Abstract: The photochemical and photo-Fenton oxidation of 1,3-dichloro-2-propanol was performed in a batch reactor, at room temperature, using UV radiation, H2O2 as oxidant, and Fenton-s reagent. The effect of the oxidative agent-s initial concentration was investigated as well as the effect of the initial concentration of Fe(II) by following the target compound degradation, the total organic carbon removal and the chloride ion production. Also, from the kinetic analysis conducted and proposed reaction scheme it was deduced that the addition of Fe(II) significantly increases the production and the further oxidation of the chlorinated intermediates.
Abstract: The aim of this study is to investigate the effect of
perceived social support and stress on the coping capability and level
of depression of foreign and local students in Malaysia. Using
convenience sampling, 200 students from three universities in
Selangor, Malaysia participated in the study. The results of this study
revealed that there was a significant relationship between perceived
social support and coping capability. It is also found that there is a
negative relationship between coping capability and depression.
Further, stress and depression are positively related whereas stress
and coping capability are negatively related. Lastly, there is no
significant difference for the stress level and coping capability
amongst local and foreign students.
Abstract: A new dual-fluid concept was studied that could eventually find application for cold-gas propulsion for small space satellites or other constant flow applications. In basic form, the concept uses two different refrigerant working fluids, each having a different saturation vapor pressure. The higher vapor pressure refrigerant remains in the saturation phase and is used to pressurize the lower saturation vapor pressure fluid (the propellant) which remains in the compressed liquid phase. A demonstration thruster concept based on this principle was designed and built to study its operating characteristics. An automotive-type electronic fuel injector was used to meter and deliver the propellant. Ejected propellant mass and momentum were measured for several combinations of refrigerants and hydrocarbon fluids. The thruster has the advantage of delivering relatively large total impulse at low tank pressure within a small volume.
Abstract: Today, the working areas put forward the administration of change. In order to provide this; it is required from the organizations to be creative. Professional creativity in offices depends on an environment that enables the development of the organization only after the individual or collective exertions within the organization. By providing this environment, the organization will gain efficiency, productivity, and work pleasure. In order to bring up the workforce appropriate to the related expectations, the professional creativity of the office management and secretarial profession candidates should be evaluated, education programs appropriate to this and related directly with the service quality should be prepared and the future of this profession should be directed. The aim of this study is to ensure the attention to improve the prepared education program as well as the creative thoughts and their applications, when carrying out an office management and secretarial training. 144 students took place in this research and a questionnaire of 48 questions was carried out.
Abstract: The human head representations usually are based on
the morphological – structural components of a real model. Over the
time became more and more necessary to achieve full virtual models
that comply very rigorous with the specifications of the human
anatomy. Still, making and using a model perfectly fitted with the
real anatomy is a difficult task, because it requires large hardware
resources and significant times for processing. That is why it is
necessary to choose the best compromise solution, which keeps the
right balance between the details perfection and the resources
consumption, in order to obtain facial animations with real-time
rendering. We will present here the way in which we achieved such a
3D system that we intend to use as a base point in order to create
facial animations with real-time rendering, used in medicine to find
and to identify different types of pathologies.
Abstract: In the present investigation, H13 tool steel has been
deposited on copper alloy substrate using both CO2 and diode laser.
A detailed parametric analysis has been carried out in order to find
out optimum processing zone for coating defect free H13 tool steel
on copper alloy substrate. Followed by parametric optimization, the
microstructure and microhardness of the deposited clads have been
evaluated. SEM micrographs revealed dendritic microstructure in
both clads. However, the microhardness of CO2 laser deposited clad
was much higher compared to diode laser deposited clad.
Abstract: This paper addresses the development of an intelligent vision system for human-robot interaction. The two novel contributions of this paper are 1) Detection of human faces and 2) Localizing the eye. The method is based on visual attributes of human skin colors and geometrical analysis of face skeleton. This paper introduces a spatial domain filtering method named ?Fuzzily skewed filter' which incorporates Fuzzy rules for deciding the gray level of pixels in the image in their neighborhoods and takes advantages of both the median and averaging filters. The effectiveness of the method has been justified over implementing the eye tracking commands to an entertainment robot, named ''AIBO''.
Abstract: This paper aims to initiate an analytical account of the
issues of compliance with economy condition for incentive pay
system application in an enterprise. Economy is considered one of the
conditions for effective incentive pay system application another
condition being the achievement of desired efficiency level of the
incentive pay system application. Bonus pay system is discussed as
an example.
Abstract: Perceptions of quality from both designers and users
perspective have now stretched beyond the traditional usability,
incorporating abstract and subjective concepts. This has led to a shift
in human computer interaction research communities- focus; a shift
that focuses on achieving user experience (UX) by not only fulfilling
conventional usability needs but also those that go beyond them. The
term UX, although widely spread and given significant importance,
lacks consensus in its unified definition. In this paper, we survey
various UX definitions and modeling frameworks and examine them
as the foundation for proposing a UX evolution lifecycle framework
for understanding UX in detail. In the proposed framework we identify
the building blocks of UX and discuss how UX evolves in various
phases. The framework can be used as a tool to understand experience
requirements and evaluate them, resulting in better UX design and
hence improved user satisfaction.
Abstract: Covering-based rough sets is an extension of rough
sets and it is based on a covering instead of a partition of the
universe. Therefore it is more powerful in describing some practical
problems than rough sets. However, by extending the rough sets,
covering-based rough sets can increase the roughness of each model
in recognizing objects. How to obtain better approximations from
the models of a covering-based rough sets is an important issue.
In this paper, two concepts, determinate elements and indeterminate
elements in a universe, are proposed and given precise definitions
respectively. This research makes a reasonable refinement of the
covering-element from a new viewpoint. And the refinement may
generate better approximations of covering-based rough sets models.
To prove the theory above, it is applied to eight major coveringbased
rough sets models which are adapted from other literature.
The result is, in all these models, the lower approximation increases
effectively. Correspondingly, in all models, the upper approximation
decreases with exceptions of two models in some special situations.
Therefore, the roughness of recognizing objects is reduced. This
research provides a new approach to the study and application of
covering-based rough sets.
Abstract: In this work, are discussed two formulations of the boundary element method - BEM to perform linear bending analysis of plates reinforced by beams. Both formulations are based on the Kirchhoff's hypothesis and they are obtained from the reciprocity theorem applied to zoned plates, where each sub-region defines a beam or a slab. In the first model the problem values are defined along the interfaces and the external boundary. Then, in order to reduce the number of degrees of freedom kinematics hypothesis are assumed along the beam cross section, leading to a second formulation where the collocation points are defined along the beam skeleton, instead of being placed on interfaces. On these formulations no approximation of the generalized forces along the interface is required. Moreover, compatibility and equilibrium conditions along the interface are automatically imposed by the integral equation. Thus, these formulations require less approximation and the total number of the degree s of freedom is reduced. In the numerical examples are discussed the differences between these two BEM formulations, comparing as well the results to a well-known finite element code.
Abstract: Blind signatures enable users to obtain valid signatures for a message without revealing its content to the signer. This paper presents a new blind signature scheme, i.e. identity-based blind signature scheme with message recovery. Due to the message recovery property, the new scheme requires less bandwidth than the identitybased blind signatures with similar constructions. The scheme is based on modified Weil/Tate pairings over elliptic curves, and thus requires smaller key sizes for the same level of security compared to previous approaches not utilizing bilinear pairings. Security and efficiency analysis for the scheme is provided in this paper.
Abstract: In the proposed method for Web page-ranking, a
novel theoretic model is introduced and tested by examples of order
relationships among IP addresses. Ranking is induced using a
convexity feature, which is learned according to these examples
using a self-organizing procedure. We consider the problem of selforganizing
learning from IP data to be represented by a semi-random
convex polygon procedure, in which the vertices correspond to IP
addresses. Based on recent developments in our regularization
theory for convex polygons and corresponding Euclidean distance
based methods for classification, we develop an algorithmic
framework for learning ranking functions based on a Computational
Geometric Theory. We show that our algorithm is generic, and
present experimental results explaining the potential of our approach.
In addition, we explain the generality of our approach by showing its
possible use as a visualization tool for data obtained from diverse
domains, such as Public Administration and Education.
Abstract: With the intention of screening for heavy metal
tolerance, a number of bacteria were isolated and characterized from
a pristine soil. Two Gram positive isolates were identified as
Paenibacillus sp. and Bacillus thuringeinsis. Tolerance of Cd2+, Cu2+
and Zn2+ by these bacteria was studied and found that both bacteria
were highly sensitive to Cu2+ compared to other two metals. Both
bacteria showed the same pattern of metal tolerance in the order Zn+
> Cd2+ > Cu2+. When the metal tolerance in both bacteria was
compared, Paenibacillus sp. showed the highest sensitivity to Cu2+
where as B. thuringiensis showed highest sensitivity to Cd2+ and Zn2+
.These findings revealed the potential of Paenibacillus sp. in
developing a biosensor to detect Cu2+ in environmental samples.
Abstract: Photoselective plastic films with thermic properties
are now available so that greenhouses clad with such plastics exhibit
a higher degree of “Greenhouse Effect” with a consequent increase in
night time temperature. In this study, we investigate the potential
benefits of a range of thermic plastic films used as greenhouse cover
materials on the vegetative and reproductive growth and development
of Iceberg lettuce (Lactuca sativa L). Transplants were grown under
thermic films and destructively harvested 4, 5, and 6 weeks after
transplanting. Thermic films can increase night temperatures up to 2
⁰C reducing the wide fluctuation in greenhouse temperature during
winter compared to the standard commercial film and consequently
increased the yield (leaf number, fresh weight, and dry weight) of
lettuce plants. Lettuce plants grown under Clear film respond to cold
stress by the accumulation of secondary products (phenolics, and
flavonoids).
Abstract: This paper investigates the effect of International
Financial Reporting Standards (IFRS) adoption on the frequency of
earnings managements towards small positive profits. We focus on
two emerging markets IFRS adopters: South Africa and Turkey.
We tested our logistic regression using appropriate panelestimation
techniques over a sample of 330 South African and 210
Turkish firm-year observations over the period 2002-2008. Our
results document that mandatory adoption of IFRS is not associated
with a reduction in earnings management towards small positive
profits in emerging markets. These results contradict most of the
previous findings of the studies conducted in developed countries.
Based on the legal system factor, we compare the intensity of
earnings management between a code law country (Turkey) and a
common law country (South Africa) over the pre and post-adoption
periods. Our findings show that the frequency of such earnings
management practice increases significantly for the code law
country.
Abstract: Little research has examined working memory
capacity (WMC) in signed language interpreters and deaf signers.
This paper presents the findings of a study that investigated WMC in
professional Australian Sign Language (Auslan)/English interpreters
and deaf signers. Thirty-one professional Auslan/English interpreters
(14 hearing native signers and 17 hearing non-native signers)
completed an English listening span task and then an Auslan working
memory span task, which tested their English WMC and their Auslan
WMC, respectively. Moreover, 26 deaf signers (6 deaf native signers
and 20 deaf non-native signers) completed the Auslan working
memory span task. The results revealed a non-significant difference
between the hearing native signers and the hearing non-native signers
in their English WMC, and a non-significant difference between the
hearing native signers and the hearing non-native signers in their
Auslan WMC. Moreover, the results yielded a non-significant
difference between the hearing native signers- English WMC and
their Auslan WMC, and a non-significant difference between the
hearing non-native signers- English WMC and their Auslan WMC.
Furthermore, a non-significant difference was found between the deaf
native signers and the deaf non-native signers in their Auslan WMC.
Abstract: The purpose of this paper is to study Database Models
to use them efficiently in E-commerce websites. In this paper we are
going to find a method which can save and retrieve information in Ecommerce
websites. Thus, semantic web applications can work with,
and we are also going to study different technologies of E-commerce
databases and we know that one of the most important deficits in
semantic web is the shortage of semantic data, since most of the
information is still stored in relational databases, we present an
approach to map legacy data stored in relational databases into the
Semantic Web using virtually any modern RDF query language, as
long as it is closed within RDF. To achieve this goal we study XML
structures for relational data bases of old websites and eventually we
will come up one level over XML and look for a map from relational
model (RDM) to RDF. Noting that a large number of semantic webs
get advantage of relational model, opening the ways which can be
converted to XML and RDF in modern systems (semantic web) is
important.
Abstract: A large amount of valuable information is available in
plain text clinical reports. New techniques and technologies are
applied to extract information from these reports. In this study, we
developed a domain based software system to transform 600
Otorhinolaryngology discharge notes to a structured form for
extracting clinical data from the discharge notes. In order to decrease
the system process time discharge notes were transformed into a data
table after preprocessing. Several word lists were constituted to
identify common section in the discharge notes, including patient
history, age, problems, and diagnosis etc. N-gram method was used
for discovering terms co-Occurrences within each section. Using this
method a dataset of concept candidates has been generated for the
validation step, and then Predictive Apriori algorithm for Association
Rule Mining (ARM) was applied to validate candidate concepts.
Abstract: Sweet cherries (Prunus avium L.) contain various
phenolic compounds which contribute to total antioxidant activity.
Total polyphenols, tannins, flavonoids and anthocyanins, and
antioxidant capacity in a fruits of a number of selected sweet cherry
genotypes were investigated. Total polyphenols content ranged from
4.12 to 8.34 mg gallic acid equivantents/g dry fruit weight and total
tannins content ranged from 0.19 to 1.95 mg gallic acid equivalent/g
dry fruit weight. Total flavonoids were within the range 0.42-1.56 mg
of rutin equivalents/g dry fruit weight and total anthocyanins content
were between 0.35 and 0.69 mg cyanidin 3-glucoside equivalent/ g
dry fruit weight. Although sweet cherry fruits are a significant source
of different phenolic compounds, antioxidant activity of sweet
cherries is not related only with the total polyphenolics, flavonoids or
anthocyanins.