Abstract: The relationship between tropical cyclogenesis and solar activity is addressed in this paper, analyzing the relationship between important parameters in the evolution of tropical cyclones as the CAPE, wind shear and relative vorticity, and the Dst geomagnetic index as a parameter of solar activity. The apparent relationship between all this phenomena has a different response depending on the phase of the solar cycles.
Abstract: The quantified residence time distribution (RTD)
provides a numerical characterization of mixing in a reactor, thus
allowing the process engineer to better understand mixing
performance of the reactor.This paper discusses computational
studies to investigate flow patterns in a two impinging streams
cyclone reactor(TISCR) . Flow in the reactor was modeled with
computational fluid dynamics (CFD). Utilizing the Eulerian-
Lagrangian approach, implemented in FLUENT (V6.3.22), particle
trajectories were obtained by solving the particle force balance
equations. From simulation results obtained at different Δts, the mean
residence time (tm) and the mean square deviation (σ2) were
calculated. a good agreement can be observed between predicted and
experimental data. Simulation results indicate that the behavior of
complex reactor systems can be predicted using the CFD technique
with minimum data requirement for validation.
Abstract: In this research a comparison between k-epsilon and
LES model for a deoiling hydrocyclone is conducted. Flow field of
hydrocyclone is obtained by three-dimensional simulations with
OpenFOAM code. Potential of prediction for both methods of this
complex swirl flow is discussed. Large eddy simulation method
results have more similarity to experiment and its results are
presented in figures from different hydrocyclone cross sections.
Abstract: In hydrocyclones, the particle separation efficiency is
limited by the suspended fine particles, which are discharged with the
coarse product in the underflow. It is well known that injecting water
in the conical part of the cyclone reduces the fine particle fraction in
the underflow. This paper presents a mathematical model that
simulates the water injection in the conical component. The model
accounts for the fluid flow and the particle motion. Particle
interaction, due to hindered settling caused by increased density and
viscosity of the suspension, and fine particle entrainment by settling
coarse particles are included in the model. Water injection in the
conical part of the hydrocyclone is performed to reduce fine particle
discharge in the underflow. The model demonstrates the impact of
the injection rate, injection velocity, and injection location on the
shape of the partition curve. The simulations are compared with
experimental data of a 50-mm cyclone.
Abstract: Methanol-to-olefins coupled with transformation of
coal or natural gas to methanol gives an interesting and promising way
to produce ethylene and propylene. To investigate solid concentration
in gas-solid fluidized bed for methanol-to-olefins process catalyzed by
SAPO-34, a cold model experiment system is established in this paper.
The system comprises a gas distributor in a 300mm internal diameter
and 5000mm height acrylic column, the fiber optic probe system and
series of cyclones. The experiments are carried out at ambient
conditions and under different superficial gas velocity ranging from
0.3930m/s to 0.7860m/s and different initial bed height ranging from
600mm to 1200mm. The effects of radial distance, axial distance,
superficial gas velocity, initial bed height on solid concentration in the
bed are discussed. The effects of distributor shape and porosity on
solid concentration are also discussed. The time-averaged solid
concentration profiles under different conditions are obtained.
Abstract: This paper describes an experimental investigation of
the drying behavior and conditions of rosehip in a convective
cyclone-type dryer. Drying experiments were conducted at air inlet
temperatures of 50, 60 and 70 o C and air velocities of 0.5, 1 and 1.5
ms–1. The parametric values obtained from the experiments were
fitted to the Newton mathematical models. Consequently, the drying
model developed by Newton model showed good agreement with the
data obtained from the experiments. Concluding, it was obtained that;
(i) the temperature is the major effect on the drying process, (ii) air
velocity has low effect on the drying of rosehip, (iii) the C-vitamin is
observed to change according to the temperature, moisture, drying
time and flow types. The changing ratio is found to be in the range of
0.70-0.74.
Abstract: Iron ore and coal are the two major important raw
materials being used in Iron making industries. Usually ore fines
containing around 5% Alumina are rejected due to higher proportion
of alumina. Therefore, a technology or process which may reduce
the alumina content by 2% by beneficiation process will be highly
attractive . In addition fine coals with ash content is used nearly 12%
is directly injected in blast furnace. Fast fluidization is a technology
by using dry beneficiation of coal and iron ore can be done. During
the fluidization process the iron ore band coal is fluidized at high
velocity in the riser of a fast fluidized bed, the heavier and coarse
particles is generally settled at the bottom in a dense zone of the riser
while the finer and lighter particle are entrained to the top dilute zone
and then via a cyclone is fed back to the bottom of the riser column.
Most of the alumina and low ash fine size coals being lighter are
expected to move up to the riser and by a natural beneficiation of
ores is expected to take place in the riser. Therefore in this study an
attempt has been made for dry beneficiation of iron ore and coal in a
fluidized bed and its hydrodynamic characterization.
Abstract: Methanol-to-olefins (MTO) coupled with
transformation of coal or natural gas to methanol gives an interesting
and promising way to produce ethylene and propylene. To investigate
solid concentration in gas-solid fluidized bed for methanol-to-olefins
process catalyzed by SAPO-34, a cold model experiment system is
established in this paper. The system comprises a gas distributor in a
300mm internal diameter and 5000mm height acrylic column, the
fiber optic probe system and series of cyclones. The experiments are
carried out at ambient conditions and under different superficial gas
velocity ranging from 0.3930m/s to 0.7860m/s and different initial bed
height ranging from 600mm to 1200mm. The effects of radial
distance, axial distance, superficial gas velocity, initial bed height on
solid concentration in the bed are discussed. The effects of distributor
shape and porosity on solid concentration are also discussed. The
time-averaged solid concentration profiles under different conditions
are obtained.
Abstract: In this research the separation efficiency of deoiling hydrocyclone is evaluated using three-dimensional simulation of multiphase flow based on Eulerian-Eulerian finite volume method. The mixture approach of Reynolds Stress Model is also employed to capture the features of turbulent multiphase swirling flow. The obtained separation efficiency of Colman's design is compared with available experimental data and showed that the separation curve of deoiling hydrocyclones can be predicted using numerical simulation.
Abstract: A new multi inner stage (MIS) cyclone was designed to
remove the acidic gas and fine particles produced from electronic
industry. To characterize gas flow in MIS cyclone, pressure and
velocity distribution were calculated by means of CFD program. Also,
the flow locus of fine particles and particle removal efficiency were
analyzed by Lagrangian method. When outlet pressure condition was
–100mmAq, the efficiency was the best in this study.
Abstract: This paper presents the results of preliminary
assessment of water quality along the coastal areas in the vicinity of
Left Bank Outfall Drainage (LBOD) and Tidal Link Drain (TLD) in
Sindh province after the cyclone 2A occurred in 1999. The water
samples were collected from various RDs of Tidal Link Drain and
lakes during September 2001 to April 2002 and were analysed for
salinity, nitrite, phosphate, ammonia, silicate and suspended material
in water. The results of the study showed considerable variations in
water quality depending upon the location along the coast in the
vicinity of LBOD and RDs. The salinity ranged between 4.39–65.25
ppt in Tidal Link Drain samples whereas 2.4–38.05 ppt in samples
collected from lakes. The values of suspended material at various
RDs of Tidal Link Drain ranged between 56.6–2134 ppm and at the
lakes between 68–297 ppm. The data of continuous monitoring at
RD–93 showed the range of PO4 (8.6–25.2 μg/l), SiO3 (554.96–1462
μg/l), NO2 (0.557.2–25.2 μg/l) and NH3 (9.38–23.62 μg/l). The
concentration of nutrients in water samples collected from different
RDs was found in the range of PO4 (10.85 to 11.47 μg/l), SiO3 (1624
to 2635.08 μg/l), NO2 (20.38 to 44.8 μg/l) and NH3 (24.08 to 26.6
μg/l). Sindh coastal areas which situated at the north-western
boundary the Arabian Sea are highly vulnerable to flood damages
due to flash floods during SW monsoon or impact of sea level rise
and storm surges coupled with cyclones passing through Arabian Sea
along Pakistan coast. It is hoped that the obtained data in this study
would act as a database for future investigations and monitoring of
LBOD and Tidal Link Drain coastal waters.
Abstract: This research were investigated, determined, and
analyzed of the climate characteristically change in the provincial
Udon Thani in the period of 60 surrounding years from 1951 to 2010
A.D. that it-s transferred to effects of climatologically data for
determining global warming. Statistically significant were not found
for the 60 years- data (R2