Abstract: A fully on-chip low drop-out (LDO) voltage regulator with 100pF output load capacitor is presented. A novel frequency compensation scheme using current buffer is adopted to realize single dominant pole within the unit gain frequency of the regulation loop, the phase margin (PM) is at least 50 degree under the full range of the load current, and the power supply rejection (PSR) character is improved compared with conventional Miller compensation. Besides, the differentiator provides a high speed path during the load current transient. Implemented in 0.18μm CMOS technology, the LDO voltage regulator provides 100mA load current with a stable 1.8V output voltage consuming 80μA quiescent current.
Abstract: Gas hydrates can agglomerate and block multiphase oil and gas pipelines when water is present at hydrate forming conditions. Using "Cold Flow Technology", the aim is to condition gas hydrates so that they can be transported as a slurry mixture without a risk of agglomeration. During the pipeline shut down however, hydrate particles may settle in bends and build hydrate plugs. An experimental setup has been designed and constructed to study the flow of such plugs at start up operations. Experiments have been performed using model fluid and model hydrate particles. The propagations of initial plugs in a bend were recorded with impedance probes along the pipe. The experimental results show a dispersion of the plug front. A peak in pressure drop was also recorded when the plugs were passing the bend. The evolutions of the plugs have been simulated by numerical integration of the incompressible mass balance equations, with an imposed mixture velocity. The slip between particles and carrier fluid has been calculated using a drag relation together with a particle-fluid force balance.
Abstract: Moisture is an important consideration in many
aspects ranging from irrigation, soil chemistry, golf course, corrosion
and erosion, road conditions, weather predictions, livestock feed
moisture levels, water seepage etc. Vegetation and crops always
depend more on the moisture available at the root level than on
precipitation occurrence. In this paper, design of an instrument is
discussed which tells about the variation in the moisture contents of
soil. This is done by measuring the amount of water content in soil by
finding the variation in capacitance of soil with the help of a
capacitive sensor. The greatest advantage of soil moisture sensor is
reduced water consumption. The sensor is also be used to set lower
and upper threshold to maintain optimum soil moisture saturation and
minimize water wilting, contributes to deeper plant root growth
,reduced soil run off /leaching and less favorable condition for insects
and fungal diseases. Capacitance method is preferred because, it
provides absolute amount of water content and also measures water
content at any depth.
Abstract: The first generation of Mobile Agents based Intrusion
Detection System just had two components namely data collection
and single centralized analyzer. The disadvantage of this type of
intrusion detection is if connection to the analyzer fails, the entire
system will become useless. In this work, we propose novel hybrid
model for Mobile Agent based Distributed Intrusion Detection
System to overcome the current problem. The proposed model has
new features such as robustness, capability of detecting intrusion
against the IDS itself and capability of updating itself to detect new
pattern of intrusions. In addition, our proposed model is also capable
of tackling some of the weaknesses of centralized Intrusion Detection
System models.
Abstract: MC (Management Control)& IC (Internal Control) – what is the relationship? (an empirical study into the definitions between MC and IC) based on the wider considerations of Internal Control and Management Control terms, attention is focused not only on the financial aspects but also more on the soft aspects of the business, such as culture, behaviour, standards and values. The limited considerations of Management Control are focused mainly in the hard, financial aspects of business operation. The definitions of Management Control and Internal Control are often used interchangeably and the results of this empirical study reveal that Management Control is part of Internal Control, there is no causal link between the two concepts. Based on the interpretation of the respondents, the term Management Control has moved from a broad term to a more limited term with the soft aspects of the influencing of behaviour, performance measurements, incentives and culture. This paper is an exploratory study based on qualitative research and on a qualitative matrix method analysis of the thematic definition of the terms Management Control and Internal Control.
Abstract: A reliability, availability and maintainability (RAM) model has been built for acid gas removal plant for system analysis that will play an important role in any process modifications, if required, for achieving its optimum performance. Due to the complexity of the plant, the model was based on a Reliability Block Diagram (RBD) with a Monte Carlo simulation engine. The model has been validated against actual plant data as well as local expert opinions, resulting in an acceptable simulation model. The results from the model showed that the operation and maintenance can be further improved, resulting in reduction of the annual production loss.
Abstract: In this paper, the requirement for Coke quality
prediction, its role in Blast furnaces, and the model output is
explained. By applying method of Artificial Neural Networking
(ANN) using back propagation (BP) algorithm, prediction model has
been developed to predict CSR. Important blast furnace functions
such as permeability, heat exchanging, melting, and reducing
capacity are mostly connected to coke quality. Coke quality is further
dependent upon coal characterization and coke making process
parameters. The ANN model developed is a useful tool for process
experts to adjust the control parameters in case of coke quality
deviations. The model also makes it possible to predict CSR for new
coal blends which are yet to be used in Coke Plant. Input data to the
model was structured into 3 modules, for tenure of past 2 years and
the incremental models thus developed assists in identifying the
group causing the deviation of CSR.
Abstract: Compacted clay liners (CCLs) are the main materials
used in waste disposal landfills due to their low permeability. In this
study, the effect on the shear resistant of clays with inorganic salt
solutions as permeate fluid was experimentally investigated. For this
purpose, NaCl inorganic salt solution at concentrations of 2, 5, 10%
and deionized water were used. Laboratory direct shear and Vane
shear tests were conducted on three compacted clays with low,
medium and high plasticity. Results indicated that the solutions type
and its concentration affect the shear properties of the mixture. In the
light of this study, the influence magnitude of these inorganic salts in
varies concentrations in different clays were determined and more
suitable compacted clay with the compare of plasticity were found.
Abstract: This paper is a survey of current component-based
software technologies and the description of promotion and
inhibition factors in CBSE. The features that software components
inherit are also discussed. Quality Assurance issues in componentbased
software are also catered to. The feat research on the quality
model of component based system starts with the study of what the
components are, CBSE, its development life cycle and the pro &
cons of CBSE. Various attributes are studied and compared keeping
in view the study of various existing models for general systems and
CBS. When illustrating the quality of a software component an apt
set of quality attributes for the description of the system (or
components) should be selected. Finally, the research issues that can
be extended are tabularized.
Abstract: Bluetooth is a personal wireless communication
technology and is being applied in many scenarios. It is an emerging
standard for short range, low cost, low power wireless access
technology. Current existing MAC (Medium Access Control)
scheduling schemes only provide best-effort service for all masterslave
connections. It is very challenging to provide QoS (Quality of
Service) support for different connections due to the feature of
Master Driven TDD (Time Division Duplex). However, there is no
solution available to support both delay and bandwidth guarantees
required by real time applications. This paper addresses the issue of
how to enhance QoS support in a Bluetooth piconet. The Bluetooth
specification proposes a Round Robin scheduler as possible solution
for scheduling the transmissions in a Bluetooth Piconet. We propose
an algorithm which will reduce the bandwidth waste and enhance the
efficiency of network. We define token counters to estimate traffic of
real-time slaves. To increase bandwidth utilization, a back-off
mechanism is then presented for best-effort slaves to decrease the
frequency of polling idle slaves. Simulation results demonstrate that
our scheme achieves better performance over the Round Robin
scheduling.
Abstract: Lanthanum oxide is to be recovered from monazite,
which contains about 13.44% lanthanum oxide. The principal
objective of this study is to be able to extract lanthanum oxide from
monazite of Moemeik Myitsone Area. The treatment of monazite in
this study involves three main steps; extraction of lanthanum
hydroxide from monazite by using caustic soda, digestion with nitric
acid and precipitation with ammonium hydroxide and calcination of
lanthanum oxalate to lanthanum oxide.
Abstract: In this paper, the signal transmission analysis of the
semicircle-shaped via structure for the differential pairs is presented in
the frequency range up to 10 GHz. In order to improve the signal
transmission properties in the differential pairs, single via is separated
centrally into two semicircle-shaped sections, which are
interconnected with the traces of differential pairs respectively. This
via structure make possible to route differential pairs using only one
via. In addition, it can improve impedance discontinuity around its
region and then enhance the signal transmission properties in the
differential pairs. The electrical analysis such as S-parameter
calculation and eye diagram simulation has been performed to
investigate the improvement of the signal transmission property in the
differential pairs with new via structure.
Abstract: In order to improve control performance and eliminate steady, a coupling compensation for 6-DOF parallel robot is presented. Taking dynamic load Tank Simulator as the research object, this paper analyzes the coupling of 6-DOC parallel robot considering the degree of freedom of the 6-DOF parallel manipulator. The coupling angle and coupling velocity are derived based on inverse kinematics model. It uses the mechanism-model combined method which takes practical moving track that considering the performance of motion controller and motor as its input to make the study. Experimental results show that the coupling compensation improves motion stability as well as accuracy. Besides, it decreases the dither amplitude of dynamic load Tank Simulator.
Abstract: In this paper we study a system composed by carbon
nanotube (CNT) and bundle of carbon nanotube (BuCNT) interacting
with a specific fatty acid as molecular probe. Full system is
represented by open nanotube (or nanotubes) and the linoleic acid
(LA) relaxing due the interaction with CNT and BuCNT. The LA has
in his form an asymmetric shape with COOH termination provoking
a close BuCNT interaction mainly by van der Waals force field. The
simulations were performed by classical molecular dynamics with
standard parameterizations.
Our results show that these BuCNT and CNT are dynamically
stable and it shows a preferential interaction position with LA
resulting in three features: (i) when the LA is interacting with CNT
and BuCNT (including both termination, CH2 or COOH), the LA is
repelled; (ii) when the LA terminated with CH2 is closer to open
extremity of BuCNT, the LA is also repelled by the interaction
between them; and (iii) when the LA terminated with COOH is
closer to open extremity of BuCNT, the LA is encapsulated by the
BuCNT. These simulations are part of a more extensive work on
searching efficient selective molecular devices and could be useful to
reach this goal.
Abstract: In research on natural ventilation, and passive cooling
with forced convection, is essential to know how heat flows in a solid
object and the pattern of temperature distribution on their surfaces,
and eventually how air flows through and convects heat from the
surfaces of steel under roof. This paper presents some results from
running the computational fluid dynamic program (CFD) by
comparison between natural ventilation and forced convection within
roof attic that is received directly from solar radiation. The CFD
program for modeling air flow inside roof attic has been modified to
allow as two cases. First case, the analysis under natural ventilation,
is closed area in roof attic and second case, the analysis under forced
convection, is opened area in roof attic. These extend of all cases to
available predictions of variations such as temperature, pressure, and
mass flow rate distributions in each case within roof attic. The
comparison shows that this CFD program is an effective model for
predicting air flow of temperature and heat transfer coefficient
distribution within roof attic. The result shows that forced convection
can help to reduce heat transfer through roof attic and an around area
of steel core has temperature inner zone lower than natural
ventilation type. The different temperature on the steel core of roof
attic of two cases was 10-15 oK.
Abstract: There is increasing evidence that earthquakes produce electromagnetic signals observable at the surface in the extremely low to very low freqency (ELF - VLF) range often in advance to the main event. These precursors are candidates for prediction purposes. Laboratory experiments con´¼ürm that material under load emits an electromagnetic signature, the detailed generation mechanisms how- ever are not well understood yet.
Abstract: The development of the signal compression
algorithms is having compressive progress. These algorithms are
continuously improved by new tools and aim to reduce, an average,
the number of bits necessary to the signal representation by means of
minimizing the reconstruction error. The following article proposes
the compression of Arabic speech signal by a hybrid method
combining the wavelet transform and the linear prediction. The
adopted approach rests, on one hand, on the original signal
decomposition by ways of analysis filters, which is followed by the
compression stage, and on the other hand, on the application of the
order 5, as well as, the compression signal coefficients. The aim of
this approach is the estimation of the predicted error, which will be
coded and transmitted. The decoding operation is then used to
reconstitute the original signal. Thus, the adequate choice of the
bench of filters is useful to the transform in necessary to increase the
compression rate and induce an impercevable distortion from an
auditive point of view.
Abstract: In policy discourse of 1990s, more inclusive spaces
have been constructed for realizing full and meaningful participation
of common people in education. These participatory spaces provide
an alternative possibility for universalizing elementary education
against the backdrop of a history of entrenched forms of social and
economical exclusion; inequitable education provisions; and
shrinking role of the state in today-s neo-liberal times. Drawing on
case-studies of bottom-up approaches to school governance, the study
examines an array of innovative ways through which poor people
gained a sense of identity and agency by evolving indigenous
solutions to issues regarding schooling of their children. In the
process, state-s institutions and practices became more accountable
and responsive to educational concerns of the marginalized people.
The deliberative participation emerged as an active way of
experiencing deeper forms of empowerment and democracy than its
passive realization as mere bearers of citizen rights.
Abstract: The fluid mechanics principle is used extensively in
designing axial flow fans and their associated equipment. This paper presents a computational fluid dynamics (CFD) modeling of air flow
distribution from a radiator axial flow fan used in an acid pump truck Tier4 (APT T4) Repower. This axial flow fan augments the transfer
of heat from the engine mounted on the APT T4.
CFD analysis was performed for an area weighted average static pressure difference at the inlet and outlet of the fan. Pressure contours, velocity vectors, and path lines were plotted for detailing
the flow characteristics for different orientations of the fan blade. The results were then compared and verified against known theoretical observations and actual experimental data. This study
shows that a CFD simulation can be very useful for predicting and understanding the flow distribution from a radiator fan for further
research work.
Abstract: Rural tourism has many economical, environmental, and socio-cultural benefits. However, the development of rural tourism compared to urban tourism is also faced with several challenges added to the disadvantages of rural tourism. The aim of this study is to design a model of the factors affecting the motivations of rural tourists, in an attempt to improve the understanding of rural tourism motivation for the development of that form of tourism. The proposed model is based on a sound theoretical framework. It was designed following a literature review of tourism motivation theoretical frameworks and of rural tourism motivation factors. The tourism motivation theoretical framework that fitted to the best all rural tourism motivation factors was then chosen as the basis for the proposed model. This study hence found that the push and pull tourism motivation framework and the inner and outer directed values theory are the most adequate theoretical frameworks for the modeling of rural tourism motivation.