Abstract: Development of levels of service in municipal context
is a flexible vehicle to assist in performing quality-cost trade-off
analysis for municipal services. This trade-off depends on the
willingness of a community to pay as well as on the condition of the
assets. Community perspective of the performance of an asset from
service point of view may be quite different from the municipality
perspective of the performance of the same asset from condition
point of view. This paper presents a three phased level of service
based methodology for water mains that consists of :1)development
of an Analytical Hierarchy model of level of service 2) development
of Fuzzy Weighted Sum model of water main condition index and 3)
deriving a Fuzzy logic based function that maps level of service to
asset condition index. This mapping will assist asset managers in
quantifying condition improvement requirement to meet service
goals and to make more informed decisions on interventions and
relayed priorities.
Abstract: Attempt was made to improve certain characteristics of bio-oil derived from palm kernel pyrolysis by blending it with diesel fuel and alcohols. Two types of alcohol, ethanol or butanol, was used as cosolvent to stabilize the phase of ternary systems. Phase behaviors and basic fuel properties of palm kernel bio-oildiesel- alcohol systems were investigated in this study. Alcohol types showed a significant influence on the phase characteristics with palm kernel bio-oil-diesel-butanol system giving larger soluble area than that of palm kernel bio-oil-diesel-ethanol system. For fuel properties, blended fuels showed superior properties including lower values of density (~860 kg/m3 at 25°C), viscosity (~4.12 mm2/s at 40°C), carbon residue (1.02-2.53 wt%), ash (0.018-0.034 wt%) and pour point (
Abstract: Combining energy efficiency with renewable energy
sources constitutes a key strategy for a sustainable future. The wind
power sector stands out as a fundamental element for the
achievement of the European renewable objectives and Portugal is no
exception to the increase of the wind energy for the electricity
generation. This work proposes an optimization model for the long
range electricity power planning in a system similar to the
Portuguese one, where the expected impacts of the increasing
installed wind power on the operating performance of thermal power
plants are taken into account. The main results indicate that the
increasing penetration of wind power in the electricity system will
have significant effects on the combined cycle gas power plants
operation and on the theoretically expected cost reduction and
environmental gains. This research demonstrated the need to address
the impact that energy sources with variable output may have, not
only on the short-term operational planning, but especially on the
medium to long range planning activities, in order to meet the
strategic objectives for the energy sector.
Abstract: In this paper, we introduce a robust state feedback controller design using Linear Matrix Inequalities (LMIs) and guaranteed cost approach for Takagi-Sugeno fuzzy systems. The purpose on this work is to establish a systematic method to design controllers for a class of uncertain linear and non linear systems. Our approach utilizes a certain type of fuzzy systems that are based on Takagi-Sugeno (T-S) fuzzy models to approximate nonlinear systems. We use a robust control methodology to design controllers. This method not only guarantees stability, but also minimizes an upper bound on a linear quadratic performance measure. A simulation example is presented to show the effectiveness of this method.
Abstract: In the present study, an attempt was made to examine
the potential of aerobic mixed culture for decolourization of Remazol Black B dye in batch reactors. The effect of pH, temperature, inoculum, initial concentration of dye and initial concentration of
glucose was studied with an aim to determine the optimal conditions
required for maximum decolourization and degradation. The culture
exhibited maximum decolourization ability at pH between 7-8 and at
30°C. A 10% (v/v) inoculum and 1% (w/v) glucose concentration
were found to be the optimum for decolourization. A maximum of
98% decolourization was observed at 25 ppm initial concentration of
dye after 18 hours of incubation period. At higher dye concentration
of 300 ppm, the removal in colour was found to be 75% in 48 hours of incubation period. The results show that the enriched mixed culture from activated sludge has good potential in removal of Remazol Black B dye from wastewater under aerobic conditions.
Abstract: There has been a growing interest in the oxygenation
by plunging water jets in the last few years due to their inherent
advantages, like energy-efficient, low operation cost, etc. Though a
lot of work has been reported on the oxygen-transfer by single
plunging water jets but very few studies have been carried out using
multiple plunging jets. In this paper, volumetric oxygen-transfer
coefficient and oxygen-transfer efficiency has been studied
experimentally for multiple inclined plunging jets (having jet plunge
angle of 60 0 ) in a pool of water for different configurations, in
terms of varying number of jets and jet diameters. This research
suggests that the volumetric oxygen-transfer coefficient and oxygentransfer
efficiency of the multiple inclined plunging jets for air-water
system are significantly higher than those of a single vertical as well
as inclined plunging jet for same flow area and other similar
conditions. The study also reveals that the oxygen-transfer increase
with increase in number of multiple jets under similar conditions,
which will be most advantageous and energy-efficient in practical
situations when large volumes of wastewaters are to be treated. A
relationship between volumetric oxygen-transfer coefficient and jet
parameters is also proposed. The suggested relationship predicts the
volumetric oxygen-transfer coefficient for multiple inclined plunging
jet(s) within a scatter of ±15 percent. The relationship will be quite
useful in scale-up and in deciding optimum configuration of multiple
inclined plunging jet aeration system.
Abstract: Feature-based registration is an effective technique for clinical use, because it can greatly reduce computational costs. However, this technique, which estimates the transformation by using feature points extracted from two images, may cause misalignments. To handle with this limitation, we propose to extract the salient edges and extracted control points (CP) of medical images by using efficiency of multiresolution representation of data nonsubsampled contourlet transform (NSCT) that finds the best feature points. The MR images were first decomposed using the NSCT, and then Edge and CP were extracted from bandpass directional subband of NSCT coefficients and some proposed rules. After edge and CP extraction, mutual information was adopted for the registration of feature points and translation parameters are calculated by using particle swarm optimization (PSO). The experimental results showed that the proposed method produces totally accurate performance for registration medical CT-MR images.
Abstract: This paper presents a possibilistic (fuzzy) model in optimal siting and sizing of Distributed Generation (DG) for loss reduction and improve voltage profile in power distribution system. Multi-objective problem is developed in two phases. In the first one, the set of non-dominated planning solutions is obtained (with respect to the objective functions of fuzzy economic cost, and exposure) using genetic algorithm. In the second phase, one solution of the set of non-dominated solutions is selected as optimal solution, using a suitable max-min approach. This method can be determined operation-mode (PV or PQ) of DG. Because of considering load uncertainty in this paper, it can be obtained realistic results. The whole process of this method has been implemented in the MATLAB7 environment with technical and economic consideration for loss reduction and voltage profile improvement. Through numerical example the validity of the proposed method is verified.
Abstract: The paper deals with results of a project “Interoperability Workplaces to Support Teaching of Security Management in a Computer Network". This project is focused on the perspectives and possibilities of "new approaches" to education, training and crisis communication of rescue teams in the Czech Republic. It means that common technologies considering new perspectives are used to educate selected members of crisis management. The main part concentrates on possibilities of application of new technology and computer-aided tools to education and training of Integrated Rescue System teams.This project uses the COST principle for the creation of specialized centers and for all communication between these workplaces.
Abstract: Studies on gas solid mass transfer using Supercritical fluid CO2 (SC-CO2) in a packed bed of palm kernels was investigated at operating conditions of temperature 50 °C and 70 °C and pressures ranges from 27.6 MPa, 34.5 MPa, 41.4 MPa and 48.3 MPa. The development of mass transfer models requires knowledge of three properties: the diffusion coefficient of the solute, the viscosity and density of the Supercritical fluids (SCF). Matematical model with respect to the dimensionless number of Sherwood (Sh), Schmidt (Sc) and Reynolds (Re) was developed. It was found that the model developed was found to be in good agreement with the experimental data within the system studied.
Abstract: This paper presents the design, development and characterization of contractile water jet thruster (CWJT) for mini underwater robot. Instead of electric motor, this CWJT utilizes the Ionic Polymer Metal Composite (IPMC) as the actuator to generate the water jet. The main focus of this paper is to analyze the conceptual design of the proposed CWJT which would determine the thrust force value, jet flow behavior and actuator’s stress. Those thrust force and jet flow studies were carried out using Matlab/Simscape simulation software. The actuator stress had been analyzed using COSMOS simulation software. The results showed that there was no significant change for jet velocity at variable cross sectional nozzle area. However, a significant change was detected for jet velocity at different nozzle cross sectional area ratio which was up to 37%. The generated thrust force has proportional relation to the nozzle cross sectional area.
Abstract: Although, it is a long time that human know about
the importance of environment in life, but at the last decade of 20
century, the space that was full of hot scientific, collegial and
political were made in environmental challenge, So much that, this
problem not only disarrange the peace and security of life, but also it
has threatened human existence. One of the problems in last years
that are significant for authorities is unsatisfactory achieved results
against of using huge cost for magnificent environmental projects.
This subject leads thinker to this thought that for solving the
environmental problems it is needed new methods include of
sociology, ethics and philosophic, etc. methods apart of technical
affairs. Environment ethics is a new branch of philosophic ethics
discussion that discusses about the ethics relationship between
humans and universe that is around them. By notifying to the above
considered affairs, in today world, necessity of environmental ethics
for environment management is reduplicated. In the following the
article has been focused on environmental ethics role and
environmental management methods and techniques for developing
it.
Abstract: Alpinia galanga is rhizome, generally known as
Greater galangal and is selected for isolation of newer constituents
accountable for various therapeutic activities. Present study is
intended to isolate glycoside from Alpinia galanga rhizomes. Alpinia
galanga methanolic extract was column chromatograph and eluted
with ethyl acetate-methanol (99:1) to isolate compound β-Sitosterol
Diarabinoside. Herein, the isolation and structural elucidation of new
compound is described. Chemical investigation of methanolic extract
of rhizomes of Alpinia galanga furnished a new compound β-
Sitosterol Diarabinoside. The IR, NMR and MASS investigations of
isolated compound confirmed its structure as β-Sitosterol
Diarabinoside, which is isolated for the first time from a medicinal
plant or any synthetic source.
Abstract: Propranolol is worldwide hypertension drug that is active in S-isomer. Patients must use this drug throughout their lives, and this action employsa significant level of expenditure. A simpler synthesis and lower cost can reduce the price for the patient. A sis pathway of S-propranolol starting from protection of (R,S)-propranolol with di-t-butyldicarbonate and then the product is oxidized with pyridiniumchlorochromate. The selective reduction of ketone occurrs with sodiumborohydride in the presence of metal chloride provided S-propranolol.
Abstract: A novel low-cost flight simulator with the development
goals cost effectiveness and high performance has been realized for
meeting the huge pilot training needs of airlines. The simulator
consists of an aircraft dynamics model, a sophisticated designed
low-profile electrical driven motion system with a subsided cabin, a
mixed reality based semi-virtual cockpit system, a control loading
system and some other subsystems. It shows its advantages over
traditional flight simulator by its features achieved with open
architecture, software solutions and low-cost hardware.
Abstract: This paper presents a multi-objective model for addressing two main objectives in designing rural roads networks: minimization of user operation costs and maximization of population covered. As limited budgets often exist, a reasonable trade-off must be obtained in order to account for both cost and social benefits in this type of networks. For a real-world rural road network, the model is solved, where all non-dominated solutions were obtained. Afterwards, an analysis is made on the (possibly) most interesting solutions (the ones providing better trade-offs). This analysis, coupled with the knowledge of the real world scenario (typically provided by decision makers) provides a suitable method for the evaluation of road networks in rural areas of developing countries.
Abstract: As a by-product of its "cyberspace" status, electronic
commerce is global, encompassing a whole range of B2C
relationships which need to be approached with solutions provided at
a local level while remaining viable when applied to global issues.
Today, the European Union seems to be endowed with a reliable
legal framework for consumer protection. A question which remains,
however, is enforcement of this protection. This is probably a matter
of time and awareness from both parties in the B2C relationship.
Business should realize that enhancing trust in the minds of
consumers is more than a question of technology; it is a question of
best practice. Best practice starts with the online service of high
street banks as well as with the existence of a secure, user-friendly
and cost-effective payment system. It also includes the respect of
privacy and the use of smart cards as well as enhancing privacy
technologies and fair information practice. In sum, only by offering
this guarantee of privacy and security will the consumer be assured
that, in cyberspace, his/her interests will be protected in the same
manner as in a traditional commercial environment.
Abstract: Al-Murabahah is an Islamic financing facility used in
asset financing, the profit rate of the contract is determined by
components which are also being used in the conventional banking.
Such are cost of fund, overhead cost, risk premium cost and bank-s
profit margin. At the same time, the profit rate determined by Islamic
banking system also refers to Inter-Bank Offered Rate (LIBOR) in
London as a benchmark. This practice has risen arguments among
Muslim scholars in term of its validity of the contract; whether the
contract maintains the Shariah compliance or not. This paper aims to
explore the view of Shariah towards the above components practiced
by Islamic Banking in determining the profit rate of al-murabahah
asset financing in Malaysia. This is a comparative research which
applied the views of Muslim scholars from all major mazahibs in
Islamic jurisprudence and examined the practices by Islamic banks in
Malaysia for the above components. The study found that the shariah
accepts all the components with conditions. The cost of fund is
accepted as a portion of al-mudarabah-s profit, the overhead cost is
accepted as a cost of product, risk premium cost consist of business
risk and mitigation risk are accepted through the concept of alta-awun
and bank-s profit margin is accepted as a right of bank after
venturing in risky investment.
Abstract: In this paper, the problem of finding the optimal
topological configuration of a deregulated distribution network is
considered. The new features of this paper are proposing a multiobjective
function and its application on deregulated distribution
networks for finding the optimal configuration. The multi-objective
function will be defined for minimizing total Energy Supply Costs
(ESC) and energy losses subject to load flow constraints. The
optimal configuration will be obtained by using Binary Genetic
Algorithm (BGA).The proposed method has been tested to analyze a
sample and a practical distribution networks.
Abstract: This paper describes a combined mathematicalgraphical
approach for optimum tool path planning in order to
improve machining efficiency. A methodology has been used that
stabilizes machining operations by adjusting material removal rate in
pocket milling operations while keeping cutting forces within limits.
This increases the life of cutting tool and reduces the risk of tool
breakage, machining vibration, and chatter. Case studies reveal the
fact that application of this approach could result in a slight increase
of machining time, however, a considerable reduction of tooling cost,
machining vibration, noise and chatter can be achieved in addition to
producing a better surface finish.