Abstract: The effect of antifungal compound from Bacillus
subtilis strain LB5 was tested against conidial germination of
Colletotrichum gloeosporioides and Pestalotiopsis eugeniae, causal
agent of anthracnose and fruit rot of wax apple, respectively.
Observation under scanning electron microscope and light compound
microscope revealed that conidial germination was completely
inhibited when treated with culture broth, culture filtrate, or crude
extract from strain LB5. Identification of purified antifungal
compound produced by strain LB5 in cell-free supernatant by nuclear
magnetic resonance and fast atom bombardment showed that the
active compound was iturin A-2.
Abstract: In the last few years, three multivariate spectral
analysis techniques namely, Principal Component Analysis (PCA),
Independent Component Analysis (ICA) and Non-negative Matrix
Factorization (NMF) have emerged as effective tools for oscillation
detection and isolation. While the first method is used in determining
the number of oscillatory sources, the latter two methods
are used to identify source signatures by formulating the detection
problem as a source identification problem in the spectral domain.
In this paper, we present a critical drawback of the underlying linear
(mixing) model which strongly limits the ability of the associated
source separation methods to determine the number of sources
and/or identify the physical source signatures. It is shown that the
assumed mixing model is only valid if each unit of the process gives
equal weighting (all-pass filter) to all oscillatory components in its
inputs. This is in contrast to the fact that each unit, in general, acts
as a filter with non-uniform frequency response. Thus, the model
can only facilitate correct identification of a source with a single
frequency component, which is again unrealistic. To overcome
this deficiency, an iterative post-processing algorithm that correctly
identifies the physical source(s) is developed. An additional issue
with the existing methods is that they lack a procedure to pre-screen
non-oscillatory/noisy measurements which obscure the identification
of oscillatory sources. In this regard, a pre-screening procedure
is prescribed based on the notion of sparseness index to eliminate
the noisy and non-oscillatory measurements from the data set used
for analysis.
Abstract: Development of cities and villages, agricultural farms
and industrial regions in abutment and/or in the course of streams and
rivers or in prone flood lands has been caused more notations in
hydrology problems and city planning topics. In order to protection
of cities against of flood damages, embankment construction is a
desired and scientific method. The cities that located in arid zones
may damage by floods periodically. Zavvareh city in Ardestan
township(Isfahan province) with 7704 people located in Ardestan
plain that has been damaged by floods that have flowed from
dominant mountainous watersheds in past years with regard to return
period. In this study, according to flowed floods toward Zavvareh
city, was attempt to plan suitable hydraulic structures such as canals,
bridges and collectors in order to collection, conduction and
depletion of city surface runoff.
Abstract: In this paper, the experimental design of using the
Taguchi method is employed to optimize the processing parameters in
the plasma arc surface hardening process. The processing parameters
evaluated are arc current, scanning velocity and carbon content of
steel. In addition, other significant effects such as the relation between
processing parameters are also investigated. An orthogonal array,
signal-to-noise (S/N) ratio and analysis of variance (ANOVA) are
employed to investigate the effects of these processing parameters.
Through this study, not only the hardened depth increased and surface
roughness improved, but also the parameters that significantly affect
the hardening performance are identified. Experimental results are
provided to verify the effectiveness of this approach.
Abstract: To help the client to select a competent agent
construction enterprise (ACE), this study aims to investigate the
selection standards by using the Fuzzy Analytic Hierarchy Process
(FAHP) and build an evaluation mathematical model with Grey
Relational Analysis (GRA). According to the outputs of literature
review, four orderly levels are established within the model, taking the
consideration of various agent construction models in practice. Then,
the process of applying FAHP and GRA is discussed in detailed.
Finally, through a case study, this paper illustrates how to apply these
methods in getting the weights of each standard and the final
assessment result.
Abstract: This paper deals with efficient quadrature formulas involving functions that are observed only at fixed sampling points. The approach that we develop is derived from efficient continuous quadrature formulas, such as Gauss-Legendre or Clenshaw-Curtis quadrature. We select nodes at sampling positions that are as close as possible to those of the associated classical quadrature and we update quadrature weights accordingly. We supply the theoretical quadrature error formula for this new approach. We show on examples the potential gain of this approach.
Abstract: Stuck-pipe in drilling operations is one of the most
pressing and expensive problems in the oil industry. This paper
describes a computational simulation and an experimental study of
the hydrodynamic vibrator, which may be used for liquidation of
stuck-pipe problems during well drilling. The work principle of the
vibrator is based upon the known phenomena of Vortex Street of
Karman and the resulting generation of vibrations. We will discuss
the computational simulation and experimental investigations of
vibrations in this device. The frequency of the vibration parameters
has been measured as a function of the wide range Reynolds Number.
The validity of the computational simulation and of the assumptions
on which it is based has been proved experimentally. The
computational simulation of the vibrator work and its effectiveness
was carried out using FLUENT software. The research showed high
degree of congruence with the results of the laboratory tests and
allowed to determine the effect of the granular material features upon
the pipe vibration in the well. This study demonstrates the potential
of using the hydrodynamic vibrator in a well drilling system.
Abstract: The paper makes part from a complex research project
on Romanian Grey Steppe, a unique breed in terms of biological and
cultural-historical importance, on the verge of extinction and which
has been included in a preservation programme of genetic resources
from Romania. The study of genetic polymorphism of protean
fractions, especially kappa-casein, and the genotype relations of
these lactoproteins with some quantitative and qualitative features of
milk yield represents a current theme and a novelty for this breed. In
the estimation of the genetic parameters we used R.E.M.L.
(Restricted Maximum Likelihood) method.
The main lactoprotein from milk, kappa - casein (K-cz),
characterized in the specialized literature as a feature having a high
degree of hereditary transmission, behaves as such in the nucleus under
study, a value also confirmed by the heritability coefficient (h2 = 0.57
%). We must mention the medium values for milk and fat quantity
(h2=0.26, 0.29 %) and the fat and protein percentage from milk
having a high hereditary influence h2 = 0.71 - 0.63 %.
Correlations between kappa-casein and the milk quantity are
negative and strong. Between kappa-casein and other qualitative
features of milk (fat content 0.58-0.67 % and protein content 0.77-
0.87%), there are positive and very strong correlations. At the same
time, between kappa-casein and β casein (β-cz), β lactoglobulin (β-
lg) respectively, correlations are positive having high values (0.37 –
0.45 %), indicating the same causes and determining factors for the
two groups of features.
Abstract: A dynamic stall-corrected Blade Element-Momentum algorithm based on a hybrid polar is validated through the comparison with Sandia experimental measurements on a 5-m diameter wind turbine of Troposkien shape. Different dynamic stall models are evaluated. The numerical predictions obtained using the extended aerodynamic coefficients provided by both Sheldal and Klimas and Raciti Castelli et al. are compared to experimental data, determining the potential of the hybrid database for the numerical prediction of vertical-axis wind turbine performances.
Abstract: In this paper, hybrid FDMA-TDMA access technique in a cooperative distributive fashion introducing and implementing a modified protocol introduced in [1] is analyzed termed as Power and Cooperation Diversity Gain Protocol (PCDGP). A wireless network consists of two users terminal , two relays and a destination terminal equipped with two antennas. The relays are operating in amplify-and-forward (AF) mode with a fixed gain. Two operating modes: cooperation-gain mode and powergain mode are exploited from source terminals to relays, as it is working in a best channel selection scheme. Vertical BLAST (Bell Laboratories Layered Space Time) or V-BLAST with minimum mean square error (MMSE) nulling is used at the relays to perfectly detect the joint signals from multiple source terminals. The performance is analyzed using binary phase shift keying (BPSK) modulation scheme and investigated over independent and identical (i.i.d) Rayleigh, Ricean-K and Nakagami-m fading environments. Subsequently, simulation results show that the proposed scheme can provide better signal quality of uplink users in a cooperative communication system using hybrid FDMATDMA technique.
Abstract: Biologically active peptides are of particular interest
in food science and human nutrition because they have been shown to play several physiological roles. In vitro gastrointestinal digestion of lentil and whey proteins in this study produced high angiotensin-I converting enzyme inhibitory activity with 75.5±1.9 and 91.4±2.3%
inhibition, respectively. High ACE inhibitory activity was observed in lentil after 5 days of germination (84.3±1.2%). Fractionation by
reverse phase chromatography gave inhibitory activities as high as
86.3±2.0 for lentil, 94.8±1.8% for whey and 93.7±1.7% at 5th day of germination. Further purification by HPLC resulted in several
inhibitory peptides with IC50 values ranging from 0.064 to 0.164
mg/ml. These results demonstrate that lentil proteins are a good
source of peptides with ACE inhibitory activity that can be released by germination or gastrointestinal digestion. Despite the lower bioactivity in comparison with whey proteins, incorporation of lentil proteins in functional food formulations and natural drugs look promising.
Abstract: A decomposition of a graph G is a collection ψ of
graphs H1,H2, . . . , Hr of G such that every edge of G belongs
to exactly one Hi. If each Hi is either an induced path in G,
then ψ is called an induced acyclic path decomposition of G and
if each Hi is a (induced) cycle in G then ψ is called a (induced)
cycle decomposition of G. The minimum cardinality of an induced
acyclic path decomposition of G is called the induced acyclic path
decomposition number of G and is denoted by ¤Çia(G). Similarly
the cyclic decomposition number ¤Çc(G) is defined. In this paper we
begin an investigation of these parameters.
Abstract: Fair share objective has been included into the goaloriented
parallel computer job scheduling policy recently. However,
the previous work only presented the overall scheduling performance.
Thus, the per-user performance of the policy is still lacking. In this
work, the details of per-user fair share performance under the
Tradeoff-fs(Tx:avgX) policy will be further evaluated. A basic fair
share priority backfill policy namely RelShare(1d) is also studied.
The performance of all policies is collected using an event-driven
simulator with three real job traces as input. The experimental results
show that the high demand users are usually benefited under most
policies because their jobs are large or they have a lot of jobs. In the
large job case, one job executed may result in over-share during that
period. In the other case, the jobs may be backfilled for
performances. However, the users with a mixture of jobs may suffer
because if the smaller jobs are executing the priority of the remaining
jobs from the same user will be lower. Further analysis does not show
any significant impact of users with a lot of jobs or users with a large
runtime approximation error.
Abstract: The NGN (Next Generation Network), which can
provide advanced multimedia services over an all-IP based network, has been the subject of much attention for years. While there have
been tremendous efforts to develop its architecture and protocols, especially for IMS, which is a key technology of the NGN, it is far
from being widely deployed. However, efforts to create an advanced
signaling infrastructure realizing many requirements have resulted in a
large number of functional components and interactions between those
components. Thus, the carriers are trying to explore effective ways to
deploy IMS while offering value-added services. As one such
approach, we have proposed a self-organizing IMS. A self-organizing
IMS enables IMS functional components and corresponding physical
nodes to adapt dynamically and automatically based on situation such
as network load and available system resources while continuing IMS
operation. To realize this, service continuity for users is an important
requirement when a reconfiguration occurs during operation. In this
paper, we propose a mechanism that will provide service continuity to
users and focus on the implementation and describe performance
evaluation in terms of number of control signaling and processing time
during reconfiguration
Abstract: The complexity of teaching English in higher
institutions by non-native speakers within a second/foreign language
setting has created continuous discussions and research about
teaching approaches and teaching practises, professional identities
and challenges. In addition, there is a growing awareness that
teaching English within discipline-specific contexts adds up to the
existing complexity. This awareness leads to reassessments,
discussions and suggestions on course design and content and
teaching approaches and techniques. In meeting expectations
teaching at a university specified in a particular discipline such as
engineering, English language educators are not only required to
teach students to be able to communicate in English effectively but
also to teach soft skills such as problem solving skills. This paper is
part of a research conducted to investigate how English language
educators negotiate with the complexities of teaching problem
solving skills through English language teaching at a technical
university. This paper reports the way an English language educator
identified himself and the way he approached his teaching in this
institutional context.
Abstract: This paper investigates the inverse problem of determining
the unknown time-dependent leading coefficient in the parabolic
equation using the usual conditions of the direct problem and an additional
condition. An algorithm is developed for solving numerically
the inverse problem using the technique of space decomposition in a
reproducing kernel space. The leading coefficients can be solved by a
lower triangular linear system. Numerical experiments are presented
to show the efficiency of the proposed methods.
Abstract: The morphological parameter of a thin film surface
can be characterized by power spectral density (PSD) functions
which provides a better description to the topography than the RMS
roughness and imparts several useful information of the surface
including fractal and superstructure contributions. Through the
present study Nanoparticle copper/carbon composite films were
prepared by co-deposition of RF-Sputtering and RF-PECVD method
from acetylene gas and copper target. Surface morphology of thin
films is characterized by using atomic force microscopy (AFM). The
Carbon content of our films was obtained by Rutherford Back
Scattering (RBS) and it varied from .4% to 78%. The power values of
power spectral density (PSD) for the AFM data were determined by
the fast Fourier transform (FFT) algorithms. We investigate the effect
of carbon on the roughness of thin films surface. Using such
information, roughness contributions of the surface have been
successfully extracted.