Abstract: We constructed a method of phase unwrapping for a typical wave-front by utilizing the maximizer of the posterior marginal (MPM) estimate corresponding to equilibrium statistical mechanics of the three-state Ising model on a square lattice on the basis of an analogy between statistical mechanics and Bayesian inference. We investigated the static properties of an MPM estimate from a phase diagram using Monte Carlo simulation for a typical wave-front with synthetic aperture radar (SAR) interferometry. The simulations clarified that the surface-consistency conditions were useful for extending the phase where the MPM estimate was successful in phase unwrapping with a high degree of accuracy and that introducing prior information into the MPM estimate also made it possible to extend the phase under the constraint of the surface-consistency conditions with a high degree of accuracy. We also found that the MPM estimate could be used to reconstruct the original wave-fronts more smoothly, if we appropriately tuned hyper-parameters corresponding to temperature to utilize fluctuations around the MAP solution. Also, from the viewpoint of statistical mechanics of the Q-Ising model, we found that the MPM estimate was regarded as a method for searching the ground state by utilizing thermal fluctuations under the constraint of the surface-consistency condition.
Abstract: In recent years Malaysia has included renewable
energy as an alternative fuel to help in diversifying the country-s
energy reliance on oil, natural gas, coal and hydropower with
biomass and solar energy gaining priority. The scope of this paper is
to look at the designing procedures and analysis of a solar thermal
parabolic trough concentrator by simulation utilizing meteorological
data in several parts of Malaysia. Parameters which include the
aperture area, the diameter of the receiver and the working fluid may
be varied to optimize the design. Aperture area is determined by
considering the width and the length of the concentrator whereas the
geometric concentration ratio (CR) is obtained by considering the
width and diameter of the receiver. Three types of working fluid are
investigated. Theoretically, concentration ratios can be very high in
the range of 10 to 40 000 depending on the optical elements used and
continuous tracking of the sun. However, a thorough analysis is
essential as discussed in this paper where optical precision and
thermal analysis must be carried out to evaluate the performance of
the parabolic trough concentrator as the theoretical CR is not the only
factor that should be considered.
Abstract: An image texture analysis and target recognition approach of using an improved image texture feature coding method (TFCM) and Support Vector Machine (SVM) for target detection is presented. With our proposed target detection framework, targets of interest can be detected accurately. Cascade-Sliding-Window technique was also developed for automated target localization. Application to mammogram showed that over 88% of normal mammograms and 80% of abnormal mammograms can be correctly identified. The approach was also successfully applied to Synthetic Aperture Radar (SAR) and Ground Penetrating Radar (GPR) images for target detection.
Abstract: Acoustic Imaging based sound localization using microphone
array is a challenging task in digital-signal processing.
Discrete Fourier transform (DFT) based near-field acoustical holography
(NAH) is an important acoustical technique for sound source
localization and provide an efficient solution to the ill-posed problem.
However, in practice, due to the usage of small curtailed aperture
and its consequence of significant spectral leakage, the DFT could
not reconstruct the active-region-of-sound (AROS) effectively, especially
near the edges of aperture. In this paper, we emphasize the
fundamental problems of DFT-based NAH, provide a solution to
spectral leakage effect by the extrapolation based on linear predictive
coding and 2D Tukey windowing. This approach has been tested to
localize the single and multi-point sound sources. We observe that
incorporating extrapolation technique increases the spatial resolution,
localization accuracy and reduces spectral leakage when small curtail
aperture with a lower number of sensors accounts.
Abstract: Purpose: Planning and dosimetry of different VMAT algorithms (SmartArc, Ergo++, Autobeam) is compared with IMRT for Head and Neck Cancer patients. Modelling was performed to rule out the causes of discrepancies between planned and delivered dose. Methods: Five HNC patients previously treated with IMRT were re-planned with SmartArc (SA), Ergo++ and Autobeam. Plans were compared with each other and against IMRT and evaluated using DVHs for PTVs and OARs, delivery time, monitor units (MU) and dosimetric accuracy. Modelling of control point (CP) spacing, Leaf-end Separation and MLC/Aperture shape was performed to rule out causes of discrepancies between planned and delivered doses. Additionally estimated arc delivery times, overall plan generation times and effect of CP spacing and number of arcs on plan generation times were recorded. Results: Single arc SmartArc plans (SA4d) were generally better than IMRT and double arc plans (SA2Arcs) in terms of homogeneity and target coverage. Double arc plans seemed to have a positive role in achieving improved Conformity Index (CI) and better sparing of some Organs at Risk (OARs) compared to Step and Shoot IMRT (ss-IMRT) and SA4d. Overall Ergo++ plans achieved best CI for both PTVs. Dosimetric validation of all VMAT plans without modelling was found to be lower than ss-IMRT. Total MUs required for delivery were on average 19%, 30%, 10.6% and 6.5% lower than ss-IMRT for SA4d, SA2d (Single arc with 20 Gantry Spacing), SA2Arcs and Autobeam plans respectively. Autobeam was most efficient in terms of actual treatment delivery times whereas Ergo++ plans took longest to deliver. Conclusion: Overall SA single arc plans on average achieved best target coverage and homogeneity for both PTVs. SA2Arc plans showed improved CI and some OARs sparing. Very good dosimetric results were achieved with modelling. Ergo++ plans achieved best CI. Autobeam resulted in fastest treatment delivery times.
Abstract: Field mapping activity for an active volcano mainly in
the Torrid Zone is usually hampered by several problems such as steep
terrain and bad atmosphere conditions. In this paper we present a
simple solution for such problem by a combination Synthetic Aperture
Radar (SAR) and geostatistical methods. By this combination, we
could reduce the speckle effect from the SAR data and then estimate
roughness distribution of the pyroclastic flow deposits. The main
purpose of this study is to detect spatial distribution of new pyroclastic
flow deposits termed as P-zone accurately using the β°data from two
RADARSAT-1 SAR level-0 data. Single scene of Hyperion data and
field observation were used for cross-validation of the SAR results.
Mt. Merapi in central Java, Indonesia, was chosen as a study site and
the eruptions in May-June 2006 were examined. The P-zones were
found in the western and southern flanks. The area size and the longest
flow distance were calculated as 2.3 km2 and 6.8 km, respectively. The
grain size variation of the P-zone was mapped in detail from fine to
coarse deposits regarding the C-band wavelength of 5.6 cm.
Abstract: This paper describes a novel projection algorithm, the Projection Onto Span Algorithm (POSA) for wavelet-based superresolution and removing speckle (in wavelet domain) of unknown variance from Synthetic Aperture Radar (SAR) images. Although the POSA is good as a new superresolution algorithm for image enhancement, image metrology and biometric identification, here one will use it like a tool of despeckling, being the first time that an algorithm of super-resolution is used for despeckling of SAR images. Specifically, the speckled SAR image is decomposed into wavelet subbands; POSA is applied to the high subbands, and reconstruct a SAR image from the modified detail coefficients. Experimental results demonstrate that the new method compares favorably to several other despeckling methods on test SAR images.
Abstract: This work deals with unsupervised image deblurring.
We present a new deblurring procedure on images provided by lowresolution
synthetic aperture radar (SAR) or simply by multimedia in
presence of multiplicative (speckle) or additive noise, respectively.
The method we propose is defined as a two-step process. First, we
use an original technique for noise reduction in wavelet domain.
Then, the learning of a Kohonen self-organizing map (SOM) is
performed directly on the denoised image to take out it the blur. This
technique has been successfully applied to real SAR images, and the
simulation results are presented to demonstrate the effectiveness of
the proposed algorithms.
Abstract: Synthetic Aperture Radar (SAR) is an imaging radar form by taking full advantage of the relative movement of the antenna with respect to the target. Through the simultaneous processing of the radar reflections over the movement of the antenna via the Range Doppler Algorithm (RDA), the superior resolution of a theoretical wider antenna, termed synthetic aperture, is obtained. Therefore, SAR can achieve high resolution two dimensional imagery of the ground surface. In addition, two filtering steps in range and azimuth direction provide accurate enough result. This paper develops a simulation in which realistic SAR images can be generated. Also, the effect of velocity errors in the resulting image has also been investigated. Taking some velocity errors into account, the simulation results on the image resolution would be presented. Most of the times, algorithms need to be adjusted for particular datasets, or particular applications.
Abstract: For a generalized Hermite sinosiodal / hyperbolic Gaussian beam passing through an ABCD system with a finite aperture, the propagation properties are derived using the Collins integral. The results are obtained in the form of intensity graphs indicating that previously demonstrated rules of reciprocity are applicable, while the existence of the aperture accelerates this transformation.
Abstract: Visualizing sound and noise often help us to determine
an appropriate control over the source localization. Near-field acoustic
holography (NAH) is a powerful tool for the ill-posed problem.
However, in practice, due to the small finite aperture size, the discrete
Fourier transform, FFT based NAH couldn-t predict the activeregion-
of-interest (AROI) over the edges of the plane. Theoretically
few approaches were proposed for solving finite aperture problem.
However most of these methods are not quite compatible for the
practical implementation, especially near the edge of the source. In
this paper, a zip-stuffing extrapolation approach has suggested with
2D Kaiser window. It is operated on wavenumber complex space
to localize the predicted sources. We numerically form a practice
environment with touch impact databases to test the localization of
sound source. It is observed that zip-stuffing aperture extrapolation
and 2D window with evanescent components provide more accuracy
especially in the small aperture and its derivatives.
Abstract: In the paper the study of synthetic transmit aperture
method applying the Golay coded transmission for medical
ultrasound imaging is presented. Longer coded excitation allows to
increase the total energy of the transmitted signal without increasing
the peak pressure. Moreover signal-to-noise ratio and penetration
depth are improved while maintaining high ultrasound image
resolution. In the work the 128-element linear transducer array with
0.3 mm inter-element spacing excited by one cycle and the 8 and 16-
bit Golay coded sequences at nominal frequency 4 MHz was used. To
generate a spherical wave covering the full image region a single
element transmission aperture was used and all the elements received
the echo signals. The comparison of 2D ultrasound images of the
tissue mimicking phantom and in vitro measurements of the beef liver
is presented to illustrate the benefits of the coded transmission. The
results were obtained using the synthetic aperture algorithm with
transmit and receive signals correction based on a single element
directivity function.
Abstract: To establish optical communication between any two
satellites, the transmitter satellite must track the beacon of the
receiver satellite and point the information optical beam in its
direction. Optical tracking and pointing systems for free space suffer
during tracking from high-amplitude vibration because of
background radiation from interstellar objects such as the Sun, Moon,
Earth, and stars in the tracking field of view or the mechanical
impact from satellite internal and external sources. The vibrations of
beam pointing increase the bit error rate and jam communication
between the two satellites. One way to overcome this problem is the
use of very small transmitter beam divergence angles of too narrow
divergence angle is that the transmitter beam may sometimes miss
the receiver satellite, due to pointing vibrations. In this paper we
propose the use of genetic algorithm to optimize the BER as function
of transmitter optics aperture.
Abstract: The output beam quality of multi transverse modes of
laser, are relatively poor. In order to obtain better beam quality, one
may use an aperture inside the laser resonator. In this case, various
transverse modes can be selected. We have selected various
transverse modes both by simulation and doing experiment. By
inserting a circular aperture inside the diode end-pumped Nd:YAG
pulsed laser resonator, we have obtained 00 TEM , 01 TEM
, 20 TEM and have studied which parameters, can change the mode
shape. Then, we have determined the beam quality factor of TEM00
gaussian mode.
Abstract: In this paper, a new probability density function (pdf)
is proposed to model the statistics of wavelet coefficients, and a
simple Kalman-s filter is derived from the new pdf using Bayesian
estimation theory. Specifically, we decompose the speckled image
into wavelet subbands, we apply the Kalman-s filter to the high
subbands, and reconstruct a despeckled image from the modified
detail coefficients. Experimental results demonstrate that our method
compares favorably to several other despeckling methods on test
synthetic aperture radar (SAR) images.
Abstract: Recently, several designs of single fed circularly
polarized microstrip antennas have been studied. Relatively, a few
designs for achieving circular polarization using triangular microstrip
antenna are available. Typically existing design of single fed
circularly polarized triangular microstrip antennas include the use of
equilateral triangular patch with a slit or a horizontal slot on the patch
or addition a narrow band stub on the edge or a vertex of triangular
patch.
In other word, with using a narrow band tune stub on middle of an
edge of triangle causes of facility to compensate the possible
fabrication error and substrate materials with easier adjusting the
tuner stub length. Even though disadvantages of this method is very
long of stub (approximate 1/3 length of triangle edge). In this paper,
instead of narrow band stub, a wide band stub has been applied,
therefore the length of stub by this method has been decreased
around 1/10 edge of triangle in addition changing the aperture angle
of stub, provides more facility for designing and producing circular
polarization wave.
Abstract: A new technique to quantify the differential mode
delay (DMD) in multimode fiber (MMF) is been presented. The
technique measures DMD based on angular launch and
measurements of the difference in modal delay using variable
apertures at the fiber face. The result of the angular spatial filtering
revealed less excitation of higher order modes when the laser beam is
filtered at higher angles. This result would indicate that DMD
profiles would experience a data pattern dependency.
Abstract: The paper presents the optimization problem for the
multi-element synthetic transmit aperture method (MSTA) in
ultrasound imaging applications. The optimal choice of the transmit
aperture size is performed as a trade-off between the lateral
resolution, penetration depth and the frame rate. Results of the
analysis obtained by a developed optimization algorithm are
presented. Maximum penetration depth and the best lateral resolution
at given depths are chosen as the optimization criteria. The
optimization algorithm was tested using synthetic aperture data of
point reflectors simulated by Filed II program for Matlab® for the
case of 5MHz 128-element linear transducer array with 0.48 mm
pitch are presented. The visualization of experimentally obtained
synthetic aperture data of a tissue mimicking phantom and in vitro
measurements of the beef liver are also shown. The data were
obtained using the SonixTOUCH Research systemequipped with a
linear 4MHz 128 element transducerwith 0.3 mm element pitch, 0.28
mm element width and 70% fractional bandwidth was excited by one
sine cycle pulse burst of transducer's center frequency.