock market liberalizations and corporate governance explanations of reasons for FDI.
Abstract: The purpose of this study is to determine in what
ways elementary education prospective teachers are being informed
about innovations and to explain the role of social influence in the
usage process of a technological innovation in terms of genders. The
study group consisted of 300 prospective teachers, including 234
females and 66 males. Data have been collected by a questionnaire
developed by the researchers. The result of the study showed that,
while prospective teachers are being informed about innovations
most frequently by mass media, they rarely seek to take expert
advice. In addition, analysis of results showed that the social
influence on females were significantly higher than males in usage
process of a technological innovation.
Abstract: This study is a descriptive-normative research. It
attempted to investigate the restaurants’ firm performance in terms of
the customers and restaurant personnel’s degree of satisfaction. A
total of 12 restaurants in Bangkok, Thailand that offer Thai cuisine
were included in this study. It involved 24 stockholders/managers,
120 subordinates and 360 customers. General Managers and
restaurants’ stockholders, 10 staffs, and 30 costumers for each
restaurant were chosen for random sampling. This study found that
respondents are slightly satisfied with their work environment but are
generally satisfied with the accessibility to transportation, to malls,
convenience, safety, recreation, noise-free, and attraction; customers
find the Quality of Food in most Thai Cuisines like services, prices of
food, sales promotion, and capital and length of service satisfactory.
Therefore, both stockholder-related and personnel-related factors
which are influenced by restaurant, personnel, and customer-related
factors are partially accepted whereas; customer-related factors which
are influenced by restaurant, personnel and customer-related factors
are rejected.
Abstract: In the present study, we aimed to design the
intrauterine and extrauterine exposure to 1800 MHz GSM-like RF
radiation and investigate its possible bio-effects on infant female
rabbits. Totally thirty-six New Zealand White female rabbits, onemonth
old, were randomly divided into four groups which are
composed of 9 rabbits; i. Group I [Intrauterine (IU) exposure(-);
Extrauterine (EU) exposure (-)], Group II [IU exposure (-); EU
exposure (+)], Group III [IU exposure(+);EU exposure(-)], Group IV
[IU exposure (+);EU exposure(+)]. The master regulatory enzymes
activities of pentose phosphate pathway (glucose-6-phosphate
dehydrogenase, G-6PD; 6-phosphogluconate dehydrogenase, 6-
PGDH) and glutathione-dependent metabolism (glutathione
peroxidase, GSH-Px; glutathione reductase, GR; glutathione Stransferase,
GST, thioredoxin reductase, TRx) were analyzed in liver
tissues of young female rabbits. Decreased G-6PD, 6-PGD, GSH-Px,
GR activities were found in Group III compared to Group I (p
Abstract: Scaffolds play a key role in tissue engineering and can be produced in many different ways depending on the applications and the materials used. Most researchers used an experimental trialand- error approach into new biomaterials but computer simulation applied to tissue engineering can offer a more exhaustive approach to test and screen out biomaterials. This paper develops the model of scaffolds and Computational Fluid Dynamics that show the value of computer simulations in determining the influence of the geometrical scaffold parameter porosity, pore size and shape on the permeability of scaffolds, magnitude of velocity, drop pressure, shear stress distribution and level and the proper design of the geometry of the scaffold. This creates a need for more advanced studies that include aspects of dynamic conditions of a micro fluid passing through the scaffold were characterized for tissue engineering applications and differentiation of tissues within scaffolds.
Abstract: Zero inflated Strict Arcsine model is a newly developed model which is found to be appropriate in modeling overdispersed count data. In this study, maximum likelihood estimation method is used in estimating the parameters for zero inflated strict arcsine model. Bootstrapping is then employed to compute the confidence intervals for the estimated parameters.
Abstract: Factor analysis was applied to two stages biogas
production from banana stem waste allowing a screening of the
experimental variables second stage temperature (T), organic loading
rates (OLR) and hydraulic retention times (HRT). Biogas production
was found to be strongly influenced by all the above experimental
variables. Results from factorial analysis have shown that all
variables which were HRT, OLR and T have significant effect to
biogas production. Increased in HRT and OLR could increased the
biogas yield. The performance was tested under the conditions of
various T (35oC-60oC), OLR (0.3 g TS/l.d–1.9 gTS/l.d), and HRT (3
d–15 d). Conditions for temperature, OLR and HRT in this study
were based on the best range obtained from literature review.
Abstract: The main objective of this paper is to estimate the cost of road traffic accidents in Egypt. The Human Capital (HC) approach, specifically the Gross-Loss-of-Output methodology, is adopted for estimation. Moreover, cost values obtained by previous national literature are updated using the inflation rates. The results indicate an estimated cost of road traffic accidents in Egypt of approximately 10 billion Egyptian Pounds (about $US 1.8 billion) for the year 2008. In addition, it is expected that this cost will rise in 2009 to 11.8 billion Egyptian Pounds (about $US 2.1 billion).
Abstract: A multiphase harmonic load flow algorithm is developed based on backward/forward sweep to examine the effects of various factors on the neutral to earth voltage (NEV), including unsymmetrical system configuration, load unbalance and harmonic injection. The proposed algorithm composes fundamental frequency and harmonic frequencies power flows. The algorithm and the associated models are tested on IEEE 13 bus system. The magnitude of NEV is investigated under various conditions of the number of grounding rods per feeder lengths, the grounding rods resistance and the grounding resistance of the in feeding source. Additionally, the harmonic injection of nonlinear loads has been considered and its influences on NEV under different conditions are shown.
Abstract: Mixed-traffic (e.g., pedestrians, bicycles, and vehicles)
data at an intersection is one of the essential factors for intersection
design and traffic control. However, some data such as pedestrian
volume cannot be directly collected by common detectors (e.g.
inductive loop, sonar and microwave sensors). In this paper, a video
based detection algorithm is proposed for mixed-traffic data collection
at intersections using surveillance cameras. The algorithm is derived
from Gaussian Mixture Model (GMM), and uses a mergence time
adjustment scheme to improve the traditional algorithm. Real-world
video data were selected to test the algorithm. The results show that
the proposed algorithm has the faster processing speed and more
accuracy than the traditional algorithm. This indicates that the
improved algorithm can be applied to detect mixed-traffic at
signalized intersection, even when conflicts occur.
Abstract: This study examines age and sex patterns of
children-s disability in the Parila union of Rajshahi, Bangladesh. For
this we assumed that (1) prevalence of disability patterns and its
severity in the middle childhood are higher than in the infancy or
latter childhood in the Parila union of Rajshahi, (2) prevalence of
disability patterns and its severity among the boys compared to girls
are higher in the study area of Bangladesh. In order to examine the
assumptions 102 samples, including their mothers were selected
based on snowball process and the respondents were individually
interviewed with semi-structured questionnaire method. The results
of the study suggest that disability patterns and its severity among the
male children were two-fold higher than the female children. In
addition, these patterns of children-s disability and its severity in the
middle childhood were also higher than in the infancy or latter
childhood. Further study should conduct how socio-structural factors
influence age and sex patterns of children-s disability patterns and its
severity in Bangladesh.
Abstract: Understanding how airborne pathogens are
transported through hospital wards is essential for determining the
infection risk to patients and healthcare workers. This study utilizes
Computational Fluid Dynamics (CFD) simulations to explore
possible pathogen transport within a six-bed partitioned Nightingalestyle
hospital ward.
Grid independence of a ward model was addressed using the Grid
Convergence Index (GCI) from solutions obtained using three fullystructured
grids. Pathogens were simulated using source terms in
conjunction with a scalar transport equation and a RANS turbulence
model. Errors were found to be less than 4% in the calculation of air
velocities but an average of 13% was seen in the scalar field.
A parametric study of variations in the pathogen release point
illustrated that its distribution is strongly influenced by the local
velocity field and the degree of air mixing present.
Abstract: Modern retailers such as hypermarket/supermarket
need to be more customer-oriented in order to survive in today-s
competitive business world. As a result, the investigation of
determinant factors of store loyalty becomes important issue for
modern retailing players. This study suggests that consumers- store
loyalty in the modern retailing market (hypermarkets and
supermarkets) is influenced by environmental factors (such as store
image, store personnel). Using a model of stimulus-organismresponse
(S-O-R), this research examines S-R relationship of store
loyalty. S-O-R framework is derived from the existence literature and
tested empirically based on Indonesian consumers- experience. The
stimuli for this study are store image, store personnel, satisfaction
and culture factors. Affect, or the consumers- liking to modern
retailing stores, mediates the chosen environmental factors on
consumer-s store loyalty. The findings showed that store image, store
satisfaction and culture have significant positive relationship to store
loyalty via affect.
Abstract: This paper discusses E-government, in particular the
challenges that face adoption in Saudi Arabia. E-government can be
defined based on an existing set of requirements. In this research we
define E-government as a matrix of stakeholders: governments to
governments, governments to business and governments to citizens,
using information and communications technology to deliver and
consume services. E-government has been implemented for a
considerable time in developed countries. However, E-government
services still face many challenges in their implementation and
general adoption in many countries including Saudi Arabia. It has
been noted that the introduction of E-government is a major
challenge facing the government of Saudi Arabia, due to possible
concerns raised by its citizens. In addition, the literature review and
the discussion identify the influential factors that affect the citizens’
intention to adopt E-government services in Saudi Arabia.
Consequently, these factors have been defined and categorized
followed by an exploratory study to examine the importance of these
factors. Therefore, this research has identified factors that determine
if the citizen will adopt E-government services and thereby aiding
governments in accessing what is required to increase adoption.
Abstract: Nowadays, quick technological changes force companies
to develop innovative products in an increasingly competitive
environment. Therefore, how to enhance the time of new product
development is very important. This design problem often lacks
the exact formula for getting it, and highly depends upon human
designers- past experiences. For these reasons, in this work, a Casebased
reasoning (CBR) system to assist in new product development
is proposed. When a case is recovered from the case base, the system
will take into account not only the attribute-s specific value and
how important it is. It will also take into account if the attribute
has a positive influence over the product development. Hence the
manufacturing time will be improved. This information will be
introduced as a new concept called “adaptability". An application to
this method for hearing instrument new design illustrates the proposed
approach.
Abstract: In this paper, a generalized self-consistent scheme, or “three phase model", is used to set up a micro-mechanics model for rough surface contact with randomly distributed asperities. The dimensionless average real pressure p is obtained as function of the ratio of the real contact area to the apparent contact area, 0 A / A r . Both elastic and plastic materials are considered, and the influence of the plasticity of material on p is discussed. Both two-dimensional and three-dimensional rough surface contact problems are considered.