Abstract: Based on a theoretical erbium-doped fiber amplifier
(EDFA) model, we have proposed an application of disturbance
observer(DOB) with proportional/integral/differential(PID) controller
to EDFA for minimizing gain-transient time of wavelength
-division-multiplexing (WDM) multi channels in optical amplifier in
channel add/drop networks. We have dramatically reduced the
gain-transient time to less than 30μsec by applying DOB with PID
controller to the control of amplifier gain. The proposed DOB-based
gain control algorithm for EDFA was implemented as a digital control
system using TI's DSP(TMS320C28346) chip and experimental
results of the system verify the excellent performance of the proposed
gain control methodology.
Abstract: The spectral action balance equation is an equation that
used to simulate short-crested wind-generated waves in shallow water
areas such as coastal regions and inland waters. This equation consists
of two spatial dimensions, wave direction, and wave frequency which
can be solved by finite difference method. When this equation with
dominating propagation velocity terms are discretized using central
differences, stability problems occur when the grid spacing is chosen
too coarse. In this paper, we introduce the splitting modified donorcell
scheme for avoiding stability problems and prove that it is
consistent to the modified donor-cell scheme with same accuracy. The
splitting modified donor-cell scheme was adopted to split the wave
spectral action balance equation into four one-dimensional problems,
which for each small problem obtains the independently tridiagonal
linear systems. For each smaller system can be solved by direct or
iterative methods at the same time which is very fast when performed
by a multi-cores computer.
Abstract: Computational fluid dynamics (CFD) simulations
carried out in this paper show that spacer orientation has a major
influence on temperature patterns and on the heat transfer rates. The
local heat flux values significantly vary from high to very low values
at each filament when spacer touches the membrane surface. The
heat flux profile is more uniform when spacer filaments are not in
contact with the membrane thus making this arrangement more
beneficial. The temperature polarization is also found to be less in
this case when compared to the empty channel.
Abstract: In this paper, we present a framework to determine Haar solutions of Bratu-type equations that are widely applicable in fuel ignition of the combustion theory and heat transfer. The method is proposed by applying Haar series for the highest derivatives and integrate the series. Several examples are given to confirm the efficiency and the accuracy of the proposed algorithm. The results show that the proposed way is quite reasonable when compared to exact solution.
Abstract: The state of melt viscosity in injection process is significantly influenced by the setting parameters due to that the shear rate of injection process is higher than other processes. How to determine plastic melt viscosity during injection process is important to understand the influence of setting parameters on the melt viscosity. An apparatus named as pressure sensor bushing (PSB) module that is used to evaluate the melt viscosity during injection process is developed in this work. The formulations to coupling melt viscosity with fill time and injection pressure are derived and then the melt viscosity is determined. A test mold is prepared to evaluate the accuracy on viscosity calculations between the PSB module and the conventional approaches. The influence of melt viscosity on the tensile strength of molded part is proposed to study the consistency of injection quality.
Abstract: Highly ordered arrays of TiO2 nanotubes (TiNTs) were grown vertically on Ti foil by electrochemical anodization. We controlled the lengths of these TiNTs from 2.4 to 26.8 ¶üÇóμm while varying the water contents (1, 3, and 6 wt%) of the electrolyte in ethylene glycol in the presence of 0.5 wt% NH4F with anodization for various applied voltages (20–80 V), periods (10–240 min) and temperatures (10–30 oC). For vertically aligned TiNT arrays, not only the increase in their tube lengths, but also their geometric (wall thickness and surface roughness) and crystalline structure lead to a significant influence on photocatalytic activity. The length optimization for methylene blue (MB) photodegradation was 18 μm. Further extending the TiNT length yielded lower photocatalytic activity presumably related to the limited MB diffusion and light-penetration depth into the TiNT arrays. The results indicated that a maximum MB photodegradation rate was obtained for the discrete anatase TiO2 nanotubes with thick and rough walls.
Abstract: To successfully provide a fast FIR filter with FTT algorithms, overlapped-save algorithms can be used to lower the computational complexity and achieve the desired real-time processing. As the length of the input block increases in order to improve the efficiency, a larger volume of zero padding will greatly increase the computation length of the FFT. In this paper, we use the overlapped block digital filtering to construct a parallel structure. As long as the down-sampling (or up-sampling) factor is an exact multiple lengths of the impulse response of a FIR filter, we can process the input block by using a parallel structure and thus achieve a low-complex fast FIR filter with overlapped-save algorithms. With a long filter length, the performance and the throughput of the digital filtering system will also be greatly enhanced.
Abstract: Ant colony based routing algorithms are known to
grantee the packet delivery, but they suffer from the huge overhead
of control messages which are needed to discover the route. In this
paper we utilize the network nodes positions to group the nodes
in connected clusters. We use clusters-heads only on forwarding
the route discovery control messages. Our simulations proved that
the new algorithm has decreased the overhead dramatically without
affecting the delivery rate.
Abstract: The Elliptic Curve Digital Signature Algorithm
(ECDSA) is the elliptic curve analogue of DSA, where it is a digital
signature scheme designed to provide a digital signature based on a
secret number known only to the signer and also on the actual
message being signed. These digital signatures are considered the
digital counterparts to handwritten signatures, and are the basis for
validating the authenticity of a connection. The security of these
schemes results from the infeasibility to compute the signature
without the private key. In this paper we introduce a proposed to
development the original ECDSA with more complexity.
Abstract: Sample of CsAg2I3 was prepared by solid state reaction. Then, microstructure parameters of this sample have been determined using wide angle X-ray scattering WAXS method. As well as, Cell parameters of crystal structure have been refined using CHEKCELL program. This analysis states that the lattice intrinsic strainof the sample is so small and the crystal size is on the order of 559Å.
Abstract: The fundamental objective of the university is to
genuinely provide a higher education to mankind and society. Higher
education institutions earn billions of dollars in research funds, granted
by national government or related institutions, which literally came
from taxpayers. Everyday universities consume those grants; in return,
provide society with a human resource and research developments.
However, not all taxpayers have their major concerns on those
researches, other than that they are more curiously to see the project
being build tangibly and evidently to certify what they pay for. This
paper introduces the concept of University – Community Business
Continuity Management for Disaster – Resilient City, which modified
the concept of Business Continuity Management (BCM) toward
university community to create advancing collaboration leading to the
disaster – resilient community and city. This paper focuses on
describing in details the backgrounds and principles of the concept and
discussing the advantages and limitations of the concept.
Abstract: Major social changes in the last century had significant impact on the Kazakh literature. Participants of the World War II, writers and poets imprisoned during the war, formed the Kazakh literature in emigration within the framework of 'Turkistan Legion'. This was a topic which remained closed until Kazakhstan gained its independence, though even after the independence, there were few research works done about the literature in emigration. The article studies the formation of the Kazakh literature in emigration, its prominent figures, its artistic heritage, and notes of emigration in works of poets and writers.
Abstract: In this paper we present a new method for coin
identification. The proposed method adopts a hybrid scheme using
Eigenvalues of covariance matrix, Circular Hough Transform (CHT)
and Bresenham-s circle algorithm. The statistical and geometrical
properties of the small and large Eigenvalues of the covariance
matrix of a set of edge pixels over a connected region of support are
explored for the purpose of circular object detection. Sparse matrix
technique is used to perform CHT. Since sparse matrices squeeze
zero elements and contain only a small number of non-zero elements,
they provide an advantage of matrix storage space and computational
time. Neighborhood suppression scheme is used to find the valid
Hough peaks. The accurate position of the circumference pixels is
identified using Raster scan algorithm which uses geometrical
symmetry property. After finding circular objects, the proposed
method uses the texture on the surface of the coins called texton,
which are unique properties of coins, refers to the fundamental micro
structure in generic natural images. This method has been tested on
several real world images including coin and non-coin images. The
performance is also evaluated based on the noise withstanding
capability.
Abstract: Crystallization has been used for the separation of
chloronitrobenzene or CNBs, which are isomeric substances (o-, mand
p-CNB) and important intermediates in chemical productions. Effects of feed composition on the crystallization of m- and p-CNB was first studied. The results conform to the binary phase diagram of
m- and p-CNB. After that, effects of FAU zeolites (NaX, CaX, BaX, NaY and CaY) above the eutectic composition (63.5 and 65.0 wt% m-CNB in the feed) was also investigated. The results showed that
the FAU zeolites significantly affected the precipitates, the
composition of which was shifted from being rich in m-CNB to rich
in p-CNB. Effects of the number of FAU zeolites on the precipitate composition was then studied. The results revealed that the
precipitates from the lower number of the zeolites had higher p-CNB purity than those from the higher number of zeolite.
Abstract: This paper presents an integrated knowledge-based
approach to multi-scale modeling of aquatic systems, with a view to
enhancing predictive power and aiding environmental management
and policy-making. The basic phases of this approach have been
exemplified in the case of a bay in Saronicos Gulf (Attiki, Greece).
The results showed a significant problem with rising phytoplankton
blooms linked to excessive microbial growth, arisen mostly due to
increased nitrogen inflows; therefore, the nitrification/denitrification
processes of the benthic and water column sub-systems have
provided the quality variables to be monitored for assessing
environmental status. It is thereby demonstrated that the proposed
approach facilitates modeling choices and implementation option
decisions, while it provides substantial support for knowledge and
experience capitalization in long-term water management.
Abstract: Classification is one of the primary themes in
computational biology. The accuracy of classification strongly
depends on quality of a dataset, and we need some method to
evaluate this quality. In this paper, we propose a new graphical
analysis method using 'Membership-Deviation Graph (MDG)' for
analyzing quality of a dataset. MDG represents degree of
membership and deviations for instances of a class in the dataset. The
result of MDG analysis is used for understanding specific feature and
for selecting best feature for classification.
Abstract: This study considers the problem of determining
operation and maintenance schedules for a containership equipped
with components during its sailing according to a pre-determined
navigation schedule. The operation schedule, which specifies work
time of each component, determines the due-date of each maintenance
activity, and the maintenance schedule specifies the actual start
time of each maintenance activity. The main constraints are component
requirements, workforce availability, working time limitation,
and inter-maintenance time. To represent the problem mathematically,
a mixed integer programming model is developed. Then,
due to the problem complexity, we suggest a heuristic for the objective
of minimizing the sum of earliness and tardiness between the
due-date and the starting time of each maintenance activity. Computational
experiments were done on various test instances and the
results are reported.
Abstract: When the profile information of an existing road is
missing or not up-to-date and the parameters of the vertical
alignment are needed for engineering analysis, the engineer has to recreate
the geometric design features of the road alignment using
collected profile data. The profile data may be collected using
traditional surveying methods, global positioning systems, or digital
imagery. This paper develops a method that estimates the parameters
of the geometric features that best characterize the existing vertical
alignments in terms of tangents and the expressions of the curve, that
may be symmetrical, asymmetrical, reverse, and complex vertical
curves. The method is implemented using an Excel-based
optimization method that minimizes the differences between the
observed profile and the profiles estimated from the equations of the
vertical curve. The method uses a 'wireframe' representation of the
profile that makes the proposed method applicable to all types of
vertical curves. A secondary contribution of this paper is to introduce
the properties of the equal-arc asymmetrical curve that has been
recently developed in the highway geometric design field.
Abstract: In this paper in consideration of each available
techniques deficiencies for speech recognition, an advanced method
is presented that-s able to classify speech signals with the high
accuracy (98%) at the minimum time. In the presented method, first,
the recorded signal is preprocessed that this section includes
denoising with Mels Frequency Cepstral Analysis and feature
extraction using discrete wavelet transform (DWT) coefficients; Then
these features are fed to Multilayer Perceptron (MLP) network for
classification. Finally, after training of neural network effective
features are selected with UTA algorithm.
Abstract: In this paper, real-coded genetic algorithm (RCGA) optimization technique has been applied for large-scale linear dynamic multi-input-multi-output (MIMO) system. The method is based on error minimization technique where the integral square error between the transient responses of original and reduced order models has been minimized by RCGA. The reduction procedure is simple computer oriented and the approach is comparable in quality with the other well-known reduction techniques. Also, the proposed method guarantees stability of the reduced model if the original high-order MIMO system is stable. The proposed approach of MIMO system order reduction is illustrated with the help of an example and the results are compared with the recently published other well-known reduction techniques to show its superiority.