Abstract: Due to the drastic increase of the wind turbines installed capacity; the grid codes are increasing the restrictions aiming to treat the wind turbines like other conventional sources sooner. In this paper, an intensive review has been presented for different techniques used to add low voltage ride through capability to Doubly Fed Induction Generator (DFIG) wind turbine. A system model with 1.5 MW DFIG wind turbine is constructed and simulated using MATLAB/SIMULINK to explore the effectiveness of the reviewed techniques.
Abstract: This paper investigates the activity of the rectus
femoris (RF) and biceps femoris (BF) in healthy subjects during salat
(prostration) and specific exercise (squat exercise) using
electromyography (EMG). A group of undergraduates aged between
19 to 25 years voluntarily participated in this study. The myoelectric
activity of the muscles were recorded and analyzed. The finding
indicated that there were contractions of the muscles during the salat
and exercise with almost same EMG’s level. From the result,
Wilcoxon’s Rank Sum test showed significant difference between
prostration and squat exercise (p
Abstract: The problem of controlling a two link robotic manipulator, consisting of a rotating and a prismatic links, is addressed. The actuations of both links are assumed to have unknown dead zone nonlinearities and friction torques modeled by LuGre friction model. Because of the existence of the unknown dead zone and friction torque at the actuations, unknown parameters and unmeasured states would appear to be part of the overall system dynamics that need for estimation. Unmeasured states observer, unknown parameters estimators, and robust adaptive control laws have been derived such that closed loop global stability is achieved. Simulation results have been performed to show the efficacy of the suggested approach.
Abstract: This paper presents a new stable robust adaptive controller and observer design for a class of nonlinear systems that contain i. Coupling of unmeasured states and unknown parameters ii. Unknown dead zone at the system actuator. The system is firstly cast into a modified form in which the observer and parameter estimation become feasible. Then a stable robust adaptive controller, state observer, parameter update laws are derived that would provide global adaptive system stability and desirable performance. To validate the approach, simulation was performed to a single-link mechanical system with a dynamic friction model and unknown dead zone exists at the system actuation. Then a comparison is presented with the results when there is no dead zone at the system actuation.
Abstract: Hydrogen is regarded to play an important role in
future energy systems because it can be produced from abundant
resources and its combustion only generates water. The disposal of
waste tyres is a major problem in environmental management
throughout the world. The use of waste materials as a source of
hydrogen is particularly of interest in that it would also solve a waste
treatment problem. There is much interest in the use of alternative
feedstocks for the production of hydrogen since more than 95% of
current production is from fossil fuels. The pyrolysis of waste tyres
for the production of liquid fuels, activated carbons and gases has
been extensively researched. However, combining pyrolysis with
gasification is a novel process that can gasify the gaseous products
from pyrolysis. In this paper, an experimental investigation into the
production of hydrogen and other gases from the bench scale
pyrolysis-gasification of tyres has been investigated. Experiments
were carried using a two stage system consisting of pyrolysis of the
waste tyres followed by catalytic steam gasification of the evolved
gases and vapours in a second reactor. Experiments were conducted
at a pyrolysis temperature of 500 °C using Ni/Al2O3 as a catalyst. The
results showed that there was a dramatic increase in gas yield and the
potential H2 production when the gasification temperature was
increased from 600 to 900 oC. Overall, the process showed that high
yields of hydrogen can be produced from waste tyres.