Abstract: A technique proposed for the automatic detection
of spikes in electroencephalograms (EEG). A multi-resolution
approach and a non-linear energy operator are exploited. The
signal on each EEG channel is decomposed into three sub bands
using a non-decimated wavelet transform (WT). The WT is a
powerful tool for multi-resolution analysis of non-stationary signal
as well as for signal compression, recognition and restoration.
Each sub band is analyzed by using a non-linear energy operator,
in order to detect spikes. A decision rule detects the presence of
spikes in the EEG, relying upon the energy of the three sub-bands.
The effectiveness of the proposed technique was confirmed by
analyzing both test signals and EEG layouts.
Abstract: Increased energy demand and the concern about
environment friendly technology, renewable bio-fuels are better
alternative to petroleum products. In the present study linseed oil was
used as alternative source for diesel engine fuel and the results were
compared with baseline data of neat diesel. Performance parameters
such as brake thermal efficiency (BTE) and brake specific fuel
consumption (BSFC) and emissions parameters such as CO,
unburned hydro carbon (UBHC), NOx, CO2 and exhaust temperature
were compared. BTE of the engine was lower and BSFC was higher
when the engine was fueled with Linseed oil compared to diesel fuel.
Emission characteristics are better than diesel fuel. NOx formation by
using linseed oil during the experiment was lower than diesel fuel.
Linseed oil is non edible oil, so it can be used as an extender of diesel
fuel energy source for small and medium energy needs.
Abstract: The power system network is becoming more
complex nowadays and it is very difficult to maintain the stability
of the system. Today-s enhancement of technology makes it
possible to include new energy storage devices in the electric
power system. In addition, with the aid of power electronic
devices, it is possible to independently exchange active and
reactive power flow with the utility grid. The main purpose of this
paper proposes a Proportional – Integral (PI) control based 48 –
pulse Inverter based Static Synchronous Series Compensator
(SSSC) with and without Superconducting Magnetic Energy
Storage (SMES) used for enhancing the transient stability and
regulating power flow in automatic mode. Using a test power
system through the dynamic simulation in Matlab/Simulink
platform validates the performance of the proposed SSSC with and
without SMES system.
Abstract: Spatial understanding and the understanding of
dynamic change in the spatial structure of molecules during a
reaction is essential for designing new molecules. Knowing the
physical processes in the reactions helps to speed up the designing
process. To support the designer with the correct representation of
the designed molecule as well as showing the dynamic behavior of
the whole reacting system is the goal of our application. Our system
shows the spatial deformation of the molecules at every time interval
by minimizing the energy level of the molecules. The position and
orientation of the molecules can be intuitively controlled by
manipulating objects of the real world using Augmented Reality
techniques. Our approach has the potential to speed up the design of
new molecules and help students to understand the chemical
processes better.
Abstract: In this work we report the recent progresses that have been achieved by our group in the last half decade on the field of computational proteomics. Specifically, we discuss the application of Molecular Dynamics Simulations and Electronic Structure Calculations in drug design, in the clarification of the structural and dynamic properties of proteins and enzymes and in the understanding of the catalytic and inhibition mechanism of cancer-related enzymes. A set of examples illustrate the concepts and help to introduce the reader into this important and fast moving field.
Abstract: In general, reports are a form of representing data in
such way that user gets the information he needs. They can be built in
various ways, from the simplest (“select from") to the most complex
ones (results derived from different sources/tables with complex
formulas applied). Furthermore, rules of calculations could be written
as a program hard code or built in the database to be used by dynamic
code. This paper will introduce two types of reports, defined in the
DB structure. The main goal is to manage calculations in optimal
way, keeping maintenance of reports as simple and smooth as
possible.
Abstract: Exchange algorithm with constraints on magnitude and phase error separately in new way is presented in this paper. An important feature of the algorithms presented in this paper is that they allow for design constraints which often arise in practical filter design problems. Meeting required minimum stopband attenuation or a maximum deviation from the desired magnitude and phase responses in the passbands are common design constraints that can be handled by the methods proposed here. This new algorithm may have important advantages over existing technique, with respect to the speed and stability of convergence, memory requirement and low ripples.
Abstract: The aim of this paper is to introduce the concepts of τ1τ2-regular generalized star star closed sets , τ1τ2-regular generalized star star open sets and study their basic properties in bitopological spaces.
Abstract: In this paper we present a substantiation of a new
Laguerre-s type iterative method for solving of a nonlinear
polynomial equations systems with real coefficients. The problems of
its implementation, including relating to the structural choice of
initial approximations, were considered. Test examples demonstrate
the effectiveness of the method at the solving of many practical
problems solving.
Abstract: Severe acute respiratory syndrome (SARS) is a respiratory disease in humans which is caused by the SARS coronavirus. The treatment of coronavirus-associated SARS has been evolving and so far there is no consensus on an optimal regimen. The mainstream therapeutic interventions for SARS involve broad-spectrum antibiotics and supportive care, as well as antiviral agents and immunomodulatory therapy. The Protein- Ligand interaction plays a significant role in structural based drug designing. In the present work we have taken the receptor Angiotensin converting enzyme 2 and identified the drugs that are commonly used against SARS. They are Lopinavir, Ritonavir, Ribavirin, and Oseltamivir. The receptor Angiotensin converting enzyme 2 (ACE-2) was docked with above said drugs and the energy value obtained are as follows, Lopinavir (-292.3), Ritonavir (-325.6), Oseltamivir (- 229.1), Ribavirin (-208.8). Depending on the least energy value we have chosen the best two drugs out of the four conventional drugs. We tried to improve the binding efficiency and steric compatibility of the two drugs namely Ritonavir and Lopinavir. Several modifications were made to the probable functional groups (phenylic, ketonic groups in case of Ritonavir and carboxylic groups in case of Lopinavir respectively) which were interacting with the receptor molecule. Analogs were prepared by Marvin Sketch software and were docked using HEX docking software. Lopinavir analog 8 and Ritonavir analog 11 were detected with significant energy values and are probable lead molecule. It infers that some of the modified drugs are better than the original drugs. Further work can be carried out to improve the steric compatibility of the drug based upon the work done above for a more energy efficient binding of the drugs to the receptor.
Abstract: This paper presents a cold flow simulation study of a small gas turbine combustor performed using laboratory scale test rig. The main objective of this investigation is to obtain physical insight of the main vortex, responsible for the efficient mixing of fuel and air. Such models are necessary for predictions and optimization of real gas turbine combustors. Air swirler can control the combustor performance by assisting in the fuel-air mixing process and by producing recirculation region which can act as flame holders and influences residence time. Thus, proper selection of a swirler is needed to enhance combustor performance and to reduce NOx emissions. Three different axial air swirlers were used based on their vane angles i.e., 30°, 45°, and 60°. Three-dimensional, viscous, turbulent, isothermal flow characteristics of the combustor model operating at room temperature were simulated via Reynolds- Averaged Navier-Stokes (RANS) code. The model geometry has been created using solid model, and the meshing has been done using GAMBIT preprocessing package. Finally, the solution and analysis were carried out in a FLUENT solver. This serves to demonstrate the capability of the code for design and analysis of real combustor. The effects of swirlers and mass flow rate were examined. Details of the complex flow structure such as vortices and recirculation zones were obtained by the simulation model. The computational model predicts a major recirculation zone in the central region immediately downstream of the fuel nozzle and a second recirculation zone in the upstream corner of the combustion chamber. It is also shown that swirler angles changes have significant effects on the combustor flowfield as well as pressure losses.
Abstract: Reducing energy consumption of embedded systems requires careful memory management. It has been shown that Scratch- Pad Memories (SPMs) are low size, low cost, efficient (i.e. energy saving) data structures directly managed at the software level. In this paper, the focus is on heuristic methods for SPMs management. A method is efficient if the number of accesses to SPM is as large as possible and if all available space (i.e. bits) is used. A Tabu Search (TS) approach for memory management is proposed which is, to the best of our knowledge, a new original alternative to the best known existing heuristic (BEH). In fact, experimentations performed on benchmarks show that the Tabu Search method is as efficient as BEH (in terms of energy consumption) but BEH requires a sorting which can be computationally expensive for a large amount of data. TS is easy to implement and since no sorting is necessary, unlike BEH, the corresponding sorting time is saved. In addition to that, in a dynamic perspective where the maximum capacity of the SPM is not known in advance, the TS heuristic will perform better than BEH.
Abstract: Three-dimensional geometric models have been used
to present architectural and engineering works, showing their final
configuration. When the clarification of a detail or the constitution of
a construction step in needed, these models are not appropriate. They
do not allow the observation of the construction progress of a
building. Models that could present dynamically changes of the
building geometry are a good support to the elaboration of projects.
Techniques of geometric modeling and virtual reality were used to
obtain models that could visually simulate the construction activity.
The applications explain the construction work of a cavity wall and a
bridge. These models allow the visualization of the physical
progression of the work following a planned construction sequence,
the observation of details of the form of every component of the
works and support the study of the type and method of operation of
the equipment applied in the construction. These models presented
distinct advantage as educational aids in first-degree courses in Civil
Engineering. The use of Virtual Reality techniques in the
development of educational applications brings new perspectives to
the teaching of subjects related to the field of civil construction.
Abstract: This paper explores the sense of place in the Vredefort Dome World Heritage site, South Africa, as an essential input for the formulation of spatial planning proposals for the area. Intangible aspects such as personal and symbolic meanings of sites are currently not integrated in spatial planning in South Africa. This may have a detrimental effect on local inhabitants who have a long history with the site and built up a strong place identity. Involving local inhabitants at an early stage of the planning process and incorporating their attitudes and opinions in future intervention in the area, may also contribute to the acceptance of the legitimacy of future policy. An interdisciplinary and mixed-method research approach was followed in this study in order to identify possible ways to anchor spatial planning proposals in the identity of the place. In essence, the qualitative study revealed that inhabitants reflect a deep and personal relationship with and within the area, which contributes significantly to their sense of emotional security and selfidentity. Results include a strong conservation-orientated attitude with regard to the natural rural character of the site, especially in the inner core.
Abstract: In today scenario, to meet enhanced demand imposed
by domestic, commercial and industrial consumers, various
operational & control activities of Radial Distribution Network
(RDN) requires a focused attention. Irrespective of sub-domains
research aspects of RDN like network reconfiguration, reactive
power compensation and economic load scheduling etc, network
performance parameters are usually estimated by an iterative process
and is commonly known as load (power) flow algorithm. In this
paper, a simple mechanism is presented to implement the load flow
analysis (LFA) algorithm. The reported algorithm utilizes graph
theory principles and is tested on a 69- bus RDN.
Abstract: The length of a given rational B'ezier curve is
efficiently estimated. Since a rational B'ezier function is nonlinear,
it is usually impossible to evaluate its length exactly. The
length is approximated by using subdivision and the accuracy
of the approximation n is investigated. In order to improve
the efficiency, adaptivity is used with some length estimator.
A rigorous theoretical analysis of the rate of convergence of
n to is given. The required number of subdivisions to
attain a prescribed accuracy is also analyzed. An application
to CAD parametrization is briefly described. Numerical results
are reported to supplement the theory.
Abstract: Accurate modeling of high speed RLC interconnects
has become a necessity to address signal integrity issues in current
VLSI design. To accurately model a dispersive system of interconnects
at higher frequencies; a full-wave analysis is required.
However, conventional circuit simulation of interconnects with full
wave models is extremely CPU expensive. We present an algorithm
for reducing large VLSI circuits to much smaller ones with similar
input-output behavior. A key feature of our method, called Frequency
Shift Technique, is that it is capable of reducing linear time-varying
systems. This enables it to capture frequency-translation and sampling
behavior, important in communication subsystems such as mixers,
RF components and switched-capacitor filters. Reduction is obtained
by projecting the original system described by linear differential
equations into a lower dimension. Experiments have been carried out
using Cadence Design Simulator cwhich indicates that the proposed
technique achieves more % reduction with less CPU time than the
other model order reduction techniques existing in literature. We
also present applications to RF circuit subsystems, obtaining size
reductions and evaluation speedups of orders of magnitude with
insignificant loss of accuracy.
Abstract: Silver-exchanged zeolites and clays are used in
polymer composites to confer broad-spectrum antimicrobial
properties on a range of functional materials. Tobermorite is a layer
lattice mineral whose potential as a carrier for Ag+ ions in
antibacterial composites has not yet been investigated. Accordingly,
in this study, synthetic tobermorite was ion-exchanged with 10 wt%
silver ions and the resulting material was incorporated into a
composite film with chitosan. Chitosan is a biocompatible,
biodegradable derivative of chitin, a polysaccharide obtained from
the shells of crustaceans. The solvent-cast Ag+-exchanged
tobermorite-chitosan films were found to exhibit antimicrobial action
against Staphylococcus aureus, Escherichia coli and Pseudomonas
aeruginosa.
Abstract: In this paper, we use Generalized Hamiltonian systems approach to synchronize a modified sixth-order Chua's circuit, which generates hyperchaotic dynamics. Synchronization is obtained between the master and slave dynamics with the slave being given by an observer. We apply this approach to transmit private information (analog and binary), while the encoding remains potentially secure.
Abstract: The paper presents the multi-element synthetic
transmit aperture (MSTA) method with a small number of elements
transmitting and all elements apertures in medical ultrasound
imaging. As compared to the other methods MSTA allows to
increase the system frame rate and provides the best compromise
between penetration depth and lateral resolution.
In the experiments a 128-element linear transducer array with
0.3 mm pitch excited by a burst pulse of 125 ns duration were used.
The comparison of 2D ultrasound images of tissue mimicking
phantom obtained using the STA and the MSTA methods is
presented to demonstrate the benefits of the second approach. The
results were obtained using SA algorithm with transmit and receive
signals correction based on a single element directivity function.