Abstract: In a wind power generator using doubly fed induction
generator (DFIG), the three-phase pulse width modulation (PWM)
voltage source converter (VSC) is used as grid side converter (GSC)
and rotor side converter (RSC). The standard linear control laws
proposed for GSC provides not only instablity against comparatively
large-signal disturbances, but also the problem of stability due to
uncertainty of load and variations in parameters. In this paper, a
nonlinear controller is designed for grid side converter (GSC) of a
DFIG for wind power application. The nonlinear controller is
designed based on the input-output feedback linearization control
method. The resulting closed-loop system ensures a sufficient
stability region, make robust to variations in circuit parameters and
also exhibits good transient response. Computer simulations and
experimental results are presented to confirm the effectiveness of the
proposed control strategy.
Abstract: In this paper we present a new approach to detecting a
flaw in T.O.F.D (Time Of Flight Diffraction) type ultrasonic image
based on texture features. Texture is one of the most important
features used in recognizing patterns in an image. The paper
describes texture features based on 2D Gabor functions, i.e.,
Gaussian shaped band-pass filters, with dyadic treatment of the radial
spatial frequency range and multiple orientations, which represent an
appropriate choice for tasks requiring simultaneous measurement in
both space and frequency domains. The most relevant features are
used as input data on a Fuzzy c-mean clustering classifier. The
classes that exist are only two: 'defects' or 'no defects'. The proposed
approach is tested on the T.O.F.D image achieved at the laboratory
and on the industrial field.
Abstract: For gamma radiation detection, assemblies having
scintillation crystals and a photomultiplier tube, also there is a
preamplifier connected to the detector because the signals from
photomultiplier tube are of small amplitude. After pre-amplification
the signals are sent to the amplifier and then to the multichannel
analyser. The multichannel analyser sorts all incoming electrical
signals according to their amplitudes and sorts the detected photons
in channels covering small energy intervals. The energy range of
each channel depends on the gain settings of the multichannel
analyser and the high voltage across the photomultiplier tube. The
exit spectrum data of the two main isotopes studied ,putting data in
biomass program ,process it by Matlab program to get the solid
holdup image (solid spherical nuclear fuel)
Abstract: The new semi-experimental method for simulation of
the turbine flow meters rotation in the transitional flow has been
developed. The method is based on the experimentally established
exponential low of changing of dimensionless relative turbine gas
meter rotation frequency and meter inertia time constant. For
experimental evaluation of the meter time constant special facility
has been developed. The facility ensures instant switching of turbine
meter under test from one channel to the other channel with different
flow rate and measuring the meter response. The developed method
can be used for evaluation and predication of the turbine meters
response and dynamic error in the transitional flow with any arbitrary
law of flow rate changing. The examples of the method application
are presented.
Abstract: In this paper, a parametric experimental study for producing paving blocks using fine and coarse waste glass is presented. Some of the physical and mechanical properties of paving blocks having various levels of fine glass (FG) and coarse glass (CG) replacements with fine aggregate (FA) are investigated. The test results show that the replacement of FG by FA at level of 20% by weight has a significant effect on the compressive strength, flexural strength, splitting tensile strength and abrasion resistance of the paving blocks as compared with the control sample because of puzzolanic nature of FG. The compressive strength, flexural strength, splitting tensile strength and abrasion resistance of the paving block samples in the FG replacement level of 20% are 69%, 90%, 47% and 15 % higher as compared with the control sample respectively. It is reported in the earlier works the replacement of FG by FA at level of 20% by weight suppress the alkali-silica reaction (ASR) in the concrete. The test results show that the FG at level of 20% has a potential to be used in the production of paving blocks. The beneficial effect on these properties of CG replacement with FA is little as compared with FG.
Abstract: The objective of global optimization is to find the
globally best solution of a model. Nonlinear models are ubiquitous
in many applications and their solution often requires a global
search approach; i.e. for a function f from a set A ⊂ Rn to
the real numbers, an element x0 ∈ A is sought-after, such that
∀ x ∈ A : f(x0) ≤ f(x). Depending on the field of application,
the question whether a found solution x0 is not only a local minimum
but a global one is very important.
This article presents a probabilistic approach to determine the
probability of a solution being a global minimum. The approach is
independent of the used global search method and only requires a
limited, convex parameter domain A as well as a Lipschitz continuous
function f whose Lipschitz constant is not needed to be known.
Abstract: The article examines the methods of protection of
citizens' personal data on the Internet using biometric identity
authentication technology. It`s celebrated their potential danger due
to the threat of loss of base biometric templates. To eliminate the
threat of compromised biometric templates is proposed to use neural
networks large and extra-large sizes, which will on the one hand
securely (Highly reliable) to authenticate a person by his biometrics,
and on the other hand make biometrics a person is not available for
observation and understanding. This article also describes in detail
the transformation of personal biometric data access code. It`s formed
the requirements for biometrics converter code for his work with the
images of "Insider," "Stranger", all the "Strangers". It`s analyzed the
effect of the dimension of neural networks on the quality of
converters mystery of biometrics in access code.
Abstract: The software system goes through a number of stages
during its life and a software process model gives a standard format
for planning, organizing and running a project. The article presents a
new software development process model named as “Divide and
Conquer Process Model", based on the idea first it divides the things
to make them simple and then gathered them to get the whole work
done. The article begins with the backgrounds of different software
process models and problems in these models. This is followed by a
new divide and conquer process model, explanation of its different
stages and at the end edge over other models is shown.
Abstract: In the paper a detailed analysis of the dynamic
response of a cooling tower shell to mining tremors originated from
two main regions of mining activity in Poland (Upper Silesian Coal
Basin and Legnica-Glogow Copper District) was presented. The
representative time histories registered in the both regions were used
as ground motion data in calculations of the dynamic response of the
structure. It was proved that the dynamic response of the shell is
strongly dependent not only on the level of vibration amplitudes but
on the dominant frequency range of the mining shock typical for the
mining region as well. Also a vertical component of vibrations
occurred to have considerable influence on the total dynamic
response of the shell. Finally, it turned out that non-uniformity of
kinematic excitation resulting from spatial variety of ground motion
plays a significant role in dynamic analysis of large-dimensional
shells under mining shocks.
Abstract: An implementation of current-mode multiphase sinusoidal oscillators is presented. Using CFTA-based lossy integrators, odd and odd/even phase systems can be realized with following advantages. The condition of oscillation and frequency of oscillation can be orthogonally tuned. The high output impedances facilitate easy driving an external load without additional current buffers. The proposed MSOs provide odd or even phase signals that are equally spaced in phase and equal amplitude. The circuit requires one CFTA, one resistor and one grounded capacitor per phase without additional current amplifier. The results of PSPICE simulations using CMOS CFTA are included to verify theory.
Abstract: In historical science and social science, the influence
of natural disaster upon society is a matter of great interest. In
recent years, some archives are made through many hands for natural
disasters, however it is inefficiency and waste. So, we suppose a
computer system to create a historical natural disaster archive. As
the target of this analysis, we consider newspaper articles. The news
articles are considered to be typical examples that prescribe the
temporal relations of affairs for natural disaster. In order to do this
analysis, we identify the occurrences in newspaper articles by some
index entries, considering the affairs which are specific to natural
disasters, and show the temporal relation between natural disasters.
We designed and implemented the automatic system of “extraction
of the occurrences of natural disaster" and “temporal relation table
for natural disaster."
Abstract: The hydrodynamic and thermal lattice Boltzmann
methods are applied to investigate the turbulent convective heat
transfer in the wavy channel flows. In this study, the turbulent
phenomena are modeling by large-eddy simulations with the
Smagorinsky model. As a benchmark, the laminar and turbulent
backward-facing step flows are simulated first. The results give good
agreement with other numerical and experimental data. For wavy
channel flows, the distribution of Nusselt number and the skin-friction
coefficients are calculated to evaluate the heat transfer effect and the
drag force. It indicates that the vortices at the trough would affect the
magnitude of drag and weaken the heat convection effects on the wavy
surface. In turbulent cases, if the amplitude of the wavy boundary is
large enough, the secondary vortices would be generated at troughs
and contribute to the heat convection. Finally, the effects of different
Re on the turbulent transport phenomena are discussed.
Abstract: The PRAF family of proteins is a plant specific family of proteins with distinct domain architecture and various unique sequence/structure traits. We have carried out an extensive search of the Arabidopsis genome using an automated pipeline and manual methods to verify previously known and identify unknown instances of PRAF proteins, characterize their sequence and build 3D structures of their individual domains. Integrating the sequence, structure and whatever little known experimental details for each of these proteins and their domains, we present a comprehensive characterization of the different domains in these proteins and their variant properties.
Abstract: Exposure to radon occurs when breathing airborne
radon while using water: showering, washing dishes, cooking, and
drinking water that contain radon. The results of radon activity
measurements in water from public drinking fountain in city of Novi
Sad, Serbia is presented in this paper. Radon level in some samples
exceeded EPA (Environmental Protection Agency) recommendation
for maximum contaminant level (MCL) for radon in drinking water
of 11.1 Bq/l.
Abstract: This paper considers the integration of assembly
operations and product structure to Cellular Manufacturing System
(CMS) design so that to correct the drawbacks of previous researches
in the literature. For this purpose, a new mathematical model is
developed which dedicates machining and assembly operations to
manufacturing cells while the objective function is to minimize the
intercellular movements resulting due to both of them. A
linearization method is applied to achieve optimum solution through
solving aforementioned nonlinear model by common programming
language such as Lingo. Then, using different examples and
comparing the results, the importance of integrating assembly
considerations is demonstrated.
Abstract: Due to the increasing penetration of wind energy, it is
necessary to possess design tools that are able to simulate the impact
of these installations in utility grids. In order to provide a net
contribution to this issue a detailed wind park model has been
developed and is briefly presented. However, the computational costs
associated with the performance of such a detailed model in
describing the behavior of a wind park composed by a considerable
number of units may render its practical application very difficult. To
overcome this problem integral manifolds theory has been applied to
reduce the order of the detailed wind park model, and therefore
create the conditions for the development of a dynamic equivalent
which is able to retain the relevant dynamics with respect to the
existing a.c. system. In this paper integral manifold method has been
introduced for order reduction. Simulation results of the proposed
method represents that integral manifold method results fit the
detailed model results with a higher precision than singular
perturbation method.
Abstract: Real-time embedded systems should benefit from
component-based software engineering to handle complexity and
deal with dependability. In these systems, applications should not
only be logically correct but also behave within time windows.
However, in the current component based software engineering
approaches, a few of component models handles time properties in
a manner that allows efficient analysis and checking at the
architectural level. In this paper, we present a meta-model for
component-based software description that integrates timing
issues. To achieve a complete functional model of software
components, our meta-model focuses on four functional aspects:
interface, static behavior, dynamic behavior, and interaction
protocol. With each aspect we have explicitly associated a time
model. Such a time model can be used to check a component-s
design against certain properties and to compute the timing
properties of component assemblies.
Abstract: Wireless Sensor Network is widely used in electronics. Wireless sensor networks are now used in many applications including military, environmental, healthcare applications, home automation and traffic control. We will study one area of wireless sensor networks, which is the routing protocol. Routing protocols are needed to send data between sensor nodes and the base station. In this paper, we will discuss two routing protocols, such as datacentric and hierarchical routing protocol. We will show the output of the protocols using the NS-2 simulator. This paper will compare the simulation output of the two routing protocol using Nam. We will simulate using Xgraph to find the throughput and delay of the protocol.
Abstract: In this paper, by applying Mawhin-s continuation theorem of coincidence degree theory, we study the existence of almost periodic solutions for neural multi-delay logarithmic population model and obtain one sufficient condition for the existence of positive almost periodic solution for the above equation. An example is employed to illustrate our result.
Abstract: One of the most used assumptions in logic programming
and deductive databases is the so-called Closed World Assumption
(CWA), according to which the atoms that cannot be inferred
from the programs are considered to be false (i.e. a pessimistic
assumption). One of the most successful semantics of conventional
logic programs based on the CWA is the well-founded semantics.
However, the CWA is not applicable in all circumstances when
information is handled. That is, the well-founded semantics, if
conventionally defined, would behave inadequately in different cases.
The solution we adopt in this paper is to extend the well-founded
semantics in order for it to be based also on other assumptions. The
basis of (default) negative information in the well-founded semantics
is given by the so-called unfounded sets. We extend this concept
by considering optimistic, pessimistic, skeptical and paraconsistent
assumptions, used to complete missing information from a program.
Our semantics, called extended well-founded semantics, expresses
also imperfect information considered to be missing/incomplete,
uncertain and/or inconsistent, by using bilattices as multivalued
logics. We provide a method of computing the extended well-founded
semantics and show that Kripke-Kleene semantics is captured by
considering a skeptical assumption. We show also that the complexity
of the computation of our semantics is polynomial time.