Abstract: A simple and dexterous in situ method was introduced to load CdS nanocrystals into organofunctionalized mesoporous, which used an ion-exchange method. The products were extensively characterized by combined spectroscopic methods. X- ray diffraction (XRD) and high-resolution transmission electron microscopy (HRTEM) demonstrated both the maintenance of pore symmetry (space group p6mm) of SBA-15 and the presence of CdS nanocrystals with uniform sizes of about 6 - 8 nm inside the functionalized SBA-15 channels. These mesoporous silica-supported CdS composites showed room temperature photoluminescence properties with a blue shift, indicating the quantum size effect of nanocrystalline CdS.
Abstract: Tea is consumed by a big part of the world-s
population. It has an enormous importance for the Turkish culture.
Nearly it is brewed every morning and evening at the all houses. Also it is consumed with lemon wedge. Habitual drinking of tea
infusions may significantly contribute to daily dietary requirements of elements.
Different instrumental techniques are used for determination of
these elements. But atomic and mass spectroscopic methods are preferred most. In these study chromium, iron and selenium contents
after the hot water brewing of black and green tea were determined
by Optical Emission Spectroscopy (ICP-OES). Furthermore, effect
of lemon addition on chromium, iron and selenium concentration tea
infusions is investigated.
Results of the investigation showed that concentration of
chromium, iron and selenium increased in black tea with lemon addition. On the other hand only selenium is increased with lemon
addition in green tea. And iron concentration is not detected in green
tea but its concentration is determined as 1.420 ppm after lemon addition.
Abstract: In this paper, a new K-means clustering based
approach for identification of voltage control areas is developed.
Voltage control areas are important for efficient reactive power
management in power systems operating under deregulated
environment. Although, voltage control areas are formed using
conventional hierarchical clustering based method, but the present
paper investigate the capability of K-means clustering for the
purpose of forming voltage control areas. The proposed method is
tested and compared for IEEE 14 bus and IEEE 30 bus systems. The
results show that this K-means based method is competing with
conventional hierarchical approach
Abstract: Topical photodynamic therapy (PDT) with
5-aminolevulinic acid (ALA) is an alternative therapy for treating
superficial cancer, especially for skin or oral cancer. ALA, a precursor
of the photosensitizer protoporphyrin IX (PpIX), is present as
zwitterions and hydrophilic property which make the low permeability
through the cell membrane. Collagen is a traditional carrier; its
molecular composed various amino acids which bear positive charge
and negative charge. In order to utilize the ion-pairs with ALA and
collagen, the study employed various pH values adjusting the net
charge. The aim of this study was to compare a series collagen form,
including solution, gel and sponge to investigate the topical delivery
behavior of ALA. The in vivo confocal laser scanning microscopy
(CLSM) study demonstrated that PpIX generation ability was different
pattern after apply for 6 h. Gel type could generate high PpIX, and
archived more deep of skin depth.
Abstract: Methods to detect and localize time singularities of polynomial and quasi-polynomial ordinary differential equations are systematically presented and developed. They are applied to examples taken form different fields of applications and they are also compared to better known methods such as those based on the existence of linear first integrals or Lyapunov functions.
Abstract: Power flow (PF) study, which is performed to
determine the power system static states (voltage magnitudes and
voltage angles) at each bus to find the steady state operating
condition of a system, is very important and is the most frequently
carried out study by power utilities for power system planning,
operation and control. In this paper, a counterpropagation neural
network (CPNN) is proposed to solve power flow problem under
different loading/contingency conditions for computing bus voltage
magnitudes and angles of the power system. The counterpropagation
network uses a different mapping strategy namely
counterpropagation and provides a practical approach for
implementing a pattern mapping task, since learning is fast in this
network. The composition of the input variables for the proposed
neural network has been selected to emulate the solution process of a
conventional power flow program. The effectiveness of the proposed
CPNN based approach for solving power flow is demonstrated by
computation of bus voltage magnitudes and voltage angles for
different loading conditions and single line-outage contingencies in
IEEE 14-bus system.
Abstract: Multi-agent system is composed by several agents
capable of reaching the goal cooperatively. The system needs an agent
platform for efficient and stable interaction between intelligent agents.
In this paper we propose a flexible and scalable agent platform by
composing the containers with multiple hierarchical agent groups. It
also allows efficient implementation of multiple domain presentations
of the agents unlike JADE. The proposed platform provides both
group management and individual management of agents for
efficiency. The platform has been implemented and tested, and it can
be used as a flexible foundation of the dynamic multi-agent system
targeting seamless delivery of ubiquitous services.
Abstract: Timetabling problems are often hard and timeconsuming
to solve. Most of the methods of solving them concern
only one problem instance or class. This paper describes a universal
method for solving large, highly constrained timetabling problems
from different domains. The solution is based on evolutionary
algorithm-s framework and operates on two levels – first-level
evolutionary algorithm tries to find a solution basing on given set of
operating parameters, second-level algorithm is used to establish
those parameters. Tabu search is employed to speed up the solution
finding process on first level. The method has been used to solve
three different timetabling problems with promising results.
Abstract: This work presents a multiple objective linear programming (MOLP) model based on the desirability function approach for solving the aggregate production planning (APP) decision problem upon Masud and Hwang-s model. The proposed model minimises total production costs, carrying or backordering costs and rates of change in labor levels. An industrial case demonstrates the feasibility of applying the proposed model to the APP problems with three scenarios of inventory levels. The proposed model yields an efficient compromise solution and the overall levels of DM satisfaction with the multiple combined response levels. There has been a trend to solve complex planning problems using various metaheuristics. Therefore, in this paper, the multi-objective APP problem is solved by hybrid metaheuristics of the hunting search (HuSIHSA) and firefly (FAIHSA) mechanisms on the improved harmony search algorithm. Results obtained from the solution of are then compared. It is observed that the FAIHSA can be used as a successful alternative solution mechanism for solving APP problems over three scenarios. Furthermore, the FAIHSA provides a systematic framework for facilitating the decision-making process, enabling a decision maker interactively to modify the desirability function approach and related model parameters until a good optimal solution is obtained with proper selection of control parameters when compared.
Abstract: Hepatitis C is an infectious disease transmitted by
blood and due to hepatitis C virus (HCV), which attacks the liver.
The infection is characterized by liver inflammation (hepatitis) that is
often asymptomatic but can progress to chronic hepatitis and later
cirrhosis and liver cancer. Our problem tends to highlight on the one
hand the prevalence of infectious disease in the population of the
region of Batna and on other hand the biological characteristics of
this disease by a screening and a specific diagnosis based on
serological tests, liver checkup (measurement of haematological and
biochemical parameters).
The results showed:
The serology of hepatitis C establishes the diagnosis of infection
with hepatitis C. In this study and with the serological test, 24 cases
of the disease of hepatitis C were found in 1000 suspected cases (7
cases with normal transaminases and 17 cases with elevated
transaminases). The prevalence of this disease in this study
population was 2.4%.
The presence of hepatitis C disrupts liver function including the
onset of cytolysis, cholestasis, jaundice, thrombocytopenia, and
coagulation disorders.
Abstract: This paper deals with the tuning of parameters for Automatic Generation Control (AGC). A two area interconnected hydrothermal system with PI controller is considered. Genetic Algorithm (GA) and Particle Swarm optimization (PSO) algorithms have been applied to optimize the controller parameters. Two objective functions namely Integral Square Error (ISE) and Integral of Time-multiplied Absolute value of the Error (ITAE) are considered for optimization. The effectiveness of an objective function is considered based on the variation in tie line power and change in frequency in both the areas. MATLAB/SIMULINK was used as a simulation tool. Simulation results reveal that ITAE is a better objective function than ISE. Performances of optimization algorithms are also compared and it was found that genetic algorithm gives better results than particle swarm optimization algorithm for the problems of AGC.
Abstract: In the present simulation work, an attempt is made to study the switching dynamics of an optically controlled 4HSiC thyristor power semiconductor device with the use of GaAs optically triggered power transistor. The half-cell thyristor has the forward breakdown of 200 V and reverse breakdown of more than 1000 V. The optically controlled thyristor has a rise time of 0.14 μs and fall time of 0.065 μs. The turn-on and turn-off delays are 0.1 μs and 0.06 μs, respectively. In addition, this optically controlled thyristor is used as a control switch for the DC-DC Boost converter. The pn-diode used for the converter has the forward drop of 2.8 V and reverse breakdown of around 400 V.
Abstract: Human activity is a major concern in a wide variety of
applications, such as video surveillance, human computer interface
and face image database management. Detecting and recognizing
faces is a crucial step in these applications. Furthermore, major
advancements and initiatives in security applications in the past years
have propelled face recognition technology into the spotlight. The
performance of existing face recognition systems declines significantly
if the resolution of the face image falls below a certain level.
This is especially critical in surveillance imagery where often, due to
many reasons, only low-resolution video of faces is available. If these
low-resolution images are passed to a face recognition system, the
performance is usually unacceptable. Hence, resolution plays a key
role in face recognition systems. In this paper we introduce a new
low resolution face recognition system based on mixture of expert
neural networks. In order to produce the low resolution input images
we down-sampled the 48 × 48 ORL images to 12 × 12 ones using
the nearest neighbor interpolation method and after that applying
the bicubic interpolation method yields enhanced images which is
given to the Principal Component Analysis feature extractor system.
Comparison with some of the most related methods indicates that
the proposed novel model yields excellent recognition rate in low
resolution face recognition that is the recognition rate of 100% for
the training set and 96.5% for the test set.
Abstract: The model-based approach to user interface design
relies on developing separate models capturing various aspects about
users, tasks, application domain, presentation and dialog structures.
This paper presents a task modeling approach for user interface
design and aims at exploring mappings between task, domain and
presentation models. The basic idea of our approach is to identify
typical configurations in task and domain models and to investigate
how they relate each other. A special emphasis is put on applicationspecific
functions and mappings between domain objects and
operational task structures. In this respect, we will address two
layers in task decomposition: a functional (planning) layer and an
operational layer.
Abstract: In this paper, we propose a new model of English-
Vietnamese bilingual Information Retrieval system. Although there
are so many CLIR systems had been researched and built, the accuracy of searching results in different languages that the CLIR
system supports still need to improve, especially in finding bilingual documents. The problems identified in this paper are the limitation of
machine translation-s result and the extra large collections of document to be found. So we try to establish a different model to overcome these problems.
Abstract: The development of Internet technology in recent years has led to a more active role of users in creating Web content. This has significant effects both on individual learning and collaborative knowledge building. This paper will present an integrative framework model to describe and explain learning and knowledge building with shared digital artifacts on the basis of Luhmann-s systems theory and Piaget-s model of equilibration. In this model, knowledge progress is based on cognitive conflicts resulting from incongruities between an individual-s prior knowledge and the information which is contained in a digital artifact. Empirical support for the model will be provided by 1) applying it descriptively to texts from Wikipedia, 2) examining knowledge-building processes using a social network analysis, and 3) presenting a survey of a series of experimental laboratory studies.
Abstract: In the urban traffic network, the intersections are the
“bottleneck point" of road network capacity. And the arterials are the
main body in road network and the key factor which guarantees the
normal operation of the city-s social and economic activities. The
rapid increase in vehicles leads to seriously traffic jam and cause the
increment of vehicles- delay. Most cities of our country are
traditional single control system, which cannot meet the need for the
city traffic any longer. In this paper, Synchro6.0 as a platform to
minimize the intersection delay, optimizesingle signal cycle and split
for Zhonghua Street in Handan City. Meanwhile, linear control
system uses to optimize the phase for the t arterial road in this
system. Comparing before and after use the control, capacities and
service levels of this road and the adjacent road have improved
significantly.
Abstract: The mineral having chemical compositional formula MgAl2O4 is called “spinel". The ferrites crystallize in spinel structure are known as spinel-ferrites or ferro-spinels. The spinel structure has a fcc cage of oxygen ions and the metallic cations are distributed among tetrahedral (A) and octahedral (B) interstitial voids (sites). The X-ray diffraction (XRD) intensity of each Bragg plane is sensitive to the distribution of cations in the interstitial voids of the spinel lattice. This leads to the method of determination of distribution of cations in the spinel oxides through XRD intensity analysis. The computer program for XRD intensity analysis has been developed in C language and also tested for the real experimental situation by synthesizing the spinel ferrite materials Mg0.6Zn0.4AlxFe2- xO4 and characterized them by X-ray diffractometry. The compositions of Mg0.6Zn0.4AlxFe2-xO4(x = 0.0 to 0.6) ferrites have been prepared by ceramic method and powder X-ray diffraction patterns were recorded. Thus, the authenticity of the program is checked by comparing the theoretically calculated data using computer simulation with the experimental ones. Further, the deduced cation distributions were used to fit the magnetization data using Localized canting of spins approach to explain the “recovery" of collinear spin structure due to Al3+ - substitution in Mg-Zn ferrites which is the case if A-site magnetic dilution and non-collinear spin structure. Since the distribution of cations in the spinel ferrites plays a very important role with regard to their electrical and magnetic properties, it is essential to determine the cation distribution in spinel lattice.
Abstract: This paper proposes a prototype of a lower-limb
rehabilitation system for recovering and strengthening patients-
injured lower limbs. The system is composed of traction motors for
each leg position, a treadmill as a walking base, tension sensors,
microcontrollers controlling motor functions and a main system with
graphic user interface. For derivation of reference or normal velocity
profiles of the body segment point, kinematic method is applied based
on the humanoid robot model using the reference joint angle data of
normal walking.
Abstract: In this paper, the discrete-time fuzzy BAM neural network with delays and impulses is studied. Sufficient conditions are obtained for the existence and global stability of a unique equilibrium of this class of fuzzy BAM neural networks with Lipschitzian activation functions without assuming their boundedness, monotonicity or differentiability and subjected to impulsive state displacements at fixed instants of time. Some numerical examples are given to demonstrate the effectiveness of the obtained results.