Abstract: Field mapping activity for an active volcano mainly in
the Torrid Zone is usually hampered by several problems such as steep
terrain and bad atmosphere conditions. In this paper we present a
simple solution for such problem by a combination Synthetic Aperture
Radar (SAR) and geostatistical methods. By this combination, we
could reduce the speckle effect from the SAR data and then estimate
roughness distribution of the pyroclastic flow deposits. The main
purpose of this study is to detect spatial distribution of new pyroclastic
flow deposits termed as P-zone accurately using the β°data from two
RADARSAT-1 SAR level-0 data. Single scene of Hyperion data and
field observation were used for cross-validation of the SAR results.
Mt. Merapi in central Java, Indonesia, was chosen as a study site and
the eruptions in May-June 2006 were examined. The P-zones were
found in the western and southern flanks. The area size and the longest
flow distance were calculated as 2.3 km2 and 6.8 km, respectively. The
grain size variation of the P-zone was mapped in detail from fine to
coarse deposits regarding the C-band wavelength of 5.6 cm.
Abstract: In this study a two dimensional axisymmetric, steady state and incompressible laminar flow in a rotating single disk is numerically investigated. The finite volume method is used for solving the momentum equations. The numerical model and results
are validated by comparing it to previously reported experimental data for velocities, angles and moment coefficients. It is
demonstrated that increasing the axial distance increases the value of axial velocity and vice versa for tangential and total velocities. However, the maximum value of nondimensional radial velocity
occurs near the disk wall. It is also found that with increase rotational Reynolds number, moment coefficient decreases.
Abstract: The Random Coefficient Dynamic Regression (RCDR)
model is to developed from Random Coefficient Autoregressive
(RCA) model and Autoregressive (AR) model. The RCDR model
is considered by adding exogenous variables to RCA model. In this
paper, the concept of the Maximum Likelihood (ML) method is used
to estimate the parameter of RCDR(1,1) model. Simulation results
have shown the AIC and BIC criterion to compare the performance of
the the RCDR(1,1) model. The variables as the stationary and weakly
stationary data are good estimates where the exogenous variables
are weakly stationary. However, the model selection indicated that
variables are nonstationarity data based on the stationary data of the
exogenous variables.
Abstract: Coagulation of water involves the use of coagulating
agents to bring the suspended matter in the raw water together for
settling and the filtration stage. Present study is aimed to examine the
effects of aluminum sulfate as coagulant in conjunction with Moringa
Oleifera Coagulant Protein as coagulant aid on turbidity, hardness,
and bacteria in turbid water. A conventional jar test apparatus was
employed for the tests. The best removal was observed at a pH of 7
to 7.5 for all turbidities. Turbidity removal efficiency was resulted
between % 80 to % 99 by Moringa Oleifera Coagulant Protein as
coagulant aid. Dosage of coagulant and coagulant aid decreased with
increasing turbidity. In addition, Moringa Oleifera Coagulant Protein
significantly has reduced the required dosage of primary coagulant.
Residual Al+3 in treated water were less than 0.2 mg/l and meets the
environmental protection agency guidelines. The results showed that
turbidity reduction of % 85.9- % 98 paralleled by a primary
Escherichia coli reduction of 1-3 log units (99.2 – 99.97%) was
obtained within the first 1 to 2 h of treatment. In conclusions,
Moringa Oleifera Coagulant Protein as coagulant aid can be used for
drinking water treatment without the risk of organic or nutrient
release. We demonstrated that optimal design method is an efficient
approach for optimization of coagulation-flocculation process and
appropriate for raw water treatment.
Abstract: In this work we develop an object extraction method
and propose efficient algorithms for object motion characterization.
The set of proposed tools serves as a basis for development of objectbased
functionalities for manipulation of video content. The
estimators by different algorithms are compared in terms of quality
and performance and tested on real video sequences. The proposed
method will be useful for the latest standards of encoding and
description of multimedia content – MPEG4 and MPEG7.
Abstract: The importance of nurturing, accumulating, and efficiently deploying knowledge resources through formal structures and organisational mechanisms is well understood. Recent trends in knowledge management (KM) highlight that the effective creation and transfer of knowledge can also rely upon extra-organisational channels, such as, informal networks. The perception exists that the role of informal networks in knowledge creation and performance has been underestimated in the organisational context. Literature indicates that many managers fail to comprehend and successfully exploit the potential role of informal networks to create value for their organisations. This paper investigates: 1) whether managers share work-specific knowledge with informal contacts within and outside organisational boundaries; and 2) what do they think is the importance of this knowledge collaboration in their learning and work outcomes.
Abstract: Located within the tropical belt region, there are
certain rules which should implemented in creating a passive
sustainable housing design in Malaysia. Traditional Malay house
possess a strong character with certain special spaces to create a
sustainable house which suit to the tropical climate in Malaysia. One
of the special space known as verandah or serambi gantung, create
various advantages in solving various issues. However, this special
space is not extremely being applied currently which produce major
issues in term of social and environmental aspects. Hence, this
phenomena create a negative impact to the occupant while Malaysia
already has a best housing design previously. Therefore, this paper
aims to explore both of the main issues mentioned above and reveal
the advantages of implementing verandah into passive sustainable
housing design in Malaysia. A systematic literature review is the
main methodology in this research to identify the various advantages
about verandah.. The study reveals that verandah is the best solution
in term of social and environmental issues and should be
implemented in current housing design in Malaysia.
Abstract: PCMs have always been viewed as a suitable
candidate for off peak thermal storage, particularly for refrigeration
systems, due to the high latent energy densities of these materials.
However, due to the need to have them encapsulated within a
container this density is reduced. Furthermore, PCMs have a low
thermal conductivity which reduces the useful amount of energy
which can be stored. To consider these factors, the true energy
storage density of a PCM system was proposed and optimised for
PCMs encapsulated in slabs. Using a validated numerical model of
the system, a parametric study was undertaken to investigate the
impact of the slab thickness, gap between slabs and the mass flow
rate. The study showed that, when optimised, a PCM system can
deliver a true energy storage density between 53% and 83% of the
latent energy density of the PCM.
Abstract: The mechanical properties including flexural and
tensile of neat vinyl ester and polymer based on layered silicate
nanocomposite materials are discussed. The addition of layered
silicate into the polymer matrix increased the tensile and flexural
modulus up to 1 wt.% clay loading. The incorporation of more clay
resulted in decreasing the mechanical properties which was traced to
the existence of aggregation layers. Likewise, up to 1 wt.% clay
loading, the thermal behaviour showed significant improvements and
at higher clay loading the thermal pattern was reduced. The
aggregation layers imparted a negative impact on the overall
mechanical and thermal properties. Wide Angle X-ray Diffraction,
Scanning Electron Microscopy and Transmission Electron
Microscopy were utilised in order to characterise the interlamellar
structure of nanocomposites.
Abstract: In this paper, we propose a novel variational method for unsupervised texture segmentation. We use a Gabor filter bank to extract texture features. Some of the filtered channels form a multidimensional Gaborian feature space. To avoid deforming contours directly in a vector-valued space we use a Gaussian mixture model to describe the statistical distribution of this space and get the boundary and region probabilities. Then a framework of geodesic active regions is applied based on them. In the end, experimental results are presented, and show that this method can obtain satisfied boundaries between different texture regions.
Abstract: A comparison between the performance of Latin and
Arabic handwritten digits recognition problems is presented. The
performance of ten different classifiers is tested on two similar
Arabic and Latin handwritten digits databases. The analysis shows
that Arabic handwritten digits recognition problem is easier than that
of Latin digits. This is because the interclass difference in case of
Latin digits is smaller than in Arabic digits and variances in writing
Latin digits are larger. Consequently, weaker yet fast classifiers are
expected to play more prominent role in Arabic handwritten digits
recognition.
Abstract: The traditional method for essential oil extraction from agarwood (Aquilaria Crassna) is to soak it in water and follow with hydrodistillation. The effect of various agarwood pretreatments: ethanol, acid, alkaline, enzymes, and ultrasound, and the effect of subcritical water extraction(SWE) was studied to compare with the traditional method. The major compositions of agarwood oil from hydrodistillation were aroma compounds as follow: aristol-9-en-8- one (21.53%), selina-3, 7(11)-diene (12.96%), τ-himachalene (9.28%), β-guaiene (5.79%), hexadecanoic acid (4.90%) and guaia- 3,9-diene (4.21%). Whereas agarwood oil from pretreatments with ethanol and ultrasound, and SWE got fatty acid compounds. Extraction of agarwood oil using these pretreatments could improve the agarwood oil yields up to 2 times that of the traditional method. The components of the pretreated sample with diluted acid (H2SO4) at pH 4 gave quite similar results as the traditional method. Therefore, the enhancement of essential oil from agarwood depends on requirement of type of extracted oil that involved extraction methods.
Abstract: Image data holds a large amount of different context
information. However, as of today, these resources remain largely
untouched. It is thus the aim of this paper to present a basic technical
framework which allows for a quick and easy exploitation of context
information from image data especially by non-expert users.
Furthermore, the proposed framework is discussed in detail
concerning important social and ethical issues which demand special
requirements in system design. Finally, a first sensor prototype is
presented which meets the identified requirements. Additionally,
necessary implications for the software and hardware design of the
system are discussed, rendering a sensor system which could be
regarded as a good, acceptable and justifiable technical and thereby
enabling the extraction of context information from image data.
Abstract: Coal fly ash (CFA) generated by coal-based thermal
power plants is mainly composed of quartz, mullite, and unburned
carbon. In this study, the effect of unburned carbon on CFA toward
its adsorption capacity was investigated. CFA with various carbon
content was obtained by refluxing it with sulfuric acid having various
concentration at various temperature and reflux time, by heating at
400-800°C, and by sieving into 100-mesh in particle size. To
evaluate the effect of unburned carbon on CFA toward its adsorption
capacity, adsorption of methyl violet solution with treated CFA was
carried out. The research shows that unburned carbon leads to
adsorption capacity decrease. The highest adsorption capacity of
treated CFA was found 5.73 x 10-4mol.g-1.
Abstract: In many industries, control charts is one of the most
frequently used tools for quality management. Hotelling-s T2 is used
widely in multivariate control chart. However, it has little defect when
detecting small or medium process shifts. The use of supplementary
sensitizing rules can improve the performance of detection. This study
applied sensitizing rules for Hotelling-s T2 control chart to improve the
performance of detection. Support vector machines (SVM) classifier
to identify the characteristic or group of characteristics that are
responsible for the signal and to classify the magnitude of the mean
shifts. The experimental results demonstrate that the support vector
machines (SVM) classifier can effectively identify the characteristic
or group of characteristics that caused the process mean shifts and the
magnitude of the shifts.
Abstract: High Speed PM Generators driven by micro-turbines
are widely used in Smart Grid System. So, this paper proposes
comparative study among six classical, optimized and genetic
analytical design cases for 400 kW output power at tip speed 200
m/s. These six design trials of High Speed Permanent Magnet
Synchronous Generators (HSPMSGs) are: Classical Sizing;
Unconstrained optimization for total losses and its minimization;
Constrained optimized total mass with bounded constraints are
introduced in the problem formulation. Then a genetic algorithm is
formulated for obtaining maximum efficiency and minimizing
machine size. In the second genetic problem formulation, we attempt
to obtain minimum mass, the machine sizing that is constrained by
the non-linear constraint function of machine losses. Finally, an
optimum torque per ampere genetic sizing is predicted. All results are
simulated with MATLAB, Optimization Toolbox and its Genetic
Algorithm. Finally, six analytical design examples comparisons are
introduced with study of machines waveforms, THD and rotor losses.
Abstract: This paper presents preliminary results of a
technology assessment analysis for the use of high pressure treatment
(HPT) on Halloumi cheese. In particular, it presents the importance
of this traditional Cyprus cheese to the island-s economy, explains its
production process, and gives a brief introduction to HPT and its
application on cheese. More importantly, it offers preliminary results
of HPT of Halloumi samples and a preliminary economic feasibility
study on the financial implications of the introduction of such
technology.
Abstract: One of the main environmental problems which affect extensive areas in the world is soil salinity. Traditional data collection methods are neither enough for considering this important environmental problem nor accurate for soil studies. Remote sensing data could overcome most of these problems. Although satellite images are commonly used for these studies, however there are still needs to find the best calibration between the data and real situations in each specified area. Neyshaboor area, North East of Iran was selected as a field study of this research. Landsat satellite images for this area were used in order to prepare suitable learning samples for processing and classifying the images. 300 locations were selected randomly in the area to collect soil samples and finally 273 locations were reselected for further laboratory works and image processing analysis. Electrical conductivity of all samples was measured. Six reflective bands of ETM+ satellite images taken from the study area in 2002 were used for soil salinity classification. The classification was carried out using common algorithms based on the best composition bands. The results showed that the reflective bands 7, 3, 4 and 1 are the best band composition for preparing the color composite images. We also found out, that hybrid classification is a suitable method for identifying and delineation of different salinity classes in the area.
Abstract: The threshold voltage and capacitance voltage characteristics of ultra-thin Silicon-on-Insulator MOSFET are greatly influenced by the thickness and doping concentration of the silicon film. In this work, the capacitance voltage characteristics and threshold voltage of the device have been analyzed with quantum mechanical effects using the Self-Consistent model. Reduction of channel thickness and adding doping impurities cause an increase in the threshold voltage. Moreover, the temperature effects cause a significant amount of threshold voltage shift. The temperature dependence of threshold voltage has also been observed with Self- Consistent approach which are well supported from experimental performance of practical devices.
Abstract: The analytical solution of functionally graded
piezoelectric hollow cylinder which is under radial electric potential
and non-axisymmetric thermo-mechanical loads, are presented in this
paper. Using complex Fourier series and estimation of power law for
variations of material characterizations through the thickness, the
electro thermo mechanical behavior of the FGPM cylinder is
obtained. The stress and displacement distributions and the effect of
electric potential field on the cylinder behavior are also presented and
some applicable results are offered at the end of the paper.