Abstract: In this paper, we propose a method of alter duration in
frequency domain that control prosody in real time after pitch
alteration. If there has a method to alteration duration freely among
prosody information, that may used in several fields such as speech
impediment person's pronunciation proof reading or language study.
The pitch alteration method used control prosody altered by PSOLA
synthesis method which is in time domain processing method.
However, the duration of pitch alteration speech is changed by the
frequency domain. In this paper, we altered the duration with the
method of duration alteration by Fast Fourier Transformation in
frequency domain. Consequently, the intelligibility of the pitch and
duration are controlled has a slight decrease than the case when only
pitch is changed, but the proposed algorithm obtained the higher MOS
score about naturalness.
Abstract: Rural areas of Tanzania are still disadvantaged in terms of diffusion of IP-based services; this is due to lack of Information and Communication Technology (ICT) infrastructures, especially lack of connectivity. One of the limitations for connectivity problems in rural areas of Tanzania is the high cost to establish infrastructures for IP-based services [1-2]. However the cost of connectivity varies from one technology to the other and at the same time, the cost is also different from one operator (service provider) to another within the country. This paper presents development of software system to calculate cost of connectivity to rural areas of Tanzania. The system is developed to make an easy access of connectivity cost from different technologies and different operators. The development of the calculator follows the V-model software development lifecycle. The calculator is used to evaluate the economic viability of different technologies considered as being potential candidates to provide rural connectivity. In this paper, the evaluation is based on the techno-economic analysis approach.
Abstract: As the electrical power industry is restructured, the electrical power exchange is becoming extended. One of the key information used to determine how much power can be transferred through the network is known as available transfer capability (ATC). To calculate ATC, traditional deterministic approach is based on the severest case, but the approach has the complexity of procedure. Therefore, novel approach for ATC calculation is proposed using cost-optimization method in this paper, and is compared with well-being method and risk-benefit method. This paper proposes the optimal transfer capability of HVDC system between mainland and a separated island in Korea through these three methods. These methods will consider production cost, wheeling charge through HVDC system and outage cost with one depth (N-1 contingency)
Abstract: The design of methods of the 20 K large dimension cold shield used for infrared radiation demarcating in space environment simulation test were introduced in this paper. The cold shield were cooled by five G-M cryocoolers , and the dimension of the cold shield is the largest in our country.Cold shield installation and distribution and compensator for contraction on cooling were introduced detailedly. The temperature distribution and cool-down time of cold shield surface were also calculated and analysed in this paper. The design of cold shield resolves the difficulty of compensator for contraction on cooling successfully. Test results show that the actual technical performance indicators of cold shield met and exceeded the design requirements.
Abstract: Cooperative learning has been defined as learners working together as a team to solve a problem to complete a task or to accomplish a common goal, which emphasizes the importance of interactions among members to promote the whole learning performance. With the popularity of society networks, cooperative learning is no longer limited to traditional classroom teaching activities. Since society networks facilitate to organize online learners, to establish common shared visions, and to advance learning interaction, the online community and online learning community have triggered the establishment of web-based societies. Numerous research literatures have indicated that the collaborative learning community is a critical issue to enhance learning performance. Hence, this paper proposes a learning community recommendation approach to facilitate that a learner joins the appropriate learning communities, which is based on k-nearest neighbor (kNN) classification. To demonstrate the viability of the proposed approach, the proposed approach is implemented for 117 students to recommend learning communities. The experimental results indicate that the proposed approach can effectively recommend appropriate learning communities for learners.
Abstract: This paper details few mechanical modeling and
design issues of RF MEMS switches. We concentrate on an
electrostatically actuated broad side series switch; surface
micromachined with a crab leg membrane. The same results are
extended to any complex structure. With available experimental data
and fabrication results, we present the variation in dynamic
performance and compliance of the switch with reference to few
design issues, which we find are critical in deciding the dynamic
behavior of the switch, without compromise on the RF
characteristics. The optimization of pull in voltage, transient time and
resonant frequency with regard to these critical design parameters are
also presented.
Abstract: The paper presents an applied study of a multivariate AR(p) process fitted to daily data from U.S. commodity futures markets with the use of Bayesian statistics. In the first part a detailed description of the methods used is given. In the second part two BVAR models are chosen one with assumption of lognormal, the second with normal distribution of prices conditioned on the parameters. For a comparison two simple benchmark models are chosen that are commonly used in todays Financial Mathematics. The article compares the quality of predictions of all the models, tries to find an adequate rate of forgetting of information and questions the validity of Efficient Market Hypothesis in the semi-strong form.
Abstract: In this paper we propose a blind algorithm for peakto- average power ratio (PAPR) reduction in OFDM systems, based on selected mapping (SLM) algorithm as a distortionless method. The main drawback of the conventional SLM technique is the need for transmission of several side information bits, for each data block, which results in loss in data rate transmission. In the proposed method some special number of carriers in the OFDM frame is reserved to be rotated with one of the possible phases according to the number of phase sequence blocks in SLM algorithm. Reserving some limited number of carriers wont effect the reduction in PAPR of OFDM signal. Simulation results show using ML criteria at the receiver will lead to the same system-performance as the conventional SLM algorithm, while there is no need to send any side information to the receiver.
Abstract: Iris localization is a very important approach in
biometric identification systems. Identification process usually is
implemented in three levels: iris localization, feature extraction, and
pattern matching finally. Accuracy of iris localization as the first step
affects all other levels and this shows the importance of iris
localization in an iris based biometric system. In this paper, we
consider Daugman iris localization method as a standard method,
propose a new method in this field and then analyze and compare the
results of them on a standard set of iris images. The proposed method
is based on the detection of circular edge of iris, and improved by
fuzzy circles and surface energy difference contexts. Implementation
of this method is so easy and compared to the other methods, have a
rather high accuracy and speed. Test results show that the accuracy of
our proposed method is about Daugman method and computation
speed of it is 10 times faster.
Abstract: Autoregressive Moving average (ARMA) is a parametric based method of signal representation. It is suitable for problems in which the signal can be modeled by explicit known source functions with a few adjustable parameters. Various methods have been suggested for the coefficients determination among which are Prony, Pade, Autocorrelation, Covariance and most recently, the use of Artificial Neural Network technique. In this paper, the method of using Artificial Neural network (ANN) technique is compared with some known and widely acceptable techniques. The comparisons is entirely based on the value of the coefficients obtained. Result obtained shows that the use of ANN also gives accurate in computing the coefficients of an ARMA system.
Abstract: A direct downconversion receiver implemented in 0.13 μm 1P8M process is presented. The circuit is formed by a single-end LNA, an active balun for conversion into balanced mode, a quadrature double-balanced passive switch mixer and a quadrature voltage-controlled oscillator. The receiver operates in the 2.4 GHz ISM band and complies with IEEE 802.15.4 (ZigBee) specifications. The circuit exhibits a very low noise figure of only 2.27 dB and dissipates only 14.6 mW with a 1.2 V supply voltage and is hence suitable for low-power applications.
Abstract: The standard approach to image reconstruction is to stabilize the problem by including an edge-preserving roughness penalty in addition to faithfulness to the data. However, this methodology produces noisy object boundaries and creates a staircase effect. The existing attempts to favor the formation of smooth contour lines take the edge field explicitly into account; they either are computationally expensive or produce disappointing results. In this paper, we propose to incorporate the smoothness of the edge field in an implicit way by means of an additional penalty term defined in the wavelet domain. We also derive an efficient half-quadratic algorithm to solve the resulting optimization problem, including the case when the data fidelity term is non-quadratic and the cost function is nonconvex. Numerical experiments show that our technique preserves edge sharpness while smoothing contour lines; it produces visually pleasing reconstructions which are quantitatively better than those obtained without wavelet-domain constraints.
Abstract: The reservoir of Kowsar dam supply water for
different usages such as aquaculture farms , drinking, agricultural and
industrial usages for some provinces in south of Iran. The Kowsar
dam is located next to the city of Dehdashat in Kohgiluye and
Boyerahmad province in southern Iran. There are some towns and
villages on the Kowsar dam watersheds, which Dehdasht and Choram
are the most important and populated twons in this area, which can to
be sources of pollution for water reservoir of the Kowsar dam . This
study was done to determine of water pollution of the Kowsar dam
reservoir which is one of the most important water resources of
Kohkiloye and Boyerahmad and Bushehr provinces in south-west
Iran. In this study , water samples during 12 months were collected to
examine Biochemical Oxygen Demand (BOD) and Dissolved
Oxygen(DO) as a criterion for evaluation of water pollution of the
reservoir. In summary ,the study has shown Maximum, average and
minimum levels of BOD have observed 25.9 ,9.15 and 2.3 mg/L
respectively and statistical parameters of data such as standard
deviation , variance and skewness have calculated 7.88, 62 and 1.54
respectively. Finally the results were compared with Iranian national
standards. Among the analyzed samples, as the maximum value of
BOD (25.9 mg/L) was observed at the May 2010 , was within the
maximum admissible limits by the Iranian standards.
Abstract: An efficient and green protocol for the synthesis of α-
aminonitriles derivatives by one-pot reaction of different aldehydes
with amines and trimethylsilyl cyanides has been developed using
natural alumina, alumina sulfuric acid (ASA), nano-γ-alumina, nanoalumina
sulfuric acid (nano-ASA) under microwave irradiation and
solvent-free conditions. The advantages of methods are short reaction
times, high yields, milder conditions and easy work up. The catalysts
can be recovered for the subsequent reactions and reused without any
appreciable loss of efficiency.
Abstract: A liquid curved jet has many applications in different
industrial and engineering processes, such as the prilling process
for generating small spherical pellets (fertilizer or magnesium). The
liquids used are usually molten and contain small quantities of
polymers and therefore can be modelled as non-Newtonian liquids. In
this paper, we model the viscoelastic liquid jet by using the Oldroyd-
B model. An asymptotic analysis has been used to simplify the
governing equations. Furthermore, the trajectory and a linear temporal
stability in the presence of gravity and rotation have been determined.
Abstract: In this study, the two dimensional heat conduction
problem for the dry friction clutch disc is modeled mathematically
analysis and is solved numerically using finite element method, to
determine the temperature field when band contacts occurs between
the rubbing surfaces during the operation of an automotive clutch.
Temperature calculation have been made for contact area of different
band width and the results obtained compared with these attained
when complete contact occurs. Furthermore, the effects of slipping
time and sliding velocity function are investigated as well. Both
single and repeated engagements made at regular interval are
considered.
Abstract: Natural ventilation has played an important role for
many low energy-building designs. It has been also noticed as a
essential subject to persistently bring the fresh cool air from the
outside into a building. This study carried out the computational fluid
dynamics (CFD)-based simulations to examine the natural ventilation
development of a work area in a public building. The simulated results
can be useful to better understand the indoor microclimate and the
interaction of wind with buildings. Besides, this CFD simulation
procedure can serve as an effective analysis tool to characterize the
airing performance, and thereby optimize the building ventilation for
strengthening the architects, planners and other decision makers on
improving the natural ventilation design of public buildings.
Abstract: This study aims at investigating the empirical
relationships between risk preference, internet preference, and
internet knowledge which are known as user characteristics, in
addition to perceived risk of the customers on the internet purchase
intention. In order to test the relationships between the variables of
model 174, a questionnaire was collected from the students with
previous online experience. For the purpose of data analysis,
confirmatory factor analysis (CFA) and structural equation model
(SEM) was used.
Test results show that the perceived risk affects the internet
purchase intention, and increase or decrease of perceived risk
influences the purchase intention when the customer does the internet
shopping. Other factors such as internet preference, knowledge of the
internet, and risk preference affect the internet purchase intention.
Abstract: This hypothesis shows that the induction and the
remanent of magnetic properties govern the mechanism processes of
DNA replication and the shortening of the telomere.
The solenoid–like formation of each parental DNA strand, which
exists at the initial stage of the replication process, enables an electric
charge transformation through the strand to produce a magnetic field.
The magnetic field, in turn, induces the surrounding medium to form
a new (replicated) strand by a remanent magnetisation. Through the
remanent [residual] magnetisation process, the replicated strand
possesses a similar information pattern to that of the parental strand.
In the same process, the remanent amount of magnetisation forms the
medium in which it has less of both repetitive and pattern
magnetisation than that of the parental strand, therefore the replicated
strand shows a shortening in the length of its telomeres.
Abstract: In this paper, we present two new one-step iterative
methods based on Thiele-s continued fraction for solving nonlinear
equations. By applying the truncated Thiele-s continued fraction
twice, the iterative methods are obtained respectively. Analysis of
convergence shows that the new methods are fourth-order convergent.
Numerical tests verifying the theory are given and based on the
methods, two new one-step iterations are developed.