Abstract: In this paper, the difference between the Alternating
Direction Method (ADM) and the Non-Splitting Method (NSM) is
investigated, while both methods applied to the simulations for 2-D
multimaterial radiation diffusion issues. Although the ADM have the
same accuracy orders with the NSM on the uniform meshes, the
accuracy of ADM will decrease on the distorted meshes or the
boundary of domain. Numerical experiments are carried out to
confirm the theoretical predication.
Abstract: Because of architectural condition and structure application, sometimes mass source and stiffness source are not coincidence, and the structure is irregular. The structure is also might be asymmetric as an asymmetric bracing in plan which leads to unbalance distribution of stiffness or because of unbalance distribution of the mass. Both condition lead to eccentricity and torsion in the structure. The deficiency of ordinary code to evaluate the performance of steel structures against earthquake has been caused designing based on performance level or capacity spectrum be used. By using the mentioned methods it is possible to design a structure that its behavior against different earthquakes be predictive. In this article 5- story buildings with different percentage of asymmetric which is because of stiffness changes and kind of bracing (x and chevron bracing) have been designed. The static and dynamic nonlinear analysis under three acceleration recording has been done. Finally performance level of the structure has been evaluated.
Abstract: The present report describes the characteristics of
damages and behavior of reinforced concrete buildings during the
tsunami action. The discussion is based on the field damage survey in
selected cities located on the coast of the zone affected by the Great
East Japan Earthquake on March 11, 2011. This earthquake is the most
powerful know earthquake that has hit Japan with a magnitude 9.0 and
with epicenter located at 129 km of Sendai city (off the coast). The
earthquake triggered a destructive tsunami with run up height of up to
40 meters that mainly affect cities located on the Pacific Ocean coast of
the Tohoku region (north-east region of Japan). Reinforced concrete
buildings in general resist the tsunami without collapse however the
non-structural elements like panels and ceilings were severely
damaged. The analysis of damages has permitted to understand the
behavior of RC buildings under tsunami attack, and has also permitted
to establish recommendations for their use to take refuge from tsunami
in places where natural topography makes impossible to reach hilltops
or other safer places.
Abstract: The increasing divorce and fertility rates outside of marriage, the changing values in the last decades have led to a high prevalence of single parent families. Currently, worldwide, singleparent families represent about a quarter of all families. Recent changes occurring in the structure of single-parent families and also the multitude of factors that influence the quality of life of these families require the development of new research tools in order to provide foundations for social policies addressed to this type of family. The purpose of this paper is to present an analysis concerning the quality of life for single parent families in Romania, based on data collected through a research methodology developed by the authors within a scientific research project funded by a national grant called Partnerships in priority areas.
Abstract: This paper presents the experimental results on
ageing deterioration of silicone rubber outdoor polymer insulator
under salt water dip wheel test based on IEC 62217. In order to comparison effect of chemical contents, silicone rubber outdoor
polymer insulators having same configuration and leakage distant
from two manufactures were tested together continuously 30,000 test cycles. Many discharge activities were observed in during the test.
After 30,000 test cycles, in spite of same configuration, differences in
degree of surface aging were observed. Physical analysis such as
decreasing in hydrophobicity and increasing in hardness
measurement were measured on two-type tested specimen surface in order to confirm degree of surface ageing. Furthermore, chemical
analysis by ATR-FTIR to diagnose the chemical change of tested
specimen surface was conducted to confirm the physical analysis results.
Abstract: Recently many research has been conducted to
retrieve pertinent parameters and adequate models for automatic
music genre classification. In this paper, two measures based upon
information theory concepts are investigated for mapping the features
space to decision space. A Gaussian Mixture Model (GMM) is used
as a baseline and reference system. Various strategies are proposed
for training and testing sessions with matched or mismatched
conditions, long training and long testing, long training and short
testing. For all experiments, the file sections used for testing are
never been used during training. With matched conditions all
examined measures yield the best and similar scores (almost 100%).
With mismatched conditions, the proposed measures yield better
scores than the GMM baseline system, especially for the short testing
case. It is also observed that the average discrimination information
measure is most appropriate for music category classifications and on
the other hand the divergence measure is more suitable for music
subcategory classifications.
Abstract: Numerical study is performed to investigate the
temperature distribution in an annular diffuser fitted with helical tape
hub. Different pitches (Y = 20 mm, and Y = 30 mm) for the helical
tape are studied with different heights (H = 20 mm, 22 mm, and 24
mm) to be compared. The geometry of the annular diffuser and the
inlet condition for both hub arrangements are kept constant. The
result obtains that using helical tape insert with different pitches and
different heights will force the temperature to distribute in a helical
direction; however the use of helical tape hub with height (H = 22
mm) for both pitches enhance the temperature distribution in a good
manner.
Abstract: The scroll pump belongs to the category of positive
displacement pump can be used for continuous pumping of gases at
low pressure apart from general vacuum application. The shape of
volume occupied by the gas moves and deforms continuously as the
spiral orbits. To capture flow features in such domain where mesh
deformation varies with time in a complicated manner, mesh less
solver was found to be very useful. Least Squares Kinetic Upwind
Method (LSKUM) is a kinetic theory based mesh free Euler solver
working on arbitrary distribution of points. Here upwind is enforced
in molecular level based on kinetic flux vector splitting scheme
(KFVS). In the present study we extended the LSKUM to moving
node viscous flow application. This new code LSKUM-NS-MN for
moving node viscous flow is validated for standard airfoil pitching
test case. Simulation performed for flow through scroll pump using
LSKUM-NS-MN code agrees well with the experimental pumping
speed data.
Abstract: The main objective of the present paper is to derive an easy numerical technique for the analysis of the free vibration through the stepped regions of plates. Based on the utilities of the step by step integration initial values IV and Finite differences FD methods, the present improved Initial Value Finite Differences (IVFD) technique is achieved. The first initial conditions are formulated in convenient forms for the step by step integrations while the upper and lower edge conditions are expressed in finite difference modes. Also compatibility conditions are created due to the sudden variation of plate thickness. The present method (IVFD) is applied to solve the fourth order partial differential equation of motion for stepped plate across two different panels under the sudden step compatibility in addition to different types of end conditions. The obtained results are examined and the validity of the present method is proved showing excellent efficiency and rapid convergence.
Abstract: Tritium activity concentration in Danube river water
in Serbia has been determinate using a liquid scintillation counter
Quantulus 1220. During December 2010, water samples were taken
along the entire course of Danube through Serbia, from Hungarian-
Serbian to Romanian-Serbian border. This investigation is very
important because of the nearness of nuclear reactor Paks in
Hungary. Sample preparation was performed by standard test method
using Optiphase HiSafe 3 scintillation cocktail. We used a rapid
method for the preparation of environmental samples, without
electrolytic enrichment.
Abstract: Microbial contamination, most of which are fecal born in drinking water and food industry is a serious threat to humans. Escherichia coli is one of the most common and prevalent among them. We have developed a sensor for rapid and an early detection of contaminants, taking E.coli as a threat indicator organism. The sensor is based on co-polymerizations of aniline and formaldehyde in form of thin film over glass surface using the vacuum deposition technique. The particular doping combination of thin film with Fe-Al and Fe-Cu in different concentrations changes its non conducting properties to p- type semi conductor. This property is exploited to detect the different contaminants, believed to have the different surface charge. It was found through experiments that different microbes at same OD (0.600 at 600 nm) have different conductivity in solution. Also the doping concentration is found to be specific for attracting microbes on the basis of surface charge. This is a simple, cost effective and quick detection method which not only decreases the measurement time but also gives early warnings for highly contaminated samples.
Abstract: 15 strains of oil-destructing microorganisms were
isolated from oil polluted soil of Western Kazakhstan. Strains 2-A
and 41-3 with the highest oil-destructing activities were chosen from
them. It was shown that these strains oxidized n-alkanes very well,
but isoalkanes, isoparaffin, cycloparaffin and heavy aromatic
compounds were destructed very slowly. These both strains were
tested as preparations for bioremediation of oil-polluted soil in model
and field experiments. The degree of utilizing of soil oil by this
preparation was 79-84 % in field experiments.
Abstract: Modeling the behavior of the dialogue management in
the design of a spoken dialogue system using statistical methodologies
is currently a growing research area. This paper presents a work
on developing an adaptive learning approach to optimize dialogue
strategy. At the core of our system is a method formalizing dialogue
management as a sequential decision making under uncertainty whose
underlying probabilistic structure has a Markov Chain. Researchers
have mostly focused on model-free algorithms for automating the
design of dialogue management using machine learning techniques
such as reinforcement learning. But in model-free algorithms there
exist a dilemma in engaging the type of exploration versus exploitation.
Hence we present a model-based online policy learning
algorithm using interconnected learning automata for optimizing
dialogue strategy. The proposed algorithm is capable of deriving
an optimal policy that prescribes what action should be taken in
various states of conversation so as to maximize the expected total
reward to attain the goal and incorporates good exploration and
exploitation in its updates to improve the naturalness of humancomputer
interaction. We test the proposed approach using the most
sophisticated evaluation framework PARADISE for accessing to the
railway information system.
Abstract: On existing online shopping on the web, SSL and
password are usually used to achieve the secure trades. SSL shields
communication from the third party who is not related with the trade,
and indicates that the trader's web site is authenticated by one of the
certification authority. Password certifies a customer as the same
person who has visited the trader's web site before, and protects the
customer's privacy such as what the customer has bought on the site.
However, there is no forensics for the trades in those cased above.
With existing methods, no one can prove what is ordered by
customers, how many products are ordered and even whether
customers have ordered or not. The reason is that the third party has to
guess what were traded with logs that are held by traders and by
customers. The logs can easily be created, deleted and forged since
they are electronically stored. To enhance security with digital
forensics for electronic commerce on the web, I indicate a secure
method with cellular phones.
Abstract: Considering the serious health hazards of air pollutants from automobiles, the present study was aimed to estimate the genotoxic/tumor inducing potential of three soil samples collected from junctions of Bus stand (BS), Crystal (CT) and Railway station (RS) of Amritsar, Punjab (India) using Allium cepa root chromosomal aberration assay (AlRCAA) and potato disc tumor assay (PDTA). The genotoxic potential in AlRCAA was 41.27% and 41.26% for BS; 37.89% and 43.38% for RS and 33.76% and 37.83% for CT during in situ and root dip treatments, respectively. The maximum number of tumors were induced in RS sample (64) followed by BS (21) and CT (9) during PDTA. The physicochemical parameters of soil sample were also studied and the concentration of lead was found to be 95.21 mg/Kg in RS, 35.30 mg/Kg in BS and 24.59 mg/Kg in CT samples.
Abstract: For today-s and future wireless communications applications,
more and more data traffic has to be transmitted with
growing speed and quality demands. The analog front-end of any
mobile device has to cope with very hard specifications regardless
which transmission standard has to be supported. State-of-the-art
analog front-end implementations are reaching the limit of technical
feasibility. For that reason, alternative front-end architectures could
support a continuing development of mobile communications e.g.,
six-port-based front-ends [1], [2].
In this article we propose an analog front-end with high intermediate
frequency and which utilizes additive mixing instead
of multiplicative mixing. The system architecture is presented and
several spurious effects as well as their influence on the system
dimensioning are discussed. Furthermore, several issues concerning
the technical feasibility are provided and some simulation results
are discussed which show the principle functionality of the proposed
superposition heterodyne receiver.
Abstract: This paper describes interconnection between
technical and economical making decision. The reason of this dealing
could be different: poor technical condition, change of substation
(electrical network) regime, power transformer owner budget deficit
and increasing of tariff on electricity. Establishing of recommended
practice as well as to give general advice and guidance in economical
sector, testing, diagnostic power transformers to establish its
conditions, identify problems and provide potential remedies.
Abstract: The VoIP networks as alternative method to traditional PSTN system has been implemented in a wide variety of structures
with multiple protocols, codecs, software and hardware–based
distributions. The use of cryptographic techniques let the users to have a secure communication, but the calculate throughput as well as the QoS parameters are affected according to the used algorithm. This
paper analyzes the VoIP throughput and the QoS parameters with
different commercial encryption methods. The measurement–based
approach uses lab scenarios to simulate LAN and WAN
environments. Security mechanisms such as TLS, SIAX2, SRTP,
IPSEC and ZRTP are analyzed with μ-LAW and GSM codecs.
Abstract: (Bi0.5Na0.5)TiO3 doped with 8 mol % BaTiO3 powder
(BNT-BT0.08), prepared by sol-gel method was compacted and
sintered by Spark Plasma Sintering (SPS) process. The influence of
SPS temperature on the densification of BNT-BT0.08 ceramic was
investigated. Starting from sol-gel nanopowder of BNT-BT
containing 8 mol % BaTiO3 with an average particles size of about
30 nm, were obtained ceramics with density around 98 % of the
theoretical density value when the SPS temperature used was about
850 °C. The average grain size of the resulting ceramics was 80 nm.
The BNT-BT0.08 ceramic sample obtained by SPS method has shown
good electric properties at various frequencies.
Abstract: The use of Quantum dots is a promising emerging
Technology for implementing digital system at the nano level. It is
effecient for attractive features such as faster speed , smaller size and
low power consumption than transistor technology. In this paper,
various Combinational and sequential logical structures - HALF
ADDER, SR Latch and Flip-Flop, D Flip-Flop preceding NAND,
NOR, XOR,XNOR are discussed based on QCA design, with
comparatively less number of cells and area. By applying these
layouts, the hardware requirements for a QCA design can be reduced.
These structures are designed and simulated using QCA Designer
Tool. By taking full advantage of the unique features of this
technology, we are able to create complete circuits on a single layer
of QCA. Such Devices are expected to function with ultra low
power Consumption and very high speeds.